Ford 6.7L Power Stroke Diesel :: 2011 - Hard Shift From Park To Drive Or Reverse
May 16, 2016
2011, 69,000 miles. My truck is experiencing very hard shifts from park to drive or park to reverse after a cold soak. It goes away once warmed up. I can't find any excessive driveline play and my transmission fluid level appears fine and in good condition.
The last repair done on my truck was around 7,000 miles ago and it was for a transmission fluid leak around the bell housing. They just replaced the seal between the torque converter and transmission.
View 13 Replies
Advertisement
So I have a 06 350 and I'm getting clunking from drive to reverse and now with drive too, I know my rear diff is on it's last days but I am wondering if that could cause the clunking and now my truck around 90km shakes likes crazy and same thing wana know if that's the diff. And if I was to fix diff myself would it not just be easier for me to just swap axles if I wanted to be cheap??
View 12 Replies
I have been having an issue with my 4-5 gear shift under hard acceleration and know that a rebuild is due soon but I was wondering if any high performance kit available with all the clutches and friction discs needed to rebuild.
View 6 Replies
A few months ago I couldn't get the shift lever out of park without trying multiple times. Then it was okay for about 5 months now it is back and worse. It is not bound up because of parking on a hill or anything like that and I press very hard on the brake pedal. It take s multiple times to get it out of park trying turning the key on and off and so on. The truck only has 86,000 miles on it and the transmission has always worked perfectly.
View 6 Replies
I have a 2005 Ford F-150 with a 4.6L and auto tranny non 4 wheel drive. I have a hard time moving from park to drive and reverse. Is there a switch that lets you put it in gear once the brake pedal is depressed? Could that have gone bad?
View 5 Replies
Reverse lights not coming on, and parking sensor stuck at ' OFF ' , have replaced switch to no avail
Any tips out there ?
2005 6.0 Supercab Lariat diesel Auto 4 wd
View 1 Replies
My wife called today after arriving at work letting me know she was having trouble shifting the car from D(drive) to P(park). I know the Gear box is set up in a stepped configuration. Sometimes its smooth shifting up to park and other times its not.
2011 Elantra Gls
Silver w/tinted windows
View 3 Replies
I am planning to buy this 2012 Camry LE (38k), automatic, I am on the test run and realized that the car's shifting from park to reverse is harder than shifting from reverse to drive. What I mean is, it is really hard to move the selector from Park to Reverse.
View 6 Replies
I have a new issue that started last Friday. When I put the truck in gear and let it begin to pull itself, drive or reverse, it has a strange jerking or slipping deal. It doesn't happen every time but when it does you can feel it in the drivetrain. I took it to the shop that did the motor work and they ran a diagnosis(while I watched) on the motor and its turns up nothing. It runs perfect, shifts like it always has, but just has this jerking/slipping thing when I let off the brake and it starts to pull itself.
If I go from brake to throttle its fine. I had the rearend diff worked on to fix the leaky ring and pinion seal and the differential cover sealed at the dealer last month. I searched and don't see anything like what I am experiencing. Could my tranny be giving it up now? It has never been overworked and never overheated. I had the full fluid service done at about 70k and now it has about 130k on it.
View 14 Replies
I am using my son's truck this week, 2012 F250, 120,000 miles or so. I left it running in the drive while I got something from inside the house. Guess it was idling approximately 10 minutes. When I put it in reverse the transmission would not shift and the truck didn't move. I killed it, re-cranked it and it went in reverse.
As I was driving down the road the transmission would change gears up and down for no reason. I stopped the truck, and put it in park. I would put it in drive and the transmission sounded like it wanted to slip. I put it back in park and the transmission would not engage. I then killed the truck, re-cranked it, and it drove fine for awhile and started doing it again,
I kill the truck, re-crank it, and we go down the road.
View 13 Replies
I have been driving a 2003 Chevrolet cavalier and the automatic shift is stuck and can only shift to neutral and drive since Thursday morning. It wont go up to reverse and parking and down to the other 3 shifts.
This first happened last April but somehow with the right grip or pressure was able to get back to all the other shifts. Since then it happened 2-3 times as I can remember and now could be getting worse.
View 1 Replies
I just noticed I could manually down shift transmission in D drive by tapping - on shift lever. I thought this was only possible in M manual mode.
View 3 Replies
I picked up a 2016 F250 Powerstroke in the first of March. I owned a 2011 before and loved it.
The 2016 has been great so far, but I've noticed a sound that wasn't present in my 2011.
When the transmission is warmed up, I get a "cla-click" sound from the transmission area when sifting from park to reverse. It doesn't do it all the time and I can only hear it, not "feel" it.
This AM I heard a similar click sound when I came to a complete stop. I only heard it while stopping, not while taking off. I could repeat it almost every time I stopped. I was in drive the whole time I heard the click sound while stopping.
What it may be? I know sounds are one of the hardest things to communicate/diagnose.
View 6 Replies
On Saturday I drove my truck 450 miles, all of it towing, in hilly New England. The turbo boost gauge was operating at 20psi or higher for many of the hills, and the 13mpg average was indicative of how hard the truck was working (normally empty I will get 20+). The next day, I drove it about 3 miles and it started a regen. Why? Wouldn't it have been passively regenerating for most of those miles? A steady 75mph for hours at a time?
View 14 Replies
My 2012 Toyota Camry SE V6. 37,500 miles. Occasionally when I'm parked shifting down to reverse it's so tight/put effort to shift & it literally thumps the entire car.. I heard to put the E-BRAKE/PARKING BRAKE down BEFORE shifting it to park & it worked but occasionally even with the E-BRAKE/PARKING BRAKE it still jerks the entire car going from PARK to REVERSE.
Also going from REVERSE to NEUTRAL it gives off a little vibration underneath me ALL THE TIME going from REVERSE to NEUTRAL.. I know these are so many questions that are probably a no-brainer answer but I'm looking to see if any one here had/has or heard of a similar or exact problem. Is the trans fluid low or dirty? I saw the CARFAX I didn't see the services he's done it's only been 1 owner on this car I'm the second. Previous owner leased it brand new.
View 7 Replies
Well I've been towing for almost 150,000 miles with a 2012 6.7 Lariat 4 wheel drive. Things have been going pretty well with the truck. I noticed some sluggish and indecisive type shifts early on but now I'm worried. I depend on this truck for pulling a horse trailer all over the country and Canada. Just recently I've been getting a hard shift or a thump or a clunk when shifting up or down in to second gear. I'm at about 152,000 miles and did a hot flush with LV ATF at about 148,000 miles. Should I worry or keep running?
I have a 97' PSD I'm thinking of giving a nice paint job and a flat bed but am reluctant to do so due to financial concerns and the fact that some folks may not want to see me pull up in an old truck no matter how nice it looks. My tranny temps have been stating under 200F and I really keep an eye on the temps when running up and down the hills while towing. The trailer is a 35' Gooseneck with a max GVRW or 14,000 pounds. Should I wait for the tranny to grenade and then drop in a built tranny and if so who's building these tranny's stronger than stock? Long time no see but this site has always been my go to for all my Ford truck questions, upgrades, etc.
View 5 Replies
The past couple of weeks I have noticed my car is hard to shift out of park when I first start it after a few hours. After I get it out of park it is good until the next time I let it cool off for a little bit. It will sometime thump too when I shift to reverse no matter if im on an incline to parked flat. I have changed the transmission fluid twice and I have 60k on it so I don't think that would have anything to do with it. Also, is this something that could cause serious damage because if it isn't I don't really care about it but if it does I would like to fix it.
View 4 Replies
What is the source of the sound? Listen for the clunk b/w 3 and 4 seconds. I just dropped off my 2016 Super Duty 6.7 CC LB 4x2 at the dealership. I'm afraid that they will say the sound is a characteristic but I never had the sound on my 2011 Super Duty 6.7 CC LB 4x4. This sound happens when I go from drive to reverse or when using the exhaust brake when towing. The sound does not exist when the transmission is cold only when it is fully hot. It will also make this noise when climbing a really steep hill in first gear with fiver and the torque converter needs to slip a little.
As far as I can tell all of the u joints are tight and the axial support is tight I only have 2000 miles on my truck.
[URL] ....
View 5 Replies
My tranny is slipping all over the place . I recently less than 1500 miles ago changed tranny fulid, tree branch and TP filter, ford filters, and 8 to 9 quarts of mercon SP. My truck is shifting like a bucking bronco. Came up with PO671. So should I replace just the 1 solenoid. Or all the valve body? I plan to run a gauge in cab to see shift pressures for testing purposes to aid in troubleshooting for current issue... reason for fluid change is history unkown.
2004 6.0 f250 4x4 tourque shift OdO is 163,800...
View 14 Replies
Near the end of a 5 hour drive on Christmas day my check engine light came on. I read the code: P0401. I got it into the dealer this week and was told it was a blocked EGR cooler. The truck has 66k miles. Lucky for me, I have the extended warranty! They replaced a "tube assembly". I sure hope this is not something that is going to repeat. I would hate to pay for this repair in the future. They had the truck 2 days. Is this a common problem or am I just "lucky"?
View 8 Replies
I'm having problems with my 6r140 in my 2011, the truck is an early build around 8/2010 I believe.
After cold soak when shifting into reverse after allowing engine to warm a bit the transmission almost always slams hard into reverse.
After that shifting from 1-3 is awful, the transmission will try to go into 3rd but downshift to 1st then fail to go back into 3rd multiple times. This situation is extremely dangerous when trying to pull into traffic.
Oh and once the transmission gets into 3rd it will skip 4th and go right into 5th. There is only 94k miles on this transmission/truck.
I just bought this truck about a month ago, does this sound like an issue with the solenoids in the valve body?
I'm very mechanically inclined and can swap them if need be but now we're talking few hundred in solenoids and then getting the trucks pcm flashed right?
Also fluid has been changed and I used mercon lv.
View 14 Replies
