My 06 6.0 is blowing a fair amount of blueish, whitish smoke only on initial startup, then continues to blow smoke slightly for around 10 min until it's warmed up. It seems to be getting a little worse as time goes on, only on startup though. truck has no other issues otherwise, has an egr delete, and some old edge tuner. I don't think it's head gaskets, no other symptoms.
View 6 RepliesI just looked back and it has been since July 7th that my girl has been sitting in my shop. Well this past weekend I finally got her back together and started. It took a while to build pressure but she finally came to life..
While I am thrilled that she is running again i have low power before the boost kicks in and is idling rough with a blueish- white smoke coming out of the exhaust. Once i kick her a little she will get up and go but I've never had the smoke before.
I'm thinking maybe a bad injector???
2006 blowing white smoke and sluggish until its driven for a few miles ..smells like fuel .. New head gaskets and the works started after 20 days over below freezing temps nights at 5 to -5 ....
View 14 Replies99 Ford F-250 4x4 Ext Cab 287,000 miles. I know she is getting a little long in the tooth but this issue is new within the last month. It does seem to be better when it has been plugged in. On start up I smoke out the neighborhood. Blueish/White smoke, also sounds like it's missing on a couple injectors. Doesn't matter if you cycle the glowplugs a good long time. Glow plugs are 1 1/2 years old along with injector o rings. Only thing new is I changed from Rotella T-6 to Delo 5W40 Syn, but it was doing it before the switch as well. I tested my glowplugs relay and that is working fine. Could I have lost a UVCH? Fuel filter six months ago or so.
View 6 RepliesI'm in the middle of an extended coolant flush and switch over to ELC. As of recently, I have noticed white smoke at startup and driving while cold and warming up. (Even at times accelerating when half warmed up ~170*). At first I attributed it to suction, so last night I changed the oil with T6 along with a new OEM filter.
After I got done with the oil, I pulled my EGR valve when the engine was hot. Is this simply goey due to warmth, or do you suspect EGR cooler leaking? I didn't take pictures of the manifold, but the lower chamber was hard and dry, while the middle section seemed to be "goey". EGR Cooler or something else???
Lately I have noticed a lot of blueish smoke coming from my exhaust at idle mostly while warming in the morning though it would do it if the truck idled for a few minutes. I took it to the dealer because I have fords ESP but the tech couldn't get the truck to smoke and wasn't getting any codes so he sent it back with a clean bill of health. After getting it back I noticed it smoking again so I picked up the egr valve kit pulled the valve and cleaned it as best I could and replaced the seals, that was last night. This morning it was blowing more smoke than it has before and has continued all day whether cold or warm. I just changed the oil last week and it's still full so it isn't burning any. Head gaskets were done along with studs last month, egr is obviously intact, cat is gone. I'm really at a loss for this, It's an 07 f350 scsb 6.0...
View 6 RepliesI would like the hear what others have to say about the problems I'm having with my 2006 F-350 sd xlt 6.0 with 113,000 miles on it. It's being used as a tool truck mostly going from a shop on the property to close by buildings on the same property. In other words very short distances. Used occasionally to take a dump trailer to a close by dumping ground.
1. White smoke from exhaust. I've read this is most likely an ERG cooler that needs replacing. Any other possible causes? If I end up having to replace the cooler is there a stock cooler that is reliable or should I get the one by bullet proof?
2. Diesel is dripping from the muffler weep hole. Last full tank lasted only 60 miles. Could this be the oil cooler? Anything else? If so is the Ford replacement cooler OK or should I go with an upgraded cooler?
I've been getting some grayish/blueish smoke on cold starts lately and decided to do some investigation to see if there was a problem or just the cold temps.
I googled it and turbo oil seal problem was pretty common so I figured it was easiest to start there. I removed the pipe between turbo and CAC and it had quite a bit of oil it in. The pipe after the CAC had a fair amount as well. I checked the oil level in the engine and it was slightly down but I can't say how accurate the dipstick is nor it was completely full after the last oil change. Either way, not much oil is entering the intake but I would assume any is too much.
Here's my main concern - What's the likelihood of getting a runaway from this?? Is it possible for the oil seal to fail 'more' than it already has putting more oil in the intake allowing for a runaway condition?
Obviously the turbo needs replaced but is it safe to run it the way it is until it completely fails or replace immediately?
06' with 85,000 on it started smoking yesterday. When idling , and stopping at red light, and then sometimes it doesn't. Run it this afternoon for about 10 miles, let it warm up. Ran good and smooth didn't smoke when cranked then at the red light it started to put out a little white smoke. Drove back home, pulled egr valve and it did have a little wet on it, the coolant level has dropped some to. I scanned it and it didn't have any codes, no misfires or anything! Is it safe to say that the egr cooler has a small crack in it and its just starting to leak?
View 14 RepliesWhen I start my truck up initially and it's somewhat cold, like even if it hasn't run for just a few hours, it seems to gargle when I get on it. I'm not slamming it while it's cold but even just trying to accelerate. Code is egr flow insufficient, the truck isn't egr deleted, I've had it for 150,000 it's got 211 now. I just clean out the egr every 15-20k and it's been great until now. Once it warms up it sounds and runs perfect.
View 2 RepliesWe have two 6.0 trucks and one is having issues. A couple days ago it started to have white smoke like crazy upon startup, and when you slowed down you could see smoke, any speed and it dispersed so it was not noticeable. It got worse very rapidly and I haven't ha. A chance to work on it, it's also burning antifreeze, that's what the smoke is. Recently the egr started to act up so I cleaned it and the code for a sticky egr went away. It came back after a few months so I cleaned it, it went away for a few days then came on with the symptoms I just described. It has been moved at work a couple times the last few days, but not driven. Today I had to move it and it would not start, no white smoke either while cranking. I read the codes and this is what it has:
P0674- cylinder 4 glow plug control
P0404- EGR control circuit range/performance
P0299- turbo underboost
P0403- EGR control circuit
P0405 EGR sensor A circuit low
I would say it's a head gasket or EGR cooler, no? What course would I take to find out what's wrong? The truck in question is a 2006 F350 SRW King ranch. It has 115k on it, and the majority are work miles pulling trailers.
Last weekend, I was riding my Golf 2.0L when it started losing power, then a thick blueish white smoke started coming out from the engine all the way through the exhaust. Stopped the car on the side of the road and had it towed back home. I've looked for loss of any oil or coolant but the levels are ok. No mixed fluids from sight. I've had a check engine light for oxygen sensor for a year or so, but I've been told that would not be the problem. I started the car a few hours after it was towed home, it was now cool so the smoke wasn't as thick. The smoke doesn't smell like coolant fluid. I took out a spark plug and there was a bit of oil onto it too. My engine runs normally. People have been telling me to look for head gasket, valve cover gasket, engine head, etc. A week later, I still can't find what it could be.
View 1 RepliesI have a 2006 f350 with 75k on it, has a mild sct towing tune, and 4' turbo abck dual exhaust. It recently started blowing whiteish smoke, so i did an EGR cooler and valve delete kit, and it stoppe dsmoking for a while.. coinsidence?
It has recently started again, at idle there is no smoke, and taking off slow from a stop, it doesnt ALWAYS smoke. but leaving a dead stop, if i get right into it, it billows whiteish smoke, and if im cruising, romp on it, let off it, then get on it again it will smoke.
Ive been told fuel pressure, injectors, turbo seal etc. when i had the down pipe off, no sticky black residue was present, so im counting out turbo seal (for now). I purchased the blue spring upgrade for fuel pressure, because i was told its not getting the right amount of fuel, once i get that ill throw it in and see if it fixes it.
whats yall's opinion? is it worth have it checked for a failed injector? as i said, no EGR in the truck, no loss of coolant either, oil is clean. It does seem a little sluggish at times off the line now as well.
Ok I bought a 2006 Ford F350 with 6.0 after driving for about 3 weeks I noticed a little bit of coolant was disappearing out of reservoir. So yesterday I was driving with a load Reservoir overflows replace coolant with one gallon of coolant and finish trip with no issues. I started truck today and it will not stop smoking it is also not overheating after hearing about head gaskets. I'm hoping it might be EGR cooler white smoke smells like raw diesel fuel. What to do?
View 3 RepliesI have a 2006 F350. It started running rough and white smoke from the exhaust. I did an injector buzz test and found no codes. Cylinder contribution check showed cylinder one was not functioning. I replaced number one injector, cleaned injector cup installed new injector and copper washer. Engine runs the same. If it was a wiring harness issue should that have shown up in the buzz test?
View 8 RepliesI have long been having troubles with white smoke at startup, even when its 90 degrees out. Long story short I've got new glowplugs, GPR, UVCHs, valve cover gaskets, injectors, turbo, valve seals, valve springs, and HPOP all within the last year. Most of those parts were needed, some maybe not so much. After installing injectors things started getting worse, whether they're related or not I'm not sure yet. I pulled passenger side valve cover off again in an attempt to figure something out and heard this coming out of the intake spider.
[URL].....
The strange thing is it goes away when it warms up. I should also note the reason I started with the passenger side is because I did a compression test and this side had the lowest readings, with #5 being 270 psi. I disconnected each injector one at a time on the passenger side to see if it made a difference while running but didn't really notice a difference. Am I looking at a motor rebuild, or at the very least a head removal?
So my truck a stock 2000 7.3 started smoking when I would start it up in the morning... figured it was a glow plug issue. Checked the relay it was good, checked the glow plugs found 2 were bad replaced them.
Thought I was done, well I started it up and took it for a drive. still smoked... thought no big deal I know some oil leaked into the cylinders doing the glow plugs.
Then it started rattling like a lift went out, no more smoke though because the truck was warm... shut it off at my buddies. Limped it "it actually still drives ok" 5 miles home.
From my research it sounds like an injector. I have tried a buzz test and they all sound the same.
I have a 98 expedition with the 4.6l 4x4 and it has 158,000 on the dash had a new engine installed at 100,000 it started running rough and sluggish last week so I changed out the spark plugs and while changing the plug I notice oil on the threads of the two rear passenger side plugs. After the new plugs it was smoking pretty bad blueish white smoke. I figured it was the oil from around the threads that had leaked into the cyl.
The smoked cleared after 2 days and ran great for a week. Now its doing the same thing again real rough idle and and its extremely sluggish. I can put the pedal to the floor and she barely wants to move almost like the tranny is going out but the rough idle leads me to believe its and engine problem. I have the check engine light on but can't get any codes. I also tried checking for vacuum leaks by spraying either round the intake and vacuum lines and didn't notice any change in rpms so I'm guess the vacuum is fine.
2007 6.0 6 speed, 187,000 miles. The other day started truck, had been running about 20 minutes before. Started fine, go to drive, chugging white smoke, smelled like unburnt diesel, baby truck home, seemed to run ok at low rpm, truck warmed up and ran fine. But I also noticed turbo boost was acting funny. Truck ran fine next few days. Then this morning, started cold fine, started to drive it and same chugging white smoke, it quit by the time j got to the end of my driveway, but drove to work, it quit smoking, ran pretty smooth, but will not build any boost. Truck is bone stock except for exhaust, it's straight piped. Ok. So this eve I borrowed my dads edge cts, here's all the engine codes:
P0069
P0269
P0299
P2262
P2269
The last one is water in fuel, since it started this crap I did notice it was right after it came on in the dash. I'm trying to figure out where to start....
On another note. VGT duty shows 85% at idle ?
Ficm voltage is constant 48 volts
Newer batteries
no change, changed stand pipe and dummy plug on driver side, no change and guess what? Now I am stuck on the side of the road waiting to give my last $100 to a tow truck! Engine is hydrolocked, fuel pressure is low, starts off at around 20 and works up to 54 with key on engine off, and that is as much as I know from the side of the road with out my AE. Blew white smoke also. Smelled of unburnt diesel. I think it's linked to my rough running issue. Maybe a bad injector? But every time I did the click test they all passed. Idk, I'm gonna remove the glow plugs and see which hole is loaded and with what. . .
View 14 Repliesyesterday I went out started my truck and white smoke started coming out my exhaust so I turned it off waited a bit started it back up let it run for a bit smoke went away drove it about 60 miles. Later that night it did the same thing but I was 2 gallons short on coolant drove it another 60 miles ran fine. Next morning decided to take it to a shop put more coolant in it drove maybe 20 miles to shop got there turned it off everything was fine never over heated once. So this shop is now telling me my trucks hydro locked and I steamed the EGR valve. And there telling me it's gonna be $8000 to fix it .
View 3 Replies