Ford 6.0L Power Stroke Diesel :: Battery Light On - No Gauge / Radio / Windows - Alternator?
Oct 23, 2015
So I have been having this little issue for a few weeks now. I will be driving along and out of nowhere my batt light will come on and my gauge cluster,radio and windows stop working and the ficim volts jump to 15.5-16.5. This is an intermittent issue. Yesterday I put my multi meter on the alternator and I am reading 13.5 or so this number was done at idle and the batt light was NOT on .
View 14 Replies
Advertisement
I have a 06 F250 6.0 My battery light has been coming on. Doesn't stay on but I'm planning a trip back east and don't want any issues to occur. I was thinking maybe the batteries. So I stopped at the local Oreilly's Auto store and had them tested. Told the guy what it was doing and he said it sounded like the alternator. He tested it and said it was going bad. He also tested the batteries and said they were good. So I went looking for a replacement alternator and they have different amp sizes. So I'm not sure on what size the original one is and if the replacement should be a bigger size amp wise.
View 11 Replies
We've got a 2012 F550 6.7 with 138k. It recently got a battery light. The batteries are right around 12 volts with the truck running or off. I also tested the output on the alternator and its not charging. I put a new alternator in it and still no charge. All the connections are tight and clean. The batteries load test ok. Where to look next?
View 4 Replies
I have an 04 f350 and the other day the windows and radio quit all at once. Lots of people are having intermittent problems but mine went from being fine to nothing all at once. I tried the circuit breaker and the relay but nothing seems to fix it. What this is?
View 8 Replies
I have a 2004 F250. Owned it for a little less than 4 miles (186k on the odometer) .. The other day making a routine run and the radio goes out. Stopped to check it out and found I had no power windows either.
Made it home, checked the fuse on the radio and its good and the the power window fuse is also good. Put a meter on the terminals and have no voltage going to them. What I need to look at???
View 11 Replies
We just replaced an injector in my truck. Everything was fine, ran great, etc.
On the freeway home, the dash, windows, locks, radio all quit working. at first they'd stop and come back, stop and come back, etc. then finally they stopped. As I was getting off the nearest exit, the truck started dying on me. Once I got pulled over out of the way, it acted like the battery was completely dead.
After a few minutes of scratching my head and staring under the hood, I happened to look at the passenger side batter, and the crossover cable from the drivers side was broken off right at the terminal!! We must have broke it off while doing the injector. as I look closer at it, it had been broken before. Some idiot before me had actually taken a broken crimp style terminal, shoved it and crimped it into a new one and called it good.
I was able to redneck it back together so i could finish the last couple miles home. I fixed it properly with a new crimp terminal, heat shrink, etc. Why did the engine die with the crossover connection broken? was it because the series was not complete, and all the electronics were running off the battery(s) and not the alternator? I'm really confused. I've heard of people only running one battery before.
View 9 Replies
My buddy is selling his truck in a couple days and was taking out speakers, afe intake, and satelite radio. I go to start the truck and i have no power to windows, no power to radio and no domelight when i switch it on and off. Dont know what i did but none of this works and everything else does.
I checked all fused all were good. I searched the forum for a solution and they said something about the automatic delay relay and i bought a new one and nothing still. I am not sure what else to do i checked with voltmeter if i had anypower to the window or radio and nothing. But the radios clock works and when i turn on the light it illuminates but doesnt turn on.
The truck is a 2002 7.3L Crewcab. f350
View 12 Replies
The past few weeks the dashboard warning light for my alternator/battery will occasionally light up while driving down the road. Whenever it does, my plug in voltage meter shows a healthy 14.x reading. It usually goes out after a few seconds, but will stay lit up for as much as thirty seconds. So other than voltage being too high or too low, what else will cause the dash trouble light to illuminate?
View 14 Replies
Alternator locked up in a parking lot. Replaced it and had to replace pigtail due to a loose wire in the harness. Now battery light comes on intermittently. New alternator is doing fine producing anywhere from 13.9v to. 14.4v. No output voltage correlation to battery light at all. The belt is still in great shape so I don't suspect slipping. Fortunately I caught the old one locking up almost immediately and had recently replaced the belt. Output voltage looks great. Are there any fuses for alternator?
Only thing I can think of that I did...when splicing in the pigtail that connects to the alternator, I briefly grounded whatever wire in the pigtail is hot. Was just a split second, but enough to see a spark and maybe enough to blow a fuse? I've seen people reference an "under hood" fuse box, but I don't seem to have one. My truck is a 2002 CC with just over 100k on the clock.
View 3 Replies
Had a bad alternator, changed it, and now the battery lite stays on all the time..Changed the alternator again with a known good one, and the light is still on all the time..
View 14 Replies
I just wanted to share with you all a cautionary tale about belt tensioners and idler pulleys. I am now a firm believer in installing the aforementioned items when you replace your drive belt. 15000 miles ago I replaced the drive belt and didn't heed the warning of some here on the forum.
For the last month or two I have noticed what sounded like road noise which I dismissed because I had just had new tires installed that had a more aggressive tread pattern than my previous tires, I also noted that the ECT had been a bit higher than normal, like running in the high 190's to low 200's on average.
Well while driving today I get the alternator warning light and lose power steering and soon after the brakes got stiff, this was followed by ever increasing ECT which got to 242* before I could get it off the road and shut down. It is too early to tell if the noises and the ECT temp rise were the result of this tensioner going out...
For what its worth the only tools required were a 10MM end wrench and a bit of skin to get the job done.
View 5 Replies
My 2006 F250 has a single alternator and recently the charge light is on intermittently and I have watched output voltage fluctuate between 12.4 to 13.5 ... sometime a .3 volt bounce one way or another for no noticeable reason.
So rather than buy a new alternator, I would like to replace the voltage regulator and put in some new brushes.
What are part numbers that I need to pick up?
View 6 Replies
2004 F-250 6.0 Turbo Diesel W/ Torque Shift Transmission. Im having a problem with my Check Gauge light coming on and Tow Haul light flashing on my 04 F-250. I got a Transmission Fluid Temperature Sensor from my local Ford Dealership. They also said i needed to replace the Transmission harness for this application because of an open circuit.
My questions are, Is Mercon SP the only ATF that can be used on the Torque shift transmission and do i really need to replace the harness or just the sensor? I have read up a little on this and so far everything say's drain the fluid, drop the trans pan, swap out the sensor, replace the trans pan (torque setting is 11flbs I believe, correct me if I am wrong, replace with Mercon SP ATF and your good to go.
View 10 Replies
Friday I pulled my steel gn 3 horse trailer about an hour each way. with the horses it weighs right at 7000 pounds. no issues. Saturday morning I drove to town, no issues. Saturday evening, I got in it to run down the road and about 2 miles from the house, the check engine light came on and the tow haul light started flashing and the temp gauge is dead. drives and shifts normal, tow haul button still functions. Truck is stock except for an EGR delete. No tuner, FICM was rebuilt. I had it on a battery minder before I left and was thinking about pulling the batteries and letting it sit for a while to see if it clears. Scan Gauge II shows no codes.
Sunday: So I let it sit all night, batteries connected and it was completely normal this morning. will see what happens when I drive it to work tomorrow
Later Sunday evening: So I just took it out for a test drive, went a couple miles down the road, shifting normal for a cold start. Temp gauge is working, just as I am almost back home. 5 miles at the most, temp is coming up to normal, gauge goes dead and check gauge light comes on and tow haul starts flashing. I think it might be the sensor.
This morning: I got about 6 or 7 miles from home, trans just got up to temp, pulling up a hill, it shifted out of overdrive, tft gauge went dead, check gauge light came on and the tow haul light started flashing. still shifts like it always has and the tow haul button still functions.
I am thinking it is just the temp sensor. Truck has 159k on it.
View 13 Replies
Installed a 20'' light bar on my 2012 and when I turn on the Aux 1 uplifter switch my radio stations have static. This was not the case before the install. I have the hot wire tied into the Aux 1 (25amp) switch. Ground is run to drivers side battery ground. Do I need some kind of relay in line?
View 5 Replies
I now have a 2002, 7.3, 250, 4x4 and love it. Everything but the milege. All in all it's a great ride. I have one little problem that's driven me nuts.
The power windows and the radio go out occasionally. Both at the same time. They come back on...... sometimes. Sometimes it takes a day or two. I've checked the fuses and then saw that there is a breaker in the 601 location in the fuse box that's probably causing the problem.
But I thought that it was supposed to shut off to protect that circuit when there is a short somewhere. I don't know where to go or how to locate the short if in fact this is my problem.
View 14 Replies
On my 2003 powersteering the windows and radio will just quit working. Then they will come on again. Maybe in and hour or a day or a week. Where do I sart.
View 6 Replies
Noticed the other day when I went to leave a job site my Check Engine Light came on but the truck started fine and seemed to run normal. while cruising down the highway I noticed that my factory boost gauge was showing 35psi and fluctuating between that and around 10. looking at my H&S it was showing normal boost readings for the current driving condition, when I came to a stop the H&S would show 0psi but the factory one would fluctuate between 0 and 35-40psi..
I can tell the turbo is not spooling at all during this time. if I take off from a stop with the gauge showing 35 the engine sounds louder than normal at first take off compared to when the gauge is reading normal. I haven't gotten a change to get it in my shop yet to look it over but does the dash gauge read from a different sensor that what my H&S is reading? Truck is an '11 F250, deleted both EGR and DPF with H&S tuner. I checked codes and all I have is P06A7. Where to start?
View 4 Replies
I just got this f350 6.0l and I experienced an electrical problem with the trans gauge, started flicking a lil then go all the way up to over hit and check gauge light go on and my tow light starts blinking..
View 4 Replies
My 04 F 350 started with a check gauge light while going down hill towing an 18 ft car hauler full of mulch. Did it for 5 seconds, then when we got to our land and I was getting ready to back up it did it again. and this time my oil pressure gauge was at zero. I shut her down. checked the oil. its full. Drive home everything is good. Today I'm getting fuel pressure gauge going nuts. 80 to 100 PSI. at idle no oil pressure and the check gauge light. but the engine is still running. Oil was changed 4K ago. fuel filters same. Where to start looking?
View 5 Replies
After changing the battery on the 2005 Accent, problem now is: no power windows, no radio, no air/heating fan, battery light always stays on. Checked all fuses in box besides driver seat an all OK. Rest of electrical seems ok ( int. and ext. lights, lighter, etc...). I would really really like not to have to bring it to the dealer.
View 4 Replies
