Ford 6.0L Power Stroke Diesel :: 2006 - Runs Smooth But Low Power

I had a no-start, replaced standpipes and dummy plugs. Passenger side dummy plug o-ring was shot, some of the others were pretty worn. Polished the spool valves and replaced injector seals. Confidently put it back together and fired it up. Idled sweet, bad low on power, especially at low rpm. FMP was bumping 45 so sent it to ED. It seemed a little better but not fixed. No visible smoke. Engine temp doesn't seem to make a big difference but it may be slightly better warm. Fuel consumption is hovering around 9mpg over the last 150mi. FPW stays around 800us warm/5.8ms cold. I think the low mpg is the excessive throttle needed to pull away from stops and climb hills.

I spent the day checking stuff and found the following.

The only codes are for a couple of glow plugs and a "key in ignition" error. No contribution codes. Monitored (with FORScan) the turbo (MAP, Baro, EBP, VGT), FICM, TPS, ICP/IPR(cold and warm) EGR, vRef, MAF vs TPS, and some other stuff like miss fire count (0), voltages everywhere I could look, and FPW. I saved a dozen files while checking this stuff and can be more specific on the numbers. Fresh fuel filters, No bubble in upper filter housing while cranking. Fuel pressure was 64 at idle, 61 when power braking or revving. No leaks on CAC or exhaust.

Possible culprits : Could I have done something to cause low power when I cleaned up the injectors? I'm sure the orientation of the spools and coils were right but I did "fudge" on the torque for the coil screws. If anything they may be a bit loose as I read a couple of times over tightening would cause problems. I am certain there is no play and a slight amount of load on them. I did clean the tips and bodies on a bench grinder with a gold colored wire wheel, light pressure and just a quick pass cleaned them up. Also, I ohmed the coils while they were on the bench. No shorts or opens except where there was supposed to be opens. All the coils were .5ohm except three read .6 and two read .8. Injector buzz sounds raggedy, not smooth. Any of that a issue?

Cold ICP/IPR is higher than it used to be, at 40 degrees I see 35% and 1300psi but ICP desired is 1250psi. I also noticed monitoring the TPS, rpm desired stays at 0. All three tracks measure position but one shows a constant .25v while the other two vary. Throttle position fault stays at "no" at all times. When it was a warm no-start (at the beginning of all this) I cranked it for maybe a minute total. ICP never went above 300psi so I knew why it wasn't starting. It was cranking normally in the beginning but part way through the second try RPM's went up suddenly as if it got easier to turn. When I started the truck the next day it limped home in this "low power" mode and even though it starts righ up now and idles smooth cold, the power issue remains. I plan to get a better set-up and recheck fuel pressure at WOT tomorrow.