Ford 6.0L Power Stroke Diesel :: 2005 F250 - Fuel Gauge At E With 1/2 Tank?
Jun 12, 2016
2005 F250 Superduty Crewcab 4x4 6.0L diesel/auto
Wife drove the truck before me and bunched the floor mat under the pedals. I didn't notice the mat issue when I drove the truck today. I accelerated fully after doing a left turn onto a busy highway. The motor spun up hard with the accelerator floored but because of the mats, the pedal stuck all the way down. I was approaching stopped traffic while under full acceleration and I shut the engine off and pulled over to the shoulder all while braking hard ( it was a hell of a ride!). I freed the pedal and restarted the engine.
Now, despite a bit less than 1/2 tank of fuel (I have the 38 gal tank), the dash readout was showing "Low Fuel", the gas gauge was below E and the engine was running like it was running out of fuel. I turned the engine off again and left it off for 1/2 hour before restarting it but the gauge and engine still behaved the same. As I drove to the nearest diesel station, the engine was not running "right". Of course the station I pulled into had 1 diesel pump and the pump was broken.
Because I thought I might actually be out of fuel, an understanding stranger took me to the store to buy some gas cans and then to another station to get 6 gallons of fuel. I got back to the truck and added the 6 gallons of fuel. When I turned the key on, the fuel gauge immediately came up to 1/2 tank. I then drove to that other station and added another 15 gallons of fuel to fill it. This confirmed that I had about 18 gallons of fuel in truck when the "Low fuel" warning occurred.
So, what the heck was going on with the fuel gauge? I am sure the "Low Fuel" warning is tied directly to the gauge but why was the gauge reading low? Is it possible that the "Key-off" while under full acceleration followed by hard braking had confused the ECU? I am just trying to figure out if I have a fuel sender problem or a confused computer that corrected itself. Until this incident, the fuel gauge has never been a problem but the wife messing up the mats has been an issue!
View 3 Replies
Advertisement
For the second time in 6 weeks My 2004 F250 Powerstroke has run out of fuel with the gauge showing a 1/4 tank. First time it was just under a 1/4 showing I had it towed to dealer and they told me it had sucked in the filters requiring replace and flush of system. The told me that this happening very often and I would be replacing all of the injectors at my cost. I told them that I didn't want this to happen again and to check out the fuel gauge and sending unit and replace if in doubt. Well they checked it out and found nothing wrong, told me it was accurate and should not be an issue again. Now 6 weeks later on the Friday night before a holiday, it did it again, this time with over a 1/4 tank showing. I really don't want to spend 6 grand replacing injectors and would really like to trust my truck again, getting to the point that I'm nervous at 1/2 tank.
View 9 Replies
The installation of the new 50 gal. Titan tank went well overall. Start up was smooth with no leaks but the fuel gauge is showing empty with about 45 gallons in the tank.
The sending unit was properly oriented ("clocked") so I'm guessing the electrical connector is not secure at the top of the sending unit. Not sure I can reach the connector without lowering the tank somewhat.
View 6 Replies
My fuel gauge acted pretty weird today. When I left my house today it was just above half a tank. I was sitting in traffic quite a bit and then looked down and it was below the e. I knew it wasn't empty so I kept going. Got to work. Went for lunch and it said full drove about 5 mins to eat and it went down to half a tank. What's going on? I am thinking of the fuel sender or wiring?
View 3 Replies
Purchased 2011 3 weeks ago. Due to not paying attention, put gas in diesel. Had tank dropped and drained but after reassembly, fuel gauge inop. When turn ignition switch on, get normal sweep of all dash gauges but fuel gauge does not read. 2nd tech says sender okay, must be gauge. Dealer ssays if it sweeps, it isn't the gauge. 011 F250 6.7L.....
View 7 Replies
I recently purchased a 2003 F250 Super Duty with a 6.0L Powerstroke Diesel. The truck came with an auxiliary fuel tank in the bed, but how it works. There is a keyed switch in the cab next to another regular switch, and I have not had the courage to try either of them yet since the whole thing looks like a DIY job. I did look under the truck, and can see what appears to be some sort of solenoid setup.
Just wondering, how it works and if it is safe to operate. I do not see any rollover valve, and want to make sure I do not overfill the tank if I use it.
View 10 Replies
I just got a 03 f250 cc lariat with the 6.0, the truck sat for a month and a half before I picked it up, I got in started and the fuel gauge showed over half and the miles to empty was accurate and the temp was as well, about half way home the gauge dropped below empty and the fuel light turned on, then the miles to empty went up to 455 and the temp showed 67 when it was 92 out. I have read other post with these problems but no one has a solution, people have recommended techron for the fuel sender, but techron is not recommended for diesel...
View 14 Replies
I recently bought a used 2015 F250. When the fuel level reached 1/4 tank it became hard to start. Sometimes up to 6 seconds of cranking to get it to start. I filled it up with fresh diesel and it fired up as soon as I turned the key. A week later the problem returned, this time I was above 1/2 tank. I run the recommended additives, I changed both fuel filters, but it didn't work. I have only had the truck 3 weeks, and it still has a warranty. There are no fault codes, and the truck run great once started. What could be wrong.
View 7 Replies
The backlight for my fuel level and oil pressure dash gauges are out. Would that require a simple bulb replacement or if there is something more difficult to replace, i.e. entire panel? The red needles illuminate, it's just the gauges themselves that are dark. The truck is my 05 Super Duty in the siggy.
View 3 Replies
I recently bought a 2005 Ford F250 Super Duty, diesel 6.0.
As I was driving to work this morning I noticed that the fuel gauge read almost full when it should have only had a half tank. A little while later I heard a beep and saw that the gauge was now on empty with a "Low Fuel" message displayed. Then I noticed the heater was suddenly blowing cold air.
I've only had the truck for a few weeks, but haven't had any other problems. I did replace the CD receiver and all of the instrument cluster lights a couple weeks ago, but everything seemed to be working fine after.
View 1 Replies
2005 6.0L F250 Lariat. I picked up a couple weeks ago. The message center in the gauge cluster will only show my mileage (kilometres) and engine hours but nothing else.
Also the three buttons/controls to the right of the steering column don't do anything. I checked the wiring behind the dash and it's all plugged in... The other problem is the SRS light will flash on and off while driving.
View 2 Replies
I have a 2005 f250 6.0 diesel. I have changed the 2 fuel filters, fuel pump, sending unit (was broke off in tank )and installed the blue spring fuel pressure regulator kit. My truck will run for a few minutes loose fuel and kill. Could this be a sensor or computer problem
View 12 Replies
I've got a leak that appears to be coming from the secondary fuel filter housing (the one in the engine compartment)... It's not coming from the filter, but from the side, where there are 4 allen bolts that attach a fitting to the side of the housing...Can I change out the gasket for that piece? I've already tightened the bolts, but the leak persists.
View 14 Replies
I have a 2006 F250 c/c LB and I am curious, how much fuel is left in the tank when the low fuel light comes on?
View 8 Replies
1/4 tank just kept cranking. Added some diesel and started right up thought it was bad fuel gauge. Went about a mile and shut down just off. coasted went got more diesel but this time cranked but no start. anti theft light was flashing too.
Towed home started right up after tow... Starting now... Tomorrow was going to change the fuel filter....
View 11 Replies
What it is or why there is a three inch pull handle hanging down on the bottom of the Diesel Tank on my niece new 2012 F350??? It is sitting hanging there begging to be snagged and ripped off the bottom of the tank!!!!! I'm at least going to Gorilla Tape it up to the bottom of the Tank.
View 10 Replies
I have my aux fuel tank pump hooked to upfitter 3. It has worked perfectly until this week. I started to transfer fuel and the aux fuel gauge and fuel pump both quit. The led on upfitter switch 3 still illuminates, but no fuel pump. I found fuse 9 on passengers kick panel is for upfitter 3. The fuse was good. Is there another fuse somewhere for the circuit I've missed? I can trouble shoot the wiring if necessary, but it's tough to do all behind the left side underbed box and not easy to get to. I've missed something simple before I go further????
View 14 Replies
I've been having a very erratic fuel gauge issue as of about 2 months ago. My fuel level would register full, when in fact I knew it only had 1/2 a tank or so. Then 5 minutes later it would be pegged on full. Under a 1/2 tank the gauge would read any where from 1/2 to empty from 1 minute to the next. So last week I decided to drop my tank and take a look. I was thinking maybe my fuel sender was broken, maybe a loose wire in the tank, or even that my float had dropped off in to the tank.
After dropping the tank, I removed the PK-Up and sending unit and everything was intact. I placed my ohm meter on the sending unit and it checked out fine. So I took the Pk-up and rolled back up underneath the truck and plugged it back in. I had my son turn the key on and off while I moved the float to different levels in order that it would register. It registered empty, 1/4/, 1/2, 3/4 and full just fine as I moved the float to those levels. If you leave the key in the run position and move the float, it won't register or better said, the in cab gauge will not adjust with the movement.
You have to turn the key off move the float and hold it there, then have your assistant turn the key on and the gauge will show the position that you've moved and held it at. I simply removed the plastic cover from the sending unit, and sprayed it down real good with electrical contact cleaner. I didn't scrub the copper contact area at all.
I was concerned that scrubbing might remove more than I wanted to, and really mess things up. I attached an Ohm meter and checked resistance thru out the float travel. All checked out good and I reinstalled it. So now my fuel gauge is working as it should be. I did make a video while I ohmed the Sender Unit thru it's travel, but for some reason it won't load.
[URL] ....
View 5 Replies
2011 F4 56.7 L diesel will not allow fuel in the tank.
View 14 Replies
When I fuel up and open the cap on the filler neck I always hear a hiss. Never could figure if it was pressure or vacuum. Today, after changing oil, I opened my fuel filter bleeder to check for water and it just started slurping and gurgling with no diesel coming out. I lowered the truck, removed the fuel tank filler cap and heard the hiss. Raised back up and opened the filter bleeder and diesel came out. I now know the hiss is a vacuum. Is this normal? If this tank is vented I have a problem somewhere.
View 6 Replies
I've had the Titan fuel tank installed for about a month now and am loving the extra range, although this morning I walked by the truck and got a slight whiff of diesel by the fuel filler door. I pulled out the flashlight to take a look, and noticed a really small, faint trail of diesel fuel running down the driver's side of the tank near the rear strap.
I crawled under the truck to inspect it as best as I could in the driveway, feeling around the sender, filler, and vent tube connections, and didn't notice any obvious puddles of diesel. About the most I got was some dampness around the sender unit seal, but it wasn't much, and could even be residue from the fuel lines dripping during installation of the tank. Based on where the trail down the side of the tank has formed, my best guess is it's going to be a filler or vent tube hose clamp that I didn't get tight enough.
Unfortunately I just filled the tank up last night and am headed out camping for the weekend this morning. I followed all the install instructions exactly, making sure to check the torque on the sender unit seal four times before installing the tank back in the truck because I didn't want to deal with any leaks, so I really hope it's not that seal. I also filled the tank up to the brim right after install and crawled all around it a day or so later and noticed no dampness or leaks. Needless to say, I'm not looking forward to dropping the tank again and then potentially waiting on parts if something is defective. I'm waiting on a call back from Titan to get their advice.
Below are a couple pics of the weepage. Obviously not a huge leak, but something I want to get taken care of ASAP.
View 11 Replies
