Ford 6.0L Power Stroke Diesel :: White Smoke At Startup And Driving While Cold And Warming Up
Aug 18, 2016
I'm in the middle of an extended coolant flush and switch over to ELC. As of recently, I have noticed white smoke at startup and driving while cold and warming up. (Even at times accelerating when half warmed up ~170*). At first I attributed it to suction, so last night I changed the oil with T6 along with a new OEM filter.
After I got done with the oil, I pulled my EGR valve when the engine was hot. Is this simply goey due to warmth, or do you suspect EGR cooler leaking? I didn't take pictures of the manifold, but the lower chamber was hard and dry, while the middle section seemed to be "goey". EGR Cooler or something else???
View 6 Replies
Advertisement
2006 blowing white smoke and sluggish until its driven for a few miles ..smells like fuel .. New head gaskets and the works started after 20 days over below freezing temps nights at 5 to -5 ....
View 14 Replies
My 06 6.0 is blowing a fair amount of blueish, whitish smoke only on initial startup, then continues to blow smoke slightly for around 10 min until it's warmed up. It seems to be getting a little worse as time goes on, only on startup though. truck has no other issues otherwise, has an egr delete, and some old edge tuner. I don't think it's head gaskets, no other symptoms.
View 6 Replies
I have a 2013 6.7 that I had fully deleted with 5" pipe turbo back and have a H&S Tuner. It was all done approximately 1000 miles ago or so. Recently I noticed after a cold start, after a rev (enough to push out black smoke) I would get white smoke follow the black. I did a light rev today and only white smoke came out after a cold start. I only have 1/4 tank of gas and truck has sat for a week. It sits a lot as it's not my daily driver. This could possibly be just moisture build up!! What are other possibilities of why I'm getting white smoke?
View 14 Replies
05, 170k miles. Studded and egr delete but I don't have paperwork on either. Got a pretty good deal on the truck but I have a few questions..
It runs and starts great, warm and cold, with only a little blue smoke on cold startup. but every now and then when idling (say at a stoplight) the engine gets noticeably rougher, not terrible. No smoke. Goes away after 5-10 seconds.
When I remove the oil cap, there is a "puffing" blow by, not constant, and its not enough to blow the cap off if I set it on backwards. Just puffing.
This may be related, but I pulled the starter wire off the drivers side and touched it to the battery to hear how it cranks, and there is a noticeable blip in the cranking, its not 100% smooth.
Don't think I am losing any coolant. Runs great, getting 15MPG. No CEL. I went and had a relative comp. check done, cylinder 7 is the problem. We both are leaning toward there being a valve problem So I pulled the valve cover, now I have a few questions.
1. When I crank the engine over without starting, I can hear a "pfft....pfft....pfft" chug of air every revolution. I pulled the cover to see if I had a obvious rocker problem, but can't see anything because the oil rail is in the way. I'm guessing this air puff is sign of a valve problem?
2. When the truck is running, there is a small, steady stream of oil running down the rail and dripping onto the valve cover mating surface of the head, I think it was at every injector, definitely 2 of them. Was getting dark, so hard to see. Is this normal, or do I have a leak? Truck has updated dummy plugs.
My next step is probably going to be pull the rail, see if there is a obvious problem, then pull the head. And tips for me? Planning on having the HVAC evacuated then pulling the airbox.
View 9 Replies
I just got a 2006 ford F250 lariat fx4,and it's already at the shop.. when cold start it has some white smoke, but once I get up to highway speeds the truck jerks and bucks. turbo is putting out normal boost. I've changed oil and filters along with fuel filters. also put on a new serpentine belt and pulley, air filter and have everything cleaned real good. the truck is acting like it's starving for fuel. FICM or injectors ?
View 14 Replies
I have an 07 6.0 with 400,000 miles. Has been a great truck with no major problems. Before I started the work I had 3 bad injectors, running rough and the oil/ coolant temp just outside of 15 degrees. So I tour her down and replaced head gaskets, installed arp studs,all new injectors,all new glow plugs and new oil cooler. Ran great for a couple days. Then when driving to work lost power on and off for a few miles then completely gone could only go 10 miles an hour. I checked codes and there was the under boost code witch has been on there for a while and I forget the other code but it was for the ipr valve so I replaced the valve and right after still the same but that code went away and the p0470 popped up. So I cleaned out the ep sensor tube and replaced the valve. After several miles she now runs great but now I'm getting a little puff of white smoke when I take off and not every time and mainly when I take off some what quick. All codes are gone expect the under boost. I have an egr delete already.
View 7 Replies
2004 f350 4x4 sc dually 130K mi. Cranked truck this morning @ 18*F. Truck not plugged in but regular quick smooth startup. Noticed light blue smoke with normal condensation exhaust for about 5 seconds, then normal condensation exhaust for about 30 seconds. Drove truck at normal operating temps with 5* deltas. To my knowledge, truck has original turbo (Garrett), never been removed or cleaned by me. VGT at startup 70-72, running after warmup mid 50's. Is this a symptom of needing to replace turbo seal, and thorough cleaning while off?
View 1 Replies
I have long been having troubles with white smoke at startup, even when its 90 degrees out. Long story short I've got new glowplugs, GPR, UVCHs, valve cover gaskets, injectors, turbo, valve seals, valve springs, and HPOP all within the last year. Most of those parts were needed, some maybe not so much. After installing injectors things started getting worse, whether they're related or not I'm not sure yet. I pulled passenger side valve cover off again in an attempt to figure something out and heard this coming out of the intake spider.
[URL].....
The strange thing is it goes away when it warms up. I should also note the reason I started with the passenger side is because I did a compression test and this side had the lowest readings, with #5 being 270 psi. I disconnected each injector one at a time on the passenger side to see if it made a difference while running but didn't really notice a difference. Am I looking at a motor rebuild, or at the very least a head removal?
View 14 Replies
Lately I have noticed a lot of blueish smoke coming from my exhaust at idle mostly while warming in the morning though it would do it if the truck idled for a few minutes. I took it to the dealer because I have fords ESP but the tech couldn't get the truck to smoke and wasn't getting any codes so he sent it back with a clean bill of health. After getting it back I noticed it smoking again so I picked up the egr valve kit pulled the valve and cleaned it as best I could and replaced the seals, that was last night. This morning it was blowing more smoke than it has before and has continued all day whether cold or warm. I just changed the oil last week and it's still full so it isn't burning any. Head gaskets were done along with studs last month, egr is obviously intact, cat is gone. I'm really at a loss for this, It's an 07 f350 scsb 6.0...
View 6 Replies
So my truck a stock 2000 7.3 started smoking when I would start it up in the morning... figured it was a glow plug issue. Checked the relay it was good, checked the glow plugs found 2 were bad replaced them.
Thought I was done, well I started it up and took it for a drive. still smoked... thought no big deal I know some oil leaked into the cylinders doing the glow plugs.
Then it started rattling like a lift went out, no more smoke though because the truck was warm... shut it off at my buddies. Limped it "it actually still drives ok" 5 miles home.
From my research it sounds like an injector. I have tried a buzz test and they all sound the same.
View 2 Replies
2007 6.0 6 speed, 187,000 miles. The other day started truck, had been running about 20 minutes before. Started fine, go to drive, chugging white smoke, smelled like unburnt diesel, baby truck home, seemed to run ok at low rpm, truck warmed up and ran fine. But I also noticed turbo boost was acting funny. Truck ran fine next few days. Then this morning, started cold fine, started to drive it and same chugging white smoke, it quit by the time j got to the end of my driveway, but drove to work, it quit smoking, ran pretty smooth, but will not build any boost. Truck is bone stock except for exhaust, it's straight piped. Ok. So this eve I borrowed my dads edge cts, here's all the engine codes:
P0069
P0269
P0299
P2262
P2269
The last one is water in fuel, since it started this crap I did notice it was right after it came on in the dash. I'm trying to figure out where to start....
On another note. VGT duty shows 85% at idle ?
Ficm voltage is constant 48 volts
Newer batteries
View 14 Replies
no change, changed stand pipe and dummy plug on driver side, no change and guess what? Now I am stuck on the side of the road waiting to give my last $100 to a tow truck! Engine is hydrolocked, fuel pressure is low, starts off at around 20 and works up to 54 with key on engine off, and that is as much as I know from the side of the road with out my AE. Blew white smoke also. Smelled of unburnt diesel. I think it's linked to my rough running issue. Maybe a bad injector? But every time I did the click test they all passed. Idk, I'm gonna remove the glow plugs and see which hole is loaded and with what. . .
View 14 Replies
I would like the hear what others have to say about the problems I'm having with my 2006 F-350 sd xlt 6.0 with 113,000 miles on it. It's being used as a tool truck mostly going from a shop on the property to close by buildings on the same property. In other words very short distances. Used occasionally to take a dump trailer to a close by dumping ground.
1. White smoke from exhaust. I've read this is most likely an ERG cooler that needs replacing. Any other possible causes? If I end up having to replace the cooler is there a stock cooler that is reliable or should I get the one by bullet proof?
2. Diesel is dripping from the muffler weep hole. Last full tank lasted only 60 miles. Could this be the oil cooler? Anything else? If so is the Ford replacement cooler OK or should I go with an upgraded cooler?
View 14 Replies
yesterday I went out started my truck and white smoke started coming out my exhaust so I turned it off waited a bit started it back up let it run for a bit smoke went away drove it about 60 miles. Later that night it did the same thing but I was 2 gallons short on coolant drove it another 60 miles ran fine. Next morning decided to take it to a shop put more coolant in it drove maybe 20 miles to shop got there turned it off everything was fine never over heated once. So this shop is now telling me my trucks hydro locked and I steamed the EGR valve. And there telling me it's gonna be $8000 to fix it .
View 3 Replies
When it is cold out side like 20 degrees I'm having problems starting my 2000 7.3 I'm cycling it about 5 times and misses smokes white for a bit then stays running I was thinking of changing out the fuel filter. What it could be?
View 6 Replies
Ok, took the sub for a spin around the block yesterday. Turbo was singing a tune when I left. white smoke and minimal boost on the way back. It is spinning, just not boosting very well. Stuck? Electrical problem? any pointers, or easy stuff yo check, before pulling the pump?
View 10 Replies
I have the green light to bulletproof it. I just tore out the engine so she is on a stand now.
The whole backstory to this truck is one day a while back he was driving, noticed white smoke and instantly parked the truck at his house and fell on some hard times and couldn't get it fixed. The truck sat for some years and now was putting some life back into her.
I drained the oil and noticed right away the chocolate milk that was coming out of it, so right there I'm heading towards head gaskets.
What I am looking for is a list of the practical things to do to the engine while it is out on a stand. I am not looking for an extra 1000hp, just looking to bulletproof it so he won't have to worry about any other failures. I'm also looking for other maintenance items to change as well, maybe injector cups?
View 14 Replies
I was passed the other day by a newer (square mirrors) nice-looking Super Duty that was slightly spewing white exhaust smoke. As a life long truck driver, I know a few diesel smells (and I kinda like some ). But, this was so pungent that it was irritating my eyes inside my own cab.
It was so irritating and nasty smelling, that I had to slow down (to let him gain some ground) and open my windows to clear out my truck. So that I may be better informed, what could've caused this?
View 14 Replies
I have a 2006 F350 6.0 litre diesel. The other day I started it up drove away and it was blowing huge plumes of white smoke out of the exhaust. Shut it off.....started it up again after a while then went on a long drive and it went away. What that was?
View 6 Replies
Replaced turbo stock with a wicked wheel. Truck smokes like crazy took turbo out rebuilt it and reinstalled in truck now truck pukes white smoke and has a of white smoke while idling. I don't get why. I've rebuilt injectors about two months ago. Truck is stock not bullet proofed at all. Truck has 170k head gaskets were done at 130k.
View 6 Replies
