I went out to the store today all was fine came back out and started driving got 2 miles down the road to a red light and the truck about stalled no power it doesn't smoke at idle but revved up it blows black and some white and the truck shakes. I am thinking its stiction or bad FICM????
View 13 RepliesWell my problem went from bad to worse. My 05 started running rough at idle, then smoothed out a bit but started smoking on acceleration a little. At this point it felt like it had more power than ever before and even ran smoother running up to 3k RPM before shifting (manual transmission). But now it's smoking so bad, I can't really drive it. It's smoking white or gray at idle but blowing black smoke on acceleration. I had a cylinder 5 contribution code but with the amount of smoke it's hard to believe only one injector is a problem. I pulled the EGR valve and it doesn't look stuck open but I'm going to replace it anyway.
View 3 RepliesToday I was riding along and all of a sudden I noticed a loss of power. I look in the rear view mirror and get into the pedal and a lot of black smoke. When I get to where I'm going and stop I noticed the idol was a little loopy. I never saw a check engine light. I have the Edge insight. I had two codes. P1000 OBD System readiness test not complete. P2290 ICP TO LOW.
When I would reset the codes the P1000 came back instantly every time. I parked the truck for about an hour. When I started it back up everything was normal. The power was back and no smoke. This happened two more times throughout the day. I have heard people describe a sticking EGR Valve causing these symptoms. Is that where I should start looking or is the ICP the culprit or something else?
I have a 2003 with 150k miles. My 6.0 has black smoke and can barely crawl up a hill. Dealership is 30 days out for an appt. Air filter, oil change, alternator, and batteries are new. I removed the EGR valve and cleaned, but the valve seat is not perfect. I can see 20 to 30 mil gap around half of the seat. Is this ok or will that little gap cause this?
Hoses all look good. No alarm lights. I have no diagnostic tool but I can use a meter well. It did have an airbag light but I found the fuse missing and replaced it. The air filter alarm switch fell apart but I bypassed it till I get new part. No alarm lights now.
So I am not sure exactly what is going on with my truck. It is a 2004 F250 has a 6.0 L. Sometimes when I take off from a stop the truck has no power and blows some black smoke. Then the turbo kicks in and all is fine. It comes and goes when it pleases no matter the temperature. What started happening is when I drive it a steady pace on the highway sometimes the turbo gets quieter and louder and quieter and louder sometimes when it gets quieter I see a little bit of black coming out of the tailpipe. Sometimes it doesn't do it at all. Also sometimes when I let off the gas the truck sounds like it's trying to laugh at me like a wastegate is fluttering.
View 10 Replies05 6.0 deleted and studded. 170k fresh filters and oil, no CEL or codes.
This has happened 3x in months, so it intermittent. Truck will start fine cold, except for this last episode ....
Truck starts right up, idles correctly, speed bumps up if its cold enough to trigger the high idle. About mid way through its warm up, at approx 130-140 idle falls off, barely runs. Almost knocking. Black smoke if you give it throttle. Has no power when its doing this. Truck will not move and almost dies in gear. Give it til 185ish degrees then pooof! All good.
However 2 days ago it wouldn't start. Cranks but won't catch. Stumbles and dies. Finally got it to start after setting the charger on it. I killed it. But this time when it started it was straight into its rough idle, no power...until about 180. I switched it off, restarted it and it was totally fine
Ficm is 47-47.5. Every now and then I see a 46.5 for a split sec
Hpop is 700-800cold cranking.
Not sure what else to look at.
Moto craft filters.
Amsoil 5w-40
Archoil in the fuel and oil
Twc3 at every fill up.
I bought a 2004 power stroke with 100k miles, ran well for 15k miles then started having low power for first few minutes to no power, regular oil changes and fuel filters at 5k, checked FICM 48v KOEO , 48v cranking, new batteries just in case. Oil pressure when cranking at 50% of gauge , even crank cycle will jump when trying to fire, no loss of coolant, block heater working, it did start a few a few times and blew white smoke until warm then full power but the last 2 times I did get it to start it ran for less than 1 minute and died could not restart.
Fresh fuel additive in both fuel and oil for stickshion, have read hundreds of posts but not seeing similar problems no codes. With key cycle 120 amp draw on passengers battery for approx 25 seconds 48 amp on right battery glow plugs good due to the amp draw? So I think my FICM is good, good oil pressure cranking, the oil pump should be good, ICP good? Because of gauge coming up? Everything I read says black smoke for EGR soot issues. Not sure where to look.
it's now 1,500 miles away on the side of the road.White smoke, knocking and lost power. Truck has 133,000 reman engine installed at 46,000. Is it common for hydro locking to bend a rod? He sent a video and it def sounds like a rod and degas is empty.
View 9 RepliesI have an 07 6.0 with 400,000 miles. Has been a great truck with no major problems. Before I started the work I had 3 bad injectors, running rough and the oil/ coolant temp just outside of 15 degrees. So I tour her down and replaced head gaskets, installed arp studs,all new injectors,all new glow plugs and new oil cooler. Ran great for a couple days. Then when driving to work lost power on and off for a few miles then completely gone could only go 10 miles an hour. I checked codes and there was the under boost code witch has been on there for a while and I forget the other code but it was for the ipr valve so I replaced the valve and right after still the same but that code went away and the p0470 popped up. So I cleaned out the ep sensor tube and replaced the valve. After several miles she now runs great but now I'm getting a little puff of white smoke when I take off and not every time and mainly when I take off some what quick. All codes are gone expect the under boost. I have an egr delete already.
View 7 RepliesI picked up a 2003 6.0 awhile back went ahead and did studs,gaskets, delete. Was driving it and seemed to lose power, started coughing and carrying on blowing bluish white smoke then shut off. Ended up hydrlocking #5, Oring on injector was tore when took out. Put all back together, ran horrible, did a balance test with AE, showed #3 injector, replaced, ran horrible, did AE dropped #1 injector. So in process of replacing the rest of the injectors. Just wondering why it is or was dropping them 1 at a time. Ficm was showing 47.6 to 48.6 volts, could that be it?????
View 14 RepliesStarted with lots of black smoke all of a sudden. Not under any significant load at that time. Reached destination (barely) and started the search. Have taken off blue connectors on CAC passenger side. Top is marginal but see no holes. Pulled the MAP hose and see nothing unusual. Have not checked the driver side CAC or the BPV sensor. Have a ScanII device that shows no codes. Got my other scanner and it too shows no codes.
Had it towed home over 100 miles 'cause now it just barely runs. Idles fine but have a engine noise change (deep and hollow) every once and a while at idle. EGR leak? Doesn't blow black smoke anymore. More of a white/blue. Exhaust smells odd. Absolutely no turbo activity. When shutting hear no whine down of the turbo. No boost evident on the dash or on the scan II. I am at a loss at this point. Will check fittings again.
I just looked back and it has been since July 7th that my girl has been sitting in my shop. Well this past weekend I finally got her back together and started. It took a while to build pressure but she finally came to life..
While I am thrilled that she is running again i have low power before the boost kicks in and is idling rough with a blueish- white smoke coming out of the exhaust. Once i kick her a little she will get up and go but I've never had the smoke before.
I'm thinking maybe a bad injector???
6.0. 115,000 miles. Everything stock, except bully dog intake filter.
I replaced the FICM recently, with one that I bought from the guy who makes those cool You Tube videos, Diesel Tech Ron. I also replaced the EGR valve. I also replaced the intercooler boots on the hot side. I cleaned the intercooler pipes. I cleaned the intake filter as well. I'm still blowing out black smoke, if I floor it when I need to pass someone.
Follow up question: I bought those boots from Riff Raff Diesel and I bought new clamps, too. I'm not sure if I installed correctly. It's already blown one off (it blew the top of the intercooler pipe off, by the turbo, but the boot stays on the turbo) and I put it back on and tightened it all the way down, and I've had to re-adjust 2 times, now, since it acts like it still wants to slip off. Do I simply have the other ones misaligned???
So I started to NM from fort worth texas with my 33" camper blew my CAC pipe four times. Finally got there. In the morning it took longer than expected to start. When it did white smoke. That was replaced with black smoke under full throttle.
I went from elevation of 700 to 8000 Ft. Should I care about black smoke? Meaning should I take it to Ford and get a rental car to get it looked at for our trip home.
96 degrees towing at 70mph with lots of climbing mountains.
1st Ford was an '08 to '10 model F250 6.4L that had an engine fire on I-82 towards Ellensburg in the passing lane.
2nd Ford was a 2005 F-250 6.0L at Vantage, he had black smoke coming out of the exhaust and a terrible engine knock, and was pulling a 32 ft TT. When I went to go talk to him, he had no idea what a ScanGauge was or anything about the truck.
When I looked at the engine bay with him I saw the EGR valve had been deleted with a block off plate and not plugged into the fan hanging on the side anywhere, he had the high rise aftermarket oil cap installed, ALL the metal/aluminum parts had bad oxidization. He had no gauges whatsoever.
Then to top it off, he said he was going to try and make it to Ellensburg while pulling his trailer. I told him he had a 4% grade for 10 miles in front of him to climb, and the another 35 miles after that on flat ground. All I could feel was, "is there any hope for this guy"?
Anyways, my question is, without any gauges, what would be some good educated guesses with the black smoke and knock? I am mostly just curious what this guys issue might of been with his truck since seeing the symptoms first hand.
My thoughts are the oil cooler leaking, and making the injector(s) stick open.
Of course now that I think of it, there's probably too many scenarios to mention.
Driving home 2003 6.0 started blowing a ton of black smoke, cars wouldn't get behind me. Found an exhaust leak on the driver side up y pipe. Would that cause this much smoke? 2 codes were 0284 and 0281, I replaced those injectors about 10k ago, at the same time replaced turbo, hpop, egr valve and cooler delete, and new oil cooler.
View 9 RepliesFound a 2004 Ex, Eddie Bauer edition says it has injector issues, blowing black smoke........ It is apart cause he thought it was the EGR. Has 245,000 on the clock. If the body is super clean I'll give him a offer, it's going to get a motor either way and I'll have my Ex back.............I really miss that truck!
View 2 RepliesDuring an out of town trip today, 6.0L 2006 started burning black smoke when accelerating. Was bullet proofed in 2013 without replacing injectors. Running a SCT programmer. After getting home I connected the tuner and didn't have any DTC's. Checked the oil, didn't smell any diesel on the oil stick. I was running the street tune, so I changed to the performance tune and it doesn't seem to be smoking as bad. What could be going on? This site has always came through for me (a non mechanic) when troubles start.
View 14 RepliesI have a 2004 f250 i purchased a month ago. Its been cold in Denver this last month which is why I didn't mind it much. But now that its been in the 70s im concerned. Its always the first start up that it acts up. I go to turn the truck on and it starts idling for only a sec or two, then shuts off. I crank it about 3-4 times before it actually comes on and stays on. There is black smoke not white smoke once it starts to idle. Once idling it stays on and drives the way it should. If i try to start the truck again it will do so with out hesitation. I just did a tune up at grease monkey including fuel filters and oil filter. again its the first start up always.
View 1 RepliesBlack smoke is bad I think, especially when I push on the gas pedal, and I hear a bad whine or something that sounds like a very loud power steering pump whining.
I also have zero on the boost gauge. The truck barely pulls itself back home and black smoke is dribbling out of the exhaust pipe.
My truck is an 03 and I changed number 5 injector and number 4 injector, checked my ficm everything is good there now I have a contribution balance code for injector 4 now injector 5 and an EGR code some guys on hear before said it could be a sensor but today I talked to my mail man who also owns a 6.0 and he sounds pretty knowledgeable he says it's possible that it could be that the computer is not reading out right and those cylinders are getting to much fuel for an instant that's what's causing the sudden puffs of black smoke. My torque pro is giving me all these codes and I'm starting to think that there is something underlying....
View 10 Replies