2005 f350 188000 on the clock had a bearing get loose in the turbo . Installed a new power-max but if the bearings are oil fed should i also change it? There are no signs of metal in the oil or the old turbo . The oil has 600 miles on it with archoil.
View 1 Replies2005 f350 6.0 all stock except egr delete. My turbo is spooling up and down constantly. I can actually watch my VGT duty cycle fluctuate while sitting at an idle too. I've cleared the codes and p0299 always shows up first, but then I'll get p0069 BARO/MAP, and a p0470 exhaust pressure sensor eventually. Sometimes it takes an hour of driving before those show up. I can watch all these values on my torque pro, and nothing seems out of the ordinary other than the turbo opening and closing at will. What can cause this? I hate to just start throwing sensors at it.
View 11 RepliesI am replacing the turbo on my 2005 f350 6.0. I have the passenger side mounting bolt and the rear mounting bolt out, but cannot get the driver side bolt to budge. I have sprayed it with WD40 and PB Blaster and tried a breaker bar. No luck breaking it loose. I am afraid I might round off the head even though I am using a 6 point socket.
View 12 RepliesI have a 06 f350 superduty with a 6.0 I have had injector problems before with the motor even hydro locking no start this is the problem my truck started blowing white smoke with a strong diesel smell everyone said it was oil cooler but I took it to a ford garage the guy said I had 2 injectors hung open and wasn't hydro locking and suggested to put all 8 in so I did 3400.00 not I went to pick it up had no power at all turbo was not kicking in so I took it right back to them they checked it out said turbo was sticking had to clean it it would take 6 hrs. said the fuel In the motor caused it it was working fine when I took it to them now they say maybe a new turbo are they giving me the run around or is this possible....
View 9 RepliesCan't seem to find a number for just the bearing and snap ring. All I can find are the dang assemblies.
View 11 RepliesI for the life of me can not even see the bolts to take them off.
2006 F350 4X4
I have 07 F350 6.0 never heard this out of any of my 6.0s. it's almost a whine but can hear it w turbo and out of empty exhaust. Almost like a supercharger noise stumped almost leaning towards actuator for turbo? Noise got real loud swapped turbos used same actuator noise is there but much quieter.
View 1 RepliesMy truck is fairly new. Its a 2015 Ford F350 with 6000 Miles. I live on the east coast in a 4 seasons climate. Its summer the average temp. is in the lower 90's. Recently, I have noticed that my truck has been shuddering and shaking between 5th & 6th gear.
It started when I was changing lanes; I tried to accelerate going about 45mph, and shuddering real hard. It was difficult to maintain my speed on a level surface. It was almost a total loss of power with no trouble codes.
Having an issue with my 05 f350. Seems when I chomp on the the throttle I get tons of boost 30 lbs plus with no power. Seems most prevalent when starting on a hill , or hard on the throttle off the line . Also getting turbo "bark " when backing off throttle. It's less prevalent when feathering the throttle and usually more noticeable 1/2 throttle or more. I'm thinking could be the Vgt actuator or clogged/ dirty ebp sensor?
View 10 RepliesThe 2004 and 2005 turbo is interchangeable and can you replace the bearing in it.
View 8 Replies2005 F250 SD, Crew Cab, Diesel 6.0L...
Hauling my jeep (close to 16,000 pounds all in F250+trailer+jeep) on a highway going a little over 70mph up a hill when I seemed to have lost some power and the check engine light came on. The turbo PSI was well over 20PSI (according to the gauge in the dash). I have a Scan Boss but I have not been monitoring turbo boost PSI.
I was only 10 miles from the final destination so I continued without stopping. It seemed that the turbo was limited for the rest of the trip. Later in the evening, no more check engine light but I haven't really driven the truck since then.
What do you think the problem was? What should the course of action be?
Need to know if you can mount a 04+ turbo on a 03 engine without changing the intake with the cross in the back ? Or does the intake have to be changed. If the intake does need to be changed will the egr need to be change as well ?
View 4 RepliesI've been having issue with my truck lacking boost over the past month or so. The psi levels are normal in the morning when I start it up cold, the problem almost always occurs at start-up when the truck is somewhat warm and has been sitting for an hour or more after use. I've had boost levels at idle from -0.14psi to -0.56psi and as low as -1.2psi when driving as the problem is occurring, but it eventually kicks on and goes to normal levels after several minutes of driving. After originally taking the truck to a local diesel mechanic I was told it had EGR codes and they recommended installing an SCT tuner and cleaning the EGR valve to solve the problem. I had them install an SCT 5015 tuner and clean the valve but I've still been having the problems with boost.
View 2 RepliesI have a 2005 F250 with 186K miles. I do minor work on my vehicles but have little experience working on my diesel. I was accelerating when I heard a pop and a hiss similar to disconnecting an air hose from an air compressor. Total loss of turbo power. No turbo reading on the turbo gauge on dash. No loss of oil. No smoke. Oil and coolant look fine. Took off turbo and everything appeared to operate like it should (according to YouTube videos). Inspected lines and rubber boots.
Rubber has some cracks but not certain if they are holes. How small/large of a hole would cause total loss? Was originally scared to take it to a shop knowing they could name their price. Not opposed to taking it somewhere now knowing the turbo works but obviously would rather save the money. Any tips on troubleshooting? I'm not opposed to proactively replacing parts/sensors as the truck has given me 186k and I plan to keep it as long as possible.
For a month or two now my truck has been making a squeal and the turbo has been sticking after hard acceleration. The sticking was a woebegone unison ring and I was hoping the squeal would be resolved when I cleaned the turbo but it didn't, in fact, it got worse.
It used to be occasionally and go away after warming up, but now it's more constant than not. It goes away when the VGT does its idle cycle and once you get up to speed.
Here's the sound - YouTube.....
This is is a truck I hardly know anything about. My wife bought it while I was deployed for herself and when it comes to vehicles she's an idiot. No, really she told me she bought it because at horse shows everyone else has one.
I noticed an oil leak and had a reputable shop look at it. They told me it was coming from some seals on the turbo. Long story short there is a brand new turbo on there, stock replacement. Now it seems very under powered and shifts hard. Pressing down anything more than 25% throttle will cause hard shifting or no shifting at all. It'll stay in second until I ease off the throttle.
I tried searching a few terms but I'm not sure what to look for. I don't know if someone has messed with the tuning. Broken clamp on the turbo. Replaced and everything is back to normal...
I have a 2005 f250 6.0 diesel. I have changed the 2 fuel filters, fuel pump, sending unit (was broke off in tank )and installed the blue spring fuel pressure regulator kit. My truck will run for a few minutes loose fuel and kill. Could this be a sensor or computer problem
View 12 RepliesWell, after getting the bed back on my '05 F350, I have been driving it on the road for a few days, but now I have a new problem.
Every once in awhile I get lag off idle for about a second, then the turbo spools and everything is fine. Other times, I step on the accelerator a bit from a stop, and the truck acts like its going to die for a moment, a puff of black smoke, and then the turbo spools and all is back to normal. It a combination of these two problems happens about 3-5 times out of 50 stops a day.
I have a scanguage and everything looks normal and I never get any codes when I check.
I have a bone stock 2005 F350 DRW FX4 6.0 Diesel. I've been averaging 10.5 to 14 MPG city. Haven't really done any hiway driving yet.
View 14 Replies2005 F 350 6.0
124000 miles. Drove the truck on a long road trip Saturday ran great. Didn't touch it Sunday. Went out Monday morning and it wouldn't start I noticed the fuel gauge said empty and the low fuel light was on. I knew there was plenty of diesel still in the tank but I still went and bought 5 gal and dumped in it fuel gauge then read over half full but still won't start. A buddy who's a mechanic swung by sprayed starter fluid in it fired right up then died he said I need a new fuel pump. I have been reading the forums. I just want to make sure is he right?
I have 2005 f350 will not shift on the fly. With a vacuum pump it will hold vacuum at both hubs but will not lock up. The seals should be good.
View 11 Replies