Ford 6.0L Power Stroke Diesel :: 2006 F250 - Draining Water From Fuel Line?
Jun 29, 2016
I have 2006 ford f250 6.0 diesel. I was changing the fuel filter on the frame rail and noticed a lot of dirt in the housing . I tried to remove the plug to drain water to see if i could get out some of the dirt. But the bolt just turned and wouldn't come out. It wouldn't tighten either. I went ahead and cleaned as much dirt as i could and changed the filter. How to get the bolt out....... I just bought the truck so i don't have any prior maintenance history...
View 4 Replies
Advertisement
Anyway, Just bought a used 2015 F350. I want to drain the water separator as the dealer can't tell me when it was done last. Anyway, I read how to do it, but once you drain it, what do you do with the diesel that drains out with?
View 14 Replies
2013 f250 6.7 yesterday during drive through heavy rain fall noticed some clean water draining on my bare feet on passenger side of the truck right below glove compartment.
View 6 Replies
I have a 2006 f250 with 120k. I am having trouble getting the water in fuel light off. I drainned the water out and replaced both filters and the fuel water sensor. The check engine light is now on and the water in fuel light is as well. I'm stumped and can't figure out what to do next. Will the check engine light come on as well with the water in fuel light or is it two different problems?
View 2 Replies
The ford dealer in Las Vegas replaced my turbo with a remanufactured one. Coming off the line (like quickly pulling into traffic) it goes flat on power until I get a few RPM's. Even with the old turbo it never did that and I drove it for the last 30k miles with it throwing the low turbo boost code. They put a little over 100 miles on it for road testing (I did have other things that they worked on. {4x4 2006 F250, 6.0 engine, 110k miles and I bought it new}....
View 4 Replies
Recently my 2011 F-250 Diesel with 21,000 miles seemed to start hard one morning. After starting the truck it ran well that day and started fine. The next morning it would not start. Had it taken to the dealer and they went to work. Started at the fuel filters and replaced low pressure fuel pump. Thought a piece of the defective pump had moved up fuel line. Removed high pressure pump and found signs of rust. All regular service intervals have been met. Didn't see this coming. No water in fuel light or other warning.
View 14 Replies
On my 2006 6.0 the water in fuel warning kept coming on the dash. After going draining a few times and a few tanks later I knew something wasn't right so I bought a new sensor. When I pulled the old sensor out, it was full of gunk that was like a white jelly. I probably could have just cleaned the old sensor but I put the new one in anyway. My issue went away for a few months when the WIF alert came back. I pulled the sensor out again and sure enough it was gummed up. I've decided to pull that little panel door off and clean the inside. I have a few questions:
1) Can that oring be purchased separatly?
2) Can I just reuse my oring if it still looks good?
View 3 Replies
2004 F550 with a 6.0. I had to clean out my fuel tank, replace the HFCM and filter on top of the engine. When I start the truck it will run for 30 seconds or so, start running rough then die. I opened the cap on the fuel filter housing on top of the engine to make sure the fuel was getting there. I turned the key on and the fuel bowl quickly filled up.
After a short time however, the fuel drained out. To where I do not know. I don't think this is normal as every time I've changed the upper filter on a 6.0 it is always full of fuel. Why could this one be draining out and could that be the issue why the truck dies after starting and running for a short period of time. I changed the o-ring on the cap and the new HFCM was purchased from Ford.
View 13 Replies
Couple of years ago I installed a fuel pressure gauge. I wrapped the fittings with teflon tape. Well within about a year it started leaking. So I shopped around and used Permatex Permashield fuel resistant sealant on the fittings. It says diesel resistant on the package. Couple months later leaking again. So I take it apart again, clean every fitting and follow the instructions to the letter. Well its leaking again. What will resist diesel fuel under 55 psi pressure. All the fittings seem to be pipe thread.
View 7 Replies
For the last four months my 04 F350 has been having the same problem every now and then. Cruising down the highway at a decent speed and the fuel pedal/fuel shuts off. Only lasts seconds then re-engages. Two lights come on. Low fuel and water in fuel. I changed the internal fuel pump last week and it did it again tonight. The truck runs great otherwise except for an occasional death shake while stopped at a light. No codes came up and FICM is at 54.
View 14 Replies
Changed fuel filters today. Now my water in fuel light is coming on. But the truck is not running any different no sputtering or anything. ????? Could this be human error
View 14 Replies
Went to go and start my truck this morning and noticed after it was running that it sounded like a misfire, then i seen the smoke... I shut the truck down and lifted the hood and seen that somehow i had a high pressure fuel injector supply line on the Lh side break off. The line that goes from the fuel rail to the injector port on the valve cover (theres 4 of them on a side). There doesn't seem to be an o-ring or anything on them, they are just pressed over and tighten down.
View 6 Replies
I had to drop my fuel tank and as a result, I replaced the fuel lines from the underbed filter to the tank. After replacing everything, I purged, purged, and purged some more. With much difficulty I was able to get the truck running and it ran good. But, I have trouble restarting the truck anytime I let it sit for a couple of hours. It cranks and cranks and eventually fires, but with much difficulty.
View 12 Replies
Ok. I have a 2015 6.7 power stroke and my fuel return line clip keeps falling off. And goes into limp mode. It has happen twice and in come up with code p0088. And I push it back on start the truck and it is fine. But idk why it is doing it
View 1 Replies
2005 PSD 6.0L Excursion ... I suspect that have a fuel leak at the fuel line fittings near the driver side cylinder head. (I believe that it is fuel, since it is so clear, I guess I should collect a few drops and see if it burns vs. coolant.)
It appears to be at the junction of the fuel lines. This is the point where the fluid drops off the tubing and falls down. The clip that holds the two tubes together at the joint is very dirty, the one below them is clean. The tag on the line that is at the joint leaking is part number 3c34-9j338-ag. Is there a o-ring in side the joint? Do I need to replace both hoses of the joint? I can't find any posting of a history of this fuel line leaking.
Or... is it that the joint never fail, and the leak is up tube? I can't see any where it is coming out when viewing it from the top.
View 6 Replies
Tonight I changed my fuel filters for the first time. Went well. However, when I was hooking up the WIF sensor connector, it wasn't pushing in very well. I looked and the pins were straight, I kept messing with it. I noticed that the sensor was loose in the housing. It looks like there are about 4 tabs that hold the end of the sensor in the housing. When the end of the sensor came off, one of the two springs and 0-ring popped out. I managed to find them and re-assemble it. Is this a normal occurrence? Do I need to order a new housing? If it falls apart and I get a WIF message, is there any type of de-rate that happens or can I keep driving?
View 1 Replies
How do you tell if there is water fuel drain plug check area ? Fuel always looks the same to me.
View 14 Replies
OK, after I drain the fuel/water dohickey, what do I do with the waste? Pour it in my neighbors garden, on the railroad tracks, in my waste oil container or other (be specific)? Also what should I use as this collector, a small piece of Tupperware?
View 6 Replies
The dreaded "water in fuel" indicator is on! I'm traveling an hour south of me in the blizzard and the WIF indicator goes on. I immediately pull over and crawl under the truck to find the wiring to the sensor disconnected!!!(I just had Ford service the vehicle Monday!) I plug it back in and no change. After 50 miles or so the truck goes into reduced power mode. I get home and ride out the storm. After cleaning up the snow I get under the truck and disconnect, clean, and re-install connector on the sensor. Drain fuel from bowl.....not a drop of water. Restart truck...still no change. I know there's no water but now what?
View 14 Replies
I was about 2 miles from my home today when the Water In Fuel Warning appeared on the dash. I drove home and got everything read to drain the water separator. I crawled under the truck and the wiring harness was unplugged from the filter housing and wrapped around the rest of the harness. I just last week had both fuel filters changed during a routine oil change.
It appears the dealer left the wire unplugged. I drained some fuel just to be safe and as expected found no water. I plugged in the wire and started the truck. The warning went away. Here is my question: Has this event set some stupid bit or trigger in the ECM that Ford can use later to deny a claim? I called the dealership and talked to a tech who said "no". The service manager is supposed to call me tomorrow.
View 14 Replies
My water in the fuel light came on for the first time since I have owned the Excursion, which is a little over a year. Only thing i have done different is Monday this week i put in some hot shot diesel fuel additive to try with stiction. Dothe additive is the cause of the light to come on?
View 2 Replies
