Ford 6.7L Power Stroke Diesel :: 2011 F250 FX4 - Whining Noise On Cold Start Up
Jan 18, 2013
When I start the cold engine mine makes a loud whining noise. I took it to the Ford dealer and they said that the sound is normal and that it's the turbo's. I think I'll take it to another ford dealership and get a second opinion, The service guy has the same truck as me and his was making the same noise on cold start up and they told him it was the turbo's also. Something's not right about the noise.
View 14 Replies
Advertisement
My truck's been doing this ever since I got it when the engine is cold. Haven't brought it up to a dealer yet because I'm not sure it's a real problem, and since it only does it when it's cold I'd have to leave it overnight.
It seems to happen when the turbo hits a certain RPM. I got it on video but you can't really hear it until the end when I raise the RPMs a bit.
YouTube - VID 20100926 104950
View 14 Replies
My first opportunity to really use four wheel drive and I am having a whine and a very slight vibration from the drivers side wheel. The noise is only noticeable under throttle/load. When I let off, there is no noise. The truck is also quite in two wheel drive.... No whine.
The truck has been to the dealer for a front end clunk that is coming from the drivers side. The dealer, as usual couldn't replicate it, and didn't do anything. I notice the clunk more on the rebound. I also notice it when using more of the suspension travel i.e. going over a apron into a shopping center, or the crown of a cross street when traveling at a good speed. Short choppy pothole bumps don't replicate the noise as easily.
If I had to guess... The two issues are related. Narrowing it down will be the key. Transfer case? Failing hub? If I don't spoon feed the dealer, I will never get it fixed.
View 10 Replies
I've got a stock '15 F250 6.7 w/ the Diesel Site FF67 fuel/water separator and a 50gal Titan Tank. I installed the filter + tank at the same time around 2 months ago; A few weeks ago, I started noticing an odd buzzing/whirring/gurgling noise (both while the truck was running, and while the fuel pump spins up right after turning the key on). I made a quick video of it this morning:
Ford F250 6.7 w/ Diesel site filter DFCM buzzing/whining - YouTube
I thought maybe it was a filter related problem (I got some little black plastic bits in the filter after installing the Titan Tank, despite my best efforts to clean it out thoroughly before installing) - so earlier this week, I replaced both stock fuel filters, and both filters in the DS filter. Didn't seem to affect the noise from the DFCM at all.
I guess my question is - does it sound like this is sucking in air? I've never found any leaking fuel (even after a 3000mi drive from TX to VA and back), and the truck has never complained about low fuel pressure as I've read that some others have run into. But I don't remember the DFCM/low pressure pump being this loud before I installed the new parts.
I spoke to the folks at DieselSite a day or two ago (those guys are great), and they mentioned that sometimes the Ford quick-release fittings work themselves a little loose from the fuel hose during the filter install, and that putting a hose-clamp around the hose+quick release fitting may solve this; I ordered from clamps from McMaster Carr that arrived today, so I may give that a try tomorrow just to see if it changes anything.
View 14 Replies
I have a 2011 Ford F250 6.7 Powerstroke. It has 107,000 miles on it.
The other day I was driving it down the highway and it got a Reduced Engine Power message on the dash. It lost power and I got off the highway to the service road. Then it died on me.
Had to get it pushed to a station then towed home. It wouldn't start. The starter cranks over for a few seconds but engine won't start. Checked all the fluid levels and batteries. My DEF fluid was only a half gallon low.
What I have noticed is that the DEF level indicator hasn't reminded me that it was low for over 4-5 months now. I had been putting in about 2-3 gallons every 3 months or so. But it hasn't reminded me lately and I just forgot. This is my first diesel.
View 5 Replies
My 2011 6.7L F250 Superduty died on interstate the other night. Picking up throttle pulling onto interstate when a message came on the dash "reducing engine power" and the truck died. It will crank but will not start. It will start on ether but dies when that runs out. Has the following codes... p1249 Wastegate control valve, p0087 fuel rail/system pressure too low, p1291 & p1292 injector high side short to ground or battery (bank 1 & 2), p2291 injector control pressure too low-engine cranking. The codes are telling me I don't have enough fuel pressure but scan tool says I have 4000 w/ key on and 6370 while cranking and I thought 5000 was the pressure needed.
View 9 Replies
I'm new to diesels. I just bought a 2004 F250 with the 6.0 V8. I have the high and low circuit, contribution codes on cylinders 4 and 8. I've only had the truck for a few days but I've been reading a ton. The symptoms are hard start, rough idle/shaking, no power when cold. When it heats up and I'm over 2000 RPM it seems to be just fine. Even when hot and below 2000 RPM it does ok. I've check the FICM. It reads 48V with key on and 48V running. My plan is to do the following:
Change the Fuel Filters
Change the oil filter
Change Air Filter
Change oil with 5-W30 synth and I have both Hot Shot/Rev-X
If that doesn't work, I'll replace the two injectors. How does that sound.
View 14 Replies
Truck has been doing this and now getting worse. 06 f250 6.0 147,000 miles. Runs like crap when you first start and truck has trouble shifting when I first take off in the mornings until it warms up then it idles fine and runs like a champ no problem shifting. Not in a cold climate 40F at the least. Not trying to take it to the dealer and get raped. Been doing research some people say get the inductive heat flash, some say needs new injectors, some say could have a bad gasket on the injector idk. I'm trying trying to get it resolved....
View 4 Replies
I'm TSing a no-start on my 2005 6.0L F250. Engine cranks fine. I've been working my way thru the TSing guide and using my new ScanGaugeII. No codes found. At glow plug warmup, (dash light goes off), I'm getting 40.5v FMP, 11.0v FLP, 14.8% ICP, and 0psi IPR. After cranking for 10-15 sec, get 35.5v, 10.0v, 84.7%, and 446psi. I've had a trickle charger on all night to keep the batteries charged. Have not seen FMP over 45 or IPR over 470.
View 14 Replies
I have a 2011 F250 6.7 Turbo Diesel I recently purchased. I am hearing a noise when accelerating from a stop. The only time I'm hearing it is when the window is down. The noise sounds like someone is tapping an aluminum pop can. It is easily reproducible as well. I decided to get under the truck and have my wife toggle the transmission from park to reverse. They noise does not occur unless one foot is placed on the brake and the accelerator is lightly pressed. (My wife had the opportunity to run me over and claim it as an accident but lucky me she decided not too). Below is a video. I had a hard time locating the noise. It sounds like it may be coming from the exhaust or drive shaft. The drive shaft does not spin when toggling from reverse to drive but the ticking noise can be simulated and heard when lightly pressing the gas while holding the brake. Something need lubed somewhere?
Clicking noise - YouTube ....
View 4 Replies
I'm new to owning a diesel. I have a. 2004 f250 6.0. I gotta smog the truck this weekend but the check engine light is on. Fault is P0674. I've notice during the day it starts up fine but at nights, lately it's been low 40 outside it won't start. Where to start at.
View 3 Replies
There's a pump or ?? I'm not sure . Our "11 6.7 is making whining vibrating sound coming off passenger side , front of valve cover . Not sure what this is . Nothing I'm searching is telling me n I'm not best with diesels .
View 3 Replies
My 2003 f250 6.0l just up and quit. It make a popping noise out of the intake when cranking. I am getting 1150 psi at the icp and ipr is at 62% which seems high to me. The FICM voltage seem fine unless the batteries are drained and I am getting FICM sync. I replaced the HPOP, ICP sensor and IPR about a year ago. I recently replaced the air conditioning compressor and power steering pump. I am at a bit of a loss. I did pull the IPR and everything looked fine.
View 14 Replies
Purchased 2011 3 weeks ago. Due to not paying attention, put gas in diesel. Had tank dropped and drained but after reassembly, fuel gauge inop. When turn ignition switch on, get normal sweep of all dash gauges but fuel gauge does not read. 2nd tech says sender okay, must be gauge. Dealer ssays if it sweeps, it isn't the gauge. 011 F250 6.7L.....
View 7 Replies
Just pu my new 2013 6.7 Diesel with 1300 miles... There is a most annoying whining coming from under the hood and sound like its coming from the secondary filter area or turbo (you can even feel it if you put your hand on the filter lines and housing) and it starts a minute or so after the vehicle has been running and you can her in the cab at 70-mph... At drive through restaurants I have to shut the tk down to place my order and never goes away..
[URL] .....
View 14 Replies
2011 F250 6.7 Lariot Fx4. My factory Trailor mirrors won't extend. When I push the button it just gives me two chimes. The power fold and other options work, just not the extend. Not sure but don't think it's a fuse since everything else works.
View 9 Replies
I just bought a used 2007 f250 with the 6.0 power stroke. The truck has approx. 160,000 miles on it. He is having a issue with the truck overheating when it is cold out. When the air temp is above 30 degrees or so, he doesn't have a issue. So,my he overheating only occurs when driving down the highway in low temperatures. It can idle in the cold fine.
View 8 Replies
2011 F-250 6.7
H&S Mini Maxx
Fully Deleted
What is going on with my tranny. I purchased my truck back in August with only 14k miles on it. It was a weekend camper hauler for the previous owner who drove very little. He bought it brand new and had it fully deleted with the mini maxx put in right away. I bought it in that current condition. Since buying it I have used it as a daily driver. Current mileage is 21k.
About 2 weeks ago I did 2 things. First, I decided to update my mini maxx from H&S's website to make it current as I was having a really firm shift from 2-3 gear. This is a know issue with my year truck due to a solenoid issue and I figured a more up to date tune might work. Second thing I did was tow for the first time since getting it. I towed an open bed car hauler with an SUV on it down the highway for about 150 miles. Prob about 7k#s. While on this trip I noticed my tranny temp go up to 235 degrees. When I reached my destination I parked the truck and stayed the night and returned back down the highway unloaded not towing anything and it still went back to 235. Trip was on the highway and is mostly flat with very few hills.
I monitor all gauges religiously and know my trans has never even gotten close to 200 before. My oil and coolant were both running in their normal mid to high 190 range and everything else appeared normal about the truck. I have talked to several diesel performance shops and received multiple ideas about what it might be. All seem to be in agreement that it is not my tuner as no one else that I can find has had this issue with their mini maxx after updating.
What is wrong range from the solenoid issue making the gears slip causing additional heat.... to my thermostat in the coolant valve having gone bad. I have had it in the local Ford dealership all week and they are completely clueless. They claim that everything they can check with their computer for flow and whatnot is functioning perfectly fine. They also claim that at 235 it is not out of spec according to Ford and that Ford doesn't consider this temperature to even be an issue or something that needs to be fixed.
View 14 Replies
I'm starting to get an intermittent CEL for P2074 ("Manifold Absolute Pressure/Mass Air Flow - Throttle Position Correlation at Higher Load"). It first came on Saturday halfway into a 4 hour drive (Not towing, just driving 75mph-80mph on the freeway). I cleared the code and restarted the truck and it immediately came back on. About a half hour later I stopped for fuel, cleared the code, and it stayed off for the rest of the trip.
Got into the truck today and drove it for 10 minutes (driving around town) and it came back on. Cleared the code and restarted the truck, drove it for about a hour and it never came back on. The truck is running and driving just fine.
The truck is a 2011 F-250, all stock (except for a AFE Cold air intake that's been on the truck for a while now). The truck has about 98,000 miles.
From what I've read on other posts, it might just be a mass air flow sensor? Should I just replace that myself, or pay the $100 extended warranty deductible and take it into Ford?
View 7 Replies
We got "bad" gas in Feb, 2016, had to replace entire fuel system. Haven't driven the truck but 4000 miles. Last week, she started spitting and sputtering and lost power. We could see fuel pouring out. NO CEL. Towed (AAA has paid for itself several times over with this truck) to dealer that replaced the fuel system, still waiting to hear from them. Does this sound like it should be under the warranty for the work they did? We have averaged a huge repair bill about every 3-4 months on this truck, 2011 F250 Lariat, 8cyl, 6.7L, since we bought it 2 years ago.
View 1 Replies
I have a 2007 F250 4X4 6.0 diesel. When first started it idles extremely rough to a point it sounds like a old gas engine missing. But after it warms up for about 15 minutes it runs and idles like a new truck. I'm thinking it's the injectors if so is this something I can change/clean .... It's 98* on a cool day , when "cold" I mean just started for many hours.
View 13 Replies
