Have a problem with the gauges and radio shutting down sometimes.. Thought it might be a loose wire or something.. But noticed on the scan gauge that it would happen when the volts went over 16 volts.. Is there an external voltage regulator or is it just time for a new alternator..
View 3 RepliesI've had a scangauge on my truck for years and today while on vacation I noticed the voltage was fluctuating between 12.5-13.5 while driving. It has always ran at 13.5-13.7 .... I checked it with a fluke and it is a solid and steady 13.8v at idle. Why would that gauge be fluctuating like that? Truck seems to be running fine.
View 6 RepliesI'm looking to use a 5V location for the Dash Boss fuel pressure sensor. I know most of the sensors (except the CMP & CKP sensors) use a 5V reference voltage. Which one to use? AIT & EBP are close to the sensor mounting location.
View 14 RepliesI have a 2003 Excursion 6.0 with edge juice with attitude
While driving first thing in the morning runs like a champ, as the engine warms up I start seeing the exhaust temps lower to 88-94, then I start getting over boost code with monitor reading of 41psi, then the Edge monitor screen will go blank, then the STALL... The excursion with start right back up but the shut off immediately. Wait 20-30 minutes in the shade and will start back up and run again poorly missing almost like turning the key off and back on... Then the next morning start all over again.
I'm thinking bad FICM or bad PMC over heating.. ??
My 6.0 powerstroke keeps shutting off when I hit a bump. It's like everything died and reset and I loose all memory to stereo and everything. When I got to work and popped the hood I tapped on the battery cover by the pcm and it shut off again.
View 5 Replies2012 6.7 F250 with 17k miles. It's getting hotter here and the last couple of days when shutting down there is a sound coming from the engine compartment that sounds like an air pump on one of those load-leveling systems. It will go on for about 15 seconds then stop.
View 12 RepliesMy wife's 2011 F-350 on start up, will sweep the gauges from one side to the other. My 2012 doesn't, is that normal?
View 14 Replies2004 f350. Trucks starts, runs, normal. But just noticed the gauges are not moving. Speedo stuck at 50, tach is at idle. Lights up just fine.
Have a code for the fuel sender, had that issue for awhile now, but also have u1262.
I have a 2006 Super Duty 6.0L, and I'm what are the two temperature gauges on the right side of the dash are? I'm sure one is engine temp, but what is the other one? Also, which gauge is which (in terms of top/bottom)?
View 11 RepliesOn my 2011 the gauges would cycle when I turned the key on... My 2014 doesn't... Is there something wrong or has Ford changed the sequence? ...
View 3 RepliesI had a '11 and when I turned the key on all the gauges would sweep across and then go to normal position. My '14 does not is that normal ?
View 1 RepliesI have a 03 f250 6.0 had it for 2 years never had a problem. Last week I went out and started it to warm it's up as it is cold out here and it started fine I then noticed some thing hanging down under the dash so I started tucking it up under there and it arced and all gauges shut off and the truck shut off. So I took the panel down and it was the biometric pressure sensor that was hanging and the previous owner had a remote start on there that I never knew about and 2 wires on the sensor were stripped and not taped as well as some others. I checked all fuses and relays all working good tested fuse box and everything good there, replaced bio sensor and still nothing turn the key and try to start it and it does nothing injectors, don't precycle fuel pump doesn't run and starter doesn't kick in. I jumped starter off the wire on fender and it turns over but still doesn't start. Also I think it's the ecu but don't want to buy another one if I'm not sure if that's the problem.
View 7 RepliesDon't have a clue what's happening here or where to begin looking but about 20 seconds after cranking the truck ALL my instrument panel gauges go dead, radio goes dead (nothing on it's display) and my driver door controls all stop working simultaneously. Funny thing though, I can still see what the computer sees with my edge insight that's plugged into my OBD2 port and all those read as normal. The engine still runs and I can drive with no issues. My headlights still work fine as do all my signals.
View 4 RepliesDriving my 2003 today seen the "check gages" light on and the trans temp gage pegged on hot. CRAP, tranny time! look at the edge evo and it reads trans temp as -60F ???. Plugged in the torque pro and it reads 8,240F. At that point I figure its PROBABLY not that hot. Let it sit for a while and back to normal. Watch trans temp on torque pro as I drive it and everything is fine till it gets to about 150, then it jumps to 60F, then 30F, the 8240F. The cooler lines and trans pan are both feel normal. Picked up a new temp sender on my way home.
View 5 RepliesLast week the engine in my truck was shutting off while driving. Happened to me 3 times over the course of two days. The first couple of times, the engine was dead for 3-5 seconds and then the engine would come alive and drive normally again. The third time was about a 10 second event...same result, engine refired on it's own and drove normally. I was in motion all three times so the engine restarts all occurred before I was able to bring the truck to a complete stop.
No check engine light...(I didn't pull any codes because I didn't have my laptop with me). So, I decided to try a new CPS. I had one in my glove box since 2003 so in it went. It replaced a black CPS that I purchased from Riffraff about 100k miles ago. The new CPS seems to have done the trick. I've driven about 500 miles since the swap and the symptom has not returned. I wonder how long this one will last. It's a Ford replacement part so maybe I'll get another 100k miles...
So I have this intermittent problem of the truck shutting down on its own when in idle or idling along in drive I immediately put the truck in N, turn the key and she starts right up again.
Does not do it at speeds, just in idle. The "check gage" and "battery" light are the only dash lights on after a shut down.
Where do I start?
I have been battling and issue with my 02 7.3 just shutting down on my at random times.
1st Time
Outside Temp: 100
Drove 5miles sitting at in idle in bimart parking lot truck shut down
Let sit overnight, went back started right up
2nd Time
Outside Temp: 100
Driving home sitting in traffic slow moving 5mph, truck shut down
Able to start up about 5mins later
3rd Time
Replaced CPS, Air filter, Fuel Filter
Outside Temp: 80
Hauling travel trailer up peak 35-45mph shut down
Allowed truck to sit 35-45mins started back up
Started hauling made it about half mile shut down
Got towed to flat land to unload trailer and haul the rest of the way
Returned to truck
Started right up 45mins later, drove it 30miles home without a problem
I am at a loss i keep reading and seeing HPOP, tin nut, IPR, EBR..
The last post I read was about the IPR : [URL] .....
I have a 2000 F250 superduty crew cab short box. It has any occasional issue of either just shutting down (engine dies) which seems to happen if i hit an occasional bump. The other issue has happened a couple of times which is it will lose power and just go to a rough idle. I shut it off and restart it and it will run fine. I'm wondering if it is the throttle position sensor.
View 2 Replies2000 F-350 7.3L no gauges or throttle, I checked the fuses and no luck....
View 4 RepliesI have an 02 F350 7.3 ... I just installed my glowshift tripple gauge pillar set. I have an EGT, Boost and fuel pressure gauge ... I followed all the constructions on installing them. The boost is working just fine and the EGT was too, but after a while the needle started going back and forth and the red warning light what blinking and then it just sat at 0 with the warning light on and stay that way. My fuel pressure gauge is connected to a sensore i put in my fuel filter housing, my fuel pressure gayge right from the start stayed at 30 psi with the red warning light on and just stays there .... Also the buttons to change the color and set the peak on the EGT gauge are sticking for some reason and staying down and aren't letting me change the color ...
View 12 RepliesIm the second owner of a 2008 Toyota Prius (Package II) with 23k miles.
View 2 Replies