I spotted a leak last nite on my 6.0. It is coolant, running down the right rear on 2 metal lines that go to the trans I think. It was dark and 24 degrees so I did not spend too much time looking. Shut the mother down til I could research. 2004 250, 6.0 FX4x4, stock. Coolant was changed to green by previous owner. Bought it 4 months ago. 187,000 miles.....
View 14 RepliesWhile servicing the bosses 121k 6.0, I noticed the coolant resevoir empty. It took 1 1/2 gallons to bring to proper level. Returning under truck to install drain plug, I noticed coolant coming from rear of the engine(right side). And of course Ford has changed the cooling system cap, so I wasn't able to pressure test it to pinpoint the leak. Started the engine and seen coolant coming from the left rear as well. I've been reading here to see what others have been seeing, (EGR cooler, head gaskets). With all the heat shields,not much room to look.
After work I did go and buy the adapter to test the cooling system. With any luck I will be able to see leak better.
I recently was informed by my local mechanic that fuel was leaking into my coolant. He said I had a cracked head based on this and it would give soon. Well, he was right, and now I need to do a head job. I found new heads, but would like to know how many book hours this should take before I proceed. He gives me a wide range of time, and don't want to get taken advantage of.
View 4 RepliesI haven't had time to take my truck to the dealer to actually be checked yet but it appears I might have a rear main seal going out from what I can see. I pressure washed the whole underside of my truck the other day and there is fresh oil where the engine connects to the transmission.
My truck is a 2011 with a 2013 engine in it. The truck has 103,900 miles on it. The engine has almost 60,000 miles on it. I have the extended warranty on it which is good. All this truck has to do is last 2 more lousy months and I'll replace it.
2011 Ford F-450 6.7L Diesel 12' Flatbed
My friend is working on a 2004 6.0 F-250 and it has used 75% of the coolant in the overflow bottle in 5 days. Can't smell coolant either. The inside of the tailpipe is wet soot black and there are wet spots on the tube coming from the intercooler to the turbo at the turbo and the intercooler. He's thinking EGR cooler.
View 6 RepliesI just purchased a used f250 6.0L a week after having it i noticed a small oil leak slowly got worse (looked as if it was coming from the too rear of the engine) then noticed about a half quart of oil under my truck. While driving it home the oil pressure gauge kept dropping then going back to normal then eventually dropping for good. The truck still ran so i drove it to take it to the mechanic but then the throttle began to become unresponsive and then gain power again then finally the truck shut off and wouldn't start again, blowing oil all over the inside of the hood and top of the engine. I checked it and noticed the pressure sensor pigtail were fraid so i replaced that along with the sensor and added oil but still wont start.
View 10 RepliesBought this truck, and the engine coolant temp gauge does not work, so I replaced the sender, still don't work.
View 8 RepliesOn our '04 Ex with 195 on the clock I've discovered a pretty good leak dripping. I crawled under it an coolant appears to be dripping off the back of both exhaust manifolds.
Less than 1000 miles ago we had an oil cooler and egr was pulled and freeze plugs installed by an excellent well respected 6.0 diesel shop. I don't think both gaskets could have blown at the same time creating two leaks. It runs fine, degas bottle still has coolant in it.
I've seen other threads that point to the heater core hose and more commonly the "orange" egr hose. It appears that an egr delete removes the hose - I think... but would that Blue / orange hose be there if the cooler was just capped and electrical unplugged?
The shop is going to look at it Monday but I'm trying to understand it better ahead of time.
2006 6.0l
Just noticed yesterday during an oil change that I had white stuff around the coolant cap on the overflow bottle and that no coolant was visible. I went and got some antifreeze premix to top it off and it only took around 1 quart. Today after driving it approx 30 miles, the coolant was again missing.
When I changed the oil the other that same day there was no coolant in it, and I don't have any puddles on the ground. Whats going on?
EGR is deleted with a sinister kit, temps are fine, today it was 94 degrees and the truck was running at 194 oil 192 Coolant when getting off the highway after 15 minutes doing ~75. I've got a little bit of stiction going on but besides that nothing seems wrong.
I LOVE my Super Duty and with only 15k on it (have a company truck) plan on keeping it for a long time. I've had an EGR Delete and new Oil Cooler along with some misc things done to the engine and turbo, about 6g's worth. Now my mechanic at NCB is telling me that the reason I'm loosing coolant is that my head gaskets are leaking. I'm looking at another 5-7 grand which is a no go for me. I'm thinking of doing the work myself, especially since I've seen where i don't have to remove the body to do it.
Okay, here is the question, I've been having a hard time finding a comprehensive list of the parts I should be getting to do the job. Looking for a list or link on what I need to do it correctly and anything I might want to do while my engine is apart so I don't have to do this again?
I have a 2012 with 41k miles on it. I noticed it was leaking oil from the front of the motor. So...I checked the oil and found it to be over full. Assuming I overfilled when I changed the oil (2000 miles ago) I changed the oil again and made certain it was filled properly, 13 qts right in the middle of the dip stick. The oil leak stops. 1000 miles later the oil leak starts again. Too much oil again and the coolant is mysteriously low!!! The dealer can get me in two weeks from now.
Time to get the 7.3 back on the road, I knew I kept the old girl for a reason. 262k of miles no truck should endure and still going strong. I was 21 when I bought the 7.3 (16 years ago) and beat the crap out of it. This truck has been pampered compared to my past trucks. I was hoping to get 14 years out of this truck too.
Is the motor OK after having coolant sloshing around in there? I just hope ford stands behind this one. I have a feeling it's not an easy fix. I am sure glad I left everything stock.
Last week I noticed I was having to refill coolant in my excursion more than I should. I hae a mechanic friend now trying to diagnose the problem. he said he doesnt think its the water pump and there's no white smoke. Are there common leaking places for the coolant on 6.0s he should be looking for?
View 4 RepliesI've just finished a marathon replacing the y-pipe, and doing the IPR screen. I had many seized/stripped bolts to contend with. 2 I had to cut off in the most awkward places.. Anyways, it all came together and completed the project late tonight...
Befoer even starting the truck I noticed coolant dripping from passenger side manifold/block heater area.. I obviously must have damaged something in my reefing on turbo to get it lined up with exhaust pipes, etc...
I cannot see the source of the leak, but it seems wet above the block heater, but pools there then drips.. I'm curious where to look. Could I have damaged the EGR cooler and its coming from there? At the manifold joint closest to the back, is there coolant flowing there? I am pretty frustrated, because after going through a day like to day, ripping my arms to shreds, straining for 12 hours straight, then having yet another issue to figure out...
Also this is as best as I could get the y-pipe to meet the turbo... slight gap at bottom.
On Friday am I noticed a 6" sized puddle on the garage floor. Coolant leak on the drivers side coming off the frame. Dropped it off at the dealer on Sunday and today the tech tells me it was in fact a radiator leak and the new one will be here wed. They hope to have it buttoned late Wednesday. I am assuming all will be covered under warranty.
I have 23k miles logged and had just got home from a 1300 mile run pulling about 18k worth of hay and trailer. Truck performed flawlessly. Averaged 11mpg for the trip. I am hoping this is the first and last radiator replacement I have to go thru.
I recently had my injectors changed at Ford and while I was driving it started dumping coolant. If the leak can be cause from the injector replacement or if they didn't put something back together right... 2005 f 350 6.0...
View 14 RepliesI have coolant blowing out of my coolant reservoir when ever i hold it to the floor it does it with or without the banks programmer... 6.0L power stroke...
View 14 Replies04 f250 364000 miles 06 6.0. New fan clutch. Ac didn't work when I put the engine in found out the fan clutch was bad so I replaced it. Now it doesn't turn at idle until the engine warms up even if I have the ac on. In the mornings it comes on and keep the temp at 190. In the after noon when if finally comes on truck runs at 210 to 190. Fss 530 when on at 210 at idle. And 800 at 1200 rpm what is going on.
View 3 RepliesI have a 2007 F250 with the 6.0. Towing up a long hill my truck went into limp mode. I didn't have gauges at the time so I didn't know what my temps were. I now have gauges. I know that the coolant and Oil temps should not be more than 10-15* apart, but what is the max temp that oil should EVER get towing up a steep and long hill? Also, what is the max temp that coolant should EVER get towing up a steep and long hill?
View 14 RepliesI have a O6 F250. Egr delete and a new oil cooler 20k ago. I have been dealing with missing coolant for about 6 months. A little here or there but it has gotten really bad the last few weeks. My last attempt was to replace the degas cap. Stopped the missing coolant for a 30 mile trip. Just to clarify it had gotten to the point I was adding one gallon per 20 miles. Needless to say I was thrilled. Next morning I came out to find coolant under the truck. Plastic Y under degass, so I replaced it. 25 miles and none missing. Next morning fluid under the truck. Now it's the egr hose.
Replaced it with a gates hose and new clamps. Fill it up with coolant go inside and its leaking in the same location. Its a pure pleasure to undertake. So I assume these leaks weren't previously leaking because the degass cap wasn't pressurizing the system. That being said the leak is on the oil cooler side of the egr hose. The snap lock fitting that was on the original housing spins around. Should that locking mechanism be removed before the hose is secured and clamped? This is the only thing I can come up with as the culprit. I have searched the information on the site but can't find any mention of it needing to be removed. The clamps are the right width and everything is seated.
I'm presently traveling and my '02 F-250 with a 7.3 PowerStroke has developed a pretty steady drip of what I am almost sure is diesel fuel. It's dripping from the very front, from the shroud around the fan and radiator area.
I have some basic tools with me, but no experience on this engine or the fuel system. Does the fuel line go up into the radiator area? What should I be looking for? I'm stranded in a campground until I figure this out.
2011 F-350 CC, 45k miles... Found out yesterday mine is leaking. Way to early for these issues to pop up.
View 1 Replies