Ford 6.0L Power Stroke Diesel :: Back Seat Power Windows Don't Work
Dec 26, 2016
It's my turn, while out site seeing my back seat power window don't work , the control from drivers seat or from the back seat door control, I popped both covers on the control switch and both are firmly plugged in, I don't have my meter with me to see if power is running back to the switch , this morning I'll try to switch out the two back seat controls to see if I can get at least that window to go down , 04 350 , would there be a fuse for each or is it in the switch in the door that the harness plugs into , that's the only window that won't go down...
View 8 Replies
Advertisement
I have a 2004 F250. Owned it for a little less than 4 miles (186k on the odometer) .. The other day making a routine run and the radio goes out. Stopped to check it out and found I had no power windows either.
Made it home, checked the fuse on the radio and its good and the the power window fuse is also good. Put a meter on the terminals and have no voltage going to them. What I need to look at???
View 11 Replies
2007 F250SD, R/H power mirror with LED lights no work. All other lights and L/H mirror work fine. Checked the fuse in passenger compartment, it's good. Where to start looking?
View 5 Replies
I have an 04 f350 and the other day the windows and radio quit all at once. Lots of people are having intermittent problems but mine went from being fine to nothing all at once. I tried the circuit breaker and the relay but nothing seems to fix it. What this is?
View 8 Replies
I'm new to the diesel having just gotten mine after having an Ecoboost F150. Question -- once the truck gets up to normal operating temps, should the climate control be capable of removing all the fog from the side windows??
View 14 Replies
We just replaced an injector in my truck. Everything was fine, ran great, etc.
On the freeway home, the dash, windows, locks, radio all quit working. at first they'd stop and come back, stop and come back, etc. then finally they stopped. As I was getting off the nearest exit, the truck started dying on me. Once I got pulled over out of the way, it acted like the battery was completely dead.
After a few minutes of scratching my head and staring under the hood, I happened to look at the passenger side batter, and the crossover cable from the drivers side was broken off right at the terminal!! We must have broke it off while doing the injector. as I look closer at it, it had been broken before. Some idiot before me had actually taken a broken crimp style terminal, shoved it and crimped it into a new one and called it good.
I was able to redneck it back together so i could finish the last couple miles home. I fixed it properly with a new crimp terminal, heat shrink, etc. Why did the engine die with the crossover connection broken? was it because the series was not complete, and all the electronics were running off the battery(s) and not the alternator? I'm really confused. I've heard of people only running one battery before.
View 9 Replies
So I have been having this little issue for a few weeks now. I will be driving along and out of nowhere my batt light will come on and my gauge cluster,radio and windows stop working and the ficim volts jump to 15.5-16.5. This is an intermittent issue. Yesterday I put my multi meter on the alternator and I am reading 13.5 or so this number was done at idle and the batt light was NOT on .
View 14 Replies
Dad's truck 2012 regular cab. Seat belt doesn't like to retract on it's own. The retracter(next to your left butt cheek) works fine, or so it seems. The belt seems to get caught in the swivel mount above your shoulder. I've tried a piece of sand paper in between the belt and the plastic but it doesn't work any better. Is there a way to adjust the retracter? Looking for a solution before we close the buckle in the door frame and have bigger issues...
View 2 Replies
Crawled under the new to me 13 super duty last weekend to see this. Where it's coming from? Over tightened oil filter maybe? The filter in the picture is the new filter fyi. Old filter had a little oil on it. It's all the way across the back of the oil pan.
View 14 Replies
I can't get the damn auto unlock to work. I've enabled it and disabled it and nothing still reset it all and all that just got the truck....
View 7 Replies
So I bought my truck about three months ago. The first day I got it I obviously wasn't paying so much attention to the key, that I didn't notice that my keyfob wouldn't work at all or had limited distance. Anyways, I go to the dealership and the keyfob(Normal one, NO Remote Start) works perfect for them every time. I have been so frustrated with this for a couple of weeks now, I decided to take it into my own hands and take it apart and see whats going in there.
On the top right side of the key, there is a gap between the two plastic pieces that you can fit a flathead in and turn to open up the actual key. In between those pieces is a rubber mat type thing, I assume to keep water out. After you take that off, you will see the battery. On BOTH of my keys, there was this clear goo stuff, which again I will assume that it's some sort of contact/battery protector put on by the factory.
Well the text on the inside of the key says not to wipe the battery contacts, but I took a Cu-Tip and got all the clear stuff off the battery and contacts! I now have 100 yard distance with my key. It works EVERYTIME now.
View 14 Replies
Crew cab, have easy access to the under rear seat storage area to grab a few quick measurement? I need to know the entire length (side to side) and width at the widest points as well as depth.
View 2 Replies
So i did this with mine but friend just bought 06 6.0. How do u shut the chime off for the seatbelt again. I know parking brake on key to on position not run. How many time do u buckle and unbuckle again?
View 14 Replies
I have my truck idling in the driveway while doing a coolant flush and it developed a weird idle. It will idle fine for a while then all of a sudden it will idle up a little for about 3 seconds then go back down. It will do this 3-4 times then go back to a regular idle for a while. I got in and watched my SCT X4 to see if anything changes. My actually RPM didn't change and neither did my fuel pressure or anything but my turbo added about 1.5 pounds of boost when it does it. It happens about every 4-5 minutes.
View 11 Replies
When I pulled my HPOP cover the other day, noticed some RTV on each side where you have the small step down from the block and the piece of metal on the backside of the pump housing. The new gasket I installed had he step down and looked like it would fill the gap, but is the RTV necessary?
There was a previous leak on the turbo drain tube that the dealer I bought it from tried to stuff some kind of fiberglass material in there to absorb the oil. I half wonder if the dealer didn't try to "fix" the back of the cover leaking by cramming some RTV in there. I have to pull the cover again in a couple days and wanted to see if I needed to do anything special when installing the cover?
View 6 Replies
I've had a minor oil leak since I got my truck back from having the EGR, head studs, head gaskets, oil cooler done. It's gotten quite a bit worse lately to the point that I'm going to have to fix it. I added some UV dye and traced it up to the engine valley. All the leakage seems to be toward the back of the valley. Is there a common component that is prone to leaking in the valley that could be a starting point?
View 14 Replies
My Front axle wont go back in! It kinda was a pain to remove too; but getting it back in is like mission impossible! I've tried turning the driveshaft, the other wheel, all kinds of stuff short if beating it with a hammer.
In an hour or so I am going to take off the diff cover and see if there is anything obvious, Id rather not but... I took it apart due to noises I was hearing up front on that axle / hub. I have all new seals and such just in case anything needed it.
View 9 Replies
I traded from a 2011 F-250 XLT recently with premium package to a 2015 F-350 Lariat, but the truck we found didn't come with a couple of the features that I loved in my last truck. I live in western Nebraska, and travel very regularly to western North Dakota and central Illinois for my business. The truck has 5200 miles (had the truck for 1 month ), but everything is still in great condition and would hope for the same in return.
View 3 Replies
Bought this truck (06 F250 cclb diesel) earlier this year and (as far as the seat is concerned) worked perfectly until about 2 weeks or so ago, when I learned that the passenger power seat works in every direction except for to move the seat back. Since every one that got in the truck didn't believe me and now the seat is almost at the glove box I finally decided I should do something about it. I have removed the fuse and let is sit with the the fuse out for about an hour, no change. I had read on another fourm that if you recline the seat back a few times it resets the module, attempted with no change. It is to the point I need to get into a bit more serious diagnostic processes however I am unsure exactly where to start.
View 2 Replies
My mechanic put a used 2005 PMC in my 2004 powerstroke. Now tachometer does not work, trans and coolant temp guages don't work and drives as if it is stuck in 3rd. gear. Does it need flashed @ a ford dealer to sync the two together?
View 14 Replies
I have a 15 F350 DRW 6.7 pulling a 19K fiver with 8K axles and disc brakes, I have to have my brake controller set at 10 to get the brakes to work well. The pads are good, just bled the system using a power bleeder, controller is set to electric over hydraulic with max gain. Why I need to have the controller set to max?
View 14 Replies
