Ford 6.0L Power Stroke Diesel :: Oil Leaks At The Front / Rear Side Of Engine
Nov 15, 2015
I have had a slight oil leak at the front of the engine for a while, and slight oil leak on the pass rear of the engine, and recently got a decent oil leak in the rear drivers side of the engine. I want to fix all three leaks if I can identify what is wrong.
Leak 1 : Front of the engine. This has been leaking a drop or two of oil every few days for over a year. Slight leak so I didnt worry about it. The leak is dripping from between the crank pulley and the engine. Is it likely the front crank seal is leaking, or maybe something above it?
Leak 2 : Rear of engine pass side. There has been a slight oil leak on this side of the rear engine for about a year too. It leaks about a drop of oil a day. I can see that the oil is all over the starter though.
Leak 3 : This just started and is a decent leak. It is dripping off the exhaust manifold as seen in the picture below and leaks a 6 inch circle of oil on the ground in a week.
Maybe leak 2 and 3 are connected? I tried to get a good look of the engine and without pulling anything off, I couldn't see any oil leaks on the top of the engine. I couldn't see the HPOP cover though because the turbo was in the way.
NOTE: I do park my truck in the driveway every day and our driveway is slanted quite a bit with the nose of the truck much higher than the back.
Here are some pics of the oil leaks:
Under pass side of truck, oil on starter : [URL] ....
Under the Drivers exhaust manifold : [URL] .....
Bottom front of engine, between pulley and engine : [URL] .....
View 4 Replies
Advertisement
Got stuck, noticed when in four wheel drive only the front passenger side and rear passenger side was pulling. Is that normal? Or should both fronts be pulling?
2011 f350 dually 4x4 6.7.....
View 13 Replies
I have developed a leak coming from the top, driver side, rear of my engine and I could not figure out where it was coming from. I took it to a reputable shop for diagnosis and they tell me that the rear leak is coming from the transmission lines.
The weird thing is I never thought the leak looked like ATF. They also told me that it looks like the stock radiator/cooler has been bypassed so I have no cooler.
Should I assume that the stock internal cooler failed and that is why the PO bypassed it? Also is there a decent write up on deleting these lines and running soft transmission lines to a aftermarket cooler?
View 5 Replies
How does one pressure test for air leaks??? Truck is a 04/04 F250 with 198K ICP sensor in the valve cover.
View 7 Replies
Have to do a brake job on the truck? I took mine truck in for a CEL (New EGT 12) and during the Multipoint inspection they saw the brakes were pretty worn (and wanted an upsell im sure). I only have 49k miles and the fronts only have 20% and rears 30% of the pads left. So I get to spend a few hours this weekend doing the deed. Anything special to look out for?
View 14 Replies
Well about 4 days after my HPOP replacement, the ol Ford is at it again. Apparently, one of my power steering lines has been rubbing on the top of my driver side front shock mount. It let loose in a giant black plume of black smoke and grinding gears as I was pulling into the corner store. Limped her home and inspected it. From what I see, its not a terribly expensive hose and shouldn't be too terrible to replace. One thing after the other [URL] .....
View 3 Replies
I have a pretty good leak coming from the front of the rear diff. is this a common problem on the 10.5 ? How hard are these to do without a lift? I still have warranty left but will have to swap out exhaust so its almost a toss up whether I do the seal myself. Also was considering a new posi unit because seems like the original is about toast, might be a good excuse to swap a new one in. 2009 with 95,000 on it. Bought it a year ago with 70,000 on it, the rear was dry till at least 90,000. I serviced the fluid at about 90,000 and didn't have a leak so now a couple thousand miles and its gushing???????
View 7 Replies
Any recommendations on brake calipers and hose?
View 14 Replies
So with the hurricane coming to my house I did the balljoints on my drivers side yesterday to prepare to evacuate today. Everything went smooth with no problems. Now fast forward to the drive to Orlando, I hit a bump going 65 and my front right side (ball joint replacement side) starts humming. I pull over and it stops, get out see nothing obviously wrong and start back on my way with no noise to speak of. It happened again and again I just slowed to almost a stop and it went away. Yesterday after the repair I took it on a trip through some crappy roads, the freeway, and all that to ensure she was safe with no problems. Maybe it is the bearing failing all of a sudden (it looked fine when I took it off). I have had a vibration at 55 consistently i think is the tires now that I replaced the ball joints (was waiting to have the tire shop check balance until after the repair) maybe that could be it?
View 3 Replies
Early 04 but 06 motor, Coolant filter, BPD EGR cooler, Head studs. I did use the search tool, overloaded with EGR cooler leaks and head gasket failure in the results.
Noticed ECT Spiking 217 (EOT 187)as went to post office,10 min run time from a cold start. Checked Degas a bit low, did my business and went home. Got home ECT 223 EOT(221) zero coolant in Degas and notice this mess. as well as puddling up under radiator.
I left the truck running and added some water to the degas hoping I could spot the leak, no love.
On our trucks do we have a weep hole for the water pump? I didn't notice any water or stains around it or the pulley. Nothing around the hoses either... yet.
Once it cools I am going to pull the fan shroud and look for a possible hole in radiator. Are there any other suspect areas?
View 7 Replies
I have an 11 F350 6.7. It has just under 200K miles on it. The other day I was driving home, about 100 miles, and my truck's temp spiked. Not like a little spike, but jumped to the 3/4 mark (if there was one) then slowly kept rising to to the overheat mark. I pulled off onto the hard shoulder waited an hour or so to let it cool down, then finished the drive home. All the way home my temp gauge seemed like it was on some sort of drug. It would jump a needle width when I would have to accelerate, then slowly cool to normal after I got up to cruising speed.
Up until this point this truck has been exceedingly reliable. I pull a 13k 5th wheel once a month and drive about 40k-ish miles a year. I also had to refill my degas bottle up to the fill line. Took 2 gallons of Ford VC-3-B Coolant and water mix. After a short run to verify the problem, it took another 1/4 to 1/2 gallon of mix. But, no overheating. No signs of leaks anywhere. Just a strong scent of coolant on shutdown outside the truck. Pressure tested the cap, I don't have a way of testing the system pressure.
Data from Autoenginuity:
Engine Oil temp 195-202 Degrees
Engine Coolant #1: 188.2-199.5 Degrees.
Engine Coolant #2: 125.5-129.9 Degrees.
I have the full CSV file.
View 6 Replies
i am recently a new owner of a 2006 6.0 F-350. So like any other used rig, it has its quirks. So the one that is bugging me to s the steering. It has been surging hard while driving. It mostly does this when cold. It feels like it's bouncing back and forth then I have to stop and force it from lock to lock. Once I do this it seems to stop it till the next day. I checked the PS reservoir and it's full. The power steering pump looks like it has a slight leak but doesn't seem to be a major issue. The lines going into the steer box are clean and no leaks...
View 8 Replies
OK, until I figure out what to do with the other truck I overheated, I've got another ambulance that needs some work, and I got to have a truck running.
This is the same config - 2006 E450 6.0 dually ambulance with 122K. Starts and runs; I drove it all the way to Houston from Minnesota when I bought it and made several shorter trips since with no problems except the AC compressor leaks freon. Then, I found oil in the degas bottle. A tech said it needs an oil cooler and he says there's some leakage at the rear main seal that's "common with this engine."
Can't recall reading a lot of rear main seal issues here. Is that right? Is oil cooler the obvious diagnosis for oil in the coolant?
View 14 Replies
2011 f350 CCLB... I want to wire a hitch mounted winch for both front and rear usage.
I see several 2 ga wire kits with quick disconnects, but was wondering which battery to go to, and which frame rail side to use. The exhaust side kinda worries me due to heat. Although the drivers side has the fuel tank, and I have skid plates blocking the inside of frame, so it doesn't sound pleasant either!
Also, best method to connect to the battery terminals. It appears the battery clamp screw is smaller than standard and wont accept a large ring winch terminal. Is there a "post doubler" available, or should I consider removing the factory cable clamp and replace with a set screw block of some sort? Hate to have a warranty issue due to a non oem battery clamp?
For the limited use, I have consider just getting one of the wiring kits, and adding high amperage "jumper clamps" and running the wire only when used?
View 6 Replies
I have a 2006 F250 with the rear driver side window that goes down but not up. I bought a new regulator and hooked it up to power before going through the trouble of removing the old one. It traveled down and wouldn't go up. The switch is working because I have power to it and thru it. What it might be?
View 5 Replies
So I went to the car wash this morning and when I pulled into the stall I heard a somewhat loud rattle coming from my front drivers side wheel. It sounded like there were a couple stones in the cap that covers the lug nuts. That wasn't the case. It did it in reverse also. Before I take it to the dealer Monday morning. Its a 2011 F-350 6.7 Lariat 4x4 w. 32,000 miles. I also have have a little whine coming from the rear when I take off from a standstill.
View 4 Replies
My left side rear blinker/ brake light is not working. The running/taillight side/filment of the bulb works, but the brake/blinker side/filament does nothing ! Just bought the truck used and it's my only issue, waiting on a owners manual, but I think each bulb is fused separate, and since half the bulb works, can I rule out the fuse and start chasing wires ??
View 5 Replies
I have a 2011 f250 crew cab lariat that actually sits about 3" higher on the passenger side in the rear. I never noticed until I put some 4" pro comp blocks on the rear. I measured before and the rear left was 40" and right was 41-3/4". Now the drivers side rear is 42" and rear passenger side is 45"? I have looked at the blocks to make sure they are seated properly and everything is installed correct so what gives? What could be causing this. I bought the truck with 99k miles and now it's at 130k miles. I do tow a small cargo trailer sometimes but it is only about 3k lbs. Now I am thinking of buying some new leaf springs to see if that corrects the problem.
View 4 Replies
have a f550 with a hpop res leak on the backside and wonder if this is in fact under any pressure when functioning since it has o rings on it as well.
View 2 Replies
I have an oil leak on a 04 f250 6.0 stock. It has 292000 miles on her. It started as a few drips on the pavement about the size of a quarter and now has escalated to a steady trickle. It's on the driver's side in front of engine running down the corner of the block and dripping off the oil pan. I pulled intake plenum and everything and I thought it was coming out of the valve cover but now it looks like its just under the valve cover. It looks like its coming out of the front corner of the head. Its wet there and looks wet around the glow plugs. I cant run it now as I've drained the oil and coolant. I don't have a gauge or anything and its plain stock.
View 14 Replies
My truck just passed the 3 year/36k by 2 days! I got it on 8/4/10 but it only has 27,000 miles of course I just found a puddle of coolant under the right front drivers side. After a little reading, I guess this is common. Should I push for Ford to fix it or get an extended warranty and turn it in on that or... Aftermarket yet that isn't half plastic like this stock POS?
View 12 Replies
