Ford 6.0L Power Stroke Diesel :: Smoking After Running For About 5 Minutes / Some Pressure In Coolant Reservoir
Jan 13, 2016
Just finished doing my own heads on my 2005 Excursion 6.0L. Turned it on with really no problems. After running for about 5 min. it started smoking. I also noticed that I had some pressure in the coolant reservoir. I toke off the cap and it stopped smoking. I placed it back one and it started to smoke again. Oil has water now. I used ford head gaskets and ARP bolts. I torqued the bolts down to ARP's specs and torque pater, 210 lbs/ft. I also replaced the oil cooler, stand pipes, stc and the dummy plugs. Also from Ford. I don't know where I went wrong.
View 14 Replies
Advertisement
I have coolant blowing out of my coolant reservoir when ever i hold it to the floor it does it with or without the banks programmer... 6.0L power stroke...
View 14 Replies
I did not run the truck for 5 months and the engine will not crank. I charged the batteries but when I turn the key nothing happen, I hear the glow plug system going but nothing else, starter does not click at all.
One thing that scares me is that there is no coolant left in the reservoir and I am scared that it went in the engine. I did have to add coolant last summer.
How can I first test the starter? Can I turn the engine by hand? If I push the truck, does the engine turn and can I tow it without damaging the engine if it is hydrolocked?
View 5 Replies
Have been working on military diesels for years. I have a 2007 Ford F-250 6.0. I am currently waiting for a new oil cooler as I have oil coming from my coolant reservoir and no coolant in my crank. My question is I have been having my engine light coming on and off intermittently since deleting my EGR cooler.
View 6 Replies
Traveling down the freeway doing about 80 the truck starts to sputter and then cuts off lose all power and gauges then Cuts back on rap back smoked out the back huge amount as I never seen before engine fully cuts off and lose all power no restart pull over the side pop the hood Reservoir has a blown coolant everywhere engine very hot get it towed home engine won't crank very well let it cool off more recharge batteries engine it only spent about 60 80 RPMs.
I have a fail CPS/ cam motion position sensor code coming up. Pull the valve cover and all rails off the both sides to check lifters and rods and everything seems normal and in place. My question is have I spun a bearing or is there something I went out worse checked EGR sensor and everything seems normal hasn't been steamed out or anything so I don't think it's a EGR or cooler. Also checked oil normal color no water. Also could it been a water pump going bad that made my reservoir let go and not egr or cooler?
View 14 Replies
I'm new to the diesel scene and I'm having trouble here i just replaced the head gaskets and did the head studs, also the EGR delete with oil cooler done all by me at home because I'm low on cash and the truck was pouring coolant through the turbo before due to overheating and bad egr and blown head gaskets i didn't have the heads checked before i installed them because I'm broke now and I need my truck but it wont start now and continues to spit and smoke coolant out the reservoir.
View 13 Replies
I bought a 2006 E350 with a 6.0L diesel. Has some issues I hope to work through, or failing that I'll ditch the thing and learn a lesson.
The pressurized coolant reservoir has a crack/leak in it. Is it wise to only replace it, or should I look for a root cause? The temp gauge does not go past 50% pulling hard up a mountain pass.
This was a fleet vehicle that was pretty much abandoned. There is a chance the reservoir was cannibalized for another rig and had the bad part thrown there but I'll never know.
View 9 Replies
Well got home and the front of the truck was covered in coolant. I must have driven 2 hrs after I noticed no coolant pressure, but temperature was great so figured it was another crappy cap. Looking to get a quick turnaround. Need to go out of town for work Saturday so I have this week to get it done.
Just put a stock unit back in? I don't think I need to do anything else in that area. Belt/pulleys/radiator all done last spring.
View 9 Replies
Ok I bought a 2006 Ford F350 with 6.0 after driving for about 3 weeks I noticed a little bit of coolant was disappearing out of reservoir. So yesterday I was driving with a load Reservoir overflows replace coolant with one gallon of coolant and finish trip with no issues. I started truck today and it will not stop smoking it is also not overheating after hearing about head gaskets. I'm hoping it might be EGR cooler white smoke smells like raw diesel fuel. What to do?
View 3 Replies
While servicing the bosses 121k 6.0, I noticed the coolant resevoir empty. It took 1 1/2 gallons to bring to proper level. Returning under truck to install drain plug, I noticed coolant coming from rear of the engine(right side). And of course Ford has changed the cooling system cap, so I wasn't able to pressure test it to pinpoint the leak. Started the engine and seen coolant coming from the left rear as well. I've been reading here to see what others have been seeing, (EGR cooler, head gaskets). With all the heat shields,not much room to look.
After work I did go and buy the adapter to test the cooling system. With any luck I will be able to see leak better.
View 14 Replies
Adding a coolant pressure gauge to truck? There are some expensive kits but considering I already have a gauge that would work, could I just buy a 5v sending unit for fuel pressure or oil pressure and have it work?
View 14 Replies
I just did a pressure check on the cooling system on my 04 6 liter. It reached 16lbs towing an enclosed trailer and into a strong head wind. I was just wondering what's the Normal pressure suppose to be, or is there a Normal pressure. I'm using the new style cap with the larger spring in it and it didn't kick any coolant out.
View 14 Replies
I recently had an upper radiator hose bust and ever since I have been having a slight water leak. It appeared to be coming from between the layers of rubber on the new hose which I replaced twice since the incident. Both hoses had water seeping from the same location. This afternoon I plan on doing a pressure test on the cooling system to diagnose where the water may be coming from.
My question is could a loss of pressure cause larger than normal Oil and Water deltas? If I have to replace the radiator is there a particular manufacturer or type I should avoid? Should I try to get a factory replacement from Ford or would an Autoparts unit be sufficient? The original is still in the truck now with 286,000 miles on it.
View 14 Replies
Im lost here, my 6.0 is building coolant pressure on start up, and the temperature is not overheating. I cant tell if the pressure is staying high while driving, but its blowing coolant passed the cap. Thermostat? The truck was on a coolant pressure tester for 24 hours and never lost a pound of pressure.
View 14 Replies
The same day that I noticed my coolant temp was running high as I was driving around in my 2011, i was driving around in my corn field cutting wood and i noticed i was dragging something under the truck. when i got out and looked under the truck, there was coolant running down all over the bell housing and oil pan. i was a bit worried that it was my head gaskets leaking but once i got it in the shop and looked at the heads, all looked good. i wasnt sure where it was coming from! so i looked up common coolant leaks on the 6.7 on youtube.
First video was one of the coolant line on the turbo leaking. so i crawled up on top and shoved a mirror down by the turbo and sure enough i could see coolant leaking around the connector fitting coming out of the turbo. apparently the gasket goes bad around this fitting allowing it to leak. i was just wondering if this is really that common of an issue? I did the work myself. and its not really that hard to get to the turbo, its just time consuming removing all the crap around it. all i had to do was remove some connectors that were attached to the plastic intake and remove the intake then you can reach into that fitting. total time was around 2.5 hours.
View 14 Replies
So a little back story. Did the oil cooler a couple of years ago as the deltas were getting high. Coolant flush and new Ford gold. Also welded EGR shut and had PHP reprogram. That was approx 25k miles ago.
Well now I have to fix the EGR because it won't pass smog. But my truck is running hot again BUT only when climbing a grade while towing my toy hauler. As soon as I crest the Temps come down fast. Also my deltas are fine normal driving, which was not the case last time I did oil cooler. My deltas were off all the time.
Also when I shut the truck off and stand in front of it after driving I can hear the coolant system gurgling.
I will be tearing my truck apart next week to fix the EGR and was thinking of doing the oIL cooler but don't want to waste money if that is not the issue. How do you tell if the water pump is bad? Also the fan is working according to scan gauge but doesn't have the big whoosh and squeal like it used to.
View 14 Replies
OK so 2006 f550 6.0
If I want to monitor fuel pressure with a gauge in cab while running all the time... (not just testing) can I purchase one of the secondary fuel filter caps that have a port in the top and connect the sensor to this to run or is there a better way? (Or is that not going to work)
Cap I am talking about is something like this
[URL]
(I know this is a combo kit but they do sell the fuel only) But since it has a threaded port in the top I could connect the fuel pressure sensor to that and go from there correct? Would that give accurate readings?
View 4 Replies
I noticed when I shut off the truck about 30-40 minutes later I'll open the degas bottle cap and notice there is no pressure.
I used a coolant pressure tester kit and pumped in 16PSI but couldn't hear or find the leak.
I'm going to buy a smoke machine in a month or two but until then, can I still drive the truck ?
I'm guessing it is a pin hole leak somewhere as once I shut the truck off... there is a lot of coolant pressure.
View 7 Replies
I have a coolant leak somewhere on the top of the engine running down to the oil pan and bell housing. I have done some research and discovered it could be the coolant inlet tube to the turbo.
View 14 Replies
My 2003 6.0 has a coolant leak. It leaks slowly while not running and more quickly while running. I have about an 8 mile drive to work every day, I can make it there and back without having to add coolant but I'm cutting it pretty close by the time I get home. In short I go from the max fill line to bone dry in about 24 hours.
With the truck running I can see water getting slung around all over the front of the engine but the majority of it seems to be coming from around the two larger pulleys in the middle. I've read that this can either be the crankshaft seal or the water pump, any way to know for sure? Any other possibilities?
View 6 Replies
My A/C will blow cold for about 3 min. and then stop for 10 min......then cold again for 3 min.....then warm for 10 min.......what is going on ? It does this when on climate control and on A/C . I had a compressor go out about 1 1/2 yrs. ago due to a fan failing...the compressor tore apart... This is not acting like that though .
View 9 Replies
