Getting an occasional tea kettle type sound when towing. Immediately thought head gaskets but no coolant loss or residue on the degas bottle or cap, no change in coolant level. If I just back off of the throttle it will go away immediately and may or may not come back on the trip.
View 12 RepliesWhat is the source of the sound? Listen for the clunk b/w 3 and 4 seconds. I just dropped off my 2016 Super Duty 6.7 CC LB 4x2 at the dealership. I'm afraid that they will say the sound is a characteristic but I never had the sound on my 2011 Super Duty 6.7 CC LB 4x4. This sound happens when I go from drive to reverse or when using the exhaust brake when towing. The sound does not exist when the transmission is cold only when it is fully hot. It will also make this noise when climbing a really steep hill in first gear with fiver and the torque converter needs to slip a little.
As far as I can tell all of the u joints are tight and the axial support is tight I only have 2000 miles on my truck.
[URL] ....
I'm having a squeak/rattle type sound coming from my front drivers side wheel (more rattle). It only happens when I go over a quick bump and happens going straight and while turning. 2012 f250. 87k miles. 4x4. I have a two inch block level (southern truck) up front..
View 14 RepliesLast year while towing my fifth wheel to the North Rim of the Grand Canyon my oil temp went to 260 degrees several times. The outside temps were 95 degrees at the start and it is a long steep climb with a heavy load. Each time I pulled over for a bit, as I couldn't remember at what temp that plastic thing inside the oil filter melted. Each time it cooled off fairly quickly but it really stressed me out. So how hot can the oil get. I am using Rotella T-6 and my temp different is only 12-15 unloaded. Could I allow 280 for 15 minutes or so?
View 11 RepliesMy dad recently bought 2006 6.0. He has had it about 2 and half months. Has the egr delete kit installed. The truck has ran great. Up until Wednesday the 3rd. My dad headed to Ut to pick up our new quads. While heading up a small grade with empty trailer in tow. Truck went to limp mode, fan kicked on, orange wrench came on on dash board. He pulled over let her cool down turned her off.
Checked fluids Then started her back up and she was fine. That has happened 3 times. Now he is on his way back (tow haul mode turned on) and it is doing it again. She hasn't went into limp mode yet. As soon as the fan kicks in my dad pulls over immediately and puts it in park. And lets her cool down checks fluids. This issue only happens mid way up a grade. So my question is...... What is causing this? How do we fix her and make her a happy truck again.
I have a 05 6.0l that started over heating while towing recently. In 2012 i did egr delete, oil cooler, stc fitting, and coolant filter. I recently changed radiator and tstat think that was the problem due to small leak in radiator, but still towing about a 4-5k load temps rise to over heat while towing. What to look for next. Also fan seems to be work properly I monitor fan speed etc., and tft on my scangauge.
View 14 RepliesI have an 06 F-250 with 122,000 miles. When driving empty at 70-75 mph the coolant temp runs 194-200 and the oil temp 5 to 10 degrees higher at the most. When I pull my travel trailer the coolant temperature will start to steadily climb then abruptly drop down under 200. I have seen the coolant temperature pass the oil temperature when this happens.
The last time I pulled the trailer I was driving at 60 mph and the coolant temperature climbed to 220 then dropped to 196. A few miles later it climbed to 230 then dropped to 200. While the temperature was climbing I slowed to about 45 mph. As it was dropping I accelerated and the temperature continued to drop.
I have flushed the cooling system, replaced the thermostat and cap with no improvement.
The pickup has an SCT tuner set to street 1 and I was told by the previous owner that the egr was deleted, but the stock egr cooler is in place. It is possible that a plug was put in. I pulled the egr valve and the carbon coating on it is gooey like it has been wet.
Just looking for comments on using the cruise control while towing? and what's the recommended weight for using the tow haul mode. The enclosed trailer I have is about 3300 lbs. taking it across the country empty. 2004 6 liter.
View 11 RepliesI have a 2006 f250 bulletproofed for about 5 years now with no problems other than normal wear and tear. I had the factory water pump go out a couple months ago so I decided to go with the bulletproof diesel pump for piece of mind now I do tow anywhere from 8K-15K about once a week with custom Gearhead tunes using SCT.
While I was changing water pump, I ordered low temp thermostat figured it would work with towing temps even though they weren't that bad to begin with my deltas always around 10-128.. Now i am seeing signs of puking out degas bottle, I replaced cap seems to work a little the truck doesn't puke unloaded unless i really get down on it.
I noticed the other day while towing I was cruising with TC locked in at around 55 mph and i watched my EOT 210* and ECT 205*, the n ECT started climbing up followed by EOT then at ECT 222* fan came on ECT finally hit 234* and started dropping fast while EOT never got over 226*. ECT would level out at 188* go back up to 205* and stay there for awhile and do it all over again...
What is going on. I've talked to a could mechanics and they aren't confident its the HG..
I was towing the 5er (about 15000#), across Southern Mn and SD today going right into a 20-25 mph wind in upper 90 temps, saw 228 on the oil temp and 199 on the tranny temp. When tow need to see for warmest temps and at what point you start to get concerned...
View 10 RepliesTook my first camping with 2012 King Ranch F350 and 37 feet Challenger 12k fifth wheel trailer over the weekend.
I noticed there is lot of transmission slips in first gear. Once it enters 2nd gear, no more slips.
My previous Chev 2008 2500HD diesel didn't slip much with same trailer.
Is this normal for this F350? My rear ratio is 3.55. No slips without hauling.
Maybe I need to ask dealer to check 1st gear towing?
I've got about 1100 miles on my new truck now and I will be heading to S.D in a week or so towing my car hauler with FJ40 on top and camping gear. About 10 000 pds.
Would it be wise to dump the factory oil and go with 5w40 Rotella? It has been getting really hot here the last two weeks and its only getting hotter as I drive south.
Over the holiday weekend I towed my 13k# 5th wheel 180 miles to the campgrounds.
According to my Torque Pro app, soot was around mid 30% when I left home. Upon arrival it had passively dropped to single digits.
After driving unloaded a few times over the weekend, the soot level had gone back up to mid 30s.
While towing home it again had passively dropped back to 1.1% .......... then boom! A regen starts.
After 22 miles it completed and soot had dropped to -13.2%.
So towing heavy, passively burning soot off, exhaust temps in the 700-800 weren't good enough for the system.
It had to start a regen and boost tempts to the 1100-1200 range WHILE TOWING to basically burn off NOTHING.
Not to mention drop my already poor MPG to single digits.
Just venting about what appears to be unnecessary exposure to high temps and wasted fuel.
I was towing a fairly heavy trailer yesterday (around 10k) and laying into the throttle to gain some speed before a big hill when I completely lost power. It slowed me down to about 10 MPH.
I was able to drive home at very slow speeds and the only way to get over 10 MPH (only up to about 20MPH was to very lightly accelerate up to speed. Any hard acceleration and it cut me off to 10 MPH. No warning lights of any kind going off...
Truck has a Hypertech Max Energy programmer on stage 2.
2013 6.7L F-250
The owner's manual recommends idling for a period of time after towing to allow the turbo to cool somewhat. After towing a 10K lb travel trailer in the mountains, what temperature should i shoot for as sufficiently cooled? When towing the oil to averages about 210-215-F. Normal operating temp is about 190F.
For the last couple months when not towing I take the front tires to 65 psi and the rears to 50 psi. It gives me the warning light which I click OK to every time I start it. This weekend I put everything back to 80 psi getting ready to tow and I can't get the warning light to go out anymore. I double checked my pressure to make sure everything was OK and it was. I will be taking it in unless someone knows a reset or something else to check out before I do.
View 8 RepliesI have a 2006 F-250 Super Duty Diesel that I just purchased. Of course there is no warranty and of course I am not that familiar with trucks or cars for that matter. I bought this to tow our 29 ft trailer, which weighs roughly 7000 and should be no problem for the truck. The first 5 times we took it out everything was good and then we took it out and had a short but steep incline and the truck started over heating.
After unhitching the trailer, I drove the truck again and it runs great, no overheating. I even went to the same hill and everything was fine. So, I took the trailer out again and the same thing happened. What this could be? Since I am so unfamiliar with mechanics of things, I really don't want to get ripped off. I have read the troubles with the engine but don't want to spend the 6-8k to rebuild if not necessary.
In the last 3 weeks I've replaced the oil cooler. IPR, ICP, fan clutch, intercooler, rebuilt the turbo, new elc coolant, egr valve, thermostat, new batteries, positive battery cable, and alternator and a host of other crap. Now I have a new problem.
When towing it overheats, almost instantly under load. I was towing a 9k trailer up a hill, a total of about a 30 second climb and it overheated (242 degrees). I'm thinking head gaskets at this point as they are stock and have the tty bolts installed.
My truck has been awesome. I tow about 16,000# behind my F350 about one weekend a month. 80% of the time my trips are 150 miles or 700 miles round trip.
Over the last three trips while towing I've noticed that the upshifts are not as smooth as they used to be. They used to be really smooth. Impressively smooth considering the load. Now they are rough.
Planning to have them check it when I go in for service next.
Towing a 5th wheel at about 10,000 lbs total. Towards the end of out 9 hour trip home and going upgrade the truck begins to loos power and the engine starts making some bad sounds. Although its hard to hear it starts about 45 seconds in and continues later when going uphill. the truck also made a very high pitched squealing/scraping sound (not a belt) like it may have been coming from the turbo. Oil temp was about 220, trans temp at 170 at the time of the event.
Truck has 216k, stock, upgraded trans cooler, original fuel pump.
Here is the video : YouTube.....
Now that I have gotten my ScanGauge II to monitor all 4 egt sensor, I am wondering about temperatures while towing, especially how long to idle a hot engine after heavy towing.
I realize all 4 sensors are post turbo (and there is no chance I'm going to drill for an after market pre-turbo sensor). It seems the first one downstream will be the one to watch.
What temperature range we should look for before turning off the engine? IIRC, Ford recommends idling for 3 to 5 minutes, but watching the temp seems a bit more specific.