Ford 6.0L Power Stroke Diesel :: 2005 F250 - Slow Oil Leak?
Aug 7, 2015
My 6.0 has been leaking oil for a couple weeks now, possibly longer judging by the staining underneath. Very slow leak. 1 drop hits the ground when I get off work and go to get in the next morning. It never really reads off the dipstick a drop in the level. I had to top up the oil yesterday but that is from about a 2-week span. But I want to get it fixed. I've attached pictures of where it's coming from and was hoping to get pointed in the right direction. Also its a 05 f250 and coming from the driver side.
View 14 Replies
Advertisement
I have a 2005 F250 with 6.0 and almost 175,000. On vacation right now and noticed when I came out of a store that there was a puddle of water under the passengers side. Chalked it up to AC defrost. The second time I was not running AC and puddle again.
Felt and smelt of it...antifreeze. Just put in all new Zerex G05 and a new degas tank because when working on it I noticed a pin hole in the base before we left. I replaced the EGR cooler and hose from Sinister about 3 plus years ago.
Would the EGR cooler hose be leaking? I've noticed that white residue on top of the intake around the where the hose is. What would cause this, Heat, wear and tare....my luck ?
View 2 Replies
I have a new *to me* 2005 F250 and last night I noticed there is a leak around the brake fluid reservoir where it connects to the frame of the truck. Everything seems to be in good order not sure exactly whats causing the leak. It only when driving and for a short while after shutting the truck down, everything seems to be in good order but still it drips a lot.
View 9 Replies
I just purchased a used f250 6.0L a week after having it i noticed a small oil leak slowly got worse (looked as if it was coming from the too rear of the engine) then noticed about a half quart of oil under my truck. While driving it home the oil pressure gauge kept dropping then going back to normal then eventually dropping for good. The truck still ran so i drove it to take it to the mechanic but then the throttle began to become unresponsive and then gain power again then finally the truck shut off and wouldn't start again, blowing oil all over the inside of the hood and top of the engine. I checked it and noticed the pressure sensor pigtail were fraid so i replaced that along with the sensor and added oil but still wont start.
View 10 Replies
This is is a truck I hardly know anything about. My wife bought it while I was deployed for herself and when it comes to vehicles she's an idiot. No, really she told me she bought it because at horse shows everyone else has one.
I noticed an oil leak and had a reputable shop look at it. They told me it was coming from some seals on the turbo. Long story short there is a brand new turbo on there, stock replacement. Now it seems very under powered and shifts hard. Pressing down anything more than 25% throttle will cause hard shifting or no shifting at all. It'll stay in second until I ease off the throttle.
I tried searching a few terms but I'm not sure what to look for. I don't know if someone has messed with the tuning. Broken clamp on the turbo. Replaced and everything is back to normal...
View 4 Replies
I've got a leak that appears to be coming from the secondary fuel filter housing (the one in the engine compartment)... It's not coming from the filter, but from the side, where there are 4 allen bolts that attach a fitting to the side of the housing...Can I change out the gasket for that piece? I've already tightened the bolts, but the leak persists.
View 14 Replies
I am fairly new to working on diesel engines. I was towing a camp trailer and got a P0299, Turbo Charger Underboost engine code. I never gotten any other codes other than this one when towing. I decided to pull the turbo and clean the vanes. Everything seemed to go back together good but now I hear what sounds like an air leak coming from the turbo area. The boots on the intercooler pipe are in good shape, I only loosened the clamps at the intercooler and the turbo. Left the boots on the pipe. I have tightened the clamps around the exhaust pipe connections with no change. I also seem to get a slower response from the turbo and possibly not as much psi as normal (according to dashboard gauge). I have driven the truck five or ten miles trying to work the turbo and have not gotten any engine codes to this point.
View 7 Replies
I've been having rather slow throttle response with my 6.0 f250 diesel at lower RPMs. Obviously, this is to be expected to some point.. Whether I'm cruising on the highway or through the neighborhood, if the truck is at lower RPMs and I try to accelerate, it doesn't want to. In order to get it to accelerate, I have to press the gas down enough to downshift it then it'll take off.
The truck doesn't have a loss of power at higher RPMs, it takes off like a bat out of hell. I've put 175CC injectors in, tuned it, power max turbo, EGR deleted / studded, etc. It's almost go out with acceleration, or go turtle power with acceleration.
Oil pump was replaced a couple years ago. This problem existed through it all, and it's rather annoying. The truck doesn't want to produce any low end power. If I try to hit the gas enough to accelerate but not enough to force a downshift, I'll just blow smoke, spool the turbo, and barely accelerate until I down shift or push the truck through it. Turbo PSI is roughly ~15ish-20ish during the sluggish transition.
View 14 Replies
The ford dealer in Las Vegas replaced my turbo with a remanufactured one. Coming off the line (like quickly pulling into traffic) it goes flat on power until I get a few RPM's. Even with the old turbo it never did that and I drove it for the last 30k miles with it throwing the low turbo boost code. They put a little over 100 miles on it for road testing (I did have other things that they worked on. {4x4 2006 F250, 6.0 engine, 110k miles and I bought it new}....
View 4 Replies
I have been dealing with a oil leak for quite some time now, oil seeping from what appears to be around the cam sensor. About a year ago I pulled the cam sensor replaced the o rings that were cracked and split out figured that was my problem. drove it for another year continued to have same seeping oil leak. cleaned it up real good dyed the oil and checked again and seems to be same issue same spot around cam sensor. Pulled it again o rings are perfect but it seems as if that is where the leak is seeping from based off the uv dye I used. is there something else right around the cam sensor that I am missing that could be the cause? I have checked ipr, crank, dip stick, hpop cover, valve cover, glow plugs, a few other spots and have found no other leaks from any other than around that came sensor.
2006 F250 6.0 King Ranch
View 10 Replies
I have a O6 F250. Egr delete and a new oil cooler 20k ago. I have been dealing with missing coolant for about 6 months. A little here or there but it has gotten really bad the last few weeks. My last attempt was to replace the degas cap. Stopped the missing coolant for a 30 mile trip. Just to clarify it had gotten to the point I was adding one gallon per 20 miles. Needless to say I was thrilled. Next morning I came out to find coolant under the truck. Plastic Y under degass, so I replaced it. 25 miles and none missing. Next morning fluid under the truck. Now it's the egr hose.
Replaced it with a gates hose and new clamps. Fill it up with coolant go inside and its leaking in the same location. Its a pure pleasure to undertake. So I assume these leaks weren't previously leaking because the degass cap wasn't pressurizing the system. That being said the leak is on the oil cooler side of the egr hose. The snap lock fitting that was on the original housing spins around. Should that locking mechanism be removed before the hose is secured and clamped? This is the only thing I can come up with as the culprit. I have searched the information on the site but can't find any mention of it needing to be removed. The clamps are the right width and everything is seated.
View 1 Replies
We got "bad" gas in Feb, 2016, had to replace entire fuel system. Haven't driven the truck but 4000 miles. Last week, she started spitting and sputtering and lost power. We could see fuel pouring out. NO CEL. Towed (AAA has paid for itself several times over with this truck) to dealer that replaced the fuel system, still waiting to hear from them. Does this sound like it should be under the warranty for the work they did? We have averaged a huge repair bill about every 3-4 months on this truck, 2011 F250 Lariat, 8cyl, 6.7L, since we bought it 2 years ago.
View 1 Replies
Noticed oil on the underside of the engine last oil change, took to Ford dealer for repair under extended warranty. Got a call back today, stating the the oil leak is coming from a injector on the drivers side, and that the injector seals is not covered under warranty. I'm having an issue understanding that oil leaking out from around the injector is not covered under a power train warranty.
View 2 Replies
Is it normal for condensation to form and then leak under the compressor? it stops when the ac is off or the truck. I have a 2004 ford f-250.
View 3 Replies
I just picked up a 2006 F250 6.0. It was having hard starts. Anyways before I started using it I started tearing things apart cause I knew for sure the turbo was leaking so that had to be resealed. I just picked up a 2003 turbo today for it out of a used truck that had 144000 kms on it. (was in an accident). I am gonna post up a few pics here of the engine bay area, there is a huge amount of old oil I believe to be, I am wondering if it was a leak or spilled oil. I am going to be cleaning this up. Putting 03 turbo in here, doing a service and then plug my Tablet with torque pro and post up some numbers and see how healthy she is. Before I post any pics Is there a way to make these pictures clickable instead of them taking room up on the page?
View 14 Replies
The drip pan under my 2005 X 6.0 was relatively full with coolant last week. The leak is intermittent, but persistent. After investigating, it appears to be coming from somewhere on the driver's side on the back of the engine. The coolant is running down the seam where the transmission mounts to the block, but I can't get my mirror back there to see exactly where it's coming from. It's not coming from the side of block and there's no evidence of coolant on top (in the valley).
I've only been doing "city" driving (no towing or highway trips) since before the leak began and the max ECT I've observed is around 205*, with 40-60* ambient temps. It's not overheating, but I have noticed the heater air is cool when I'm at a stoplight, suggesting the coolant level is low (I've refilled coolant once and heater worked fine afterwards).
I have not observed oil in the degas bottle, but have not yet checked the dipstick for coolant bubbles in the oil. Also, FWIW, I had to replace my degas bottle back in October after it cracked on the side. I do use ELC free, red coolant, have a coolant filter and flushed the system about 18 months ago.
Thoughts on source of coolant leak? Don't say head gasket....
View 10 Replies
I have a 2005 Ford f250 Diesel 4x4 with - unfortunately - the crappy 6.0 engine. Yesterday my Daughter parked in the yard and this morning the truck not only will not start but will not even turn over. I thought maybe the batteries were dead but that is not he case. When you turn the switch on you can hear the pump start up but it will not turn over? All the lights come on and the bell comes on when you open the door and the dashboard lights work but the thing will just not turn over. I am assuming this may be some type of electrical issue or something but whatever the problem is it just came out of the blue. Ford imo should have recalled this engine.
View 14 Replies
I have an 05 f250 with 109k. Recently I turned off my truck, waited about 45 min or so and upon returning the truck would just crank and crank with no fire. After waiting about 4hrs the truck started right up like nothing was wrong.
Yesterday it did it to me again. This time I have it a small shot of starting fluid and it fired right up and ran like a champ all the way to the shop..... I got the call today from the mechanic saying I have 5 injectors that are bad, 2 glow plugs and harnesses. His quote was 2400 out the door.
View 5 Replies
I had this truck for two months no problems yesterday went on a small trip about 50 miles in on ,the hwy. I start seeing some smoke and then no power turned off & on engine several times a little hard starting no power at all I put the pedal to the floor It barely moves ran into another super d. guy he said fuel filters , I turned around and crawled back home and changed fuel filters still no power. no codes "don't no where to start".
View 8 Replies
I recently purchased my 2011 F250 Powerstroke a week ago today with 87000 miles on it. the dealer assured me they did all the maintenance on the truck before i was able to drive it home. I noticed on my dash that it kept popping up i needed to change oil soon.. so i got out to investigate and realized i was about a quart low on oil so i looked around more and am seeing that i have a leak coming from the back of the engine running down to the oil pan.. I have not noticed any on on the ground at all but what this leak is coming from...
View 14 Replies
I got a problem with my Ford F250 6.0 Diesel. The truck got a new HPOP but still wont start. ICP show everything between 15 und 75 PSI, it raises to 75 PSI max during cranking. The IPR shows 84,75% during cranking.
We get the code P0270 and P2285 in exchange but never together. We already checked the FICM but it looks good on the inside. I now ordered a new ICP sensor....
View 14 Replies
