Ford 6.0L Power Stroke Diesel :: 2006 F350 - No Power At All / Turbo Was Not Kicking In
Mar 6, 2017
I have a 06 f350 superduty with a 6.0 I have had injector problems before with the motor even hydro locking no start this is the problem my truck started blowing white smoke with a strong diesel smell everyone said it was oil cooler but I took it to a ford garage the guy said I had 2 injectors hung open and wasn't hydro locking and suggested to put all 8 in so I did 3400.00 not I went to pick it up had no power at all turbo was not kicking in so I took it right back to them they checked it out said turbo was sticking had to clean it it would take 6 hrs. said the fuel In the motor caused it it was working fine when I took it to them now they say maybe a new turbo are they giving me the run around or is this possible....
View 9 Replies
Advertisement
I for the life of me can not even see the bolts to take them off.
2006 F350 4X4
View 14 Replies
2005 f350 6.0 all stock except egr delete. My turbo is spooling up and down constantly. I can actually watch my VGT duty cycle fluctuate while sitting at an idle too. I've cleared the codes and p0299 always shows up first, but then I'll get p0069 BARO/MAP, and a p0470 exhaust pressure sensor eventually. Sometimes it takes an hour of driving before those show up. I can watch all these values on my torque pro, and nothing seems out of the ordinary other than the turbo opening and closing at will. What can cause this? I hate to just start throwing sensors at it.
View 11 Replies
2005 f350 188000 on the clock had a bearing get loose in the turbo . Installed a new power-max but if the bearings are oil fed should i also change it? There are no signs of metal in the oil or the old turbo . The oil has 600 miles on it with archoil.
View 1 Replies
I have 07 F350 6.0 never heard this out of any of my 6.0s. it's almost a whine but can hear it w turbo and out of empty exhaust. Almost like a supercharger noise stumped almost leaning towards actuator for turbo? Noise got real loud swapped turbos used same actuator noise is there but much quieter.
View 1 Replies
My truck is fairly new. Its a 2015 Ford F350 with 6000 Miles. I live on the east coast in a 4 seasons climate. Its summer the average temp. is in the lower 90's. Recently, I have noticed that my truck has been shuddering and shaking between 5th & 6th gear.
It started when I was changing lanes; I tried to accelerate going about 45mph, and shuddering real hard. It was difficult to maintain my speed on a level surface. It was almost a total loss of power with no trouble codes.
View 14 Replies
I am replacing the turbo on my 2005 f350 6.0. I have the passenger side mounting bolt and the rear mounting bolt out, but cannot get the driver side bolt to budge. I have sprayed it with WD40 and PB Blaster and tried a breaker bar. No luck breaking it loose. I am afraid I might round off the head even though I am using a 6 point socket.
View 12 Replies
So this '06 F350 is blowing fluid from the steering pump fitting when you move steering wheel to either side all the way(lock). Is the internal o-ring blown in the fitting? Do these have the teflon seal at the pump? Pretty new to the 6.0 scene. Got a new line ordered.
View 6 Replies
I have a 2006 f350 4x4 dually 6.0. The other morning when leaving for work I hard a loud air noise, like a jet. It only happens when the motor is trying to create boost. I have NO boost. No smoke. If I push the fuel pedal past 1/4, nothing. Its like its stuck and no more power at all. I have changed the boot from the turbo to the intercooler pipe. (looked like it had cracks in it). Checked the cold pipe, no cracks seen. Check the exhaust clamps, into the turbo, they are tight. The turbo is seeping oil around the seal. I took the inlet, fresh air, pipe off. Check the turbo spool for looseness, fins, spun the wheel, ran the engine and watch to wheel. Seen no issues. Where to go now?? No coolant leaks, no oil leaks.
View 7 Replies
My dad recently bought 2006 6.0. He has had it about 2 and half months. Has the egr delete kit installed. The truck has ran great. Up until Wednesday the 3rd. My dad headed to Ut to pick up our new quads. While heading up a small grade with empty trailer in tow. Truck went to limp mode, fan kicked on, orange wrench came on on dash board. He pulled over let her cool down turned her off.
Checked fluids Then started her back up and she was fine. That has happened 3 times. Now he is on his way back (tow haul mode turned on) and it is doing it again. She hasn't went into limp mode yet. As soon as the fan kicks in my dad pulls over immediately and puts it in park. And lets her cool down checks fluids. This issue only happens mid way up a grade. So my question is...... What is causing this? How do we fix her and make her a happy truck again.
View 7 Replies
I drive an 06 f350 with a 6.0 diesel. My truck has quit on me twice in two months. It lost power then stalled and would not restart. I had just changed fuel filters but checked them anyway to see if they were plugged. They looked clean so i put them back in and the truck fired up. It ran good then two months later it did the same thing.
I noticed I could not hear the fuel pump so i pulled the cap off if the top fuel filter to see if there was fuel in it, and heard air being sucked in (or pushed out?) as i loosened the cap. I put the cap back on then turned the key and i could hear the fuel pump working. I waited for glow plugs and it fired up. Is my engine getting vapor locked, or sucking air? If so then why would it only happen every now and then instead of continuously?
View 14 Replies
2006 f250 egr delete banks intercooler / cac tubes. Afe intake ... Sinister egr delete plate..... Truck smokes when sitting at a lite upon take off. Removed down pipe found slight amount of oil. Removed turbo put a kit in it and it is worse now. The turbo was in bad shape. The thrust bushing was pretty ate up and it had a lot of shaft play. I cant believe it wasn't hitting the housings. My thought was maybe the housing is bad. If the orings fail on the vgt solenoid what happens ? The vgt is working cause i can throttle it with the auto ingenuity...
View 14 Replies
So I bought my first diesel last night and I'm in LOVE!!! It's an 06 F-250 with 6.0 (obviously). It's bulletproofed, rebuilt FICM, EGR deleted, and 4 inch exhaust IIRC. Previous owner had an issue with the turbo and replaced it. New turbo was DOA so he rebuilt it (sort of) and added a precision turbo (again IIRC) back housing (I think) to it. It has an SCT tuner as well and I have it set on the custom economy tune. Is this normal? Is there something I need to be doing about this?
View 6 Replies
I just picked up a 2006 F250 6.0. It was having hard starts. Anyways before I started using it I started tearing things apart cause I knew for sure the turbo was leaking so that had to be resealed. I just picked up a 2003 turbo today for it out of a used truck that had 144000 kms on it. (was in an accident). I am gonna post up a few pics here of the engine bay area, there is a huge amount of old oil I believe to be, I am wondering if it was a leak or spilled oil. I am going to be cleaning this up. Putting 03 turbo in here, doing a service and then plug my Tablet with torque pro and post up some numbers and see how healthy she is. Before I post any pics Is there a way to make these pictures clickable instead of them taking room up on the page?
View 14 Replies
The ford dealer in Las Vegas replaced my turbo with a remanufactured one. Coming off the line (like quickly pulling into traffic) it goes flat on power until I get a few RPM's. Even with the old turbo it never did that and I drove it for the last 30k miles with it throwing the low turbo boost code. They put a little over 100 miles on it for road testing (I did have other things that they worked on. {4x4 2006 F250, 6.0 engine, 110k miles and I bought it new}....
View 4 Replies
I would like the hear what others have to say about the problems I'm having with my 2006 F-350 sd xlt 6.0 with 113,000 miles on it. It's being used as a tool truck mostly going from a shop on the property to close by buildings on the same property. In other words very short distances. Used occasionally to take a dump trailer to a close by dumping ground.
1. White smoke from exhaust. I've read this is most likely an ERG cooler that needs replacing. Any other possible causes? If I end up having to replace the cooler is there a stock cooler that is reliable or should I get the one by bullet proof?
2. Diesel is dripping from the muffler weep hole. Last full tank lasted only 60 miles. Could this be the oil cooler? Anything else? If so is the Ford replacement cooler OK or should I go with an upgraded cooler?
View 14 Replies
2005 F250 SD, Crew Cab, Diesel 6.0L...
Hauling my jeep (close to 16,000 pounds all in F250+trailer+jeep) on a highway going a little over 70mph up a hill when I seemed to have lost some power and the check engine light came on. The turbo PSI was well over 20PSI (according to the gauge in the dash). I have a Scan Boss but I have not been monitoring turbo boost PSI.
I was only 10 miles from the final destination so I continued without stopping. It seemed that the turbo was limited for the rest of the trip. Later in the evening, no more check engine light but I haven't really driven the truck since then.
What do you think the problem was? What should the course of action be?
View 9 Replies
Having this problem, what to do to correct it? There is no hole in the boot and this just started about a year ago. Does not do it all the time.
View 4 Replies
I know I have a clogged oil cooler and normally I'm not home much during the summer months to know how it does during the summer. The outside temperature is around 95*, but the thermostat on the Ex is reading from 102 to 112, and it actually read 122 yesterday. Also, with the hot weather, I'm not noticing the fan kicking on under normal driving without a load. The AC is working, but it's not the ice cold AC I'm use to and does get better while cruising down the highway.
View 2 Replies
This truck is bone stock FYI. I get in it to crank it and I get nothing. Batteries are good, everything in the cluster lights up, and looks normal. No codes are thrown. I can hear the solenoids click under the dash and hood. I check the voltage of ignition cable at the starter and I get no reading.
There is a single thick yellow with light blue stripe coloured wire on the passenger side of the engine compartment, beside the vacuum pump with a "squeeze and pull" type disconnect. Disconnect it, and connect the male half of the connector to the passenger side battery positive terminal. Do this with the ignition key in the RUN position. Does the truck start?
This is where it gets weird. The truck does start and after i reconnect the wire it it starts normal. I started it several times throughout the day. The next morning I get in the truck. No start. I have to use the wire and manually connect it to the battery and it starts right up again. This time I get a "Tow/Haul" light blinking on the dash. It will go into gear but pressing the acceleration pedal does nothing. I turn it back off, attempt to start it normally and it starts right up. No it will go into gear and drive. Now I am thinking maybe the neutral safety switch?
Could it be a solenoid sticking or the neutral safety switch or something else entirely?
View 14 Replies
I have a 2006 6.0l f350 crew cab that blows air hard every time I accelerate. Sounds like you're going 100mph with the hood unlatched. It blows real hard for a minute and goes away if I accelerate through it or let off.
View 7 Replies
