Ford 6.7L Power Stroke Diesel :: 2013 - Rear View Camera Wiring Diagram?
May 10, 2014
2013 F350 Lariat with the factory OEM rear view camera. I am replacing the tailgate with a 5th wheel tailgate for a few months and would like to still retain the convince of a rear view camera.
I have obtained a Ford camera harness to use as a jumper for a non OEM camera which comes with the standard basic RCA wiring which I plan to mount to the bottom of the 5th wheel tailgate.
My hope is to wire the camera direct to the Ford wire harness which is a 6 wire pigtail. Which wires on the camera mate to which wire on the trucks wire harness.
View 14 Replies
Advertisement
So my 2012 rearview camera was super clear and this 2013 is super blurry! Only difference is that this one has has MyFordTouch with no nav. The 12 had the nav option. Camera lens its self looks clean.
Oh yeah and the thing automatically autoplays my voicemails as soon as I start the truck and I hate that it does that. Can't figure out how to get that from happening.
View 14 Replies
Was wondering if there is a way to adjust the view angle of the back-up camera? Mine appears to be a little off center.
View 6 Replies
I am in need of a wiring diagram for a 00 ex with factory auto dimming rear view mirror. It only has 3 wires and I think I have them figured out but would like to make sure before making a pigtail to install a mirror I have that has 6 wires.
View 7 Replies
My truck didn't come with factory option aux switches. Can it be added, and is wiring present?
View 14 Replies
2002 F250 diesel ... I found these two plastic pieces yesterday on the floor near the 4X4 shifter. I noticed the other day when i step on the brake the rear view camera in the head unit comes on, so i am thinking they are either a part of the brake switch on the pedal assembly, or something to do with the shift tube.
View 2 Replies
Where I can find a wiring diagram of the inside and outside lights on the 6.0s? I'm trying to wire up my running boars lights to my dome lights and tail lights but don't know the colors or locations of the wires. The tail lights wouldn't be as hard to find as the dome lights, what is the location and color of both.
View 14 Replies
I need to connect a remote start stop for a bucket truck attachment to this new 2016 F550. Found everything except the ignition wiring harness diagram. Need to know what I can tie in to.
View 4 Replies
Just bought a new Tiguan 2013 for my wife, which has the rear view camera. However upon reversing, there's no beeping to warn you that you're about to hit something.. Shouldn't that be the case?
My only experience of rear view camera's are on rentals and they've always beeped when something is in view.
View 5 Replies
Menu -> Setup -> Phone -> Phone Display Settings
Display Phonebook Transfer Status: Off
Display Call History Transfer Status: Off
Menu -> Setup -> Bluetooth -> Detailed Bluetooth Settings
Display Phone Status: Off
Display Portable Player Status: Off
View 14 Replies
Currently I have a license plate camera wired always on connected to a 7inch lilliput monitor infront of my center console on that hump in the floor. The monitor is connected to a 12v plug on the dash. In this configuration, I have to reach down and turn the monitor on whenever I want to reverse and im hoping I can make it turn on whenever I go into reverse. Right now, if I turn it on then turn the truck off, the monitor stays on with a bright blue no signal screen which forces me to turn the monitor on, then off, every time I reverse if I want to use it.
Any way to make the monitor turn on/off when I put my Ex in reverse?
View 14 Replies
I can't find a wiring diagram for the UVCH pigtail anywhere. The one that came with the harness assumes the old one was still connected. My wires were burned through and I need to know what colors to wire in from the truck to the new harness so everything matches up.
View 9 Replies
I am looking at putting a couple small LEDs in the pinch weld area under the doors on the cab. I want to have them come on when I open up a door. Where is the best place to grab power from the door switch circuit for that? The passenger side I was thinking of grabbing it where it goes into the sleeve between the cab and the door, but on the drivers side there are a lot of things in the way to get to that point. Can I pick it up down in the door jamb area? Is there a wire going to the dome light there?
View 8 Replies
Got a 2002 7.3 f550 and the other morning it wouldn't go into high idle. Noticed my parking brake light was off. Messed with the switch and eventually jumped straight from the connector to ground... still no light. The light does illuminate with key on. I have tested the fuses. Where do I go from here? Looking for a wiring diagram....
View 14 Replies
Any pic or wiring diagram of the starter relay that is mounted to the fender. I'm trying to start the truck finally but it's just cranking and I think I might have mixed up the wiring. Is there supposed to be a constant hot at the glow plug relay when the ignition is off?
View 14 Replies
I have a new to me 1999 F250 with the 7.3 engine. The previous owner installed a push button start to get around the ignition actuator being broke. Over the weekend I pulled the column and replaced the actuator but the truck will still not start with the key; with the push button it starts just fine. I'm not getting any power on the starter relay signal wire, so I suspect something in between the key and starter relay. I searched around a bit, but could not find a wiring diagram for a 1999 diesel super duty.
View 3 Replies
2011 f350 CCLB... I want to wire a hitch mounted winch for both front and rear usage.
I see several 2 ga wire kits with quick disconnects, but was wondering which battery to go to, and which frame rail side to use. The exhaust side kinda worries me due to heat. Although the drivers side has the fuel tank, and I have skid plates blocking the inside of frame, so it doesn't sound pleasant either!
Also, best method to connect to the battery terminals. It appears the battery clamp screw is smaller than standard and wont accept a large ring winch terminal. Is there a "post doubler" available, or should I consider removing the factory cable clamp and replace with a set screw block of some sort? Hate to have a warranty issue due to a non oem battery clamp?
For the limited use, I have consider just getting one of the wiring kits, and adding high amperage "jumper clamps" and running the wire only when used?
View 6 Replies
I'm trying to find the wiring diagram for the power windows in a 96 f150. I've got a set of these that i need to fab a harnes for to install in my 82.
View 12 Replies
In my 6 day old Golf TSI, I'm noticing the rearview camera is quite noisy when it deploys and retracts. I don't recall how it sounded during test drives, but I'm surprised I can hear it at all, let alone as loudly as it seems.
Likely normal, but thought I'd post this up to see what others are experiencing. Might drop by the dealership and check another one out for comparison.
View 8 Replies
Picked up a mk6 tdi a couple weeks ago (my first vw), and yesterday my rear view camera started acting up. And by acting up I mean, the screen only displays black, and the camera is stuck open, protruding under the badge and will not close. I've checked to make sure everything is still plugged in, and it is. I'm not exactly sure what to try next?
View 3 Replies
I own a 2015 passat, yesterday in ny it rain the whole day. I went to reverse and the screen told me "the rear view camera not available" the first time it has happen to me, now it's working fine.
View 6 Replies
