What's everyone's fan rpms at idle? Mine vary and lately I've experience a strange issue where fan immediately locks up and rages right after cold startup. Today it was running 2900 rpm. It settled to about 480-500 but I know I'm the past it's been like 300 or so at idle.
View 6 RepliesI bought a 2006 F-350 4WD Lariat SRW with a little over 200,000 miles on it. The truck seems to run perfectly, except when pulling a load (9,000-10,000 lbs) down the interstate/highway. Sometimes, when pulling above 65-70 mph for an extended period of time (45 minutes to an hour) the truck will all of a sudden idle down and won't get above 2300-2500 RPMs (even if you put it in neutral and floor it). It's not enough to shut it down, but it won't let the truck accelerate as fast as normal. Killing the truck and cranking it back makes it go back to running normal for a little while, but the periods of it acting up get shorter after each killing and restarting. I took it to the Ford place while it was acting up, and they thought it was a turbo problem. They cleaned the turbo and said everything looked fine, but the same problem arose after leaving the shop. They've been stumped at 3 different Ford shops, but one said there's a 95% chance a new turbo would fix the problem. What might be wrong?
View 8 RepliesSo I just purchased my first diesel a couple weeks ago (2003 f250 Lariat). I love it! However, I'm having concerns about my turbo whistle on it. At idle and while in higher RPMs is sounds ridiculously loud (even at 0 PSI in the boost). I've been doing my research on it and I know the 03's have the loudest sounding turbos because they have less vanes than the later models. I know without a video it's going to be hard to diagnose, but I am wondering if a loose boot would cause a turbo whining sound through the exhaust? I have yet to hear ANY other diesel in person that has a turbo whine as loud as mine.
View 14 RepliesWhile I'm cursing at highway speed everything is fine. But when u punch it it pass someone it's like I actually slow down, same from a red light. I've got a livewire programmer in it and this problem is somewhat new. It just seems to keep getting worse, I was going up a hill on the interstate this morning and at 2800 rpms I was actually slowing down. I'm not sure if the fuel pump is going out or if the transmission is slipping or what.
View 7 RepliesIt's a 2004 6.0 excursion with about 190,000 miles. At 185,000 I pulled the motor and did new oem head gaskets, Arp head studs, bulletproof egr cooler and oil cooler system, bulletproof 48v ficm, strictly diesel regulated return, and I've been running gear heads srl tune before and after the truck was rebuilt.
Recently the truck has been acting up at random times. While running the gear head srl tune, the truck will lose power, the boost gauge on my edge insight will get stuck along with Icp psi, the water in fuel light and glow plug light will come on, and then after a few seconds it will clear itself and run fine. Last night I was on a two lane road and putting my foot into it and the truck did the same thing where it loses power, but this time the truck actually died on me while I was cruising at 60.
Same lights were on but this time the cruise control light fluttered while the truck was in the midst of dying. I tried restarting it and it took two sets of cranking before it fired and stayed running. On the way home I babied it and the truck lost power and the Rpms dropped and only the glow plug light came on. Got home and ran codes and I got camshaft and crankshaft position sensor codes and I tuned it back to stock, drove it around, and the truck ran fine, but while on a stock tune I am getting a egr valve code.
I have a 2012 F-250 6.7L w/8K miles. I have been struggling with this issue for 6 mo. The engine feels like its missing at low RPM. I would equate it to the feeling of a bad coil pack in a gas engine. The boost indicator drops to 0 for a split second then recovers. The dealer says they can't find the issue but went ahead and replaced the turbo. After the turbo replacement It got worse. This is an intermittent problem with no codes.
View 14 RepliesI have a 2003 6.0 and I got a scan gauge recently to monitor the fan speed rpm's.
When the engine is running at 2500 rpms the fan speed is only at around 350-400 rpm's.
I did have a code for IAT 2 circuit high I think I read that the egr is disabled when the iat 2 sensor is getting more than 4.8 volts.
Can a bad iat 2 sensor, egr valve or icp sensor cause the fan not to function properly?
My new to me 2006 F-350 6.0L began having starting issue this week. I'll try to describe it as best I can. Not every time I start it, but about every 3rd or 4th time this happens.
- She will start to crank as if the batteries are weak.
- Very low starter rpm's. If I stop cranking, and immediately try again it will do the same.
- if I wait 30 seconds to a minute, she will go back to a high rpm crank and start up after 2-3 seconds.
I have Auto Ingenuity and a SCT tuner so I can data log PID's.
Just bought 2 new F-350 with 6.7s for a service truck and feed truck. I have a 2011 6.7 so pretty familiar with it. I noticed both these new trucks shift at a lot lower RPMs. At times if going from pasture to pasture I have noticed the tach at 900 rpm in 6th gear. My 2011 doesn't do that, it shifts at a higher rpm. Both of the trucks have been deleted, and I have a SCTx4 tuner in each truck and have both tuned to the lowest setting, Tow 40HP. Is this a fuel economy thing?
View 5 RepliesMy '03 7.3 is "surging" on idle. When warmed up, and idling, the RPMs will drop by 300 or 400 for a few seconds and then will correct and shoot back up. It cycles like this (every 5 seconds-ish) continually . I just put in a new IDM and checked the UVCH - is there a separate idle control mechanism that I need to have a look at? (2003, 7.3, 214K, stock).
View 14 RepliesMe and the wife just now noticed this issue after about a week of owning this 6.0 f350 auto 4x4. Leaf spring front and rear. Long bed. Listing all this stuff because not sure if it matters.
Around 50mph if we drive normally about 1500rpm the truck seems to jerk a little as we climb in speed. If we get the truck into the 2000rpm range it goes away.
Not sure if it's suspension, transmission or engine. Any clue what it could be. ???
I get what I can only describe as a "missing" when Im on the interstate just cruising along with rpms below say around 1900. That seems to be when I have noticed it. It is not very frequent but often enough to not let me forget about it. Happens when I'm towing it seems more than when not. Seems the rpms have to be below 18-1900 and in 5th speed. You can just feel the truck ever so slightly missing like in the old days of points and distributor caps. No tunes
View 7 RepliesI literally just got this truck 1 week ago. '05 6.0 F250. I have read numerous other threads and have not found an answer. I will start from the beginning.
I was driving on the hwy and once the engine is hot and I am over 55mph the truck feels like it wants to stall. The rpms drop and come right back up. Its like a 'hiccup'. If it starts to act up and I pull over it remains at idle and not stall. Once i get back on the hwy IF I go over 55mph the truck will stall and I will not be able to start until cool.
After doing some reading through the forums I replaced the IPR on the HPOP.
I tested the high pressure oil system. I took off the valve covers and tested both the right and left side individually, with the IPR valve open and close; cannot find a leak.
I took the fitting off of the top of the HPOP and tested with air there as well. I only hear air out of the weep hole in the back behind the gear on the pump.
I took the oil pump off and charged the branch tube with air, no leaks.
I checked all the dummy plugs. They have been already replaced with the upgraded ones and the orings all looked good.
I took the upper half of the standpipes out - look good, orings looked good. I was unable to get the lower half of the standpipe out on the passenger side due to the air box and the driver side only the top half came out when unscrewed from the oil rail.
I put it all back together with 2 new batteries.
I started it, (started cold), drove it 25 miles and it stalled, let it cool down and it started. Drove it 20 more miles and I pulled into a parking lot and I shut it off, and it started right back up 3 times. When it shut it off on the highway I unplugged the ICP sensor and it did NOT start.
It runs fine until I go over 55mph then I am getting the same stall issue. I can drive it around under 50mph and have no issues. I drove it under 50mph and shut it off a total of 3 times and it started back up no problem. If I drive it over 55mph rpm gauge drops and then comes right back up and IF it stalls I cannot start until it cools. Once it stalls out, If I try to crank on it, my IPR is 84.8% IPC - 99-120.
I am using a Scanguage II at idle:
ICP - 18.5
IPR - 585
FMP - 47.5
My FICM Voltage stays between 12.5 - 13.0 while running.
I just flushed my coolant system and installed a red ELC, Riffraff billet thermo housing, Ford thermostat, new hoses and Riffraff coolant filter. When I first started the truck and was waiting for the thermostat to open I notice at idle the flow from the coolant filter into the Degas bottle was a lot.
Fast forward a week and about 75 miles I have zero flow at idle and it will start to dribble at about 1300 RPM's and increase from there. It seems the flow would not be dependent of the thermostat being open since the connection is below it. I am wondering if my Donaldson filter is already full?
I used a flusher that uses air and water, after flushing I used air to blow to tap water out. How fast have you guys seen one fill up? I ordered 2 extra but just do not want to waste the first one
So it looks like my lift pump (low pressure fuel pump and sending unit) is going. Multiple low fuel pressure warnings over last two days and hesitation at low RPMs. Not hearing pump run when I turn the key all the time but no issues starting. About 16,000 miles since last fuel filter change but picked up new filters today at dealer.
Asked about a fuel pump and he quoted PS401 and none available in Canada and had to inquire direct to Ford - 30 day wait on a part that will turn my truck into a brick if not replaced. Can't find a PS401 but I can get a PS 402 out if the USA in 5 days.
Any difference in these? Dealer is an idiot and can't even determine if there is a difference or too lazy to find out for me. I don't even know if I can prime the truck if I change filters at this point and this is a quick change job for me if I had the pump. Going over the system from back to front in the morning.
Don't ask about warranty. Just hit 160,000 KM on my truck.
[URL] ....
Ratchet buzz noise my truck makes. Is not present until motor warms up. Noise is not present as much at idle but when you accelerate upwards to 1800 RPMs it makes such an obnoxious buzzing noise its embarrassing. Noise seems to come from top center area of motor.....
I've been having rather slow throttle response with my 6.0 f250 diesel at lower RPMs. Obviously, this is to be expected to some point.. Whether I'm cruising on the highway or through the neighborhood, if the truck is at lower RPMs and I try to accelerate, it doesn't want to. In order to get it to accelerate, I have to press the gas down enough to downshift it then it'll take off.
The truck doesn't have a loss of power at higher RPMs, it takes off like a bat out of hell. I've put 175CC injectors in, tuned it, power max turbo, EGR deleted / studded, etc. It's almost go out with acceleration, or go turtle power with acceleration.
Oil pump was replaced a couple years ago. This problem existed through it all, and it's rather annoying. The truck doesn't want to produce any low end power. If I try to hit the gas enough to accelerate but not enough to force a downshift, I'll just blow smoke, spool the turbo, and barely accelerate until I down shift or push the truck through it. Turbo PSI is roughly ~15ish-20ish during the sluggish transition.
After start up it bucks and surges, acts like it is starving. RPMs fluctuate. Once it fully warms up and driven a little bit it clears and runs normal. This all began after the alternator went bad and battery warning light came on. Batteries never went completely dead, but could low batteries effect sensors or control module. This morning it was difficult to start, not low battery problem, but a lot of bucking and black smoke. I changed the fuel filters and a little better. New air filter last week when alternator was replaced. No codes have appeared.
View 2 RepliesRecently I have noticed that when on a tune other than stock I am getting a surge at idle - my RPMs drop to around 621-630 then shoot back up to 660-675. On my stock tune my RPMs stay around 640-667 and don't cause the surge (felt as a shimmy so to speak). Is there anything else that causes a similar symptom? I attribute it to tuning due to it only happening when running anything but stock but could be wrong.
View 2 RepliesI have 2003 f250 6.0, had the turbo rebuilt and I put it back in, my turbo is whistling but I'm also getting a humming noise kinda sounds like a when u down shift at high rpm's idk what's going on, I try and power break as well to build up boost and the tires do not even spin...
View 4 RepliesI purchased my 2013 F350 PSD July of 2014 and immediately noticed "the shudder" when the engine was lugged down to 1000-1100 rpms on a hill. Sounding like somewhere around the turbo belching air too. At first I was startled but learned to manually downshift to higher rpms and it will stop. Once or twice I tried accelerating out of it and it shuddered as bad as the poster who said it made the steering shudder too.
My truck has 16,000 miles and I never let the rpms drop now. So I figure I have a real problem I'm not imaging. What should I tell my dealer is the TSB or remedy ?