Ford 6.0L Power Stroke Diesel :: 2007 - No Crank / Heavy White Smoke Blowing Out Of Tail Pipe
Mar 21, 2017
I try to turn on my truck today and it will not crank. The day before I had change two injectors and I turned on the truck when two fill up my tank and I put a full bottle of injector cleaner with it. When I drove off, a few blocks down the truck turn off on me. I started to turn on the truck and every time I did it would blow heavy white smoke out the tail pipe and then it would shut off. I did this about 10 times until I decide to call a tow truck. The next day I empty out the fuel tank and fill it with diesel only. I tried to turn on the truck and it would not crank. I ended putting two new batteries and still the same result. What can this be ? 2007 6.0 Diesel ...
View 14 Replies
Advertisement
I just came back from a 200 mile trip and parked my truck. Next day, got in the truck and turned the key.... it turned over and white smoke coming out the tail pipe. After doing some research(you tube),I ruled out cps sensor because it was showing low rpms on tach. Replaced glow plug relay and still have same issue.. what else to look at that I can do without getting it towed. Hunting season coming soon and I need the beast.
View 14 Replies
I have a 95 Nissan pick-up truck that is blowing white smoke from the tail pipe, sounds like a choo-choo train, and has visible liquid dripping from the same. What is the problem???
View 4 Replies
I just bought this 2007 F250 a 126K miles on it. Drove it about 1500 miles with no problems. I changed the coolant to Rotella ELC, installed Sinister Diesel Coolant and Oil Filter Bypass, and changed oil to Rotella 15W-40. 3 days after I did this it was in the mid 30's in the morning when I headed to town. It was blowing white smoke, so I stopped and smelled it. It did not smell sweet. I saw what looked liked diluted oil dripping from the exhaust. As I turned around it stopped. I revved it up and no smoke. I headed back into town(around 10 miles) no smoke. Drove home and no smoke. I was at home for about an hour and when I started the truck it was blowing white smoke.
I revved it up a couple times and it went away. I drove about 125 miles and no smoke. I let the truck sit about an hour and when I started it was blowing white smoke and no matter how much I revved the truck it did not go away. I went to work and the truck sat for 3 weeks. I just installed the blue spring kit. Started the truck and no smoke at first. Then, when it went to fast idle a little wisp of white smoke. As soon as I revved the truck up it got worse. Then it blew out what once again looked like diluted oil about 5 feet out the exhaust( I have a huge tractor weight sprayed with this). My first thought was maybe with the thicker oil I am getting some stiction so I am planning to change the oil to 5W-40 and add Hot Shot Secret tomorrow. But blowing the oil like substance out the exhaust has me concerned.
View 3 Replies
I have a 2004 GMC Sierra 2500 Duramax diesel pickup. It has been blowing white smoke from the tail pipe and drinking coolant, 10 - 15 gallons since February. There are no obvious leaks of coolant under the truck. However, within the last 3 weeks it has on 4 occasions spewed coolant from the surge tank from the overflow vent. We have narrowed down the problem to either a headgasket leak or an injector leak.
We had it in to the dealership (big mistake) and they found nothing wrong. They think we either need to wait for something catastrophic to happen or do the head gasket and replace the heads. There is a technical service bulletin about the head gasket. There is anecdotal info from an article written by a master tech from GM about the injectors. We also know there is something about GM paying for the injectors and injector sleeves to be replaced if there is an issue like we have.
All the dealership is saying they did was drive around the truck and saw no coolant spewing forth and no smoke. They did see a lowering of coolant level in the surge tank. They also did another pressure test on the coolant system and found nothing. Outside temps and weather conditions have no effect on this situation unfortunately nor does the length of time it's driven. How much should a head gasket/head job cost? How much time should it take? Does it require removal of the cab? How much should an injector job cost? How much time should that take?
View 2 Replies
I have an 07 6.0 with 400,000 miles. Has been a great truck with no major problems. Before I started the work I had 3 bad injectors, running rough and the oil/ coolant temp just outside of 15 degrees. So I tour her down and replaced head gaskets, installed arp studs,all new injectors,all new glow plugs and new oil cooler. Ran great for a couple days. Then when driving to work lost power on and off for a few miles then completely gone could only go 10 miles an hour. I checked codes and there was the under boost code witch has been on there for a while and I forget the other code but it was for the ipr valve so I replaced the valve and right after still the same but that code went away and the p0470 popped up. So I cleaned out the ep sensor tube and replaced the valve. After several miles she now runs great but now I'm getting a little puff of white smoke when I take off and not every time and mainly when I take off some what quick. All codes are gone expect the under boost. I have an egr delete already.
View 7 Replies
So I am owning my first diesel so I am still getting use to it. Shortly after I bought it, I had to make my 900 mile drive to work and it ran great. After being here for a week or so I noticed heavy white smoke bit thought it had to do with the -5- -10. And haven't seen the white smoke since the weather warmed up. Since then I have noticed a "knocking" sound that to me sounded like a rod that I didn't notice before. After reading through these forums, it sounds like I probably have a cracked injector. I have had no engine light or anything. So my question is, can an injector fail or be cracked without an engine light and can a code reader detect which one it is with no light on?
View 6 Replies
After running perfectly fine all day my truck will seem to bog down and when I press the accelerator the reaction is extremely delayed and tons of black smoke will come out of the tail pipe before the truck actually gains power and takes off. The check engine light has been coming on but will turn itself off after the truck has been shutdown a few times....
View 10 Replies
Have a lot more smoke from the tail pipe when they are running their tow tune vs their street tune? For me it seems like a lot especially right now being cold out but I still notice a haze at idle when the engine is warm. Also can smell a difference.
Getting a ficm tuner from php tomorrow so interested to see what that does for things.
View 7 Replies
Yesterday I was coming back from town and as I was looking in p/s mirror changing lanes I noticed heavy white smoke. I only noticed this upon decel or coast. Once I rolled back into the throttle the white smoke would dimminish. I'm sure it was coolant from the smell. The truck (04 F250 CC 6.0) is now at the dealer for troubleshooting. I believe it to be a blown head gasket, but wouldn't that make it blow white smoke out the exhaust all the time? Maybe a cracked EGR cooler?
View 11 Replies
Got a 2 wheel drive 2000 Excursion with approx. 215K miles with the 7.3L.
Slight shake in motor + you can literally floor the pedal and you'll move a little faster than a snail.
Does this sound like bad injectors? Also - tried to start it today and it was just cranking forever...Couldn't get it to start..I did notice while I was in drivers seat looking out the window...some white smoke coming from tail pipe while it was cranking...
View 13 Replies
My truck has been having this issue pretty much since I have had it, but it seems to be getting worse, or so I think.
When the truck is cold, it does not want to move very well. Like it's missing, and it does this until it gets warmer. Also, I have puffs of blue smoke come out the tailpipe when this occurs with it cold.
Injectors? Injector o-rings? Stiction?
FICM volts are good at 46.5v-48v when cranking.
View 6 Replies
Truck started running rough on way home the other day. First gave me P0404 code and would get black smoke along with whitish smoke coming from the tail pipe. I haven't been able to notice or track an amount of coolant loss yet.
Swapped EGR valve this morning and now noticed this once she kicked into high idle (still warming up). About to hook up the IDS, hoping I this is not head gasket .
[URL] .....
View 14 Replies
I have a 2006 F350 6.0 litre diesel. The other day I started it up drove away and it was blowing huge plumes of white smoke out of the exhaust. Shut it off.....started it up again after a while then went on a long drive and it went away. What that was?
View 6 Replies
2006 blowing white smoke and sluggish until its driven for a few miles ..smells like fuel .. New head gaskets and the works started after 20 days over below freezing temps nights at 5 to -5 ....
View 14 Replies
My 2006 6.0 is blowing white smoke/steam and Im losing coolant (not out the top). Pulled the EGR valve and its wet down there. All signs lead to EGR cooler? I've been reading a lot on this forum and Ill do the oil cooler at the same time. I seems VERY important to flush the coolant system before I tear into this. I am afraid of hydro locking the motor or ruining the head gasket or stretching the head studs if I run the truck. How can I do this without further damaging the engine? I am doing this myself. I'll have 3 solid days to finish this job because I have to tow my trailer in 5 days.
View 5 Replies
My 04 PS was blowin white smoke constantly while running. I just towed a uHaul from Connecticut to Virginia Beach and had some coolant issues on the drive down (I was out of coolant on 95 in PA, added coolant and it made the rest of the drive no problem). I got here to Virginia and it was low on coolant again. I added coolant to it, and now I have some other issues. I had what looked like oil comin out the stacks onto the bed, so I pulled the turbo thinking it was seals. But the turbo was just rebuilt prior to me buying it with a wicked wheel in it. It still had stock EGR and it has 202K on it.
Checked and found EGR valve was wet. Ordered an EGR delete kit, and just finished installing it. Now with everything put back together, the truck doesn't want to start. It cranks but doesn't fire. I pulled the codes from my tuner and I got: P0403, P0405, P0683, and P2623. I know P0403 and P0405 are related to EGR but the others I'm at a loss on. The EGR delete kit I bought included the blank to remove the valve but what do I do with the plug that used to plug into it? Any way forward to get the truck back up and runnin again? This is my daily driver and not lookin to break the bank to get it goin again but I really need her to be reliable.
View 14 Replies
I picked up a 2003 6.0 awhile back went ahead and did studs,gaskets, delete. Was driving it and seemed to lose power, started coughing and carrying on blowing bluish white smoke then shut off. Ended up hydrlocking #5, Oring on injector was tore when took out. Put all back together, ran horrible, did a balance test with AE, showed #3 injector, replaced, ran horrible, did AE dropped #1 injector. So in process of replacing the rest of the injectors. Just wondering why it is or was dropping them 1 at a time. Ficm was showing 47.6 to 48.6 volts, could that be it?????
View 14 Replies
2006 overheats and starts blowing white smoke, smells like antifreeze, added 2 gals of water to make it 1 mile home. Smokes on the way @195 temp and when I shut it off it smokes out tailpipe for another 3 min. Smells like the head gaskets just went, what should I check? The eot and ect have been 10 deg or less.
This has 225,000 miles on it ran great before this, so would it be stupid too not get a redone set of heads while I'm doing the gaskets and studs?
I was thinking of getting heads from here, UCF Machine Shop - Precision machining, engine rebuilding and more. Cummins + Ford Rebuild Specialist. And a Sinister Diesel Complete Solution For Ford Powerstroke 2003-2007 6.0L. Are these the right places to deal with or should I look elsewhere?
View 14 Replies
Well my problem went from bad to worse. My 05 started running rough at idle, then smoothed out a bit but started smoking on acceleration a little. At this point it felt like it had more power than ever before and even ran smoother running up to 3k RPM before shifting (manual transmission). But now it's smoking so bad, I can't really drive it. It's smoking white or gray at idle but blowing black smoke on acceleration. I had a cylinder 5 contribution code but with the amount of smoke it's hard to believe only one injector is a problem. I pulled the EGR valve and it doesn't look stuck open but I'm going to replace it anyway.
View 3 Replies
2007 6.0 6 speed, 187,000 miles. The other day started truck, had been running about 20 minutes before. Started fine, go to drive, chugging white smoke, smelled like unburnt diesel, baby truck home, seemed to run ok at low rpm, truck warmed up and ran fine. But I also noticed turbo boost was acting funny. Truck ran fine next few days. Then this morning, started cold fine, started to drive it and same chugging white smoke, it quit by the time j got to the end of my driveway, but drove to work, it quit smoking, ran pretty smooth, but will not build any boost. Truck is bone stock except for exhaust, it's straight piped. Ok. So this eve I borrowed my dads edge cts, here's all the engine codes:
P0069
P0269
P0299
P2262
P2269
The last one is water in fuel, since it started this crap I did notice it was right after it came on in the dash. I'm trying to figure out where to start....
On another note. VGT duty shows 85% at idle ?
Ficm voltage is constant 48 volts
Newer batteries
View 14 Replies
