Ford 6.0L Power Stroke Diesel :: 2007 F350 - Turbo Whine And Out Of Empty Exhaust
Apr 17, 2017
I have 07 F350 6.0 never heard this out of any of my 6.0s. it's almost a whine but can hear it w turbo and out of empty exhaust. Almost like a supercharger noise stumped almost leaning towards actuator for turbo? Noise got real loud swapped turbos used same actuator noise is there but much quieter.
View 1 Replies
Advertisement
2007 F-350 6.0L, Wife phoned and said that the truck backfired a couple of times and there was black smoke from exhaust. When she stopped at idle there is now alot of white smoke but coolant level looks fine. She has about 200 km's to go before she is home pulling a 20 foot horse trailer with 1 horse.
View 14 Replies
Had a bad turbo on my 07 F550 with a 6.0. Replaced it today and took her for a ride. Started smoking and oil was spitting out of the weep hole in the muffler. A lot of smoke. The truck was smoking before I replaced the turbo too but I didn't have any oil coming out of the weep hole. I'm hoping it is just oil that had been passed into the exhaust by the bad turbo that is now being burnt off and pushed out by the new turbo. Does this sound plausible?
View 1 Replies
I have a 2011 that does not currently have the complete factory exhaust system on it and no muffler. With the nice weather I have been driving around with the windows down and hear a noise out of the exhaust that sounds like tires spinning on wet pavement when I let off the throttle or at some shifts of the transmission. Boost seems normal, and don't hear any noise while under load. I think it is just the VGT closing and making the noise. With deleted sys heard this noise in exhaust?
View 4 Replies
I have a 06 f350 superduty with a 6.0 I have had injector problems before with the motor even hydro locking no start this is the problem my truck started blowing white smoke with a strong diesel smell everyone said it was oil cooler but I took it to a ford garage the guy said I had 2 injectors hung open and wasn't hydro locking and suggested to put all 8 in so I did 3400.00 not I went to pick it up had no power at all turbo was not kicking in so I took it right back to them they checked it out said turbo was sticking had to clean it it would take 6 hrs. said the fuel In the motor caused it it was working fine when I took it to them now they say maybe a new turbo are they giving me the run around or is this possible....
View 9 Replies
2005 f350 6.0 all stock except egr delete. My turbo is spooling up and down constantly. I can actually watch my VGT duty cycle fluctuate while sitting at an idle too. I've cleared the codes and p0299 always shows up first, but then I'll get p0069 BARO/MAP, and a p0470 exhaust pressure sensor eventually. Sometimes it takes an hour of driving before those show up. I can watch all these values on my torque pro, and nothing seems out of the ordinary other than the turbo opening and closing at will. What can cause this? I hate to just start throwing sensors at it.
View 11 Replies
I for the life of me can not even see the bolts to take them off.
2006 F350 4X4
View 14 Replies
2005 f350 188000 on the clock had a bearing get loose in the turbo . Installed a new power-max but if the bearings are oil fed should i also change it? There are no signs of metal in the oil or the old turbo . The oil has 600 miles on it with archoil.
View 1 Replies
For a while now, I have been hearing a very high pitch whistle noise from the turbo/exhaust area. Everybody told me it was an exhaust leak, but I never could pin point the leak. While I was under the truck last weekend I found the flex joint on the passenger side up pipe was broken a leaking.
I ordered a Dorman replacement pipe that comes with a new gasket and hardware.
I will be the first to admit, I am not a fan of Dorman parts... BUT, this pipe is really nice. It looks identical to the pipe being sold on Dieselsite.com, it doesn't have the scoop inside to direct exhaust gas to the EGR cooler and it comes with all the mounting hardware.
[URL] ....
Once I got the turbo down pipe out of the way and soaked the bolts with penetrating oil, I had the broken up pipe off in 30 minutes.
View 8 Replies
My truck is fairly new. Its a 2015 Ford F350 with 6000 Miles. I live on the east coast in a 4 seasons climate. Its summer the average temp. is in the lower 90's. Recently, I have noticed that my truck has been shuddering and shaking between 5th & 6th gear.
It started when I was changing lanes; I tried to accelerate going about 45mph, and shuddering real hard. It was difficult to maintain my speed on a level surface. It was almost a total loss of power with no trouble codes.
View 14 Replies
I have a 2006 F350 6.0L Powerstroke. While towing my RV this weekend in 96 degree weather, it appeared that my transmission started to whine after several minutes of pulling some large hills. I was in tow/haul mode. It did not appear that I was loosing power however the sound was very concerning. The sound went away after leveling off, or switching out of tow/haul mode. The sound coincidentally appeared as I approached the top of the hills which ranged from 1 to 3 miles in length.
View 11 Replies
I have a 2005 F350 w/6.0 turbo diesel. Had starter replaced last spring. Went to store recently, came out & truck starter would just wind and whine, no flywheel engagement. Mechanic replaced Napa starter under warranty and now the starter whines when just trying to connect the battery(s) without even turning the key. I did try several attempts at starting truck when stranded at the local store, with no results but starter whining. Could I have created a dead short some where, and where would be a good place to start?? How do you get a schematic of the starting system?
View 2 Replies
I am replacing the turbo on my 2005 f350 6.0. I have the passenger side mounting bolt and the rear mounting bolt out, but cannot get the driver side bolt to budge. I have sprayed it with WD40 and PB Blaster and tried a breaker bar. No luck breaking it loose. I am afraid I might round off the head even though I am using a 6 point socket.
View 12 Replies
Last winter I pulled something and getting out has been difficult. Climbing in my F 350 even tougher so it hasn't been used much. Now that I'm driving a bit I have not seen it regen. Truck stop regenning, is it possible? What happens if it just stops? It use to regen every 200 miles or so and I have been paying attention.
View 7 Replies
This past Monday I was finally able to pick up a 2012 F350 dually and over the weekend I was able to do an EGR and DPF delete and I come to find out while under the truck that it has an oil leak I looked under the hood and it seems that there is oil around the turbo and after the test drive there is a LightStream of oil coming down the exhaust.
Another question is that I have read about the possible problem is that early build 2011's have that's why I chose to look for a 2012 so I didn't even consider looking at the build date when getting it and I come to find out it was November 2011 and this truck has a plastic oil pan should I be worried about The possibility of this engine taking a dump on me and if so what can I do to prevent it?
View 1 Replies
I have a 2013 F-350 with the 6.7L. I pull a 36' 5th wheel with a Swivel Wheel motorcycle on the back. So I'm pretty heavy. Plenty of pulling power, but going down hill, the automatic braking doesn't work anywhere near as well as the exhaust brake I had on my '96 F-250 with the 7.2L. Considering installing the BD Dual Vane Exhaust Brake. Looking for feedback about installing the BD DVEB. How well does it work?
View 2 Replies
Attempting to take this on myself. My passenger side manifold was replaced a year ago.....BTW This damn truck - all stock - no modifications of any kind - just turned 100k miles. One owner - me.
So I have removed everything I think I need to to gain reasonable access including the fenderwell and all the intake tubes and battery and coolant reservoir. I want to use some heat and try not to break the bolts but there is a thin wiring harness just above the exhaust manifold. I can't find it in any diagrams on the ford parts site. It looks like the glow plug and injector harnesses are up above near the intake manifold but this one is down below all that. It connects to small rubber thing - 1 for each cylinder. There is nothing else electrical near it - everything else is up top.
Now my rant - look away if you are a die hard ford truck fan or 6.0L powerstroke fan.
So far I've had to replace both exhaust manifolds because they burned and rusted right through. New transmission cooler lines -yes - rusted through and cooler (because we couldn't get the lines off without destroying the cooler). Cat got clogged (that was fun to find and fix). All 4 front ball joints replaced. Transmission dip stick tube rusted through. Several brake lines had to be replaced due to rust. The air conditioner quit with about 80k miles. I haven't fixed that yet. My oil pan is rusting through and needs replacement. Friggin oil pan! I have never in my long life experienced that. I know of other diesel pickups that are older with far more miles that live in the northeast, used for plowing and never garaged that don't have their oil pans rusting through. Just had to change both power steering lines that go to the gearbox due to leak caused by rusting through. EGR needs to be cleaned or replaced almost as often as the oil need changing. This POS needs to be out of my life!
Too bad because if it was dependable and wasn't made out of the cheapest crappy metal Ford could find it would be a great truck. Rides and hauls great. Plows great. Good looking truck, too. Standard cab 8 foot bed. Dark green. Just can't keep doing this.
View 13 Replies
My 2012 F350 Lariat has 6100 miles on it now and on the way home tonight I got a "speed limited to 50 mph in 50 miles" message on the display. It states that there is a "diesel exhaust fluid system fault". The def was topped off about 2000 miles ago and the message center says that the fluid level is "ok". I am going to be on the phone with the dealer first thing in the morning. This is my personal/work truck and if I can't tow a trailer then I can't work. My guess would be a faulty sensor. I have no doubts that the dealer will get this resolved quickly as they have been great about everything else. I also want to say that other than this, I am sure minor issue, this truck is awesome!
View 14 Replies
I'm on the road and I pulled over for a pit stop so I don't have time for a search right now, but I noticed under heavy acceleration a turbo whine so high pitched it almost sounds like metal on metal. Is this normal and I just noticed it, a leak somewhere, or maybe indication of something worse? The truck seems to be running ok otherwise. It's an '02 w/7.3 and 220k miles.
View 3 Replies
I have a 2007 F350 6.0 Diesel. Truck starts and runs great for about 10 miles and then loses power and slows down til it dies, it does this without any kind of warning and does not rattle or anything. If i let it sit for about 15 min it will start right up and drive fine for another 10 miles or so and do the same thing.
It did the same thing in December but would not restart at all and the ficm was the cause at that time so i went ahead and replaced the ficm just to eliminate it. I also replaced the fuel pump and the ipr and icp valves are good. The only engine code has to do with the fuel level sensor and that has been on for a year. The egr was recently replaced, the hpop is putting out the psi that it is supposed to and there are not any internal air leaks.
View 2 Replies
My 2007 F350 CC DRW KR has developed a serious oil leak recently. The oil runs down both sides of the bell housing but seems to be worse on the passengers side. It only leaks after five or so minutes of running and not while off. I have searched literally hundreds of threads and found only one that seemed similar and the resolution was never posted.
The truck is stock with only a turbo back 4" exhaust. I initially thought of the STC fitting failing and cracking the rear engine cover, but I still have very good ICP (650 almost immediately when cranking and at idle, 3000+ when on the throttle).
I plan to pull the turbo next weekend to check the drain tube and HPOP cover as well as checking/replacing the STC fitting (since I'm in there).
View 1 Replies