I have a 2004 Ford F350 6.0. It is leaking diesel from the front of the engine to the ground. I have a video of this and pictures as well but I'm not sure what I'm looking at. What I can do??Puddle after about 20 min of running.
Dripping from here, left of hose....
For the last four months my 04 F350 has been having the same problem every now and then. Cruising down the highway at a decent speed and the fuel pedal/fuel shuts off. Only lasts seconds then re-engages. Two lights come on. Low fuel and water in fuel. I changed the internal fuel pump last week and it did it again tonight. The truck runs great otherwise except for an occasional death shake while stopped at a light. No codes came up and FICM is at 54.
View 14 RepliesA little background, this is an 04, f-350. It sis not start a week ago so I charged the batteries and it started, started fine this morning, (had not driven it for the week) Drove it to work, 35 miles, parked it, and it will not start.
I downloaded Torque and got a few numbers,
HPOP 1900 FMP 48V (repaired last summer) and FVP 11.5V.
Ran out of battery to surf more and look, so I am trying to figure out the app, and the issue with the truck. It seems to turn over good, until I ran the battery down, and the GP cycles normally, and the injector buzz seems good. Temp is in the 50's...
I have a 2004 F350 with 6.0. My problem is the 4x4 will not engage from inside the truck. I have to get out and twist each hub to lock in the 4 wheel drive. If I rev the engine with high rpms the front will lock in with a big jerk. It use to lock in just by turning switch. What is the best way to fix it?
View 5 Replies2004 f350 after i shut the truck off something was buzzing. So I popped the hood and found its the injector harness or injectors.Is this normal or something I need to look into?
View 3 RepliesI recently was informed by my local mechanic that fuel was leaking into my coolant. He said I had a cracked head based on this and it would give soon. Well, he was right, and now I need to do a head job. I found new heads, but would like to know how many book hours this should take before I proceed. He gives me a wide range of time, and don't want to get taken advantage of.
View 4 Replies04 f350 drw 2x4 ... I know this is a weird question, but i put 4 new tires on the rear of my truck and developed what i can describe as "loose body" symptoms. Most noticeable in going down the highway it feels like the rear of the truck sways and its hard to control and keep straight at times. Check tire pressures n front and rear suspension for broken springs or loose joints. Nothing looks broken or out of place. Prior to replacement truck drove straight n all was good. Also noticed steering wheel is now off center.
View 9 RepliesWhile driving the other day, the truck suddenly began to stall when pressing the accelerator. The water in fuel light came on as did the glow plug light. This continued with the truck sometimes dying all the way and other times just stalling then picking back up. No difference in throttle pressure seemed to make a difference except that letting off totally then slowly pressing seemed to let it keep running sometimes.
So I get home and drain the fuel water separator. I gets about a thimble full of water and lots of the rusty looking junk others have talked about. Try to run the truck again, same thing as before. I then changed fuel filters and thought that had it licked but after about 10 minutes it started again. By the way, the 6mm plug seemed to have about a third of the threads rusted off. Not sure what that means as I drain it at least twice a year.
I have read a lot about the ICP and IPR issues and was wondering if this could be my problem. I am hoping its not the HPOP. My other thought was something in the fuel tank blocking the in tank filter. I checked the top mount bowl and it was only about two thirds full after running the truck
Truck info: Late 2004 Ford F350 Dually 4x4 crewcab, 6.0, EGR delete plate,4" turbo back exhaust with cat delete, no muffler,K&N filter and filter box, Diablo tuner usually set to 60hp upgrade.
So this '06 F350 is blowing fluid from the steering pump fitting when you move steering wheel to either side all the way(lock). Is the internal o-ring blown in the fitting? Do these have the teflon seal at the pump? Pretty new to the 6.0 scene. Got a new line ordered.
View 6 RepliesThis past Monday I was finally able to pick up a 2012 F350 dually and over the weekend I was able to do an EGR and DPF delete and I come to find out while under the truck that it has an oil leak I looked under the hood and it seems that there is oil around the turbo and after the test drive there is a LightStream of oil coming down the exhaust.
Another question is that I have read about the possible problem is that early build 2011's have that's why I chose to look for a 2012 so I didn't even consider looking at the build date when getting it and I come to find out it was November 2011 and this truck has a plastic oil pan should I be worried about The possibility of this engine taking a dump on me and if so what can I do to prevent it?
So I just changed the oil on my truck I had a ford motorcraft filter on there and replaced it with a Fram filter ( only because that's what was on the shelf at the big W store ) I drove it to town and back once ( 35 miles round trip ) ...
I was going to add a trickle charger to my truck as It will be sitting for a while and I was laying under the front of the truck trying to fish the power cord down and I looked back and see I had Oil spray going down the center of my truck . So I thought dam my filters not tight as when I looked at it , had oil streaks coming down it. So I checked it was tight , would not move.
So I wiped if off with a rag and it looks to me as if the filter is leaking at the top seam . were the filter is crimped . There's not way I can take it off and take it back to the store. a filter that is oil soaked . I am going to replace it but before I do I am going to see if I can get the leak on video
I am getting ready to go on vacation this weekend with my f350 and I was driving today when suddenly the truck shut down while going at about 25 mph. I tried to start it and it just kept cranking. I got it started 5 mins later and it threw a P0069 code. I drove for about 2 more miles and it shut down again, and started right back up. I'm guessing map sensor? This was the last thing I needed to happen!
View 14 RepliesTook my '11 F350 CC 6.7 Lariat with 31k miles on it into the dealer to have the tranny fluid leak looked at. I noticed this leak a few weeks ago as the bell housing was damp with fluid and the bolts heads on the underside of the poly engine oil pan were pooled with fluid. It is a very slow leak as I have parked it for 3 days and there were no drips of fluid on the ground, just collecting on the grid like pattern on the oil pan. Checked Fluid level and it is also full.
Anyway, the dealer put dye in the tranny fluid and told me to drive it for a few days. I took it back in on Monday and called this morning for an update. The mechanic informed that they ordered a new torque converter and some other parts to be "proactive" because he believes the TC is the issue. I asked if the cab would have to be pulled and they informed that all the work could be done from underneath. Glad I noticed this before the B2B warranty expired because this would have been expensive. I will be THOROUGHLY inspecting the entire vehicle from top to bottom before I hit 36k.
Is the A/C condenser pretty simple to replace on the 2006 F350? Replaced the compressor but then noticed the condenser was leaking. Looks simple just wondering if there are any quirks to it.
View 14 RepliesI've got a problem with an '05 f-350 with the 6.0. Initially I had a code for the #1 glow plug so I replaced the plug and the code was still there. Next I tested the harness and the rest of the plugs on the same harness and everything checked out fine. This lead me to the Gpcm which I then replaced. The first thing I noticed was when removing the old Gpcm I got a spark when removing the mounting nuts.
When I installed the new Gpcm the truck started fine and no codes came up so I thought all was good till I went to start the truck the next day and the batteries were dead. I thought I possibly left something on so i started charging the batteries but noticed they seemed to have a draw on them. I put my hand on the new Gpcm and it was very warm with the key off so I have the batteries disconnected till I can figure this out.
So I'm having a problem with my truck revving up out of no where. Happens more when I'm driving. It only shoots up a little bit but sometimes goes up 1000 more rmps. Happens for a quick second then stops and does it again. I've had the ckp replaced and it has an egr delete. Other than that it's stock. I got home and let it idle for a minute. The rpms fluttered up and down in small increments and almost stalled out. What is causing this?
View 4 RepliesI recently had my injectors changed at Ford and while I was driving it started dumping coolant. If the leak can be cause from the injector replacement or if they didn't put something back together right... 2005 f 350 6.0...
View 14 RepliesThe other day, I started having problems with the truck not starting when at operating temp. Went for a drive and stopped a a scenic overlook, and spent about 30 minutes taking pictures. Went back to the truck, and it wouldn't start. Outside temp was about 95 degrees.
I tried for about half an hour to start it, but all it would do is turn over. There was a work crew there with their heavy machinery, and I was able to borrow their starting fluid. One quick squirt into the intake, and it fired right up.
Although I do have an oil leak from the right valve cover, when I checked the oil, it was just off the full mark. The truck was parked on a slight angle with the driver side being about a foot higher than the passenger side.
2003 F350 w/6.0, 180,000 miles
What the problem is with my F-350 6.0. I have an intermittent problem with my Speedo reading zero while I'm doing 70mph on the fwy. since the speedo won't work the truck goes into limp mode, the turbo will not function at optimum level. I have replaced the diff. sensor, the trani sensor, the a.b.s.sensors, the instrument cluster to a reman cluster. Then when I had a local mechanic plug a laptop dianostic program on it as he was running through the system inadvertently the radio cut out, so I found that who ever installed the after market stereo they cut a few wires to the harness, I went to the junk yard found the harness end and replaced the end. so with all that said and done no one knows what is causing this speedo not to work and limp mode. about 4 years ago the oil pump stopped working and ruined the turbo so the whole front end of that glorious 6.0 was rebuilt the problem started about a year after that.
View 2 RepliesWhen I installed the blue spring kit I noticed that my fuel pressure would stay around 60-61 PSI. Since this was safe I changed my gauge info to display FICM. Anyway I decided I better go back and check on the Fuel PSI since it has been awhile since I checked. I started noticing that when I start my truck up in the morning my fuel pressure usually stays around 60-61 PSI. After it warms up sometimes it will hover around 55 PSI. Other times it will be back at the 60 PSI mark. Not sure if this is regular or not since I haven't been keeping long term track of what is going on. Truck runs great though, just wondering if maybe the fuel pump is getting weak. Also I have my sensor attached to the test port on the fuel bowl.
View 1 RepliesCouple of years ago I installed a fuel pressure gauge. I wrapped the fittings with teflon tape. Well within about a year it started leaking. So I shopped around and used Permatex Permashield fuel resistant sealant on the fittings. It says diesel resistant on the package. Couple months later leaking again. So I take it apart again, clean every fitting and follow the instructions to the letter. Well its leaking again. What will resist diesel fuel under 55 psi pressure. All the fittings seem to be pipe thread.
View 7 Replies