Ford 6.0L Power Stroke Diesel :: Passenger Side Lower-outer Tie Rod Is Clunky
Jul 23, 2015
I know jack about tie rods. But what I do know is the passenger lower-outer tie rod is clunky [Right where it connects near the wheel. Jacked up the truck and moved the tire from right to left and the passenger side lower tie rod made a very obvious clunking noise right where it connects with the upper piece.
My question is, can I just replace the passenger lower arm or do I need to replace the upper [not sure what it's called] that it connects into? While under the truck I found it difficult to figure out exactly how they are joined together and taken apart? My drivers side is nice and tight, no clunking.
2005 F-250 CREW CAB 4X4
View 11 Replies
Advertisement
So what size nut is on the outer tie rod? So far I'm good on the ball joint nuts, calipers, caliper bracket, hub to knuckle (21mm or 22mm--but either way I'm good), and locking hub. I'm putting this all down in my manual so I don't have to guess since i have to load everything up when doing the heavy work.
View 6 Replies
I purchased a 2011 350 crew cab lariat 6.7 diesel last week. That night i noticed that the passenger side map light was considerably dimmer than the drive side. Had to go back to the dealership 2 days later anyways to get a second key made. Showed the tech the light and he gave me 2 new bulbs to replace both lights with. Both were great for about a week but i noticed the passenger side has once again become dim....
View 1 Replies
Can you replace the passenger side up pipe without pulling the turbo, etc? My bellows blew out. Y-pipe is still ok. I've already deleted the EGR, so what's the best to put back? Go back to the original style or just put in a straight pipe? Where to get one?
View 2 Replies
I discovered my passenger side carpet was a little damp not bad but was wet. I hosed down the window, windshield, door, and the sunroof areas and didn't see any water coming in!? The only thing I've noticed, when running the AC it seems to have "more" water coming down the frame area but not totally sure but sure seems like a lot more than I remember! Just wondering if, when driving down the road, that the water from the AC is coming in somehow?? Again, the carpet isn't completely soaked but damp, even up under the glove box area on the carpet. Heater core?
2006 F350 4x4 CC KR with 138K completely stock!
View 14 Replies
I have to change out the inner seals on my front axle on my 04 f250 6.0 4x4. was wondering what the torch spects are for the bolts on the end caps and the torch spects on the differential cover? I already have the passenger side axle out. was changing my ball joints on that side when I noticed a bunch of oil in the axle case and on the hub knuckle. Also, this might be a long shot but is there any way to change the inner seal on the drivers side without taking out the axle on that side? I have the passenger out and if I could get away without pulling the driver side that would be awesome.
View 10 Replies
I've just finished a marathon replacing the y-pipe, and doing the IPR screen. I had many seized/stripped bolts to contend with. 2 I had to cut off in the most awkward places.. Anyways, it all came together and completed the project late tonight...
Befoer even starting the truck I noticed coolant dripping from passenger side manifold/block heater area.. I obviously must have damaged something in my reefing on turbo to get it lined up with exhaust pipes, etc...
I cannot see the source of the leak, but it seems wet above the block heater, but pools there then drips.. I'm curious where to look. Could I have damaged the EGR cooler and its coming from there? At the manifold joint closest to the back, is there coolant flowing there? I am pretty frustrated, because after going through a day like to day, ripping my arms to shreds, straining for 12 hours straight, then having yet another issue to figure out...
Also this is as best as I could get the y-pipe to meet the turbo... slight gap at bottom.
View 9 Replies
Got stuck, noticed when in four wheel drive only the front passenger side and rear passenger side was pulling. Is that normal? Or should both fronts be pulling?
2011 f350 dually 4x4 6.7.....
View 13 Replies
I have a 2011 f250 crew cab lariat that actually sits about 3" higher on the passenger side in the rear. I never noticed until I put some 4" pro comp blocks on the rear. I measured before and the rear left was 40" and right was 41-3/4". Now the drivers side rear is 42" and rear passenger side is 45"? I have looked at the blocks to make sure they are seated properly and everything is installed correct so what gives? What could be causing this. I bought the truck with 99k miles and now it's at 130k miles. I do tow a small cargo trailer sometimes but it is only about 3k lbs. Now I am thinking of buying some new leaf springs to see if that corrects the problem.
View 4 Replies
There's a pump or ?? I'm not sure . Our "11 6.7 is making whining vibrating sound coming off passenger side , front of valve cover . Not sure what this is . Nothing I'm searching is telling me n I'm not best with diesels .
View 3 Replies
We just replaced the #5 injector. Went to take for a test drive and the 4 glow plug caps on passenger side popped off and leaking oil while driving. Pushed them back on and they popped off again. They shouldn't be under pressure should they.
View 6 Replies
I have a 2011 F250 4X4 Supercab 6.7L that has a highly annoying knock/rattle (you can't hear it) under the front passenger side floor. It feels like someone is tapping on the floor beneath your feet any time you hit a bump or when on a rough road.
Its been in at least 5 times in 2 yrs with cab mount adjustments/shims, cab mount replacements and realignment of the exhaust and brackets. The knock has been there since about day one (I assume anyway, I'm rarely on that side of the cab) and have burned up my 36k warranty, although I'm told i'm good because it is pre-existing.
I keep insisting its in the suspension and keep being told they can't find anything. The mechanic indicated that this is a known problem, but Ford has not put out any service bulletins other than to do the cab mounts and suspension. Has anyone had this problem and found the solution?
View 9 Replies
Drove my truck for the first time in a few months and there was a noticeable ticking coming from the passenger side glovebox area when the HVAC is running. I cycled between AC and fresh air and the sound persisted. What it could be?
Took a quick video on my phone, you'll have to turn up the audio to hear the ticking : 2011 F350 HVAC ticking - YouTube ....
View 3 Replies
I have a small coolant leak coming from the passenger side near the back of the engine that forms a spot about the size of a dinner plate if it sits for a few days.
One thing I noticed is if I turn off the AC selector switch when I park I will get the drip but if I leave the switch on MAX AC when I shut the truck off I do not get any leaking.
It is definitely coolant and not just the condensation from use of the AC. If I haven't used the truck for a few days or if I have run it with the AC off I will get the drips.
If I run with the AC on and leave the switch in the on position when I shut the truck off it won't leak. I have tried to locate it from looking above and below but can't determine where it is coming from.
View 4 Replies
Fixing issues with my truck. I just ordered some latex surgical tubing and am getting ready to fix the rattling noise in my rear door by using the Epic's Door Seal Mod. Hopefully this will take care of that issue.
One more annoying noise though. Has there been any fixes to the buzzing window noise that is coming from the front passenger side. If the wind is blowing right and I'm running over 50mph, at times get a loud buzzing noise and really bugs me. Something is vibrating and at first i thought i had a speaker going out but found out that wasn't it.
I've called my dealer and informed them of this and asked if they've heard of this but of course they haven't and this usually means the won't do anything besides look for recalls or something. I have the noise recorded and scheduled an appointment with my Ford Dealer but again, they won't do anything most likely.
View 7 Replies
Some people say it's normal to lose some boost after the delete, some say it's not and you need a tuner. Before the delete, I could regularly see around 28-29 psi on the factory gauge if I jumped on it. Now, I see about a max of 20-21. I have no leaks that I can find and the truck runs just as it did before. I still have my EGR plugged in laying on top of the engine and don't have a check engine light-yet. Is there a definitive answer as to how to fix this or is it really considered normal to lose that much boost after a delete? I don't really want a tuner because I'm not looking to add HP, but if that's what it takes, then I need to save up. I also read somewhere it can depend on the strategy.
View 14 Replies
Trying to get some assistance on a mystery oil leak. I see wetness above the oil pan on the left side near a tube. That is the most fresh oil I can find at the highest point. The passenger side and starter also have drips, but i am thinking it may be running across the oil pan rail as I cannot any source on that side. Also, recently started having a rough idle - surging. Of course I thought ICP, doesnt feel wet.
View 6 Replies
Have just about 1,600 miles on tuck born on 12/14/11. Love it, but.. When going slow in subdivision I am getting some hesitation/bucking when going in the upper 20s/lower 30s. When I feel it I look down and I am usually in 3rd. Is this the transmissible thing? When it happened Sunday it felt like it was going to die. If I start off with a quicker start (to get to highway speed) it shifts fine. It just started the last few weekends......
View 14 Replies
Just bought 2 new F-350 with 6.7s for a service truck and feed truck. I have a 2011 6.7 so pretty familiar with it. I noticed both these new trucks shift at a lot lower RPMs. At times if going from pasture to pasture I have noticed the tach at 900 rpm in 6th gear. My 2011 doesn't do that, it shifts at a higher rpm. Both of the trucks have been deleted, and I have a SCTx4 tuner in each truck and have both tuned to the lowest setting, Tow 40HP. Is this a fuel economy thing?
View 5 Replies
Was replacing my cracked and leaking charge air cooler pipe Friday evening and noticed oil all over the place at the lower front of the engine. It has been a few months since I've been under the truck. No drips on the ground so it must be a slow leak while driving. Oil level is fine so it hasn't been leaking for long.
Any ideas from this limited two picture view? Front main seal? I've been reading the vacuum pump leaks oil as well but I'm not sure where that is other than driven by the HPFP. I took additional pictures but those were useless, it's a bit cramped in this area.
In the past ten months I've had the turbo coolant inlet pipe leak repaired and then the DEF heater failed, which means replacing the entire pump of course. The wastegate solenoid air compressor noise started some time ago as well at shutdown but I haven't been concerned about that (it doesn't seem to cause an issue). 96,000 miles.
View 5 Replies
This past week my wife and I took a short trip and returned on a gravel road. I went to start my truck the next morning and there was a puddle of diesel fuel on the driveway. When I looked under it, I noticed that the tip of the fuel filter housing is gone and is leaking slowly from there. I called the dealer and they would not fix it on warranty, the truck has 20k on it. The service man said he would not turn this into ford. I've had the similar problems with this particular dealer. It's obvious that a protective cover is needed for this. I kept the part and am thinking of sending it to ford.
View 13 Replies
