Last week I noticed I was having to refill coolant in my excursion more than I should. I hae a mechanic friend now trying to diagnose the problem. he said he doesnt think its the water pump and there's no white smoke. Are there common leaking places for the coolant on 6.0s he should be looking for?
View 4 Replies2006 6.0l
Just noticed yesterday during an oil change that I had white stuff around the coolant cap on the overflow bottle and that no coolant was visible. I went and got some antifreeze premix to top it off and it only took around 1 quart. Today after driving it approx 30 miles, the coolant was again missing.
When I changed the oil the other that same day there was no coolant in it, and I don't have any puddles on the ground. Whats going on?
EGR is deleted with a sinister kit, temps are fine, today it was 94 degrees and the truck was running at 194 oil 192 Coolant when getting off the highway after 15 minutes doing ~75. I've got a little bit of stiction going on but besides that nothing seems wrong.
I noticed about 1 year ago I had diesel in my coolant but wasn't sure.. took it to a Ford Guy about 45 minute's away.. He seems to know his stuff but when he tested the coolant the results said less than 2% diesel.. But he did find an injector issue and swapped it out..
Forward to present.. there is diesel in my coolant now , since the level is rising to almost overflow and I believe this has been doing on for quite some time as I have that smell you get in the cab..
BTW - All injector cups have been done about 3 Years ago.. On another note , I get white smoke on start up especially if the truck has sat for a day or 2.. What can cause diesel in the coolant.. I did a complete coolant flush this summer and was super **** about getting all the old coolant and gunk out.. Ended up with only clear water coming out the degas
My 2006 6.0 is blowing white smoke/steam and Im losing coolant (not out the top). Pulled the EGR valve and its wet down there. All signs lead to EGR cooler? I've been reading a lot on this forum and Ill do the oil cooler at the same time. I seems VERY important to flush the coolant system before I tear into this. I am afraid of hydro locking the motor or ruining the head gasket or stretching the head studs if I run the truck. How can I do this without further damaging the engine? I am doing this myself. I'll have 3 solid days to finish this job because I have to tow my trailer in 5 days.
View 5 RepliesOk I bought a 2006 Ford F350 with 6.0 after driving for about 3 weeks I noticed a little bit of coolant was disappearing out of reservoir. So yesterday I was driving with a load Reservoir overflows replace coolant with one gallon of coolant and finish trip with no issues. I started truck today and it will not stop smoking it is also not overheating after hearing about head gaskets. I'm hoping it might be EGR cooler white smoke smells like raw diesel fuel. What to do?
View 3 RepliesNewbie hear to the 6.0L's. But I'm learning an awful lot really quick from all of you here. I've read lots of tech stuff on these EGR Coolers, oil coolers, FICM tests. This is what I got happening right now.
2004 F-250 6.0L. Today was 45 degrees in Reno. 5400 ft elevation. Tried to start it without block heater. Would not even crank. It tried to crank but sounded like it locked up on first crank. Tried again, nothing. Same. Tried yet again and finally got to getting the engine to crank, but wouldn't start after about 5 seconds of cranking. Waited a little while not wanting to burn out my FICM, then tried again. Same as previous, would crank but not turnover. Checked batteries. Both were over 12.3 V cold, motor not running. This next time, turned key on and let it sit in ON position for about a minute. Then cranked and it took about 5 seconds and then the motor finally cranked over. Lots of black smoke as usual for a cold start like this. Battery volts after cranking over and running were now both over 13.6 V.
Keep in mind the truck has started better than this before in 15 degree weather just about a month ago.
After it started I noticed what appeared to be oil/coolant residue directly underneath trucks transmission area. It was not tranny, but in that area. I got under the truck and can see this fluid coming from EGR Cooler area.
Now for the smoke. Just stared smoking on start up. White smoke. Then it would disappear as engine warmed up. Now its constant white smoke when warmed up and applying the throttle. Smells like coolant coming out of exhaust. Not diesel.
I parked truck facing downwards on my driveway. Then I checked EGR Valve. When I pulled it it was WET. Not dry. Peeked in EGR Valve hole, didn't see coolant. Just wetness. I did change gasket and rings on it the day before as well.
As for FICM, it reads 47.9 Volts on key turn, 48.1 on cranking and 47.8 running. FICM good by all standard 6.0L literature. Degas bottle passed pressure test holding near 15 PSI for 20 minutes! No oil in degas bottle that I can see.
Truck is stock. Is my egr cooler and oil cooler shot? Would a bad egr cooler or oil cooler cause this awful cold start? When I plug in the block heater, it starts NO PROBLEM, but still white smoke. Also, NO loss of power at any time.
2007 6.0 6 speed, 187,000 miles. The other day started truck, had been running about 20 minutes before. Started fine, go to drive, chugging white smoke, smelled like unburnt diesel, baby truck home, seemed to run ok at low rpm, truck warmed up and ran fine. But I also noticed turbo boost was acting funny. Truck ran fine next few days. Then this morning, started cold fine, started to drive it and same chugging white smoke, it quit by the time j got to the end of my driveway, but drove to work, it quit smoking, ran pretty smooth, but will not build any boost. Truck is bone stock except for exhaust, it's straight piped. Ok. So this eve I borrowed my dads edge cts, here's all the engine codes:
P0069
P0269
P0299
P2262
P2269
The last one is water in fuel, since it started this crap I did notice it was right after it came on in the dash. I'm trying to figure out where to start....
On another note. VGT duty shows 85% at idle ?
Ficm voltage is constant 48 volts
Newer batteries
no change, changed stand pipe and dummy plug on driver side, no change and guess what? Now I am stuck on the side of the road waiting to give my last $100 to a tow truck! Engine is hydrolocked, fuel pressure is low, starts off at around 20 and works up to 54 with key on engine off, and that is as much as I know from the side of the road with out my AE. Blew white smoke also. Smelled of unburnt diesel. I think it's linked to my rough running issue. Maybe a bad injector? But every time I did the click test they all passed. Idk, I'm gonna remove the glow plugs and see which hole is loaded and with what. . .
View 14 RepliesI would like the hear what others have to say about the problems I'm having with my 2006 F-350 sd xlt 6.0 with 113,000 miles on it. It's being used as a tool truck mostly going from a shop on the property to close by buildings on the same property. In other words very short distances. Used occasionally to take a dump trailer to a close by dumping ground.
1. White smoke from exhaust. I've read this is most likely an ERG cooler that needs replacing. Any other possible causes? If I end up having to replace the cooler is there a stock cooler that is reliable or should I get the one by bullet proof?
2. Diesel is dripping from the muffler weep hole. Last full tank lasted only 60 miles. Could this be the oil cooler? Anything else? If so is the Ford replacement cooler OK or should I go with an upgraded cooler?
I have a 2006 v6 ford mustang and just developed this problem yesterday.
When I drive the car, the temp guage stay right in the middle, but when I park I get white smoke come from under the hood. I popped the hood and saw coolant leaking from where the top radiator hose meets the engine block. This was producing the smoke. When I checked the hoses, the top hose was hot and hard, the bottom hose was cool and soft.
Extra info:1. I did not touch the radiator to see if there were cool or warm spots2. The overflow bottle looked empty or close to it, but the engine was still hot from driving to work
Thinking this could be one of the following:
1. bad thermostat
2. clogged radiator
3. Air bubble somewhere blocking the coolant flow
yesterday I went out started my truck and white smoke started coming out my exhaust so I turned it off waited a bit started it back up let it run for a bit smoke went away drove it about 60 miles. Later that night it did the same thing but I was 2 gallons short on coolant drove it another 60 miles ran fine. Next morning decided to take it to a shop put more coolant in it drove maybe 20 miles to shop got there turned it off everything was fine never over heated once. So this shop is now telling me my trucks hydro locked and I steamed the EGR valve. And there telling me it's gonna be $8000 to fix it .
View 3 Replies2005 F250, 6.0, 60K miles, recently (within last 1K miles) had ARP studs, EGR delete and new oil cooler installed. Shortly after (5-6 weeks later) I noticed blue smoke under any load (taking off from red light, backing up) but not at idle or startup. Was using the "Performance" SCT canned tune after the stud install, but had the "65HP Tow" canned tune installed when I first noticed the smoke and now back to stock after noticed the smoke as a precaution. Everything else original except FICM, filters and batteries and use 5w40 Mobil 1 since new.
View 14 RepliesOk, took the sub for a spin around the block yesterday. Turbo was singing a tune when I left. white smoke and minimal boost on the way back. It is spinning, just not boosting very well. Stuck? Electrical problem? any pointers, or easy stuff yo check, before pulling the pump?
View 10 Replies I have the green light to bulletproof it. I just tore out the engine so she is on a stand now.
The whole backstory to this truck is one day a while back he was driving, noticed white smoke and instantly parked the truck at his house and fell on some hard times and couldn't get it fixed. The truck sat for some years and now was putting some life back into her.
I drained the oil and noticed right away the chocolate milk that was coming out of it, so right there I'm heading towards head gaskets.
What I am looking for is a list of the practical things to do to the engine while it is out on a stand. I am not looking for an extra 1000hp, just looking to bulletproof it so he won't have to worry about any other failures. I'm also looking for other maintenance items to change as well, maybe injector cups?
I was passed the other day by a newer (square mirrors) nice-looking Super Duty that was slightly spewing white exhaust smoke. As a life long truck driver, I know a few diesel smells (and I kinda like some ). But, this was so pungent that it was irritating my eyes inside my own cab.
It was so irritating and nasty smelling, that I had to slow down (to let him gain some ground) and open my windows to clear out my truck. So that I may be better informed, what could've caused this?
I have a 2006 F350 6.0 litre diesel. The other day I started it up drove away and it was blowing huge plumes of white smoke out of the exhaust. Shut it off.....started it up again after a while then went on a long drive and it went away. What that was?
View 6 RepliesReplaced turbo stock with a wicked wheel. Truck smokes like crazy took turbo out rebuilt it and reinstalled in truck now truck pukes white smoke and has a of white smoke while idling. I don't get why. I've rebuilt injectors about two months ago. Truck is stock not bullet proofed at all. Truck has 170k head gaskets were done at 130k.
View 6 RepliesSo This all started when I noticed my 03 Ex 6.0 started to not upshift every once and awhile.It has 300,000 miles on it.As far as I know it has never had tranny filter changed.So I said it shall be done.I did both internal and external filters and the fluid was very dark but not burnt.The pan was very clean and no sludge or metal on magnet.Put in new fluid and ran the truck until warm and checked fluid level and all was good.Now this where things get weird.Went for a drive and truck would not up from first easily or I had to feather pedal to upshift. If I put my foot into it I got a lot of black smoke after about 5 seconds and some sort of shuttering in the engine on deceleration. Ran AE for codes and nothing came up. The engine has EGR Delete. Blue spring, new injectors, glow plugs......
View 3 RepliesI bought a 2004 power stroke with 100k miles, ran well for 15k miles then started having low power for first few minutes to no power, regular oil changes and fuel filters at 5k, checked FICM 48v KOEO , 48v cranking, new batteries just in case. Oil pressure when cranking at 50% of gauge , even crank cycle will jump when trying to fire, no loss of coolant, block heater working, it did start a few a few times and blew white smoke until warm then full power but the last 2 times I did get it to start it ran for less than 1 minute and died could not restart.
Fresh fuel additive in both fuel and oil for stickshion, have read hundreds of posts but not seeing similar problems no codes. With key cycle 120 amp draw on passengers battery for approx 25 seconds 48 amp on right battery glow plugs good due to the amp draw? So I think my FICM is good, good oil pressure cranking, the oil pump should be good, ICP good? Because of gauge coming up? Everything I read says black smoke for EGR soot issues. Not sure where to look.
it's now 1,500 miles away on the side of the road.White smoke, knocking and lost power. Truck has 133,000 reman engine installed at 46,000. Is it common for hydro locking to bend a rod? He sent a video and it def sounds like a rod and degas is empty.
View 9 RepliesI went out to the store today all was fine came back out and started driving got 2 miles down the road to a red light and the truck about stalled no power it doesn't smoke at idle but revved up it blows black and some white and the truck shakes. I am thinking its stiction or bad FICM????
View 13 Replies