Ford 6.0L Power Stroke Diesel :: 2006 F250 Started Surging At Idle
May 31, 2009
Just bought a 2006 F250 with 6.0. A week or so ago, it surged once at idle at a light. Sort of felt like someone bumped into your rear. It has gotten more frequent over the last week or so. Now it does it often. It tends to rev up and then back down again over and over. Then it will clear up again. My brother said his 7.3 used to have a similar problem (as did quite a few others apprently) and it was the Cam positioning sensor (CPS). Where is it located?
View 14 Replies
Advertisement
My friends 2004 6.0 f250 has 280000 miles on it and it runs perfect "did" until I tuned it with my sct tuner to run a looney tune so he could see what it was like. The truck started he revved it up to 3'000 rpm then when it returned to idle it acted like someone shut the key off. The high pressure oil system is new and has 700 psi and the icp is good also the ipr. The truck Is not getting any fuel at all, no smoke from cranking at all. It is returned to stock and is still being difficult. It has fuel I checked the upper fuel filter, it has enough oil, and it also has a good motor just don't fire. Why?
View 3 Replies
Last night pulled in at rest stop and truck started surging then stalled put dieselkleen in and topped off tank but no luck eventually would not run at all. Had it towed to ford and this morning started right up running fine. Having them change fuel filters. Not sure what to do got to get back to drive?
View 11 Replies
A few weeks ago I got in my 2005 EX and started for work. As I idled in traffic, the engine started surging (it had never done this before). So I took it right to Ford and dropped it off before it got worse. Of course, they couldnt look at it until Monday (this was a Thursday), so I had to get a rental.
I get the call on Monday that the surging problem was an injector, but covered by my warranty. But, it seems that my EGR cooler was bad, but even more important was my blown head gasket.
WHAT?! My truck did NOT have a blown head gasket when I dropped it off. But thats besides the point. There was much back and forth between Ford and my warranty company, but finally I got them to cover the head gasket.
But, I had to pay for the EGR cooler. So I asked the Ford mechanic if I could supply him with an upgraded cooler, so I wouldn't have this issue in the future. He said no problem. I then told him I was going to buy a Bulletproof and he said no, get a delete kit. He said "I've done a number of these, and its really the best solution.". He even HEAVILY recommended the ADT Delete kit. He even said that since I have a 2005, we can just leave the EGR valve hooked up and I wouldn't have a CEL issue.
Fast forward several days. I picked up my EX last night and... CEL is on. I called and spoke to the mechanic and he told me that I must have an upgraded program, and that my only option is a tuner to turn off the EGR completely. He also told me that I don't need an expensive SCT or Bullydog just for the EGR.
Anyways, with all of the above setting of the stage complete, just wondering what my best option is here... Is there a simple/cheaper tuner I can use to just disable the EGR? Is it worth the money to get a more expensive tuner? For the most part, this is my daily driver and I don't need a performance or towing tune. I wouldn't mind better mileage, though
View 14 Replies
I've got an issue with my truck, I was towing home my camper this weekend and my engine started missing out and vibrating very bad, then it overheated... pulled over and check codes, p0263, p0299, p0300, p0301. Oil all over engine, tons of blow by, definitely a dead miss on cylinder 1. Smokes bad out of exhaust, zero power, and blows cap off of oil filler when loose, tons of smoke and oil from ccv.
My question is, could it be in the valve train? Or is it going to lie in the piston/rings? Blown head gasket? It did overheat, but didn't puke out of bottle, turbo timer kept it running for a bit after I shut it down roadside, egts were definitely high. Also the egr is deleted, have a predator programmer with custom tune for she delete.
View 14 Replies
I replaced the exhaust back pressure sensor and the readings on my sct programmer didn't change at all so I don't want to keep blindly throwing money at it if one of you has experienced this and found a cure. The interesting thing is it never throws a code or check engine light or anything according to my sct. Doesn't even show that the egr valve is unplugged. I have read that it could be a bad turbo, vgt solenoid, icp, throttle positioning sensor, or a couple other things.
It feels like I'm the front car in a bump draft in cup racing when I'm at a steady speed. The truck has arp head studs, new style egr cooler with the tubes, coolant filtration, new oil cooler, new ficm, blue spring, all filters have been changed in the last month.
2004 powerstroke surge/ rapid idle - YouTube ...
View 14 Replies
I have a 2006 f250 with a 6.0 with sct livewire, arp studs&gaskets, oil cooler, blue spring mod, sinister egr cooler and it had been giving me some real troubles lately. Started off as a code for injector #8 so I replaced that and while I was in there I rebuilt the oil rail with new nipple cups and orings, replaced standpipe and dummy plug in that bay(also updated the arc fitting less than a year ago), new exhaust back pressure sensor tube because it was right plugged with carbon, and a new egr valve because that was right packed with carbon as well, all backed together and torqued to spec from the Haynes manual and the truck still sounds like its missing at an idle with some light smoke(just smells like unburnt fuel). From there I went to test the ficm which is also only a couple years old and it seems to stay at a constant 48v so at this point...
View 11 Replies
I have a 2006 f-250 6.0. About 2-ish months ago, it started revving up while I was parked and hooking up a trailer. It ended up needing an ICP sensor and pigtail wires. Was fine after that until around 10 days ago, it died when I was driving down the road and wouldn't start back up. That time it was the IPR. Got it back Friday, drove home (40 min) and didn't need to drive it until today. I fired it up, and we're back to the revving/surging. I decided not to take it on the road, really tired of being stranded. Could it be the icp again? Something else? I'm so tied of throwing money at this thing.
View 7 Replies
I was driving my 2011 the other day home from work and experienced a rough idle. Normally the truck idles pretty smooth. I noticed when I was driving at highway speeds the truck seems to shake a lot. I pulled over and turned the truck off. I did a walk around and could find anything out of the ordinary. I started it back up and no more rough idle. However while i was driving at freeway speeds I could feel a momentary lack of power, then the truck would regain its speed. This would only last a sec or two.
I figured I'd give it a few days.... well now its gotten worse. Its doing the same thing but a noticeable difference in the lack of power. I still have boost pressure and the turbo seems to working fine. Im trying to figure out what it might be. I'll be taking my truck into ford again...
View 12 Replies
A few weeks ago i had a surging idle issue very intermittently, and it went away for a while so i stopped thinking about it. Just got back from a weekend in vermont, about 130 miles each way, and i noticed as soon as i got to vermont and came to a stop sign it was surging, and when i just got home it was surging again. Why would this have picked back up after long stretches of running for a while? Runs great as far as i know, just have this surging idle for some reason.
View 14 Replies
So any ICP sensor been proven bad but i was not leaking oil? The symptoms of my truck sound similar to a bad ICP...fluctuating idle, surging, stalling, but it does run and start. IT tends to start acting up when it hits operating temp.
I have an 04 and the ICP sensor is in the easy spot to get to on the valve cover vs under the turbo (that's awesome) so its an easy swap. but just wondering if there is any way to test it over simply swapping it. I do not have a monitor yet but a dongle is on order and will get the torque app for my tablet.
View 14 Replies
Truck has been doing this and now getting worse. 06 f250 6.0 147,000 miles. Runs like crap when you first start and truck has trouble shifting when I first take off in the mornings until it warms up then it idles fine and runs like a champ no problem shifting. Not in a cold climate 40F at the least. Not trying to take it to the dealer and get raped. Been doing research some people say get the inductive heat flash, some say needs new injectors, some say could have a bad gasket on the injector idk. I'm trying trying to get it resolved....
View 4 Replies
While driving home the other night at highway speed my truck lost power. I just filled the tank about 15 miles before then and everything was running fine. No lights came on the dash before the truck died and now can't get it started. Bad fuel? Clogged filter?
View 5 Replies
I have an 03 6.0 F250. My truck started blowing fuse #45 and it would kill my gauges (fuel, oil, mph, rpm, temp, trans temp, and odometer) and I was just replacing the fuse and putting off the repair.
However, the most recent time my gauges blew, the fuse did not, and I put in a 20 amp fuse, in hopes that it would not blow so quickly, bad idea. So naturally, I ordered a new shift lever, in hopes that it would fix the gauges and I wouldn't have to deal with it anymore, but I think it was too late and something else needs to be replaced. What I could possibly have blown by having a larger fuse in there?
View 9 Replies
Went out to start my truck this morning and it wouldn't start. Cranks fine and almost started once but died. Checked all fuses all my voltages are good. Oil and coolant are good. When I turn the key on I can hear the fuel pump and sounds like it's priming correctly. Might be an issue with a clogged fuel filter? Maybe? Haven't had any problems or issues otherwise.
View 6 Replies
My truck died on the way home the other night. After pulling over it started right up but died three more times on the way home. Changed fuel filters, cps sensor which wasn't bad when tested, checked fuel pressure (60 psi), cleaned egr valve, fcim has 48 volts, batteries have 12 volts. Tried unplugging egr valve and icp sensor. Truck will start with icp unplugged . Ipr, stand pipes and dummy plugs were replaced last year when I purchased truck. Truck will run in park fine no issues idled normal, builds rpms and boost. Put it in drive when it gets warm rough idle and dies but starts right back up evertime. When truck doesn't die it has no power.
View 10 Replies
I have a 2004 Ford F250 with 174,000 miles the truck has a slight miss a rough idle one hot or pulling I have 2 codes nut no light when I go into the ford oem feature in my scanner a PO 272 and a PO404 .. Where to start?
View 4 Replies
I'm new to diesels. I just bought a 2004 F250 with the 6.0 V8. I have the high and low circuit, contribution codes on cylinders 4 and 8. I've only had the truck for a few days but I've been reading a ton. The symptoms are hard start, rough idle/shaking, no power when cold. When it heats up and I'm over 2000 RPM it seems to be just fine. Even when hot and below 2000 RPM it does ok. I've check the FICM. It reads 48V with key on and 48V running. My plan is to do the following:
Change the Fuel Filters
Change the oil filter
Change Air Filter
Change oil with 5-W30 synth and I have both Hot Shot/Rev-X
If that doesn't work, I'll replace the two injectors. How does that sound.
View 14 Replies
Just happened today right after I bought diesel. thought it may be water in fuel but after researching wondering if it is injector, etc. It starts every time knocks real bad sometimes for a minute, but clears up to idle ok. During idle no smoke, slightest acceleration however produces white smoke harder I accelerate more it plumes and it smells like diesel in the air.
Cannot get past 15 or so mph till switching into 2nd gear then 25mph max. Had to drive 4 miles like this I can say it cleared up and drove 1/2 mile until I had to stop at a traffic light then going from idle to acceleration again ran bad rest of way home another 2 miles.
A few years ago I did have a rough idle and accel. similar and it ended up being the broke pick-up/sending unit in tank (but of course that was when you get to around 1/4 tank of fuel and didn't run bad above that much fuel in tank), plus there was almost or more than a gallon of water in tank. I have done the mod for the fuel pickup with hoses, filter canister, etc. but wondered at first today if I had gotten bad gas or water in the tank again. Not sure how that much water got in the tank to begin with but that was bout 5 or 6 years ago.
Truck has over 200k miles and Ive had it for 11 years. In the morning will check the ICP sensor by unplugging look at fuel filter bowl, etc. A question I have is: Is water heavier than diesel, would it run thru my line first? thinking diesel is heavier than gas because of oil content....
View 2 Replies
I have a 2007 F250 4X4 6.0 diesel. When first started it idles extremely rough to a point it sounds like a old gas engine missing. But after it warms up for about 15 minutes it runs and idles like a new truck. I'm thinking it's the injectors if so is this something I can change/clean .... It's 98* on a cool day , when "cold" I mean just started for many hours.
View 13 Replies
04 f250 364000 miles 06 6.0. New fan clutch. Ac didn't work when I put the engine in found out the fan clutch was bad so I replaced it. Now it doesn't turn at idle until the engine warms up even if I have the ac on. In the mornings it comes on and keep the temp at 190. In the after noon when if finally comes on truck runs at 210 to 190. Fss 530 when on at 210 at idle. And 800 at 1200 rpm what is going on.
View 3 Replies
