Ford 6.7L Power Stroke Diesel :: 2011 - Hesitation Or Lag At Takeoff
Oct 2, 2013
I'm taking my new to me 2011 KR 6.7 I've had it 1 week, to the dealer tomorrow to get them to look at the hesitation on takeoff. I have read on here that not all trucks are doing it. There is 25500 miles on it and have been averaging 15.3 mpg empty, is this about normal for what people are seeing? I'm running the 3.31 gear ad I thought I would get better mpg. This truck was built in Feb. of 2011 would it have the 400/800 settings or would it have to be flashed?
View 14 Replies
Advertisement
When i take off in morning truck will change from low to 2nd and hesitate for a second and then go on ok. was sitting at light the other day an went to take off an mashed dn on fuel pedal an it just sit there an then took off, dont no whats going on.:-
View 9 Replies
I have experienced a hesitation on my truck since I purchased it 6 months ago. I get a one to two second hesitation at take off from a stop. I have checked the back pressure tube and the one that goes to the turbo controller no problems. I have a Edge CTS programmer that only shows ... for EBP.
View 13 Replies
So loss power on take off and then stopped at store quick shut it down. Came out of store ten minutes later no start just turns over and over. I replaced IPR last year the one on passenger side near frame if that's correct and perhaps this is the ICP near back of engine?
View 14 Replies
So I am not sure exactly what is going on with my truck. It is a 2004 F250 has a 6.0 L. Sometimes when I take off from a stop the truck has no power and blows some black smoke. Then the turbo kicks in and all is fine. It comes and goes when it pleases no matter the temperature. What started happening is when I drive it a steady pace on the highway sometimes the turbo gets quieter and louder and quieter and louder sometimes when it gets quieter I see a little bit of black coming out of the tailpipe. Sometimes it doesn't do it at all. Also sometimes when I let off the gas the truck sounds like it's trying to laugh at me like a wastegate is fluttering.
View 10 Replies
Purchased my first used Super Duty 2011 F250 6.2. Love the truck. This is my 3rd ford truck. I get home from work, so the truck is warm. Sit for 20 min, then leave to take the kids to their games. After turning onto the street then accelerating power is lost for 1-2 seconds, then the truck continues to accelerate. If I let off the pedal, then the truck will slow down, if I hold the pedal position of push down it does nothing. This is going to drive me crazy. Not sure if this is a TCM reprogram issue? It only does this on the initial take off. I want to start playing with my new truck, but want to fix this bug first.
View 5 Replies
Can a bad or lazy VGT solenoid cause a P132B code? I just recently had the turbo cleaned and the VGT solenoid replaced about 3 months ago. The truck is a bit sluggish at take off. Is there anyway to check the solenoid to see if its bad?
View 14 Replies
06 250 w 65k and it is sluggish on take off, and puffs black smoke most of the time. other than that it runs good.
View 14 Replies
Ok I have a 2004 f250 6.0L, has 104k on it. A little back story... truck was running well when I started to get surging on takeoff and it was blowing black smoke when it surged. After it hit 1600 rpm it would blow out and run normal. So did some research and found it could be the FCIM, I have the 4 pin and tested it and had 48.5v so it tested good. Did some more research and found symptoms leading towards the ICP so I replaced that and the ICR also.
Upon doing this my surging issue cleared up but now I'm getting a miss around 1200 + rpm weather it's in park Reving it or driving, but it is not throwing any codes, I did check with my code reader. I have also changed both fuel filters and have the EBP sensor on order as I hear they can be troublesome. My question is what should I do next or look at? I was trying to avoid the dealer so I can learn more about the truck in diagnosis.
View 14 Replies
05 F-350 6L .. Automatic Transmission
When I got the truck I noticed it would slam hard into reverse. Ever since it is taking longer to engage reverse gear and now I have to rev it to 1000 rpms for it to engage with a hard SLAM.
I also noticed that if I do a fast take off, there is a knocking sound coming from drive shaft/differential area (like knock knock knock knock knock then goes away). Then a slight vibration ending at around 30 kph (~20 MPH). There is also some oil leaking from the transmission. I added some mercon sp yesterday - it was a bit low.
My guess for the knocking and vibration is the center support bearings and U-joints. Transmission??? One thing I know I am going to be banging away at that shaft but the transmission problem really scares me.
View 5 Replies
So lately I have been having issues with my 6.0 smoking, hesitating, and chugging. It seems worse when the vehicle has been idling for a minute or two (as in at a red light) and when I depress the accelerator it starts to move, but chugs and sputters, spurting light gray smoke, then the boost hits hard, the truck surges forward, leaving a massive cloud of smoke behind, then seems to run fine until I come to a stop again. I got the usual EGR codes, so I cleared the codes, pulled and cleaned the EGR valve of all built up soot and carbon, and reinstalled it. It seemed to run okay again right after doing that work on it, but then started acting up again this afternoon.
Shot the same codes for EGR (P0404, P1335). I cleared them again, and it continues to drive like crap. Other than EGR that I can look into? Or will I need to pull and clean the valve again tomorrow when the sun is up? At first I was thinking I might also be having fuel injector stiction issues, possibly turbo vane stiction issues, maybe FICM issues, but it's only feeding me codes for EGR.
View 12 Replies
My truck is developing a hesitation or a miss when accelerating. It only does it in the beginning of accelerating like when just starting off from a stop. Seems like its more noticeable with the more I get on it. If that makes any sense. When just lightly accelerating it doesn't do it, like going slow through town from light to light. But when I give it more is when I feel it. It seems like it only does it before the turbo kicks in and it puts out a little smoke too only before turbo kick in. After that it runs good with no noticeable miss or anything. WOT runs feel good after it clears up. Its just when first starting out with anymore that 1/4 throttle I can feel it.
View 14 Replies
I have a 06 f250 king ranch with 6.0 . A few days ago my scangauge showed a code P0405
I changed my egr and after it showed two codes : P0405 and P0404
It still has a hesitation and loss of power , although better than before the Change.
View 3 Replies
i bought a used 2011 F250 and really like the truck and there is no comparison when towing the trailer.
1.) I've noticed the truck doesn't shift smoothly from 3rd to 4th. Under light acceleration the RPMs climb, then drop slightly, then climb, and finally the truck shifts into 4th gear. It's almost like the truck wants to shift but doesn't. I believe a selenoid was replaced on the truck.
2.) From a dead stop, when pushing slightly on the gas pedal there is a slight hesitation or unresponsiveness with the truck wanting to proceed forward.
View 14 Replies
So I was turning into my neighborhood tonite, when I got a really loud thud and a major hesitation in the engine. Fortunately I was in my neighborhood and could basically coast to my house.
No CEL came on and I don't seem to have any leakage (only thing dripping underneath was condensation from a/c I believe). Obviously too late for service tonite, so have tow scheduled for 7am. What could have happened? The no CEL has me confused. I was able to restart it and it seems to idle fine, but give it has and it hesitates.
View 14 Replies
When I am on the highway, my 2005 Excursion (6.0) will hesitate/sputter/buck intermittently, usually between 70-80mph/ 1800-2200 RPM, but especially triggered by hills and inclines. Each sputtering episode usually lasts about 5-10 seconds and then will go away for minutes at a time. Does not sputter upon take off or initial acceleration. There is no smoke of any kind. Just got it out of the shop where the mechanic replaced ALL 8 injectors and the fuel pump, as well as flushed the fuel lines, and new fuel filters, and oil change (2 injectors were bad, but there was metal in the fuel filters, so to be safe I replaced all of them - ALL OEM PARTS for everything, including filters).
The week before, I had the IPR valve replaced. Also, recently had the back pressure sensor replaced and the EGR was deleted - and turbo cleaned when the EGR was deleted last month. I also tried unplugging the ICP sensor to make sure that wasn't the issue. Dropped $6k into this thing in the past month and about to lose my mind (and wallet). All research points to either clogged EGR or bad fuel injectors, but both have been addressed, so I am not sure where to look next. No current codes showing up. No signs of leaking oil.
View 14 Replies
Have just about 1,600 miles on tuck born on 12/14/11. Love it, but.. When going slow in subdivision I am getting some hesitation/bucking when going in the upper 20s/lower 30s. When I feel it I look down and I am usually in 3rd. Is this the transmissible thing? When it happened Sunday it felt like it was going to die. If I start off with a quicker start (to get to highway speed) it shifts fine. It just started the last few weekends......
View 14 Replies
I've only owned a 6.0 for about 10 months now. I have a 2005 SCab FX4 with 125,000 miles on it. It has an Airaid cold air intake and MBRP exhaust without a muffler, everything else is stock. The stuttering/hesitation starts at about 1500 rpm, is worst at 1600rpm and seem so to go away at 2000rpm. It also seems to hesitate when I barely press the gas pedal while driving. Based on other fuel issues with other vehicles, I would assume this is a fuel problem, but am not well versed in the 6.0 engines. Fuel filters were said to be good by the dealership about 10,000 miles ago. EGR valve was replaced last week. I'm not blowing smoke of any color, even at WOT. I was thinking an injector may be the issue, but I show no other symptoms besides the hesitation/vibration. I don't feel any lack of power when I give it full throttle. I would like to know a definitive way to diagnose the problem without going to the stealership.
View 7 Replies
Finally registered on this site after hearing good things from others who are currently on here. Been a 6.0 PSD owner since buying the truck since new in 2003-F250 CCSB. I have done regular maintenance on it and have had a good run until recently. Everything is stock on the motor and currently has 229 000 miles.
I will describe my current problem: I have borrowed my brother's tablet and have the following numbers from the Torque pro app. While trying to accelerate it now has a hesitation and seems to not have the power.
At idle: 630 psi HPOP, 24 % IPR, 47 volts FICM, ICP volts .1
Trying to accelerate on at highway speeds: 1230 psi HPOP, 83% IPR, 47 volts FICM, ICP volts 2.6
Also, sometimes when starting the truck it seems to rev extra high for a split second. My brother says I may have a high pressure leak on the system. What I should check first?
View 14 Replies
Recently I replaced the unison ring on my turbo, EBP sensor and cleaned carbon out EBP tube/upper part of motor. After doing so she seemed to run fine but not like I remember when I first got her. Plenty of power but ever so slightly off, only an owner would notice. Few weeks later she hesitates a little bit while she's cold in the morning. I let her run 3-5 minutes b4 actually driving but as u know it's a little while to get up to operating temp. Temps seem OK 190-200 EOT/ECT. Fresh oil/filter, air filter, coolant, EGR was cleaned out a little while back and EGR valve replaced 25k ago. I'm not sure where to look at this point...the motor has about 30k on it.
View 3 Replies
So it looks like my lift pump (low pressure fuel pump and sending unit) is going. Multiple low fuel pressure warnings over last two days and hesitation at low RPMs. Not hearing pump run when I turn the key all the time but no issues starting. About 16,000 miles since last fuel filter change but picked up new filters today at dealer.
Asked about a fuel pump and he quoted PS401 and none available in Canada and had to inquire direct to Ford - 30 day wait on a part that will turn my truck into a brick if not replaced. Can't find a PS401 but I can get a PS 402 out if the USA in 5 days.
Any difference in these? Dealer is an idiot and can't even determine if there is a difference or too lazy to find out for me. I don't even know if I can prime the truck if I change filters at this point and this is a quick change job for me if I had the pump. Going over the system from back to front in the morning.
Don't ask about warranty. Just hit 160,000 KM on my truck.
View 12 Replies
