I have a 06 f250 that has a coolant leak in the front of the engine. It's was leaking about a month ago replaced the water pump it stopped. Then about 2 weeks later it started back up again. It only happens when the engine is cold. But once it warms up it starts leaking again. I am confused as all get out on this.
View 1 RepliesNothing to be alarmed about, I'm just letting y'all know I have a coolant leak on the front of the motor. It leaks about 8oz. Of fluid/week.
I have been through the radiator issues, 5 in all on my '08 and 1 on my '11 at 52,000 miles. This one is different, I'm pretty sure it's the water pump.
I'll give the official word as soon as I can get it diagnosed. I guess it's because I tow all the time, nothing real heavy, just everyday use. Truck is hardly ever on its own.
I just replaced the oil/egr cooler, stand pipes and dummy plugs along with all suggested upgrades, just filled with oil hooked up batteries and while filing with coolant it started gushing out from under the intake in front. I think I see an o-ring pushed out.. I hope I can lift the intake without removing the turbo!!!
View 1 RepliesI have a O6 F250. Egr delete and a new oil cooler 20k ago. I have been dealing with missing coolant for about 6 months. A little here or there but it has gotten really bad the last few weeks. My last attempt was to replace the degas cap. Stopped the missing coolant for a 30 mile trip. Just to clarify it had gotten to the point I was adding one gallon per 20 miles. Needless to say I was thrilled. Next morning I came out to find coolant under the truck. Plastic Y under degass, so I replaced it. 25 miles and none missing. Next morning fluid under the truck. Now it's the egr hose.
Replaced it with a gates hose and new clamps. Fill it up with coolant go inside and its leaking in the same location. Its a pure pleasure to undertake. So I assume these leaks weren't previously leaking because the degass cap wasn't pressurizing the system. That being said the leak is on the oil cooler side of the egr hose. The snap lock fitting that was on the original housing spins around. Should that locking mechanism be removed before the hose is secured and clamped? This is the only thing I can come up with as the culprit. I have searched the information on the site but can't find any mention of it needing to be removed. The clamps are the right width and everything is seated.
My truck just passed the 3 year/36k by 2 days! I got it on 8/4/10 but it only has 27,000 miles of course I just found a puddle of coolant under the right front drivers side. After a little reading, I guess this is common. Should I push for Ford to fix it or get an extended warranty and turn it in on that or... Aftermarket yet that isn't half plastic like this stock POS?
View 12 RepliesI bought a 2006 E350 with a 6.0L diesel. Has some issues I hope to work through, or failing that I'll ditch the thing and learn a lesson.
The pressurized coolant reservoir has a crack/leak in it. Is it wise to only replace it, or should I look for a root cause? The temp gauge does not go past 50% pulling hard up a mountain pass.
This was a fleet vehicle that was pretty much abandoned. There is a chance the reservoir was cannibalized for another rig and had the bad part thrown there but I'll never know.
I have a coolant leak somewhere on the top of the engine running down to the oil pan and bell housing. I have done some research and discovered it could be the coolant inlet tube to the turbo.
View 14 RepliesWhile servicing the bosses 121k 6.0, I noticed the coolant resevoir empty. It took 1 1/2 gallons to bring to proper level. Returning under truck to install drain plug, I noticed coolant coming from rear of the engine(right side). And of course Ford has changed the cooling system cap, so I wasn't able to pressure test it to pinpoint the leak. Started the engine and seen coolant coming from the left rear as well. I've been reading here to see what others have been seeing, (EGR cooler, head gaskets). With all the heat shields,not much room to look.
After work I did go and buy the adapter to test the cooling system. With any luck I will be able to see leak better.
I have a small coolant leak coming from the passenger side near the back of the engine that forms a spot about the size of a dinner plate if it sits for a few days.
One thing I noticed is if I turn off the AC selector switch when I park I will get the drip but if I leave the switch on MAX AC when I shut the truck off I do not get any leaking.
It is definitely coolant and not just the condensation from use of the AC. If I haven't used the truck for a few days or if I have run it with the AC off I will get the drips.
If I run with the AC on and leave the switch in the on position when I shut the truck off it won't leak. I have tried to locate it from looking above and below but can't determine where it is coming from.
Was replacing my cracked and leaking charge air cooler pipe Friday evening and noticed oil all over the place at the lower front of the engine. It has been a few months since I've been under the truck. No drips on the ground so it must be a slow leak while driving. Oil level is fine so it hasn't been leaking for long.
Any ideas from this limited two picture view? Front main seal? I've been reading the vacuum pump leaks oil as well but I'm not sure where that is other than driven by the HPFP. I took additional pictures but those were useless, it's a bit cramped in this area.
In the past ten months I've had the turbo coolant inlet pipe leak repaired and then the DEF heater failed, which means replacing the entire pump of course. The wastegate solenoid air compressor noise started some time ago as well at shutdown but I haven't been concerned about that (it doesn't seem to cause an issue). 96,000 miles.
Well got home and the front of the truck was covered in coolant. I must have driven 2 hrs after I noticed no coolant pressure, but temperature was great so figured it was another crappy cap. Looking to get a quick turnaround. Need to go out of town for work Saturday so I have this week to get it done.
Just put a stock unit back in? I don't think I need to do anything else in that area. Belt/pulleys/radiator all done last spring.
I am having a heck of a time finding this coolant leak. It drips off the power steering pump. I replaced the upper radiator hose and the heater "y" hose that goes to the bottom of the Degas bottle. I recently replaced the lower radiator hose as well. So the truck runs normal. When the system is under pressure I do not see any leaks. But after the engine is completely cold it starts leaking a small puddle of coolant. Its appears to be coming from the power steering pump. But I am sure its something above or near it. This is on my 2005 Excursion with a 6.0. Can the water pump be going bad and leaking this direction. I would expect a water pump to leak straight down the middle of the engine. What to look for? The thermostat seal stays dry. but it has to be in that area. What is really messing with me is. When it is hot and pressured up It does not seem to leak. Only after it has been sitting for hours and cools off..........What the heck!
View 14 RepliesI am in the middle of a several thousand mile road trip, and I am with family in Utah when this evening I noticed a puddle under my 6.0 Excursion.
Coolant leak? - YouTube
The fluid does not smell like typical coolant, but from the location of the drip, I cant think of it being anything else.
Seen a coolant leak near the back of the block? I did an oil change and noticed coolant on the bell housing.
View 7 RepliesI recently had an upper radiator hose bust and ever since I have been having a slight water leak. It appeared to be coming from between the layers of rubber on the new hose which I replaced twice since the incident. Both hoses had water seeping from the same location. This afternoon I plan on doing a pressure test on the cooling system to diagnose where the water may be coming from.
My question is could a loss of pressure cause larger than normal Oil and Water deltas? If I have to replace the radiator is there a particular manufacturer or type I should avoid? Should I try to get a factory replacement from Ford or would an Autoparts unit be sufficient? The original is still in the truck now with 286,000 miles on it.
I installed a BPD EGR cooler about 4 years ago just as a preventative measure (along with an oil cooler) in my '06 F-250 6.0. About 6 months ago some coolant was found to be coming down the rear of the engine and onto the garage floor but only in the mornings after cooling down and even then not every morning.
A couple weeks ago I did a coolant flush and put the red ELC coolant in and now I can see better where the coolant is coming from. It appears to be coming out from the O-ring between the cooler and the intake manifold. I did check the torque on the stud and bolt and they are tight.
Is there a way the drop the cooler enough to install a new O-ring with out going through the whole process of removing the intake manifold and everything that is associated with that? The thought is daunting...
Coolant seen leaking under passenger door it was running down frame rail looked under hood and seen coolant around the air filter cover . Tank was low 2012 cab chassis 33,000 miles
View 4 RepliesThe drip pan under my 2005 X 6.0 was relatively full with coolant last week. The leak is intermittent, but persistent. After investigating, it appears to be coming from somewhere on the driver's side on the back of the engine. The coolant is running down the seam where the transmission mounts to the block, but I can't get my mirror back there to see exactly where it's coming from. It's not coming from the side of block and there's no evidence of coolant on top (in the valley).
I've only been doing "city" driving (no towing or highway trips) since before the leak began and the max ECT I've observed is around 205*, with 40-60* ambient temps. It's not overheating, but I have noticed the heater air is cool when I'm at a stoplight, suggesting the coolant level is low (I've refilled coolant once and heater worked fine afterwards).
I have not observed oil in the degas bottle, but have not yet checked the dipstick for coolant bubbles in the oil. Also, FWIW, I had to replace my degas bottle back in October after it cracked on the side. I do use ELC free, red coolant, have a coolant filter and flushed the system about 18 months ago.
Thoughts on source of coolant leak? Don't say head gasket....
Had a coolant leak I finally traced to the rubber hose on an egr delete (previous owner installed, not sure of brand). Looks like the jackwagon who installed it cranked the clamps way too tight and they eventually split the hose. I have a piece of heater hose that looks like the right diameter and cut to size should fit fine. I guess I am just looking for some reassurance that it would be ok to use in that situation...
View 3 RepliesI noticed I was a bit low on coolant and started looking around. Found a drip on the serpentine belt and harmonic dampener. The T-stat is dry and was replaced 1.5 yrs ago with a full flush. Both hoses are fine and there is no coolant near the steering assembly.
I am figuring it is coming from the water pump. I am planning to put in that Bulletproof water pump and Mishimoto silicon hoses. Anything else I should consider before I dive in. I'll put a new T-stat on since the coolant is drained and it is cheap $20 insurance. BTW hoses and water pump are original (7/05 build date).
Additional information - no spots on driveway (from coolant anyway) and single drop on the dampener. No mess anywhere else and I am down about 1/2 gallon - degas is almost empty.
I've been smelling coolant for a few weeks with no apparent leak. Walk out today, small puddle under truck. Coolant running/drip along seam of engine and trans right in front of downpipe on passenger side. Even with a mirror I can't see up far enough. Looking from top is impossible. What could be leaking up there? Turbo?
View 4 Replies