Ford 6.0L Power Stroke Diesel :: A/C Won't Work At Idle - Fan Not Cooling The Condenser Down?
Jul 27, 2015
I noticed my A/C hasn't been up to par. It's not bad when driving but just ok when idling. So today I changed the orfice tube and the accumulator. Vacuumed the sys. down and charged it up, 2 lbs 10 oz. It is worse! the compressor kicks on and off constantly only cooling to 80 degrees.
I noticed the high goes right up to 350 then the compressor shuts off .... 7 seconds later, back on and up to 350lbs and off again. I think the high-pressure switch is shutting the compressor off before anything goes kaboom but why isn't my fan cooling the condenser down? my FSS shows no increase in fan speed. Sitting at 450.
I think I'm going to cool the condenser down with a hose now to see if that works. If so, That would be telling me the fan isn't doing it's job correct?
View 5 Replies
Advertisement
Is the A/C condenser pretty simple to replace on the 2006 F350? Replaced the compressor but then noticed the condenser was leaking. Looks simple just wondering if there are any quirks to it.
View 14 Replies
I recently did the high idle mod but as many of you know it does not work with remote start. I found the below link on how to make it work with rewiring how the aux switches receive power. Are the aux switches hot all the time even with the key off?
[URL] ....
View 5 Replies
Under normal driving, my cooling fan rarely comes on. The truck runs ECT 194 to 200 and EOT about 7-8 degrees warmer. On grades in the mountains, not towing, it will cycle on if the ECT gets to 210, cools it down and cycles again if needed. My question is, under similar conditions, what does your truck do? When towing my 5th wheel, about 13k, when its 90 degrees plus, at between 60 and 65mph on level ground, my ECT runs 210 and the fan comes on to around 1400rpm and cools it back down to about 204.
When the ECT gets back to 210, the fan does the same. On uphill grades, I see as much as 220 ECT. When this happens the fan comes on at around 2500rpm and cools it down to about 199 pretty quickly. I have a new oil cooler so my oil always follows and on my last trip I never saw more than EOT of 225 on the longest, steepest grade. The reason I ask is to see if this seems normal. My mech keeps mentioning that if my fan is cycling it may be head gaskets. But, I don't have any other head gasket symptoms. I think it seems pretty normal. If the fan doesn't come on and cool the engine when its working this hard, then what is it for? What does your truck do under similar conditions?
View 11 Replies
The 2011 Platinum's "black" interior is really chocolate in color. This just killed a potential sale today. But I did drive it and it didn't dissapoint. Probably out of my price range,but if money wasn't and object, probably would go for the loaded blk. 4x4 Platinum.
View 8 Replies
I think i have a truck with a condenser that has a restriction, how i could prove this with a test or something maybe like a temp test across from the inlet to outlet side...the symptoms are lack of cooling the hotter the temp outside the worse the cooling is also when it rains while I am driving the it fezzes me out....ill post pressure readings later.
View 1 Replies
getting ready to do a cooling system flush per the instructions Cheezit posted a while back, which say "refer to Cooling System Draining, Filling and Bleeding in this section." I think I can figure out the drain and fill but how do you bleed the system?
View 14 Replies
I have a 2003 6.0 Exc. I have installed an external "Bullet Proof" oil cooler, and essentially all of the "bullet proofing" accessories with the exception of head studs. I also have installed a Mishimoto oil cooler, as the OEM cooler had a crack in the upper tank, My particular problem is that the cooling fan does not kick on (audibly) until about 230 deg or so. It quickly cools to about 215, and the fan kicks off (audibly). On the long uphills here in AZ, it will repeat this process, sometimes getting as high as 240deg.
(As monitored by my EDGE tuner) I have utilized the blue-wire-to-ground trick noted elsewhere, manually turning the fan on myself, and that works great. What I'm asking, is what sensor sends coolant temp to the ECU, ( and where is it located in the cooling system) which in turn determines how much to turn the cooling fan on? What typical level the sensor sends to the ECU to control the fan? I would like to put together a circuit that "fools" the ECU into turning the fan full "on" at about 210 deg, and stays on until the coolant temp reaches 195 or so. I would like to check that sensor first, and make sure it is working correctly before I try to band aid a fix.
View 14 Replies
My truck was parked at home and hadn't been started for 10 days. When I did start it for the first time, I heard the cooling fan spooling up or down, consistent with the engine rpm. After pulling away from my home I saw the fan speed spool up to near 2,800 rpm during the short period it was locked-in with the engine speed.
While driving out of my neighborhood, and about 1/3 of a mile from my house, the fan returned to normal speed of about 480 rpm. I have the FSS pid displayed on my Scangauge and was able to see the fan speed while hearing it. Now I know what the fan sounds like at a high rpm. It makes quite a roar.
This has never happened before. I've driven the truck a few times since then and it hasn't occurred again. What may have caused this?
View 7 Replies
2006 F350 6.0 throwing code P0480 and I'm having a hard time figuring anything out pertaining to my truck. Trying to figure out what exactly it is and how to fix it myself.
View 3 Replies
I currently have a 2003 F-250 6.0 with 112,000 miles on it. While traveling interstate speeds (70+) and the I can hear the cooling fan rev up and down every 10-15 seconds. Is this normal?
Also when it spins up, it sounds normal then make a high pitched squealing noise. Thoughts?
I am also needing to rebuild the fuel bowl. I noticed DieselOrings offers rebuilds for the 7.3 but not the 6.0. Will these fit or any suggestions on parts?
View 7 Replies
My engine cooling fan came on when I first started the truck, was reading of 2k on torque app, ECT was appx 100* with the EOT a little cooler after about 5-10 minutes things went to normal around 600 rpm. It did not happen anymore during the drive, I was seeing about 192* ECT and 198-200 EOT. I let her set for 2 days and took her to town and the fan was at normal RPM's, Is there any problems or is that normal?
View 9 Replies
Noticed this past month on colder days my upper hose is collapsed, typically a symptom of a bad radiator pressure cap.
This hose is connected from the water pump to the radiator. The radiator is connected to the Degas bottle which has a nonstandard radiator cap.
Do these plastic caps vent the same way a typical cap does?
Cap for 2011 Ford F-350 Super Duty|9C3Z-8101-B
View 3 Replies
6L w/automatic trans,no tunes,no mods. Fan doesn't speed up when ac is turned on. I checked connector at fan shroud and #25 10a fuse and wanted to see if there's anything else I can do or check before taking it to dealer. I haven't towed heavy since I noticed ac not cooling at idle but last time I did tow the fan ramped up on hills and stop and go. I'm in Texas so I must get this right asap. I heard of some with manual override so I would like to do that as well but also heard rumors the override can damage pcm. Any manual override?
View 8 Replies
Here is the issue i am having. 2011 F-350 King ranch with all bells and whistles. In Arizona now we are in the season that the weather is cold in the AM and sometimes hot enough in the late afternoon to need the A/C in the truck. with the settings on Auto which i normally do, and the external temp reading in the 80s, and the internal thermostat set at 70 or lower, the A/C compressor will not engage and allow for cooling the cab of the truck. But sometimes it will work just fine. I am assuming there is a temp sensor for cabin temperature. Where that is located. or will i have to change out the entire Climate Control Module. I would take it in to have it checked out but it is an intermittent problem, and i cant not have my truck for a couple of days while they try and figure it out.
View 13 Replies
Turns out I've lost nearly all of the coolant from my secondary cooling system and am trying to diagnose the problem.
Things I noticed:
-All of the hoses appear to be in good condition.
-Coolant is dripping from the center of the engine bay.
-After inspecting the turbo area, it appears the valley below the turbo is wet.
The intake manifold is still on the truck, so I haven't been able to get a better look. Is there anything else near the area I am describing that has coolant? My guess is the turbo water inlet?
Perhaps this : Coolant leak on the 6.7 Powerstroke diesel - YouTube...
View 6 Replies
I have a 2007 6.0 that this has happened to twice now. It's fine around town but I never hear the can come on. Friday when on the interstate my my temp gauge started to rise past normal operating temperature before fan came on. Is this normal? After the fan came on it stayed at normal temp for the rest of trip....
View 5 Replies
I have an 05 Prius with 53k miles and the ac just recently stopped working. The blower fan still comes on, but neither the compressor nor condenser cooling fan will come on. I've checked the fuses and relays, and they check out ok. I'm hoping there may be one I missed? It just stopped working with no warning signs. What could be causing this? If the compressor was bad, the condenser fan would still work, right? I'm fearing it's the ac inverter. Do the symptoms match?
View 9 Replies
I have a 99 f350 and my a/c does not work at idle at highway rpm it blows cold. but once i let it sit and idle even on 1300rpm high idle it will now blow cold. it blows hot untill i rev it up aroung 2000rpm or drive down the road. I have charged the a/c system it has the proper about of refidgerant in it compressor gap is correct. Is it supposed to be like this? If not what are some things to check?
View 14 Replies
It's my turn, while out site seeing my back seat power window don't work , the control from drivers seat or from the back seat door control, I popped both covers on the control switch and both are firmly plugged in, I don't have my meter with me to see if power is running back to the switch , this morning I'll try to switch out the two back seat controls to see if I can get at least that window to go down , 04 350 , would there be a fuse for each or is it in the switch in the door that the harness plugs into , that's the only window that won't go down...
View 8 Replies
2007 F250SD, R/H power mirror with LED lights no work. All other lights and L/H mirror work fine. Checked the fuse in passenger compartment, it's good. Where to start looking?
View 5 Replies
