Ford 6.7L Power Stroke Diesel :: 2011 - Increase Trailer Brake Output?
Jun 24, 2015
I still have my 2011 6.7 f350 CC. I have a triple axle (single wheel) gooseneck tilt deck trailer that I pull my older dozer and backhoe on.
With the trailer brake gain set to 10 I don't have as much brake engagement as I would like. It actually wont lock them up at all when adjusting the gain. Loaded I don't feel any engagement when manually sliding the controller.
On my sons 99 f350, with after market controller he can adjust his output so that the brakes engaugelock at just about any adjustment (way over breaking) so I believe the trailer brakes work fine, I just don't get enough output from the factory controller.
Is there any additional adjustments the factory controller has or any suggestions to increase the output more so the brakes have a bit more engagement?
View 14 Replies
Advertisement
2005 Excursion 6.0 with normal bullet proof mods... towing 6000# dual axle enclosed race car trailer.
I've been towing this same package since 2008 all over the eastern half of the US and averaging right around 10MPG.... hand calculated from fill up to fill up. Sometime a bit more on a flat run to Daytona, or a bit less through the mountains... but very close to 10 MPG.
Well the factory trailer tires finally wore out and I replaced them with 8 ply Maxxis M8008 trailer tires...... highly recommended by the camper crowd.
Since then, I've been round trip Baltimore to Pittsburg, and Baltimore to Daytona (total of 2500 miles) and I've been averaging a bit over 12 MPG consistently..... again hand calculated. Same package, same highway speeds.... nothing has changed in my towing style.
Seems almost to good to be true. At this rate the tires will almost pay for themselves by the time they are worn out. Any trailer tires make such a difference ?
View 6 Replies
I'm having some electronic problem with my 350. I parked it and took both batteries out for about a week. I put 2 brand new ones in and hooked them up truck won't start. So I turned key on and left on and the fault that comes up is the "trailer brake module fault" also the abs light, parking brake light & passenger airbag lights are on. Sometimes if I leave key on long enough the lights go away and I can start the truck. But it shuts down during idle. I unplugged the tbc (indash) and the #22 fuse under hood and #31# on passenger side. Still showing the fault. I'm not being allowed to start the truck. I used my tuner and found one code (P0884 tcm power input intermediate)..
View 14 Replies
It just came on when I ran up to the gas station followed by the airbag light and the traction control light.. truck ran fine. I've tried looking this up found some people have had this message and there truck won't start.
View 6 Replies
I have a 15 F350 DRW 6.7 pulling a 19K fiver with 8K axles and disc brakes, I have to have my brake controller set at 10 to get the brakes to work well. The pads are good, just bled the system using a power bleeder, controller is set to electric over hydraulic with max gain. Why I need to have the controller set to max?
View 14 Replies
Brought my truck (2012 F350) for recall service for one of the faulty exhaust temperature sensors. It took them one week to replace the sensor (!), then when I came to pick it up I got: "Trailer Brake Module Fault" message on the display.
I have never seen this message, since I own the truck (I am original owner). The service adviser said it will take a minute to reprogram the module and took the truck back to the shop. Came back after a while, saying that it didn't work and I need to leave the truck, so another technician can work on it tomorrow. Tomorrow came and I got the call that they reprogrammed the module, but the message still shows up, so they need to work on it (another day!).
As of now they still don't know what is going on. Apparently they broke something while replacing the EGT sensor and how to fix it.
View 12 Replies
I have an issue with my 2011 SD. When i press on the brake pedal I get a message saying I have a trailer connected and then when I step on the brake pedal again it says trailer disconnected. This happens every time I touch the brake pedal. I have replaced the trailer connector 7 way plug thinking that was the issue to no avail.
View 3 Replies
Ok 2011 ford f350 6.7. Turn key on, no crank, no start. Trailer brake module failure flashes on the screen. If you leave the key on after 5 to 10 minutes the heater kicks on and you can start it. Runs down the road, hitting every pot hole for 1000 miles fine. Shut it off, try to immediately restart, same thing. If you hook up a booster box to it it starts. Replaced both batteries, cleaned cables. Scanned it, only codes are with the instrument panel : loss of communication with trailer brake module, with abs, with heat and air, and with parking aid modules. Tried to scan abs, parking aid, and brake, scanner would not communicate. When it is running communicates fine with them. Need a direction to go from here?
View 14 Replies
I have an 08 F450 equipped with Ford integrated trailer brake controller. I tow between 6,000# and 14,000# machinery on a daily basis. I know the gain can be adjusted up to ten. I have noticed while braking "normal" The controller only outputs 1 green bar of power. Manually, the brakes on all my trailers don't grab untill around 3 bars of output. I find myself always sliding the manual lever to relieve the truck. The truck is suffering. I have the gain set to 10 just to get minimal result from the 1 bar output. I know my trailer brakes rock, they can stop the truck and trailer if needed. Can it be adjusted? How many bars are you folks getting with easy braking?
View 6 Replies
Was out on a camping trip. Went to move the truck and it acted like the emergency brake was on. I put it in and out of park 3-4 times with the same result. Noticed when I took my foot off the brake, it went from 1st to 5th. One of the guys in our group said to turn off the truck, wait 10 seconds. I did and all is well again. There were no CEL lights or anything.
Have 2700 miles on my 2011 (bought new May)
View 7 Replies
I was wanting a fuse digram for a 2011 f250 6.7. My right brake light is out and I don't have a way of knowing what fuses have to deal with the lights. If some one could tell the which ones or send me a diagram
View 2 Replies
Have 50,000 mile on my 2011 F350 6.7 and up until today the truck has been flawless. This is my weekend vehicle and sees very light duty hauling fishing gear to my boat (100 miles hwy) and pulling my 7x12 enclose trailer with goose decoys. On a couple of occasions pulling my 29 CC from marina to my home and back. Took truck in for oil change and tire rotation, service advisor informs me I have 2mm on rear brakes and 3mm on fronts. Not sure why rears have more wear than fronts. Schedule to have brakes done for today and now find out that front right caliper is sticky and they want to replace both front calipers. I cannot believe that a 2011 SD F350 with 50,000 miles and of that mostly highway needs brakes let a lone calipers are going bad. Service manger tried to tell me that brake fluid should be replaced every 2 years, to which I responded that I have Ford perform all scheduled maintenance. He went on to say that this is not scheduled maintenance, wtf bs is he telling me, if it is necessary then it would be scheduled maintenance. Truck gave zero indication of stuck caliper, no sound and no excessive brake dust on wheel.
View 14 Replies
We've got a 2012 F550 6.7 with 138k. It recently got a battery light. The batteries are right around 12 volts with the truck running or off. I also tested the output on the alternator and its not charging. I put a new alternator in it and still no charge. All the connections are tight and clean. The batteries load test ok. Where to look next?
View 4 Replies
Brake booster failures on 2011 and newer F-250's? I purchased a 2011 last august and the mechanic at the dealer I purchased the truck from stated that he had replaced the vacuum pump, vacuum brake booster and brake master cylinder on the truck just before I bought it as they were bad. Since then I have had two factory Ford vacuum Boosters fail on me. That makes at least three new factory Ford booster assemblies in this truck within the last year. What could be causing the problem? The truck is out of warranty and I am at a loss as to what could be causing them problem. Too much vacuum? Luckily the last two boosters have failed while sitting in a drive through and at a stop light, otherwise I may have had trouble stopping.
View 3 Replies
Been having a on/off problem with my trailer lights. Some times the right hand side does not work, them it starts working. I thought it was my trailer until I rented a bobcat this weekend. They couldn't get the right side lights to work.
I stopped by my Ford dealer and a service tech came out and checked out my pigtail. All checked ok. It seems odd that both trailers would not work on the right side. Two different types of trailers. One is my RV, the other was a flat bed for hauling the bobcat.
View 10 Replies
Love the turn signals of flashing 3 times if you just tap it. It will flash 5 times on the tap when you are pulling my rv. Is there a way to increase the number of flashes? Say 3 to 5 and 5 to 7. Couldn't find anything in the owners manual.
View 1 Replies
Is there a MPG gain with synthetic oil or adding a tonneau cover?
I'm planning on doing the tonneau but curious if any noticeable differences with either.
View 14 Replies
I have a 2011 F-350 CCSB 4x4 w/ 20" Wheels and the electronic locker. I have had for some time a noise when I go over small bumps (pulling into garage up a 1" lip) at slow speeds. It sounds/feels like side to side movement. I have traced this down to what sounds like looseness inside the rear differential. To recreate, I lay down and shove hard on the spare tire. This pushes the truck side to side. I can hear a clank/clunk at both wheels around the brake area.
View 14 Replies
Hooked up the toyhauler Friday and before we were off of our street I got the "Wiring Fault on Trailer", brakes on trailer worked, got out and verified the lights were working so we proceeded on.
When we got to the destination the manual says that if the fault stays on when disconnected it is an issue on the truck side, it is still on when the trailer is disconnected.
View 10 Replies
Borrowed a buddys trailer that had wiring issues. I ended up blowing a mini fues & maxi fuse in my truck. 06 F350 CC ... Replaced both fuses in the truck and had park lights on the truck but now dont get any lights on any trailers. All factory plugs 7pin & 4 pin. I get turn signals and brake lights on the trailers but that is all. If the fuses are good were should I start looking for problems? or is there more fuses I may be missing. I have metered all the fuses under the dash aswell as under hood all check out. Where to go next ???
View 14 Replies
My trailer wiring is not working, at least from what I can tell. Embarrassingly, I know this because the little brake light I have in my trailer hitch no longer lights up. I've tried different bulbs and a different unit, so it's definitely the wiring. I do not have access to a trailer right now, so unfortunately that's all I have to go on. It's plugged into the 4 pin jack. Is this something I should be going to the dealer for, or more like a blown/loose fuse or something?
View 13 Replies
