The oil and water readings on my SG have been gradually climbing for the last few year to where they are about 15* above the ambient temperature after sitting over night. My question is could the values for the other readings be getting high. For instance going down the road at 65mph my ICP was 1250 and my IPR was 62.
View 3 RepliesI have 2007 6.0, rough idle starts, rough and no power till engine reaches running temperature, runs great after that. If the engine is off for half hour, and restarted, runs rough again till engine temp is back again.
View 3 RepliesI have a 2003 Excursion 6.0. I didn't post this in the 6.0 section because it may not be just a 6.0 issue. (See what I get) On cold starts, anything under 150 degree water temp reading on the SGII. I get a CHECK GAGE light on accompanied by the check engine light. No codes read on the SGII pending or stored. Just some of the time I get a water in fuel light too. This tends to go out fairly soon after driving. (Even after I just drain the fuel pump it still happens.) other issues that accompany the lights are as follows.
The trans temp does not give a reading to the dash. The oil temp does not give a reading the dash. Both show proper temp on the SGII. When in reverse the back up alarm beeps as if something is behind me. And the auto door locks will not activate after 10 mph. The tach also will not show a reading in the dash. SGII shows the numbers. Now the kicker, this ALL gets resolved the instant the water temp hits 150 degrees. The only lingering issue is the that the tach will surge or drop every now and then. The tow/haul light does not come on when this is going on. I've checked the battery terminals all are clean. Both batteries are brand new.
I got burned with a smoker back in the mid 1980's and have been hesitant to come back. I am currently pulling my 5er and my enclosed gooseneck with a 6.2 gasser SRW. It has the 3.73 gears in it...not the best for towing.
I am thinking about ordering a new SD DRW 2wd with the 6.7 PSD.
Both my trailers are rated at 18000 GVW, what would be the best ratio to order? 3.73's?? 3.55? Fuel mileage will be what it will be with what ever ratio I go with. The truck will be mainly a puller. Not a daily driver.
I recently observed coolant temps of up to 217 degrees as reported by my mini max and oil of 230 as reported by the dash while towing 9000 pounds from San Diego to Las Vegas on the 15 going up the 16 mile mountain grade. My temp gauge on the dash never moved a bit, it stayed in the same spot from 199 to 217 so I assume its not too hot. My mini max defuel setting has the coolant temp at 220? I slowed down and tried to keep it under 210.
View 8 RepliesLooking at another 6.0. It's an 2005 with 156k. When test driving it on the scan gauge water temp stayed around 160 and don't believe it ever went above 170 if it even made that. Bad t-stat? Or a more significant issue? The other issue I seen that concerned me, is cruising at 65 for 10 minutes plus to check deltas their was up to a 20 degree difference so I'm thinking plugged oil cooler and bad egr cooler. Temps were 190 eot and maybe 170 ECT. Wasn't sure if the water temp issue affected the results on this reading or not.
View 14 RepliesThe water temperature in my 97 3 liter Aerostar seems to be higher than I would expect when climbing a mountain road with the aircon on full. It was only about 75 degrees F and the elevation went from 300 feet up to 2,400 and the gauge was at 3/4 to the red zone.
I don't use aircon much here in the south Bay Area but as I recall the gauge on both my 96 and 97 Aeros was straight up during such climbs. The 96 is out of coolent so I can't compare it now.
The reason I'm rather concerned is we are about to leave on a 2,500 mile road trip with 4 people and lots of gear through Nevada and Utah and we'll climb a lot of passes in 90 degree heat or higher.
The mileage is about 135k and the water pump was replaced about 2 years ago. The radiator was replaced at about 100k.
Ever since having the EGR delete done, the oil temp has been LOWER than the coolant temp. I am assuming this is bad info from the sending unit? They are reading with in a degree of each other at start up, but when at operating temp the gauge will read lower. Before the EGR delete I had a delta of about 4-7* oil hotter than coolant.
View 1 RepliesYesterday I noticed when I parked my truck the Speedo was reading 10 mph. I drove around a bit and used my GPS to get my real speed which was 10 under what the Speedo read. I parked the truck for the night and in the morning nothing had changed, I drove for a bit and all the sudden the Speedo worked like normal.
Later that say the Speedo got stuck at 50 mph and now when I stop it reads anywhere between 50 to 60 mph and goes up from there. When I'm doing 30 mph it'll read 80 to 90 mph. Cruising on the highway it reads well over 100 mph.
I've done some reading and it seems like it either the cluster or a speed sensor. My cluster has had a lot of problems lately of not working at all, no gauges work, radio turns off and the Windows don't work but a good slap on the dash will fix that most of the time.
What are the most favorable low-side/high-side pressure readings for the AC when fully charged?
View 7 RepliesI recently bought this Ford F250 6 with 117k... I've had it 3 weeks and it is now at 120k... My Odometer is reading Fast. From Tucson to Phoenix it read 302 mi, on my trip monitor it read 102 mi.. I've made this trip many times before and 102 miles is about right. It's a big issue because I get paid by the mile.
View 13 RepliesI tried searching here for a pid to get oil pressure. Can't find it. Is it possible to get oil pressure readings on these motors? I assumed it would be because we have a dummy oil pressure gauge on the dash. I thought it would be in the pop up list of gauges on Torque but I didn't see it.
View 6 RepliesI'm just curries as to the highest millage on a 6.7. I have a 2011 and only 36,000. My 7.3 had near 300,000 when I sold her and the engine was still running strong. Wondering if the 6.7 has that same longevity.
View 14 RepliesI've had a scangauge on my truck for years and today while on vacation I noticed the voltage was fluctuating between 12.5-13.5 while driving. It has always ran at 13.5-13.7 .... I checked it with a fluke and it is a solid and steady 13.8v at idle. Why would that gauge be fluctuating like that? Truck seems to be running fine.
View 6 RepliesJust changed the fuel filter in my '04 6.0, no issues worked just like normal, filter primed truck started, great. Well now my fuel pressure gauge is reading dead 0, I know that can't be right because the truck is running, but noticed my fuel mileage seems about 2 mpg lower all of a sudden. Had R&R Injectors installed about 40k ago, figure it's just a bad gauge but wanted to check and see before messing with the frickin wiring. Also, have had a lot of pressure buildup in the coolant tank, has had head gaskets and studs, anything else it could be besides head gaskets? Have had a lot of wiring issues with this truck from the previous owner....
View 14 RepliesI have an 07 6.0 diesel and I'm having trouble once it gets hot. It begins to lose throttle response and shakes while cruising and also has a rough idle. sometimes it dies while idling but after cooling off for a few minutes starts back up and runs fine. I've checked the high pressure oil and the ficm and both of those are fine. I've done an EGR delete so it has nothing to do with that either. My MPG also goes way down when this happens.
View 5 RepliesI know they're supposed to be within 15 deg of each other. How bad is this? Pulling a small trailer with a polaris rzr on it. Running 75mph
View 14 RepliesThis is not on my truck. This is on my buddies 04 we just did the egr delete and oil cooler and a bunch of other stuff to.
Coolant temp doesn't go past 170 which I assume a new thermostat will fix this issue no problem.
but, the oil temp never goes past 140 no matter what driving for an hour at 70 and it doesn't change.
Bad sensor? Or would replacing the thermostat bring the oil temp up to where it should be?
To start off. I have a 2004 F350 with the 6.0 in it which just had a top end rebuild done on it due to the head gasket blowing on it. During the rebuild the EGR cooler was also deleted, ARP head studs, Heads were milled down to make them flat (shop said they had to take 9 thousands off to do so), new up pipes installed, new back pressure sensor installed due to the plug head snapping off, new glow plugs, new glow plug rail harness, oil rail rebuilt due to bad o-rings on the ball tubes, injectors were installed with all new seals and had polished the spool valves hoping to avoid stiction (however its spelled can never remember), and lastly the EGR was deleted electronically with tuner. Also had to get 2 new batteries as they were stone dead and would not take a charge. And had to get a new alternator due to low output. Not sure if the alternator killed the batteries or the batteries killed the alternator either way it needed replaced to.. Unfortunately after i got that fixed i had to get a new starter as it died 3 days later.
Ever since its gone back together Ive had a consistent intermittent miss with the truck. Ive searched every article i can find but seems most complain about misses when cold. Mine is the exact opposite as it only does it once the engines up to normal operating temp. It accelerates hard and fast like it has no issues. While its cold it doesnt miss at all. Once its warmed up sometimes while cruising it will feel like its missing on every cylinder or better description would be as if your driving on a cobble stone road.. If you mash the pedal for a couple seconds till it kicks down and raises the rpms it stops.. Its most prevalent at idle though.. You can literally hear the difference in the engine when it starts missing. Truck will shake as if its got a large lopey cam. Odd part while sitting at idle it will cycle back and forth between running smooth and missing. But same with at cruise as soon as you get on the throttle it goes away. If its doing it while sitting idle at a light, it will take a couple seconds once your on the throttle for it to smooths out. But always does.
Ive tested the Ficm hot and cold, KOEoff and KOEOn.. getting a steady 48v from the main board.. Scan gauge says the Logic boards reading steady 13v... Also from the scan gauge it says my ICP pressure is in the 640 range at idle (full throttle highest ive seen is 3600psi so dont think its a pressure leak) and volts bounce between .80-.90.. but oddly once it starts missing the ICP pressure jumps up 20 psi.. IPR at idle reads 23.5-25.5.. at cruise its up around 45ish.. fuel pressures said to 70 psi.. which its usually around that most times, cruising itll be around 66psi. I had 3 injectors replaced not this past spring but the year before (ironically same symptoms).. Injectors 5,7,8 were replaced then.. ICP sensor was also replaced at the same time as it split and shorted out the connector which was the initial reason i took it in that time since it was dumping the oil on the ground.
I dont have any way to perform a cylinder contribution test and after spending 6K on a rebuild I really cant afford to take it in to have someone else do it. A local guy was able to scan the truck for me but he couldn't do the contribution test either but was able to buzz test them. Everything passed there but we also found some hidden fault codes my code readers did not find. The ones we found hidden said that injectors 2, 4, and 7(again??) are reading low contribution. Of what I've read 2 & 4 sit on either side of 7 in the firing order so have wondered if they're not pulling down 7's results.
I really cant afford to replace the injectors till near the end of next month. Is there anything else I can look at that might actually possibly be causing false readings or intermittent misses only when warm.
My dad's 03 has had some work done after his oil cooler was clogging. New oil cooler, egr delete, head studs etc. The oil temp seemed to run some what high when he got it back. After a couple interstate runs on cold days 15-20 degrees, the water ran around 185 and oil as high as 218 but usually a bit lower. What's going on here? how could this thing be clogged again? It hasn't seem to gotten much worse since we got it back but not better either.
View 8 RepliesI've been searching for a while now but have not found an exact match to my problem.
So, Yesterday I was pulling a large load home (15K lbs) over flat land/small rolling hills and I experienced a coolant temp spike. And I am trying to figure out what caused it. I was traveling 65 mph about 2k rpm and 20lbs of boost, I was motioning the ECT, EOT, TFT, and Fan Speed via my scanguage and 99% of the time the ECT was in the 209-220 range, once it got up to 220 the fan would come on and the ECT would drop to 209 ish pretty quickly.
However, twice the ECT shot up from 215 ish to 240 within seconds then the dash indicator said check coolant temp then the fan came on and cooled it down to 200 within seconds, I did lose about 1/2 gal of coolant. So today I'm going to get a new degas cap (still OEM original) and continue to monitor the situation.
My EOT ECT delta has been a constant 10-13 degrees for the 3 years i've been monitoring it so i believe my oil cooler is still functions within spec and all my cold soak temps are within a degree or two for various ambient temps (20 -80) so all my sensors should be good.
Also, tonight I'm going to pull the EGR valve and check if there is any coolant in the intake, but if there is not, where should I start looking and what should I start worrying about e.g. head gaskets?