Ford 6.7L Power Stroke Diesel :: 2010 - Location Of Plug On Main Harness?
Feb 16, 2013
Have a 2010 Lariat crew cab and I just bought an upfitter switch set and relay harness. Found where to mount the relay block and have been able to get the switch panel installed in its home. For the life of me though I cannot find the plug in the main harnes under the dash to plug the relay harness into to power everything up. I've read several threads here and even found the drawings that indicate plug #C215 in a diagram for the 2011+ trucks. When I get access panel out and look underneath the dash where it should be....no spare or open plug. Is the plug location diferent in 2010 from the 2011?
View 2 Replies
Advertisement
Could a leaking passenger side glow plug harness cause a "hot no start?
View 5 Replies
I'm really struggling to get this sucker off my 2014 6.7 F350
it says in the ford manual to lift the plastic tabs then pull off, I did that easily with 3 on each side, but the end plug on each side (the one closest to the windshield) does not seem to have a liftable tab (it looks different to the others as its at the end of the cable)
I've almost broken it but not quite, its over $300 for new harness, ouch
I do have the odd little hook tool they sell for this, it worked with the other 3 for sure, but I've spent ages on the 4th on each side and cannot budge either of them
View 2 Replies
Got a 2003 6.0 that seems to be leaking from the glow plug harness. How hard would it be to just replace them? I've heard that trying to remove these things can be a pain because they almost always break. But if I'm just going to replace them who cares right?
Is there anything I need to be careful about? Or can I just rip em on out? Also I've noticed two different styles of harness should I replace mine with the other style or just keep it the same? And yes those valve cover nuts are loose. I'm aware
View 2 Replies
Do all New trucks come with the factory clearance light plug-in-connector and if so, where would it be located? The reason I ask, is I'm considering adding the cab clearance lights to my 15 F350. Really would like the factory lights but I hear Recon makes some similar.
View 14 Replies
Is there a difference between the two harness #'s here besides the first number:
3C3z9d930aa
4C3z9d930aa
Are they the same part? Is one for a different model truck than the other?
View 7 Replies
Need to know the Ford part number for cab light wiring harness? I am wanting to install some LED cab lights but I do not currently have any so I will need the wiring harness.
View 3 Replies
2011 F-350 CC, 45k miles... Found out yesterday mine is leaking. Way to early for these issues to pop up.
View 1 Replies
Is it possible to add the decent control if my truck didn't come with it? Is the harness already wired for it and the computer programmed for it or would I have to get it reprogrammed and get a new harness?
View 6 Replies
Will a 05 injector harness work on a early 04?
View 1 Replies
I am tearing down my junkyard engine to prep it to put into my truck and I came across this on the rear main seal... is this a wear ring?
It kinda looks like a oil slinger. My new seal is on the way so I have nothing to compare it to.
I don't want to be yanking on it if it's supposed to stay.
View 6 Replies
As it turns out my entire dash needs to come out to repair the HVAC so thinking while it's out I should add the diesel supplemental heater. What's involved with this? I need to replace the entire HVAC plenum so imagine the version with the supplemental heater can be bought instead. I know it's an 1800W electrical heater so my main question is the wiring harness on a regular truck setup for it or do I need to change the harness. And then I suspect the HVAC control module would need to be reprogrammed as well.
View 13 Replies
First I lost the power window functionality in the rear left door... didn't think too much of it, then I lost the power door lock functionality, which was bad because I was assuming my door was getting locked when it wasn't actually. Pulled open my door this evening and found this:
I think my truck overheard me when I was saying "I like a good electrical problem, those are my favorite." I'll solder it up to get it working tonight, and then I'll see what a new harness costs... although really they should have used ultra-fine-strand wire with silicone insulation for an application that sees lots of flexing.
My multimeter's test leads are such an example of wiring that is intended to see lots of flexing.
View 14 Replies
Looking for an electrical schematic and or wiring diagram of the windshield wiper circuit for a 06' Super Duty?
View 5 Replies
I need to connect a remote start stop for a bucket truck attachment to this new 2016 F550. Found everything except the ignition wiring harness diagram. Need to know what I can tie in to.
View 4 Replies
Replace the tft but still the problem, someone cones the number part of tft sensor harness, and as replace , 2006 f350 4x4....
View 2 Replies
I haven't had time to take my truck to the dealer to actually be checked yet but it appears I might have a rear main seal going out from what I can see. I pressure washed the whole underside of my truck the other day and there is fresh oil where the engine connects to the transmission.
My truck is a 2011 with a 2013 engine in it. The truck has 103,900 miles on it. The engine has almost 60,000 miles on it. I have the extended warranty on it which is good. All this truck has to do is last 2 more lousy months and I'll replace it.
2011 Ford F-450 6.7L Diesel 12' Flatbed
View 5 Replies
My fathers truck had the tail lights go out the other night so we checked the fuse and the bulbs both good. Took it to ford and they found that a wire harness in the front left wheel well had rubbed through and needed replacement. I went and checked mine and yup it was rubbing through the wire just not all the way yet. Might want to take a look. It is at the top of the well near the coil spring. I will get the camera out tomorrow in the daylight and take a picture of the location.
View 13 Replies
Trying to locate my a/c drain tube on my super duty. Noticed the other day no water draining with the a/c running. Wanna check to make sure the tube is not clogged.
View 14 Replies
was looking for the oil pressure sensor and can't find it got it narrowed to 2 there is a sensor between the the oil filter and fuel filter i think thats the temp sensor and then there's 1 at the say 11 o'clock position behind the the oil filter...both have a 2 pigtail connector.
View 4 Replies
I've had a 2007 Coachman Freelander class C RV with E-450 for about 8 months now. We have been on 7 camping trips to the same location this summer, and the engine has sputtered in exactly the same place on 6 of these trips. It's pretty freaky, like the road has bad mojo there.
We have to come down a steep incline for about 2 miles, dropping about 500' vertical at about 6500' elevation. Then we drive for 2 miles on the flat before hitting a big mountain climb up to 7500'. About 30 seconds into the climb, the engine will sputter, and kick out smoke from the tailpipe. The first time I pulled over, and it idled fine. I took off and climbed the hill just fine. Now I just drive through the sputter, and it goes away after a minute.
So what's happening? Is the fuel tank sloshing crud around? I never get a water-in-fuel alarm, although the E450 doesn't have much of a message center. It doesn't happen on other sections of mountain road. This rig has about 38,000 miles, and is bone stock. I put new oil and fuel filters in before the summer. This rig is the same size as my old '82 RV E350 w/ 460, and boy is the 6.0L an improvement!
View 14 Replies
