Ok, so I have read on this subject and there are lots of posts about this being normal but why? What causes this? I have recently owned two 6.0's and neither of them had black oil even when I changed the oil! My last 6.0 a 2006 had oil that was nearly the same color out of the drain plug as the oil I was putting in! Why this happens on the 6.7.
View 10 RepliesDriving home 2003 6.0 started blowing a ton of black smoke, cars wouldn't get behind me. Found an exhaust leak on the driver side up y pipe. Would that cause this much smoke? 2 codes were 0284 and 0281, I replaced those injectors about 10k ago, at the same time replaced turbo, hpop, egr valve and cooler delete, and new oil cooler.
View 9 Replies06 250 w 65k and it is sluggish on take off, and puffs black smoke most of the time. other than that it runs good.
View 14 RepliesWhen I'm driving sometimes it will pour black smoke and make no boost, and then the next time I get on the throttle it goes make to making boost like normal. It has the following thing done in the last 50k. I have a 2006 f-250 lariat FX4 it has the following mods:
EGR delete,
Powermax Turbo,
Rudy's Diesel Up Pipe,
4" Turbo Back Muffler Delete,
New For Injectors,
Blue Spring mod,
Gear Head Tune,
S&B Elbow And S&B Cold air kit
My tailgate emblem has lost the blue color. Is this a common problem? Is it easy to replace the emblem?
View 12 RepliesSo I changed my oil with T6 and archoil and immediate miss at around 1500rpm then it clears up. I can stomp on it after that and it's fine. I know this has happened to others. My last oil change was also T6 and archoil. 2005 F250, stock, atlas 40, 216,000 miles.
View 5 RepliesChanged the fuel filters. No issues in replacing.
Primed them by the book - key on 30 seconds 6 times
Now I have low pressure warning and reduced power.
All parts were FOMOCO...
Today I was riding along and all of a sudden I noticed a loss of power. I look in the rear view mirror and get into the pedal and a lot of black smoke. When I get to where I'm going and stop I noticed the idol was a little loopy. I never saw a check engine light. I have the Edge insight. I had two codes. P1000 OBD System readiness test not complete. P2290 ICP TO LOW.
When I would reset the codes the P1000 came back instantly every time. I parked the truck for about an hour. When I started it back up everything was normal. The power was back and no smoke. This happened two more times throughout the day. I have heard people describe a sticking EGR Valve causing these symptoms. Is that where I should start looking or is the ICP the culprit or something else?
I have a 2003 with 150k miles. My 6.0 has black smoke and can barely crawl up a hill. Dealership is 30 days out for an appt. Air filter, oil change, alternator, and batteries are new. I removed the EGR valve and cleaned, but the valve seat is not perfect. I can see 20 to 30 mil gap around half of the seat. Is this ok or will that little gap cause this?
Hoses all look good. No alarm lights. I have no diagnostic tool but I can use a meter well. It did have an airbag light but I found the fuse missing and replaced it. The air filter alarm switch fell apart but I bypassed it till I get new part. No alarm lights now.
I went out to the store today all was fine came back out and started driving got 2 miles down the road to a red light and the truck about stalled no power it doesn't smoke at idle but revved up it blows black and some white and the truck shakes. I am thinking its stiction or bad FICM????
View 13 RepliesSo I am not sure exactly what is going on with my truck. It is a 2004 F250 has a 6.0 L. Sometimes when I take off from a stop the truck has no power and blows some black smoke. Then the turbo kicks in and all is fine. It comes and goes when it pleases no matter the temperature. What started happening is when I drive it a steady pace on the highway sometimes the turbo gets quieter and louder and quieter and louder sometimes when it gets quieter I see a little bit of black coming out of the tailpipe. Sometimes it doesn't do it at all. Also sometimes when I let off the gas the truck sounds like it's trying to laugh at me like a wastegate is fluttering.
View 10 Replies05 6.0 deleted and studded. 170k fresh filters and oil, no CEL or codes.
This has happened 3x in months, so it intermittent. Truck will start fine cold, except for this last episode ....
Truck starts right up, idles correctly, speed bumps up if its cold enough to trigger the high idle. About mid way through its warm up, at approx 130-140 idle falls off, barely runs. Almost knocking. Black smoke if you give it throttle. Has no power when its doing this. Truck will not move and almost dies in gear. Give it til 185ish degrees then pooof! All good.
However 2 days ago it wouldn't start. Cranks but won't catch. Stumbles and dies. Finally got it to start after setting the charger on it. I killed it. But this time when it started it was straight into its rough idle, no power...until about 180. I switched it off, restarted it and it was totally fine
Ficm is 47-47.5. Every now and then I see a 46.5 for a split sec
Hpop is 700-800cold cranking.
Not sure what else to look at.
Moto craft filters.
Amsoil 5w-40
Archoil in the fuel and oil
Twc3 at every fill up.
Started with lots of black smoke all of a sudden. Not under any significant load at that time. Reached destination (barely) and started the search. Have taken off blue connectors on CAC passenger side. Top is marginal but see no holes. Pulled the MAP hose and see nothing unusual. Have not checked the driver side CAC or the BPV sensor. Have a ScanII device that shows no codes. Got my other scanner and it too shows no codes.
Had it towed home over 100 miles 'cause now it just barely runs. Idles fine but have a engine noise change (deep and hollow) every once and a while at idle. EGR leak? Doesn't blow black smoke anymore. More of a white/blue. Exhaust smells odd. Absolutely no turbo activity. When shutting hear no whine down of the turbo. No boost evident on the dash or on the scan II. I am at a loss at this point. Will check fittings again.
Getting ready to take my Truck in for the Radio turning offt. About half the time I start my truck the radio doesn't play sound, it's on but no sound. If I touch it or change the station then sound starts to come out, is this normal?
View 14 Replies2005 F-350 6L
Just changed my alternator, that was the easy part apparently...............
Cant get fan belt back on? My pulleys don't look the same as the picture under the hood. I can see a idler on passengers side down low, but cant seem to make it move to give me some slack.
What kind of tool to use on idler to get slack?
6.0. 115,000 miles. Everything stock, except bully dog intake filter.
I replaced the FICM recently, with one that I bought from the guy who makes those cool You Tube videos, Diesel Tech Ron. I also replaced the EGR valve. I also replaced the intercooler boots on the hot side. I cleaned the intercooler pipes. I cleaned the intake filter as well. I'm still blowing out black smoke, if I floor it when I need to pass someone.
Follow up question: I bought those boots from Riff Raff Diesel and I bought new clamps, too. I'm not sure if I installed correctly. It's already blown one off (it blew the top of the intercooler pipe off, by the turbo, but the boot stays on the turbo) and I put it back on and tightened it all the way down, and I've had to re-adjust 2 times, now, since it acts like it still wants to slip off. Do I simply have the other ones misaligned???
So I started to NM from fort worth texas with my 33" camper blew my CAC pipe four times. Finally got there. In the morning it took longer than expected to start. When it did white smoke. That was replaced with black smoke under full throttle.
I went from elevation of 700 to 8000 Ft. Should I care about black smoke? Meaning should I take it to Ford and get a rental car to get it looked at for our trip home.
96 degrees towing at 70mph with lots of climbing mountains.
1st Ford was an '08 to '10 model F250 6.4L that had an engine fire on I-82 towards Ellensburg in the passing lane.
2nd Ford was a 2005 F-250 6.0L at Vantage, he had black smoke coming out of the exhaust and a terrible engine knock, and was pulling a 32 ft TT. When I went to go talk to him, he had no idea what a ScanGauge was or anything about the truck.
When I looked at the engine bay with him I saw the EGR valve had been deleted with a block off plate and not plugged into the fan hanging on the side anywhere, he had the high rise aftermarket oil cap installed, ALL the metal/aluminum parts had bad oxidization. He had no gauges whatsoever.
Then to top it off, he said he was going to try and make it to Ellensburg while pulling his trailer. I told him he had a 4% grade for 10 miles in front of him to climb, and the another 35 miles after that on flat ground. All I could feel was, "is there any hope for this guy"?
Anyways, my question is, without any gauges, what would be some good educated guesses with the black smoke and knock? I am mostly just curious what this guys issue might of been with his truck since seeing the symptoms first hand.
My thoughts are the oil cooler leaking, and making the injector(s) stick open.
Of course now that I think of it, there's probably too many scenarios to mention.
Found a 2004 Ex, Eddie Bauer edition says it has injector issues, blowing black smoke........ It is apart cause he thought it was the EGR. Has 245,000 on the clock. If the body is super clean I'll give him a offer, it's going to get a motor either way and I'll have my Ex back.............I really miss that truck!
View 2 RepliesI changed both fuel filters on my 2015 F350 6.7 I turn the key online for 30 seconds then turned it off for total of 6 times when to start the truck this morning after driving it yesterday and it took a little bit longer to turn over before it finally did, did I miss something up that I do something wrong. So I let my truck warm up this morning after going to start it at took a little bit longer for it to turn over I turned it off wait a few seconds then turned it back on and she started up how she used to perfectly fine does it just need to go through a drive cycle. This is the second fuel filter replacement nothing was wrong with the other ones I'm at 40000 miles now ... also it seems like the fuel filter on the frame rail is louder if you put the filter in upside down on that will it fit stupid question I'm sure I did it right but thought I'd ask before I tear it apart....
View 14 RepliesSwapped a new oil cooler and welded Egr shut. Truck ran fine the first 3-4 times I started it except for exhaust leak at the y-pipe/turbo connection. Tried to start it today and it started then ran real rough, blowing whit smoke. Now it will not start at all and blows whit smoke. The only codes I'm getting are egr codes that I've always had due to having the 05 and up intake elbow and the egr turned off via sct. What could be the issue?
View 8 Replies