Ford 6.0L Power Stroke Diesel :: Rough On Cold Startup - Surge / Lack Of Power During Light Acceleration
Jan 16, 2017
My 2007 6.0 has a really rough (almost 'miss') during cold start up. After 5 seconds or so, it smooths back out and sounds normal. Until gauge reaches normal operating temp - there is a surge/lack of power during light acceleration. I also hear a frequent compressor coming on and running for a while which I am contributing to a possible vacuum leak. Maintenance is always done on time and I've already had a few costly repairs (both internally as well as externally) on the engine. I usually always wait for the glow-plug indicator to turn off before cranking the engine and let it idle for 5-10 minutes prior to driving it. Once the vehicle climbs to normal temp. everything seems to be fine but the compressor still comes back on every so often.IS it worth simply replacing the vacuum canister located behind the passenger side battery - or should I find someone to hook up a diagnostic unit first?
View 5 Replies
Advertisement
Having some problems with an e-350 dying when in gear and rough idle. Truck starts up after it dies. Vehicle acts like it is starving for fuel. I have check fuel pressure after fuel pump and getting 55psi. High oil pressure pump with in normal ranges. Cleaned and checked egr and it was in the closed position. Fuel filters have been changed. Injector buzz test ok.
View 14 Replies
I've been having issue with my truck lacking boost over the past month or so. The psi levels are normal in the morning when I start it up cold, the problem almost always occurs at start-up when the truck is somewhat warm and has been sitting for an hour or more after use. I've had boost levels at idle from -0.14psi to -0.56psi and as low as -1.2psi when driving as the problem is occurring, but it eventually kicks on and goes to normal levels after several minutes of driving. After originally taking the truck to a local diesel mechanic I was told it had EGR codes and they recommended installing an SCT tuner and cleaning the EGR valve to solve the problem. I had them install an SCT 5015 tuner and clean the valve but I've still been having the problems with boost.
View 2 Replies
2004 f350 4x4 sc dually 130K mi. Cranked truck this morning @ 18*F. Truck not plugged in but regular quick smooth startup. Noticed light blue smoke with normal condensation exhaust for about 5 seconds, then normal condensation exhaust for about 30 seconds. Drove truck at normal operating temps with 5* deltas. To my knowledge, truck has original turbo (Garrett), never been removed or cleaned by me. VGT at startup 70-72, running after warmup mid 50's. Is this a symptom of needing to replace turbo seal, and thorough cleaning while off?
View 1 Replies
I have a 2007 6.0 crew cab that I'm having some recent issues with. When starting cold in the A.M. the truck will crank, start for a half second then shut down, after about 3 times it will finally catch and keep running. I'll let it warm a bit, then for the first few minutes of driving it will have a pretty noticeable surge on acceleration only, not at idle.
The surge goes away mostly after warm however you can still feel it happening between 22-2700 rpm and can just see the rpm moving back and forth a little. Lastly the fuel mileage has dropped a good amount. If I baby it around town I'll get 10.5 and can see 9ish occasionally.
Truck has brand new ford fuel filters, ford blue spring, fresh oil change, FICM has 3k miles on it, new batteries in last 6 months. Turbo egr oil cooler done in last 20k. Currently has 120k on it.
View 2 Replies
This morning I noticed when I started the truck had a rough idle shaking truck. The truck felt weak. Boost would go up but truck felt like it was in sand. While coasting on the highway at 50-55mph the truck not only lags in power but vibrates viciously until the overdrive kicks in that vibrations in cab and ssteering wheel go away.. What might be going on?
View 6 Replies
I've got a slight surge that's very noticeable cold and not so much after warmed, I can hear the turbo surging and feel a slight power increase on and off, checked with forscan the normal values, alls inline, I did not ck fuel pressure yet but will, I noticed vgt, boost fluctuates when this happens, icp ipr readings inline, this is a 04 with throttle plate inside the air elbow area, can this cause a surge and how to test this, I am not familiar with this setup as my 05 does not have it.
View 6 Replies
I have a 2002 F350 4wd with the 7.3. I was driving the truck and all of a sudden it was running like crap. the engine light was on. after a minute or so the engine light goes off and the truck is running fine. then again starts running like crap. I am close to the house so I limp it home. runs like crap.... will barley climb small hills. engine light is on. get home turn it off... next day... starts up and runs great for 10 - 15 min. engine light comes back on... runs like crap.... my neighbor says "It's the crank position sensor" I replace it.... runs great for a month.... now it's doing the same thing......
View 9 Replies
Happened last night two blocks away from home. The idle seemed a little rough at start-up but didn't think much of it because the coolant temp was only 132 degrees. Pulled out of the driveway up to the stop at the corner. Totally bogged upon accelerating, went a block, then came the sound of a hubcap rolling down the street along with a check battery light, no power steering, and REALLY sucky brakes.
View 14 Replies
I'm new to diesels. I just bought a 2004 F250 with the 6.0 V8. I have the high and low circuit, contribution codes on cylinders 4 and 8. I've only had the truck for a few days but I've been reading a ton. The symptoms are hard start, rough idle/shaking, no power when cold. When it heats up and I'm over 2000 RPM it seems to be just fine. Even when hot and below 2000 RPM it does ok. I've check the FICM. It reads 48V with key on and 48V running. My plan is to do the following:
Change the Fuel Filters
Change the oil filter
Change Air Filter
Change oil with 5-W30 synth and I have both Hot Shot/Rev-X
If that doesn't work, I'll replace the two injectors. How does that sound.
View 14 Replies
I have a 2003 f350 6.0 and did head studs with the egr delete and Warren diesel Injectors 155cc. I have both warrens tunning and loney wild tunes.
In all the tunes when i first start the truck up after sitting for a while it will rev real high. Like when i was a kid and tried to impress someone and catch the motor as soon as it fired up and rev it real quick. I mean it sounds cool but i don't want it to do it for obvious reasons. It also gets out of control when you are driving it down the road until its warmed up. If you just try and drive it normal it will start to take off once it gets around 1500 rpms unless you really feather the peddle. Its almost as if its getting to much fuel but it does it with both tunes.
In the tow mode the truck tows like crap. I can literally have the peddle to the floor and it struggles to move a 10k car trailer. I really just wanted a more fuel efficient truck that had a little pep. Now i wished i had left it stock with the new studs.
View 11 Replies
05, 170k miles. Studded and egr delete but I don't have paperwork on either. Got a pretty good deal on the truck but I have a few questions..
It runs and starts great, warm and cold, with only a little blue smoke on cold startup. but every now and then when idling (say at a stoplight) the engine gets noticeably rougher, not terrible. No smoke. Goes away after 5-10 seconds.
When I remove the oil cap, there is a "puffing" blow by, not constant, and its not enough to blow the cap off if I set it on backwards. Just puffing.
This may be related, but I pulled the starter wire off the drivers side and touched it to the battery to hear how it cranks, and there is a noticeable blip in the cranking, its not 100% smooth.
Don't think I am losing any coolant. Runs great, getting 15MPG. No CEL. I went and had a relative comp. check done, cylinder 7 is the problem. We both are leaning toward there being a valve problem So I pulled the valve cover, now I have a few questions.
1. When I crank the engine over without starting, I can hear a "pfft....pfft....pfft" chug of air every revolution. I pulled the cover to see if I had a obvious rocker problem, but can't see anything because the oil rail is in the way. I'm guessing this air puff is sign of a valve problem?
2. When the truck is running, there is a small, steady stream of oil running down the rail and dripping onto the valve cover mating surface of the head, I think it was at every injector, definitely 2 of them. Was getting dark, so hard to see. Is this normal, or do I have a leak? Truck has updated dummy plugs.
My next step is probably going to be pull the rail, see if there is a obvious problem, then pull the head. And tips for me? Planning on having the HVAC evacuated then pulling the airbox.
View 9 Replies
I was driving and my truck started have lack of power, could barely get going on hills, tons of blue smoke (smelled like diesel) real rough idle. I unplugged injectors and found #5 made no difference. I replaced it today and I can't get it to start. It'll get to 2000+ psi 48v ficm, low pressure oil registers, ficm says its in sync. It will crank and blow a lot of black like its half firing or something. It has even crank to, until it tries to fire. From what I've been reading could it be the ficm? That one circuit is fried?
View 14 Replies
I have a 2003 with 150k miles. My 6.0 has black smoke and can barely crawl up a hill. Dealership is 30 days out for an appt. Air filter, oil change, alternator, and batteries are new. I removed the EGR valve and cleaned, but the valve seat is not perfect. I can see 20 to 30 mil gap around half of the seat. Is this ok or will that little gap cause this?
Hoses all look good. No alarm lights. I have no diagnostic tool but I can use a meter well. It did have an airbag light but I found the fuse missing and replaced it. The air filter alarm switch fell apart but I bypassed it till I get new part. No alarm lights now.
View 14 Replies
While I'm cursing at highway speed everything is fine. But when u punch it it pass someone it's like I actually slow down, same from a red light. I've got a livewire programmer in it and this problem is somewhat new. It just seems to keep getting worse, I was going up a hill on the interstate this morning and at 2800 rpms I was actually slowing down. I'm not sure if the fuel pump is going out or if the transmission is slipping or what.
View 7 Replies
Blown fuse causing a lack of power to the OBD port?
I just got my Kiwi2 BT OBD2 adapter and was hoping to start diagnosing my truck, but the adapter won't power on while connected to the truck.
I pulled and visually inspected fuse #12, I also verified power to the cigarette lighter plug and the accessory 12v power outlet.
The adapter powered up with no problem when I connected to a co-worker's Tacoma.
View 14 Replies
I'm in the middle of an extended coolant flush and switch over to ELC. As of recently, I have noticed white smoke at startup and driving while cold and warming up. (Even at times accelerating when half warmed up ~170*). At first I attributed it to suction, so last night I changed the oil with T6 along with a new OEM filter.
After I got done with the oil, I pulled my EGR valve when the engine was hot. Is this simply goey due to warmth, or do you suspect EGR cooler leaking? I didn't take pictures of the manifold, but the lower chamber was hard and dry, while the middle section seemed to be "goey". EGR Cooler or something else???
View 6 Replies
I have a 2004 f350 with a 03 bullet proofed motor. The truck did not have any power and the turbo wouldn't support until I put a new vgt solenoid in and it ran great for about 3 miles... Stalled doing 65 kinda lacked power while accelerating but got up to speed quick. I pulled over and no start. It is running error code kam on pcm from disconnecting batteries but could this cause the stall and no start? Or should I be looking into icp sensor?
View 2 Replies
My ride again has started to develop a small studder during acceleration. It seems like only when it's cold. But when the temps are at normal it's not there.
At work now, but would like to get a heads up on it by the time I get home. To know what to look for.
No modes, no codes nothing but the studder.
Using T6 every 5000klm, fuel filter every 15000klm.
I have a fuel filter at home and will first replace it, before anything else.
BTW, all filter are OEM
About a year ago I had something similar. But I through some codes. I will look them up here at FTE.
View 14 Replies
I Have A 2013 F250 I Have A H&S On It. I Have It Delete. And The Cel Comes On In The Morning, Ill Get The Code In The Morning. But It Has Something To Do With Coolant Temp Sensor. It Also Does Like A Bucking/Power Surge. Boost Goes From 0-10-15 ,When you Hold Pedal Steady. Do I Need To Update My H&S Or What?
View 14 Replies
I have a 2006 F250 6.0 Amarillo Edition. 133,000 When I bought the truck it was a theft recovery vehicle where the turbo, injectors, FICM and wiring harness were stolen. The company I bought it from replaced the injectors, wiring harness-new, and a used FICM, and turbo. Also has EGR delete and SCT tuner with basic tunes. I believe the SCT was put on to mask another problem. No dealer would spend that kind of money to sell a truck unless something was wrong. The truck would accelerate some with the tuner but shift the tires so hard it would bark them. I removed the tuner and went back to stock program.
The truck will barely move and takes a long time to accelerate under a load. In park and neutral it is fine. A friend has a ford diagnostic program on his computer and says the readings were all good except EBP was a little high. Removed exhaust and air intake to verify no restrictions. Turbo sounded like the vanes might be sticking so I replaced the turbo and VGT solenoid. Now truck feels like its trying to make more boost but not transferring power to the engine. Have blown the silicone hose off twice now during testing. Checked the EBP sensor and tube and only thing I see is a little carbon buildup inside the sensor. What else to check. I'm new when it comes to diesels.
View 6 Replies
