Ford 6.0L Power Stroke Diesel :: Cause Of Coolant Temp Spike
Mar 28, 2016
I've been searching for a while now but have not found an exact match to my problem.
So, Yesterday I was pulling a large load home (15K lbs) over flat land/small rolling hills and I experienced a coolant temp spike. And I am trying to figure out what caused it. I was traveling 65 mph about 2k rpm and 20lbs of boost, I was motioning the ECT, EOT, TFT, and Fan Speed via my scanguage and 99% of the time the ECT was in the 209-220 range, once it got up to 220 the fan would come on and the ECT would drop to 209 ish pretty quickly.
However, twice the ECT shot up from 215 ish to 240 within seconds then the dash indicator said check coolant temp then the fan came on and cooled it down to 200 within seconds, I did lose about 1/2 gal of coolant. So today I'm going to get a new degas cap (still OEM original) and continue to monitor the situation.
My EOT ECT delta has been a constant 10-13 degrees for the 3 years i've been monitoring it so i believe my oil cooler is still functions within spec and all my cold soak temps are within a degree or two for various ambient temps (20 -80) so all my sensors should be good.
Also, tonight I'm going to pull the EGR valve and check if there is any coolant in the intake, but if there is not, where should I start looking and what should I start worrying about e.g. head gaskets?
View 12 Replies
Advertisement
Ever since having the EGR delete done, the oil temp has been LOWER than the coolant temp. I am assuming this is bad info from the sending unit? They are reading with in a degree of each other at start up, but when at operating temp the gauge will read lower. Before the EGR delete I had a delta of about 4-7* oil hotter than coolant.
View 1 Replies
This is the only 6.0 I have owned. My tranny temp (with the Torque Pro) is pretty much always the same as my ECT. My ECT will move, and less than 2 seconds later, the tranny will move to the same temp. Is this normal? I was expecting lower tranny temps, but maybe it should be the same because of sharing the radiator.
View 11 Replies
The truck has been just terrific, mostly used for towing our travel trailer. Earlier this year i developed a leak and lost 3 quarts of oil before I caught it. I would think with 15 quarts in her this shouldn't have been too big a deal. However, I am now experiencing 10-15 degree swings between ECT and EOT. Before I give the particulars, yes, I have had three new thermostats, two Ford and one brand X.
Anyway, coolant temps are 184-200 depending upon load, terrain, etc. At the same time, oil temps run 205-230. There is no oil cooler to get plugged up. She's got 120K on the clock, doesn't burn oil, no disappearing coolant. I am concerned about blowing a head gasket or other serious damage at these temps, but don't have a clue where to start? Yes, the fan does come on, but still this seems plenty hot.
View 14 Replies
Bought this truck, and the engine coolant temp gauge does not work, so I replaced the sender, still don't work.
View 8 Replies
I have an 04 F350 and I was wondering if the fan is supposed to be locked up when the A/C is on. In max A/C with the fan on 3 it's barely keeping cool in the 95 degree heat we have been having. If I rev the engine I don't hear the fan noise like I do when the coolant temp hits 218 and the fan roars. Freon was replaced several months ago, along with receiver/dryer and orifice tube when I did the HG's. The A/C shop drew a vacume and did not find any leaks.
View 7 Replies
What the coolant temp should be around after plugging in the block heater overnight? Not looking for an exact measurement since this can be affected by OAT and the length of time it has been plugged in. But when it's -15 to -20F this weekend I was wondering what to expect.
View 13 Replies
I have a 2006 350. When I am pulling my camp trailer (about 12,500 lbs) up a grade I hear a fan or blower turn on and I get a high pitched squeal. It will also have a beep and my in dash display will say high engine temp. I have a bullydog pmt programmer (i tow with it in stock mode) the display will show my coolant temp at about 180 degrees. If I pull over and let it idle for about 2 minutes the warning clears and the temp gauge returns to normal. the display reads about 180 degrees the whole time this goes on. I know the engine is not over heating so why do i get this warning and squeal?
View 4 Replies
Coolant temps getting much higher than oil temps under load. Is there any problem that could cause this other than a bad temperature sensor? Reading temps with an Edge CTS 2 monitor. Think I'm going to hook up a mechanical gauge in the morning and see what it shows.
View 8 Replies
I have coolant blowing out of my coolant reservoir when ever i hold it to the floor it does it with or without the banks programmer... 6.0L power stroke...
View 14 Replies
Well got home and the front of the truck was covered in coolant. I must have driven 2 hrs after I noticed no coolant pressure, but temperature was great so figured it was another crappy cap. Looking to get a quick turnaround. Need to go out of town for work Saturday so I have this week to get it done.
Just put a stock unit back in? I don't think I need to do anything else in that area. Belt/pulleys/radiator all done last spring.
View 9 Replies
This weekend my friend and I plan on doing a coolant flush, new Mishimoto thermostat housing with high temp thermostat and install a Mishimoto coolant filter.
Truck currently has some unknown green coolant in it and Im going to replace it with Rotella ELC. I plan on doing a couple hose water flushes then follow with about 5 distilled water flushes. I've been reading about putting some Cascade in on first flush to dissolve any silicate goo that might be in there hanging out. I might give that a try. Im sure I can manage this part from all the stuff I read about doing flushes.
This is the part that looks like a little more work involved than the flush. Doing the thermostat kind of worries me because of the tight area in there to work with the fuel line and the EBP sensor being right there. The current thermostat holds temps around 175-185 under normal driving. I bought the new Mishimoto thermostat housing with the high temp thermostat installed in it when they had their pre sale going on for the housing.
I decided to just go with the whole thing because of all the stuff I read about people having issues with the thermostat not fitting the older housing correctly since Im certain I have the original housing from 2004, like everything else that's still original on my truck. I plan on removing the thermostat before doing the flushes and then installing the new housing and thermostat and coolant filter before I add the ELC.
The coolant filter install looks fairly simple to do so I should be ok with that.
View 11 Replies
I drove my 99.5 7.3 F-350 1 mile to a friends and hooked it to the OBDII to get a code for my abs light.it had not been drove all day. we hooked into the pcm and he noticed the temp at 375* it was idling. is this right he didnt think it should have been that high???Will the engine coolant temp sensor, if it were bad,show a high temp of 375*? On the OBDII it showed a temp of 375* .....
View 14 Replies
Plugged in my ScanGaugeII on a whim, it's usually on my 6.5 Suburban daily drivers, but was curious to monitor a few things on the 7.3
Noticed this right away, coolant temp reading a solid -40*F and never budging.
View 7 Replies
I was going to order a ECT gauge and was wondering where to mount the sensor. I have already used the port under the T-stat for the coolant filter. The gauge sensor is a 1/8 NPT. Would the block drains be a good location, or is there another location that will work.
I know the coolant filter housing has a port, but I would prefer the sensor be on the motor.
View 11 Replies
While driving at any speed my temp gauge and oil pressure gauge spike well above "H" and stay there. The red battery light sometimes flickers too. The Battery gauge is low. I replaced the terminal to then negative battery cable because It was loose. I have also replaces the alternator. I had the battery checked and it was good, it just at 45% charge. That's why I replaced the alternator. After I did that, It seemed to have fixed the issue. But after 3 days, it has come back again. Now this morning on the way to work, driving down the freeway, my speedometer jumped to 85 MPH and there was a squealing like noise coming from the engine. I am not sure if the two are related issues.
View 10 Replies
My 2004 ford explorer 4.0 has this issue where the check gauges will come on for 2-3 sec, then the temp gauge will go from normal and peg to hot and as soon as it pegs it drops right back down to normal. I have had the thermostat replaced and have flushed the radiator. I am at a loss here....
View 3 Replies
I have an 07 6.0 diesel and I'm having trouble once it gets hot. It begins to lose throttle response and shakes while cruising and also has a rough idle. sometimes it dies while idling but after cooling off for a few minutes starts back up and runs fine. I've checked the high pressure oil and the ficm and both of those are fine. I've done an EGR delete so it has nothing to do with that either. My MPG also goes way down when this happens.
View 5 Replies
I know they're supposed to be within 15 deg of each other. How bad is this? Pulling a small trailer with a polaris rzr on it. Running 75mph
View 14 Replies
This is not on my truck. This is on my buddies 04 we just did the egr delete and oil cooler and a bunch of other stuff to.
Coolant temp doesn't go past 170 which I assume a new thermostat will fix this issue no problem.
but, the oil temp never goes past 140 no matter what driving for an hour at 70 and it doesn't change.
Bad sensor? Or would replacing the thermostat bring the oil temp up to where it should be?
View 6 Replies
I recently observed coolant temps of up to 217 degrees as reported by my mini max and oil of 230 as reported by the dash while towing 9000 pounds from San Diego to Las Vegas on the 15 going up the 16 mile mountain grade. My temp gauge on the dash never moved a bit, it stayed in the same spot from 199 to 217 so I assume its not too hot. My mini max defuel setting has the coolant temp at 220? I slowed down and tried to keep it under 210.
View 8 Replies
