Is there one fuse for the entire instrument cluster? Because today the entire instrument cluster went dead, even the digital odometer part. Hoping it is just a simple blown fuse...
View 14 RepliesMy 06 instrument cluster has a few bulbs that are out. I have seen the video on how to remove and send off to be repaired but have not seen any thing on how to replace bulbs. Is this something that I can do myself? Is there "kit" to replace all the bulbs? Where can I get the bulbs? Here is a pic of my panel.....
View 14 RepliesI've been searching for instructions/procedure on how to remove the instrument cluster on my 2006 6.0 Superduty. My odometer has been showing the classic signs of a cold solder joint, cutting in and out constantly. It's been doing this for a couple of years, and I've taken it to the dealership, since it's still under warranty, however they were not able to find the problem since they were not able to witness the lighting go off and on. I figured I'd just do it myself and not even bother with the dealership if I don't have to. I've read the threads on how to fix the issue, however, everything I've found is for 2004 or older models. Are there any threads specific to the 2006? Or, is the instrument cluster on the 2006 the same as another year model? Maybe I can find this info. there.
View 9 RepliesI have a 2013 F250 with 49.575 miles and Saturday the truck left me stranded. I was towing my small trailer and doing about 45 mph.....When just out of nowhere .....I got every possible warning come across my display and none of my instruments were working. That included speedo,tach,boost....even the radio and ac were effected in some way. So after a few miles I was able to pull over ....cut the truck off and it wouldn't start.... So I had Ford roadside service tow it to my home dealership.
View 13 RepliesSo, went to drive the truck (2004 F250 6.0, 145000 mi) yesterday and the right half of my instrument cluster was not working (tach, trans temp and water temp), CEL and check gauges lights on. My scan gauges gives me readouts of all 3, so I know the computer knows the right values. Pulled all three fuses related to the cluster, all looked good. All gauges, including those not working, did full sweeps with key on after putting fuses back, so I know they function. Also, the glow plug light stays on way longer than normal.
View 2 RepliesMy right side of my instrument cluster is not working. the Tachometer, Engine Temp and Trans Temp gauge are non responsive, and the CEL and Check gauge light is on. I have seen other posts with people that had the same problem but no solution to what fixed the problem. 2004 F250 Lariat.
View 4 RepliesGot in my 06 F350 dually 2 weeks ago and after start up had no instrument indications. Truck ran great, flat line on panel. Tow haul light out also. Drove it for appx 5 miles, shazam all start working and then they cycled on and off for a while. After 10 miles, came on solid. Happened again at a later date.
Here's what I discovered. I noticed high voltage on my Scangage II. As in 16.2VDC. Monitored it coming back from a hunt. 14.9-15.5VDC. Would blank out only after hitting 16.2VDC. I'm suspecting there might be a cutout to protect the instrument cluster from damage.
Installed a new alternator on Friday the 13th. Drove home this weekend, 4 hours and no problems. Hopefully didn't boil off the batteries. Now 13.5-13.9VDC ... Just something to be aware of!!
I have a 2001 1.8t Passat that won't start. The story starts about 6 months ago with occasionally (maybe once a week) finding the clock and trip odometer reset. Figured It would eventually get better or worse. Then once last week I lost power to the instruments completely when driving, The tach and speedometer dropped to zero and returned to normal in a second. Yesterday on the way to work that happened again several times, but it never effected the drive-ability at all. After work , went to leave and the dash doesn't light up and is dead silent when turning the key even the clock and odometer are blank ,the Traction control light is the only response on the cluser. It won't crank, the power windows and sunroof also won't work. Most everything else is normal, blower motor, headlights and interior lights, blinkers, door locks, all work, radio powers on.
Here's what I've done so far. Removed the negative battery cable to see if a reset would work. No change. Checked every fuse I could find, no bad fuses. Replaced the Ignition switch, no change. Have 12.05 V on the red starter wire in the crank position. After replacing the ignition switch, the radio now displays SAFE --- 0001 and doesn't do anything else (not sure if that means anything). I have reseated all the relays under the hood, and under the dash. No change. Wiggled every part of the wiring harness I could get access to to see if that changed anything. No change.
I'm now expecting the solution to be the wiring to the CCM, the instrument cluster, or the CCM itself. Going to try push starting it tomorrow, If that fails I'll have it towed home and get back to taking things apart Friday night.
I just bought this 2006 f350 lariat. The instrument cluster, radio, pwr windows (and prob other things) will go dead intermittently. No rime or reason, some days no prob, others, several time a day. Always come back by itself, cycling the power has no effect. I if it is shut down during a no power episode it will not run right till the power comes back to the dash, radio, windows. Looking on line seems to be a common problem with the "retained power accessory relay" circuit in the instrument cluster. I found nothing on a DIY fix...
View 14 RepliesSo, on my drive home from the pub tonight, my clusters went dead, then came back on, then died again. This behavior repeated for the 5 mile drive home. In addition, I believe the lights weren't working as well. The engine was still running, so I simply continued on home and parked for the night. The only thing I can think of might be the problem is the fact that I replaced the serpentine belt the day before yesterday. Is it possible that the alternator is not charging the battery properly and that is what my problem is?
View 14 RepliesI was installing a brake controller and repair wiring at the seven pin today for a customer and noticed when I began work I have no power windows, power seats, or instrumentation on the dash. Truck otherwise runs fine.
Got wiring for the brake controller straightened out and thought I could get the other stuff working, but I went through all the fuses and could find nothing amiss. Several comments on the Internet about a power saver relay board built into the back of the instrument cluster. Does that fit these symptoms?
I have 2002 F250 4x4 with 5.4 V8. It has auto locking hubs. If I haven't used the 4wd lately I have to manually lock the hubs in, right side sticks, so I have to use pliers to lock into place. After a few times it works in auto fine. Anyway my issue. I went to use my 4wd so I manually locked the hubs, hopped in the truck and flipped it into 4wd. When I did the instrument cluster died. Radio, power windows and locks, turn signals all work. I just don't have any speedo, tach, fuel gauge, water temp, battery, no odometer. All went blank. I checked some of the fuses that I thought it could be from the owners manual but still no luck.
View 3 RepliesI pushed the Tow/Haul button on the gear shift and my instrument cluster went DEAD. Have checked the 3 fuses labeled instrument panel (F4,F35,F41) and they look OK.
2003 F250 6L diesel .....
I have a 2000 f350 XLT SD v10 gas. The radio works, the heater works and the power windows work too. It's just the cluster. Lights work in the cluster it's the gauges are dead truck starts fine.
View 2 RepliesSo I recently bought a 2002 volvo s60 base sedan with a dead instrument cluster. I sent it out to be repaired and when I got it back and plugged it in, it did not work. At first I thought it was the company who repaired who messed up, but I looked up the numbers on the cluster and it is out of a 2001 Volvo. I have no way of contacting the previous owner to find out if they tried swapping out the cluster with one from the junkyard, or if they have the original cluster.
I don't know what to do because I cant send the cluster back to the company since I don't know if its the original one or not. Is there any way I can find out what the original numbers are on my cluster. Is there any way to find out the original numbers on the cluster using my vin number? I called the volvo dealer and all they gave me was the part number for a new cluster.
I am currently converting a 1999 E350 7.3 diesel bus into a camper to live in. The bus has already had a lot of weird custom work. Done by someone else and a lot of the interior torn out and extra insulation put in. There is an exposed electrical panel behind the drivers seat. It was a cheap buy, previously fleet maintained with only 120k.
I was hooking up a battery for accessories to a terminal labeled "Battery" that does run indeed directly to the + terminal of the battery in the engine compartment.
Unfortunately I mistakenly connected the accessory battery to a terminal labeled "ignition" that runs to behind the dash. When I tried starting the vehicle off the auxiliary battery for a test everything went out for 2 seconds, I heard a click from the engine compartment, and everything than came back on. This is when I realized my mistake.
It used to be the speedo only didn't work (which I assumed was the step motor), now after this mistake all the gauges, the odometer and the buzzers don't work. Lights like the battery and airbag warning indicator still function.
Checked fuse 2 (15 amp) for the instrument cluster and it is intact. Actually checked every fuse in the vehicle in both fuse panels and all are intact. The radio works though and the vehicle is not equipped with power windows.
Going to go get a radio removal tool to take apart the dash and get back there. What this could be? Did I fry a relay? Did I fry the cluster circuit board.
My problem is similar to that of coyote54 back in 05. I have a 2001 Grand Caravan Sport. Instrument Cluster is dead, Information lights on top of dash are dead, Turn signals and Hazard lamps are not working. Found Hazard Lamp fuse to be blown. Replaced fuse and blows immediately indicating a short. Haynes describes a Turn Signal/Hazard Lamp and Daytime Running Light Module located on the junction block but there is no such animal that I can find. One of the responses to coyote54 described a Hazard relay located within the steering column........again, I do not see anything on the column that resembles a relay. Is there a hazard flasher/relay on the 2001 GC.
View 14 RepliesDo the gauge cluster out of one super Duty will work in another truck, just plug and play? I have a 2015 550 that the fuel gauge has quit, which is causing the truck to go into limp mode because it will not allow a regen on the DPF. This is a business truck and i need it to be rolling. There appears to be a national back order on gauge clusters from Ford. I have another truck in the fleet that I could do without so I was wondering if I could just swap the clusters would it work?
View 6 RepliesI have a 2012 F350 XLT that came out of Canada. So of course the speedometer is in KM. (Large numbers are km and smaller numbers are mph). I am trying to find out if I can simply change out my cluster with a mph cluster???
View 4 RepliesMy 2005 is doing strange things. The fuel gauge is always incorrect. I have done the following:
1. Replaced fuel level sensor.
2. Inspected and tested wiring from the firewall to the tank.
There are no codes present and the fuel % listed in torque is always correct. The gauge sometimes reads 1/2 above full, nearly all of the time it's above the 3/4 tank mark. I have an android head unit that I am using to gauge fuel level right now. I believe the cluster is bad.
I have a 2012 Ford F 450 turbo diesel dual wheel truck,my problem is an engine light came up on the instrument panel so i hooked up my scangauge and found the code P20BA I went further into the diagnostics of the scangauge and found nothing,i cleared the code and drove down the road and the light came back on could the sensor be faulty and if so does any body know where the sensor is located.
View 6 Replies