I am looking for a fuse panel diagram for a 07 F350 6.0 ? The truck didn't have a owners manual in it and I have a couple things not working and testing each fuse is just more self hate than I can submit myself to today.
View 3 RepliesI was wanting a fuse digram for a 2011 f250 6.7. My right brake light is out and I don't have a way of knowing what fuses have to deal with the lights. If some one could tell the which ones or send me a diagram
View 2 RepliesMy wife's 2013 Passat started blowing hot air. I checked the fuses and they are ok. I looked at the sensor switch for the AC on the passenger side of the engine compartment and it looks like the wire caught on something and frayed/cut through. I don't see where it went through to fix. Finding info on this car is a slight challenge. The owners manual doesn't even have a map of the fuse panels.
View 3 RepliesSo I have a 1999.5 F350 diesel and the fuse panel under the steering wheel is acting up. I was driving my truck home the other night and I lost power and my truck shut off. I have had a problem in the past with the #30- 30 amp fuse ( controls the PCM and glow plugs from my understanding) that is under the steering wheel, I replaced the fuse and everything started working normally again. Until the other night when my truck shut off, so I replaced the fuse the truck drove again for 20 feet died again, I was able to hold the #30 fuse and allow my truck to start up again but would eventually killed the PCM and shut off again and would not start up due to what I believe the fuse location shorting it out and killing the power to the PCM preventing me from starting it up again.
I had my truck towed home and charged the battery and it started up fine the next morning. If I push on the #30 fuse my truck the shorts out and kills the power, I do not know if this is normal? The fuse is sitting loose in the fuse holder is there anyway making it fit tighter to prevent it from being so loose? I have read every other post online about the problems and tried everything they have recommended but still can not figure out what was wrong with my truck. I disconnected the fuel filter heater, and also the wastegate solenoid to see if that would prevent the truck from shorting out if I pushed the fuse it did not work.
What the problem could be causing the #30 - 30 amp fuse to be shorting out preventing everything from working? Or how to test the fuse panel and all the relays?
Batteries charged, connection & cables checked. After turning ignition switch, gauges on dash jump around & starts clicking in fuse panel. Top left relay then clicking sound from beside steering column on right side next to trailer brake box. Been having electrical issues & something draining batteries...had absolutely no cold start this winter. No decent mechanics here other than to be ripped a new one @ local dealership.
View 1 RepliesI was to leave tomorrow for a trip with three horses. Last night when I parked my truck the dome light went on and off and there was a noise (like a relay opening and closing?) coming from the area. (I have been having issues with the turn signal getting "tired". At times they would only come on solid then other times try would quit after sitting at a long light.)
Checked my manual for fuses to this issue and I removed the fuse in the spot indicated for the "dome and courtesy lights", number 14. Actually I had removed spot number 15 (5amp). This ended the noise. Drove the truck after and all seemed in order, cruise control, turn signals, interior lights! This was the incorrect fuse according to the book! This event occurred with the ignition in the OFF position. Not wanting to start my trip before I get this in order.
The tech folder "Coffee Table" book link is broken - no more visual aid from there! So, Looking for a copy of the illustrations that show the EGT sensor locations?
View 3 RepliesMy truck didn't come with factory option aux switches. Can it be added, and is wiring present?
View 14 RepliesWhere I can find a wiring diagram of the inside and outside lights on the 6.0s? I'm trying to wire up my running boars lights to my dome lights and tail lights but don't know the colors or locations of the wires. The tail lights wouldn't be as hard to find as the dome lights, what is the location and color of both.
View 14 RepliesI have a late 03 f350 and see some relay boxes under the hood drivers side rear bolted to the fender, looking for a diagram of what those relays do,also one box has a 10a fuse. Also any have a fusebox breakdown for same truck in cab under steering with 4 plastic cover screws?
View 12 Replies2013 F350 Lariat with the factory OEM rear view camera. I am replacing the tailgate with a 5th wheel tailgate for a few months and would like to still retain the convince of a rear view camera.
I have obtained a Ford camera harness to use as a jumper for a non OEM camera which comes with the standard basic RCA wiring which I plan to mount to the bottom of the 5th wheel tailgate.
My hope is to wire the camera direct to the Ford wire harness which is a 6 wire pigtail. Which wires on the camera mate to which wire on the trucks wire harness.
I need to connect a remote start stop for a bucket truck attachment to this new 2016 F550. Found everything except the ignition wiring harness diagram. Need to know what I can tie in to.
View 4 RepliesGot a 2002 7.3 f550 and the other morning it wouldn't go into high idle. Noticed my parking brake light was off. Messed with the switch and eventually jumped straight from the connector to ground... still no light. The light does illuminate with key on. I have tested the fuses. Where do I go from here? Looking for a wiring diagram....
View 14 RepliesFirst off my vents stopped blowing completely. At this time the thermostat was still functioning. Fuse 28 was blown. I replaced the fuse and it blew again shortly after turning the heater on. I replaced the relay and resistor and still blowing fuses. For some reason I tried a 30A fuse and it didn't blow but a few minutes after turning on the heater there was a burning smell. I immediately turned it off and pulled the fuse back out, which was hot. I then replaced the blower motor and at this point there is no power at all to the control panel. The fuses are all fine as well as the relay and resistor. There's power to the fuses. So it seems like somewhere between the fuse box and the control panel I'm losing power.
View 7 RepliesThe power port in my dash went out. The diagram I got off the internet says fuse #39 or 41. Both are good. Where else should I look?
View 1 RepliesI just identified an annoying squeak as the right side of the tailgate, right at the hinge, rubbing on the section of the rear passenger side quarter panel (one with FX4 decal) where it curls around to the rear. Any way to easily adjust the tailgate slightly to the drivers side? When the tailgate is up, the gap is noticeably smaller on the passenger side, and when down, the edge of the tailgate rubs the edge of the quarter panel, paint to paint.
View 1 RepliesIhave a 2008 E 350 6.0 , while driving i hit a small pothole no big deal the van stops running and coasts to the side of the road. get her towed. The dash lights show the PATS is engaged so it is no start no crank.
The 30 amp fuse PCM power relay is blown. when i replace it it blows as soon as i turn the key. im checking for wire chafing but so far have found none.
I purchased 2011 F250 King Ranch Edition about 3 months ago. I'm loving the truck and not had any issues until 3 weeks ago. I locked the truck as usual using the key Fob, and upon returning to the truck, I noticed the doors weren't locked. After some brief trouble shooting, I discovered the the fuse was blown that according to the manual controls just the power door locks. I thought it was strange that a new truck would be popping a fuse so I replaced it...a couple of days later it blew again. This time I was locking the truck with the door key pad. I took it to the dealership and they checked it over and said they replaced the fuse and cycled it numerous times but could not reproduce the problem. The told me that they even put a call in to the Ford engineers and they said check the key pad for water intrusion. The dealership told me they disassembled the key pad and found nothing wrong....lock and unlocked the door some more and the fuse would not blow. I picked the truck up four days ago and the fuse blew again last night. Everything else works...alarm sets and goes off if any of the doors are opened. The only thing that I can find that doesn't work when the fuse is blown is the remote start.
View 14 RepliesBlown fuse causing a lack of power to the OBD port?
I just got my Kiwi2 BT OBD2 adapter and was hoping to start diagnosing my truck, but the adapter won't power on while connected to the truck.
I pulled and visually inspected fuse #12, I also verified power to the cigarette lighter plug and the accessory 12v power outlet.
The adapter powered up with no problem when I connected to a co-worker's Tacoma.
I just purchased a crashed 2011 F350 and trying to figure out why there is no power to the fuse box under the hood. I have power to the cab lights,cluster and so on but will not turn over. Checked the fuse box under the hood and seems to be not power to it. Is there a main fuse somewhere or what do you think??
View 7 RepliesI know that to remove the lower knee panel under the steering wheel all that has to be done is to pull it off and the attachment snaps will pop free. However, How do I go about removal of the dash panel to the left of the steering wheel? This would be the narrow panel that also houses an ac vent, headlight and I believe it is the adjustable pedal control.
View 5 Replies