Ford 6.7L Power Stroke Diesel :: AC Not Blowing Cold Despite Of Enough Air Flow
May 16, 2017
Just as the title says the ac on my truck is not blowing cold like it used to, it has enough air flow but it's just not cold?
View 5 Replies
May 16, 2017
Advertisement
Ford 6.0L Power Stroke Diesel :: AC No Longer Blowing Cold Air
Ac is no longer blowing cold air and was thinking about trying a can of ac pro on her. However, I have heard some pretty bad stories about people killing their compressors and overcharging the system. Is it not worth the risk.
View 7 RepliesFord 6.0L Power Stroke Diesel :: A/C Is Not Blowing Cold - Refrigerant Leak
So, trucks A/C is not blowing cold, and i replaced the compressor a couple years ago ( 40k miles?) took the truck to a shop to have them use one of them sniffers to check for a refrigerant leak. Was told that it needs a new evaporator core. Charged the truck up with refrigerant and it blew cold for a while but is now blowing hot again and it's summer time here in FL
So, replacing evaporator core here? I tried to find some how-to videos on youtube, but to no avail. I'd like to do it myself if possible. I think the shop quoted 3-400 in labor atleast.
Ford 6.7L Power Stroke Diesel :: A/C Just Suddenly Stop Blowing Cold Sometimes
Blows cold, so not a freon issue, but it will sometimes just suddenly stop blowing cold as if I punched the "A/C" button disengaging the compressor. Sometimes if I just wait a while it will come back on by itself, sometimes I have to stop and shut the truck clear off and take the key out, then start it back up and all is well again and it blows cold again.
High pressure switch failing???
BCM issue???
Ford 6.0L Power Stroke Diesel :: Compressor Cycling But AC Not Blowing Cold At All
So my Ac is not blowing cold at all. I can hear the compressor cycling. I filled the sys with freon. Still not cold I am pretty sure I have a leak but wouldn't it still blow cold? What do I need to check to fix this? The temps are getting in the upper 90's and 100 s I need Ac bad...
View 14 RepliesFord 6.0L Power Stroke Diesel :: Cold Start Blue Smoke Blowing Until Warms Up And Accelerate
I have a 07 6.0 powerstroke, I had 2 bad injectors so I replaced all of them with reman's. I had a problem with them coming loose. the first time this happened it hydrolocked the motor, number 8 cylinder. so I pulled all the injectors and replaced all the seals and washers and torqued them down a little more than spec like 27 lbs. it runs great and starts great even at 25 degrees but I noticed this morning that when starting it up after it sits (cold) it blows blueish smoke until late it warms up and I accelerate. is this normal? should I check fuel filters? oil in fuel?
View 14 RepliesFord 6.7L Power Stroke Diesel :: CEL Code P02E1 - Diesel Intake Air Flow Control Performance
My truck threw a CEL after the first start today. The CTS reports it twice. I noticed it about two minutes after start.
P02E1 - Diesel Intake Air Flow Control Performance
The air box gauge is green and it doesn't reset when I push it so that appears to be fine.
The one thing I can easily notice is the sound of the turbo. Typically when I stop and park, the turbo spools up, then down, then spools again and gives a sigh of relief and it's then silent. It's not doing that currently.
Now, I can hear it constantly when parked and it spools down after I turn off the engine, even two minutes later. That is not normal for my truck when I wait for the above to finish its routine. When I start the truck, the turbo immediately spools to where I can hear it which is also not normal, as if it's building 0.5 psi. I realize that's funny to say on a turbo diesel but I know the sounds of my truck. The EGT's are fine, EOT, ECT, TFT are fine and I can build boost when driving without issue. I took the drive to work easy this morning so the highest I noticed was 10 psi.
I restarted the truck after a 20 minute drive to the office and it didn't clear the CEL. The CTS squawked four times when it woke up the second time but it didn't show me which PID it was upset about.
I'm thinking this has nothing to do with the CAI and this is something downstream of there. EGR related? I haven't opened the air box yet, at work and in dress clothes so that'll need to wait. My past four or five regenerations all started between 1.94 and 1.97 soot gpl. That is also not normal and is something I have been keeping my eyes on. Currently the DPF is at 2.10 so it has made it further. Normal behavior (post emissions flash) is above 2.54 soot gpl for an AR.
Ford 6.0L Power Stroke Diesel :: Fuel Pressure PSI And Flow
I've done some searching on this site and found some good information but I still have some questions about Fuel Pressure and fuel flow. A few months back when I had a bad injector and bubble tested to verify and it took around 15 seconds to fill the bowl(filter removed) from near empty is that normal or the sign of a healthy HFCM?
Tonight I was able to check the fuel pressure for the first time and when I turned the key on fuel pressure was slow to build for 2-3 seconds held at 20 psi then spiked up to 62psi and stayed at that psi during the starting cycle and held steady during idle. Is it acceptable to hesitate with a pressure build at the beginning of the cycle?
Ford 6.0L Power Stroke Diesel :: IRP High Flow Oil Cooler
Is the irp high flow oil cooler any good? Or is it better to stay with the oem
View 14 RepliesFord 6.7L Power Stroke Diesel :: Turns Over But Won't Start / No Fuel Flow
I changed out my fuel filters today on my 2016 F350 SD and right parts, no leakes, main filter full, and I did the 6 cycle fuel pump prime. Turns over but won't Start. Redid the 6 cycle prime several times now and still no start. Pulled the 2ndary filter lines while it was priming to see if flowing and got squirted on both lines.
View 8 RepliesFord 6.0L Power Stroke Diesel :: 2004 F250 - EGR Low Flow Code
I am driving a early 2004 F250 CCSB with a 6.0l. I have a Code that is for an EGR Low Flow. I have a Scan Gauge II that I have been using to try and determine why this is. I have replace the EGR Cooler (unrelated), the EGR valve, and the MAF.
My EVD and EVM are tracking. My IA1 reads a letter (B usually) and 3 numbers that are in the 6 to 900 range. My IA2 appears to read normal with atmospheric temps at start up and goes up and down IAW the EVD and EVM readings. My FIA (already programmed) reads outside temperature along with the overhead console. The EBP reading doesn't exist, it is blank.
Ford 6.0L Power Stroke Diesel :: 2003 - Coolant Flow Not At Its Max / Blocked
Coolant flow seems to be not at its max output seems like it's blocked somewhere. Lots of pressure in bypass line of radiator after clamping of hose and releasing pressure of degas bottle?
View 11 RepliesFord 6.7L Power Stroke Diesel :: Check Engine Light On - EGR Cooler Had No Flow
I found out today that the 2012 6.7 that I have purchased used with 30, 500 Miles on it a month ago has been in previously for warranty work. It appears that the previous owner took it in with a check engine light and after diagnostics found that the EGR cooler had "no Flow". Ford replaced the EGR cooler core under warranty before I bought it. (It now has 31, 950 on it). Normally I would think, GREAT, something I don't have to worry about doing. But being new to the diesel world, I was just wondering if this is something I should be concerned with. Anything else I should be keeping an eye on etc.... Also is this abnormal to occur with such low mileage?
View 14 RepliesFord 6.0L Power Stroke Diesel :: Code For EGR Flow Restriction Cause Limp Mode?
I'm going to do a weld-in-plug delete in my RV in the next couple weeks, and its a crapshoot apparently if it'll throw a code. My immediate concern is I want to go on a trip right after, and I won't have time to fiddle about getting an SCT tuner to turn the code off. What I definitely don't want is a code for EGR flow restriction to eventually cause my motor to go into some kind of limp mode while I'm in the middle of a long drive. Is this possible?
View 14 RepliesFord 6.0L Power Stroke Diesel :: Sticking Turbo - EGR Insufficient Flow P0401 Code
The truck in question is a 2004 6.0L Excursion, stock original turbo, no tunes, and EGR cooler delete done 1 year ago. Scanned for codes and none were found except for EGR insufficient flow P0401 code which is due to the EGR cooler delete.
Upon startup (no issues there) the VGT reads 67-70, now once the truck goes to high idle to warm up (1150 or so RPM) the VGT slowing climbs to 85 and stays there. If I blimp the throttle or step on the brake it goes back to 67-70 at normal idle. This has been happening for a few months now on a regular basis. I have checked the MAP, BARO, and EBP readings at KOEO and they are all within 0.6 of each other (14.4-15.0). The EBP tube was checked and cleaned (no buildup present)..
Ford 6.7L Power Stroke Diesel :: P2073 Code - Manifold Absolute Pressure / Mass Air Flow
My truck threw a P2073 code. Its Manifold Absolute Pressure/Mass Air Flow - Throttle Position Correlation at Idle. I do have aftermarket intake. It threw this code 2 weeks after install. Does this mean my mass air flow sensor is going to fail soon?
View 14 RepliesFord 7.3L Power Stroke (1999-2003) :: AC Stopped Blowing Cold
My 02 F350 7.3 new to me trucks ac stopped blowing cold. Not air gap issue (shims have been removed prior to my ownership-I pulled hub and checked), the charge is good (according to the shop I went to for evac and refill), and the compressor's cycling quickly. I'm no HVAC guy by any stretch. I have a cheapie gauge from days long ago that I connected to my low side port (which I know isn't definitive) and it reads from 25 to about 40/45 depending on the cycle.
Additional info that may not be anything:
1) Where the line goes from accumulator to evaporator the foam seal is slightly messed up and I feel ice cold air coming out of the housing.
2) The line is warm before the orifice and cold after it.
3) The lines going to the accumulator are both hot (after taking it to shop, before were lukewarm).
4) The condenser doesn't seem to have excessive plugging and I have rinsed it with garden hose sprayer with no difference.
5) The air from the vents blows good, just warm.
6) I've replaced the actuator for the blend door already.
Ford 7.3L Power Stroke (1999-2003) :: F350 - A/C Is Not Blowing Cold As It Should
99 f-350 crew cab. The A/C is not blowing cold as it should. Have already replaced the compressor and clutch, orifice tube and accumulator, also cleaned evaporator coil and put a new blower motor on, also a new blend door actuator. Also put a valve in to block coolant from the heater core. System has had vacuum pulled and charged correctly by my mechanic, he says he doesn't know of anything else to do, that it was as good as its going to get. Ive been in 2 more trucks identical to mine and the A/C will freeze you out, as to where mine will not come close. Temp coming out of the vents barely gets down to 60 degrees
View 14 RepliesFord 6.7L Power Stroke Diesel :: Power Door Lock Fuse Blowing Occasionally?
I purchased 2011 F250 King Ranch Edition about 3 months ago. I'm loving the truck and not had any issues until 3 weeks ago. I locked the truck as usual using the key Fob, and upon returning to the truck, I noticed the doors weren't locked. After some brief trouble shooting, I discovered the the fuse was blown that according to the manual controls just the power door locks. I thought it was strange that a new truck would be popping a fuse so I replaced it...a couple of days later it blew again. This time I was locking the truck with the door key pad. I took it to the dealership and they checked it over and said they replaced the fuse and cycled it numerous times but could not reproduce the problem. The told me that they even put a call in to the Ford engineers and they said check the key pad for water intrusion. The dealership told me they disassembled the key pad and found nothing wrong....lock and unlocked the door some more and the fuse would not blow. I picked the truck up four days ago and the fuse blew again last night. Everything else works...alarm sets and goes off if any of the doors are opened. The only thing that I can find that doesn't work when the fuse is blown is the remote start.
View 14 RepliesFord 6.7L Power Stroke Diesel :: AC Blowing Nothing But Warm Air
Well it's that time of year to start using my air conditioning. Went to use it today and it is blowing nothing but warm air. Worked perfectly last time I used it last year. I thought about buying that 134a ac recharge kit from auto zone.
View 14 RepliesFord 6.0L Power Stroke Diesel :: 2007 - Power Loss When Driving - White Smoke Blowing
I have an 07 6.0 with 400,000 miles. Has been a great truck with no major problems. Before I started the work I had 3 bad injectors, running rough and the oil/ coolant temp just outside of 15 degrees. So I tour her down and replaced head gaskets, installed arp studs,all new injectors,all new glow plugs and new oil cooler. Ran great for a couple days. Then when driving to work lost power on and off for a few miles then completely gone could only go 10 miles an hour. I checked codes and there was the under boost code witch has been on there for a while and I forget the other code but it was for the ipr valve so I replaced the valve and right after still the same but that code went away and the p0470 popped up. So I cleaned out the ep sensor tube and replaced the valve. After several miles she now runs great but now I'm getting a little puff of white smoke when I take off and not every time and mainly when I take off some what quick. All codes are gone expect the under boost. I have an egr delete already.
View 7 Replies