Ford 6.7L Power Stroke Diesel :: Adding Supplemental Heater - Wiring Harness?


Nov 6, 2014

As it turns out my entire dash needs to come out to repair the HVAC so thinking while it's out I should add the diesel supplemental heater. What's involved with this? I need to replace the entire HVAC plenum so imagine the version with the supplemental heater can be bought instead. I know it's an 1800W electrical heater so my main question is the wiring harness on a regular truck setup for it or do I need to change the harness. And then I suspect the HVAC control module would need to be reprogrammed as well.

View 13 Replies

Advertisement

Ford 7.3L Power Stroke (1999-2003) :: Adding LEDs - Wiring Harness?

I am going to add some led's to illuminate the steps getting into my truck at night. I plan on putting them directly under the door over the steps. Is there a wire under the door threshold I can tap into at each door? If so what color? If not, where to get the power from. I want them to turn on and off with the interior lights when doors are opened.

View 1 Replies

Ford 6.7L Power Stroke Diesel :: Adding Decent Control / New Harness?

Is it possible to add the decent control if my truck didn't come with it? Is the harness already wired for it and the computer programmed for it or would I have to get it reprogrammed and get a new harness?

View 6 Replies

Ford 6.7L Power Stroke Diesel :: Cab Light Wiring Harness PN?

Need to know the Ford part number for cab light wiring harness? I am wanting to install some LED cab lights but I do not currently have any so I will need the wiring harness.

View 3 Replies

Ford 6.7L Power Stroke Diesel :: Door Wiring Flex Harness Shredded

First I lost the power window functionality in the rear left door... didn't think too much of it, then I lost the power door lock functionality, which was bad because I was assuming my door was getting locked when it wasn't actually. Pulled open my door this evening and found this:

I think my truck overheard me when I was saying "I like a good electrical problem, those are my favorite." I'll solder it up to get it working tonight, and then I'll see what a new harness costs... although really they should have used ultra-fine-strand wire with silicone insulation for an application that sees lots of flexing.

My multimeter's test leads are such an example of wiring that is intended to see lots of flexing.

View 14 Replies

Ford 6.0L Power Stroke Diesel :: 2006 - Wiring Harness For Windshield Wiper Circuit?

Looking for an electrical schematic and or wiring diagram of the windshield wiper circuit for a 06' Super Duty?

View 5 Replies

Ford 6.7L Power Stroke Diesel :: 2016 F550 - Ignition Wiring Harness Diagram?

I need to connect a remote start stop for a bucket truck attachment to this new 2016 F550. Found everything except the ignition wiring harness diagram. Need to know what I can tie in to.

View 4 Replies

Ford 7.3L Power Stroke (1999-2003) :: 2001 F350 - Fog Light Wiring Harness

Where I can get the head light to fog light wiring harness..it is almost as hard as finding the holly grail..... 2001 f350 7.3 .......

View 9 Replies

Ford 7.3L Power Stroke (1999-2003) :: 2000 - Ignition Harness Wiring Colors?

My 2000 f350 has wires that dont match anything I've seen. I need to mate this to an 08 harness so I need to be accurate. I have

(2) yellow. I know this is 12v constant
(2) green/purple I know this is 12v constant
(1) red/black
(2) solid red
(1) solid black
(1) gray/light blue

View 3 Replies

Ford 7.3L Power Stroke (1999-2003) :: 2000 - Got Code P1316 - Injector Wiring Harness?

I have a 2000 Ford F550 7.3. I bought a Superchips programmer to read the codes on my truck and up pops this P1316, so I did some research and found out that the most common problem is the injector wiring harness. I bought new valve cover gaskets and the injector wiring as well because the truck is old and I figured new wires wouldn't hurt.

So after installing the new wiring harness and gaskets I'm still getting this Code! The truck idles rough and serge's sometimes, also there is a lack of power and some shaking between 40 and 50 miles per hour, however form 50 to 60 MPH seem's to be just fine. I don't trust the "Mechanic Shops" around here and will only take the truck in as a last resort.

View 10 Replies

Ford 6.0L Power Stroke Diesel :: Difference Between Injector Harness?

Is there a difference between the two harness #'s here besides the first number:

3C3z9d930aa

4C3z9d930aa

Are they the same part? Is one for a different model truck than the other?

View 7 Replies

Ford 6.0L Power Stroke Diesel :: 2005 Injector Harness Fit On 2004?

Will a 05 injector harness work on a early 04?

View 1 Replies

Ford 6.7L Power Stroke Diesel :: 2010 - Location Of Plug On Main Harness?

Have a 2010 Lariat crew cab and I just bought an upfitter switch set and relay harness. Found where to mount the relay block and have been able to get the switch panel installed in its home. For the life of me though I cannot find the plug in the main harnes under the dash to plug the relay harness into to power everything up. I've read several threads here and even found the drawings that indicate plug #C215 in a diagram for the 2011+ trucks. When I get access panel out and look underneath the dash where it should be....no spare or open plug. Is the plug location diferent in 2010 from the 2011?

View 2 Replies

Ford 6.0L Power Stroke Diesel :: Leaking Glow Plug Harness Cause Hot No Start

Could a leaking passenger side glow plug harness cause a "hot no start?

View 5 Replies

Ford 6.7L Power Stroke Diesel :: 2014 - Removing Glow Plug Harness?

I'm really struggling to get this sucker off my 2014 6.7 F350

it says in the ford manual to lift the plastic tabs then pull off, I did that easily with 3 on each side, but the end plug on each side (the one closest to the windshield) does not seem to have a liftable tab (it looks different to the others as its at the end of the cable)

I've almost broken it but not quite, its over $300 for new harness, ouch

I do have the odd little hook tool they sell for this, it worked with the other 3 for sure, but I've spent ages on the 4th on each side and cannot budge either of them

View 2 Replies

Ford 6.0L Power Stroke Diesel :: 2003 - Leaking From The Glow Plug Harness

Got a 2003 6.0 that seems to be leaking from the glow plug harness. How hard would it be to just replace them? I've heard that trying to remove these things can be a pain because they almost always break. But if I'm just going to replace them who cares right?

Is there anything I need to be careful about? Or can I just rip em on out? Also I've noticed two different styles of harness should I replace mine with the other style or just keep it the same? And yes those valve cover nuts are loose. I'm aware

View 2 Replies

Ford 6.0L Power Stroke Diesel :: 2006 F350 - Code P0713 / TTF Sensor Harness

Replace the tft but still the problem, someone cones the number part of tft sensor harness, and as replace , 2006 f350 4x4....

View 2 Replies

Ford 6.0L Power Stroke Diesel :: 2007 - EGR Deletion - Adding Programmer?

We just picked up a 2007 f350 dully with 71,000 miles on it. Have done some research but still would love some input. We would like to do the egr delete and add a monitor/programmer to monitor things. We will be using this as a daily driver and to haul our dj equipment trailer (nothing big) have looked at several programmers and also talked with several local diesel owners currently leaning toward the Edge Cts2.

View 9 Replies

Ford 6.7L Power Stroke Diesel :: Adding Blank Gauge Display Screen?

I came across a post where someone said it was possible to add a gauge/setting to the blank "gauge display" screen. I've searched and searched but can't find the post. Ho to add to the gauge display blank screen.

View 14 Replies

Ford 6.7L Power Stroke Diesel :: MPG Increase With Synthetic Oil Or Adding A Tonneau Cover?

Is there a MPG gain with synthetic oil or adding a tonneau cover?

I'm planning on doing the tonneau but curious if any noticeable differences with either.

View 14 Replies

Ford 6.7L Power Stroke Diesel :: 2013 - Adding Rear Wheel Well Liners?

I first saw them on the 2013 build and price and was thinking that I should look into adding them to my 12. I never got around to looking up part numbers. So, recently I thought of it again and after a little poking found that they could be had as a Ford accessory kit for around $110 depending on your dealer. MSRP is 133 I think. So, I hit the dealer and grabbed a set they had in stock. Install took 30 minutes. Very easy. They give the wheel wells a finished look and offer lots more protection than the small plastic strips on the rear that came with the truck. A hundred or so bucks well spent if you don't have them. There are aftermarket ones that are a touch cheaper on eBay by Rugged Liner but they don't work with the 5th wheel prep which I have.

View 14 Replies





Copyrights 2005-15 www.bigresource.org, All rights reserved