Ford 6.0L Power Stroke Diesel :: 2004 - Dead Pedal Every Now And Then
Dec 23, 2016
Recently I have been experiencing dead pedal every now and again, but it eventually comes back. Its happened on the interstate a couple of times and that can get pretty dangerous. Now I am having issues with a no start condition out of no where. It will eventually crank but it churns and churns for a VERY long time, like 15- 30 mins before it will fire again. This has happened twice now. Here are the codes I pulled from Torque:
P0263
P0281
P0299
P0528
Where this is all coming from? I thought at first bad TPS on the adjustable pedals, but now with the no start condition, could it be fuel pump related? Yesterday I was at the dump and it was idling, then got real erratic and shut down. Then wouldn't start for 20 minutes.
View 14 Replies
Advertisement
Had 3 separate episodes dead pedal on my 04 bone stock 6.0. About a week ago I pulled out on the road and the truck went to idle and would not respond no matter how much throttle I gave. After about 10 seconds it woke up and took off. Had this happen 2 more times this afternoon.
No codes or dash lights.... What this might be? I have a 500 mile road trip this weekend and am worried about being stranded on the side of the road.
View 14 Replies
Is there one thing that when broken makes both the steering and brakes lose all power? Does the power steering and hydroboost share a pressure source?
My brake pedal is dead and I get no steering boost, but the master cylinder and PSP are full of fluid. Do I replace both, or replace one first to see if that fixes both? Or could it just be a hose leaking? Not sure how to diagnose this one.
View 1 Replies
Does the 2015 F350 have the dead pedal on the left drivers side? The one they used to put in to rest your foot on?
View 13 Replies
Just changed the fuel filter in my '04 6.0, no issues worked just like normal, filter primed truck started, great. Well now my fuel pressure gauge is reading dead 0, I know that can't be right because the truck is running, but noticed my fuel mileage seems about 2 mpg lower all of a sudden. Had R&R Injectors installed about 40k ago, figure it's just a bad gauge but wanted to check and see before messing with the frickin wiring. Also, have had a lot of pressure buildup in the coolant tank, has had head gaskets and studs, anything else it could be besides head gaskets? Have had a lot of wiring issues with this truck from the previous owner....
View 14 Replies
I have an 04 6.0 psd and if I am stopped in drive with the brake pedal down I can't turn my steering wheel at all. If the truck is in park and my foot off the brake pedal I can turn the steering wheel both ways just fine. When I am driving I don't have any problems with the steering. I have checked the power steering fluid and it is full. This makes it kind of hard when I am trying to pull in and out of parking spots. What could be causing this and what the solution would be to fix it?
View 10 Replies
i have a 04 ford excursion 6.0 with the egr delete, was stopped at a light to make a left turn, when i stepped on the accelerator pedal nothing happened as the engine was just idling. i pumped the pedal around 10 times and finally got the engine to rev up. i just got this excursion and don't know to much about the maintenance on it. i am going to drain the water and change the two fuel filters. my neighbor is familiar with diesel engines and he said to look at the throttle sensor. i have run this engine up to 900 miles and it has started and run perfectly. i believe the usual maintenance like oil changes etc were done on it. would any error codes show up even though no warning lights on the dash.
View 8 Replies
I am pretty sure my pedal is going.. Today and last month it would just die from a dead stop push the pedal and no go, but truck idling fine. I cleaned it off a few weeks ago but now its back. push pedal in and out a few times and all is fine for a few weeks. Truck runs fine other than that. Does not throw a code, just trans light comes on because no movement I think, then it goes off as soon as i start to move along. I have a adjustable pedal assembly 2c3z-9f836-de 508.45 at white bear lake ford.
View 1 Replies
Is there one fuse for the entire instrument cluster? Because today the entire instrument cluster went dead, even the digital odometer part. Hoping it is just a simple blown fuse...
View 14 Replies
My batteries go dead over night, had them checked but they say there good, can't figure out what's causing them to die.
View 8 Replies
I had a crank no start with very low hpo pressure. I went to do an air test and could not get my IPR valve to do anything with 12 volts applied. I have a switch wired to it, and went as far as wiring the IPR valve directly to the battery and got nothing. This is a brand new ipr valve, never seen a mile of driving, and I'm wondering if my luck could really be bad enough to get a bad one in the box, or if it could be my truck that's frying them. I have cranked on it a lot trying to start, but I have a feeling this IPR is to blame. I'm on my way to get a warranty replacement now. If my truck could frying them, would that be just a bad ground or what? Any way to test my wiring? I have a multimeter...
View 14 Replies
July 11, 2013 replaced HPOP. June 26, 2014, Going down I20 in Dallas engine shuts off. Three days later Ford techs declare said HPOP dead . Looking at another HPOP along with stand pipes and dummy plug seals. Hopefully I can get some warranty relief on the pump. Do these things eat HPOP?
View 14 Replies
I have a 2014 F250 with the 3.55 rear end and 6500 miles and since new it has a hesitation from a dead stop that I cannot determine if it is normal or not. I took it into a dealer that specializes in diesels and they drove it and told me it is normal. Every time I see someone with the 6.7 I ask them if they have the same problem and I get all kinds of explanations from turbo lag to protecting the tranny. The hesitation I feel is when I throttle from a dead stop. It is a very slight hesitation, but very noticeable, almost like a little "dead spot." If I take my foot off the brake and let it take off on its own for just a second or two and then throttle smoothly it is not there at all. If this is not normal, I want to do everything I can to get it fixed. It is driving me nuts.
View 13 Replies
Here are the basics:
1. Suppose I come to a dead stop or a rolling stop and I continue keeping a small or very small amount of pressure on the accelerator. When I try to start again gently, there are two outcomes: (a) the "hesitation" or "no or dead throttle response," when I had added only a small amount of pressure, or (b) a "lurch" when I add more pressure to counter act the hesitation!
2. On the other hand, if I come to a stop or a partial/rolling stop, and remove all pressure from the accelerator before I start again, it seems I can start from a stop normally, both gently and under control. I have been experimenting by being certain there is no accelerator pedal at all prior to any start from dead or nearly a dead stop. That isn't, however, a fail-safe approach because of various driving conditions.
But, even if that provides a partial remedy, there is still a problem because this isn't the way the accelerator should work. It should not take all that learning, adjustment, and counter-measures to drive safely.
I certainly agree with the another poster: either of the two results of this: the "hesitation," and/or the sudden "lurch," could put the truck in a dangerous situation. I already have experienced this near chaos a couple of times.
So, is this problem continuing to appear on 6.7 2011 Fords, and, if anyone has a 2012---has this problem appeared on the most recently built Fords?
View 14 Replies
I have had my truck for 13k miles and have been working through all the to-do items. Monday my FICM went dead, I got a replacement with 2 new batteries (ALT was ok 140 amp). Today I pulled the EGR valve for cleaning and noticed it was very moist but pretty clean. I looked down inside the intake and notice it was oily/wet. Is this a leaking EGR cooler issue or could the FICM going bad have something to do with it as well?
View 5 Replies
2004 6.0 lariat ... The compass on my overhead console has gone dead or at least doesn't show anything other than sometimes calibrating ... All other functions miles to empty etc work fine just the compass feature ...
View 2 Replies
Don't have a clue what's happening here or where to begin looking but about 20 seconds after cranking the truck ALL my instrument panel gauges go dead, radio goes dead (nothing on it's display) and my driver door controls all stop working simultaneously. Funny thing though, I can still see what the computer sees with my edge insight that's plugged into my OBD2 port and all those read as normal. The engine still runs and I can drive with no issues. My headlights still work fine as do all my signals.
View 4 Replies
I have not started my truck for some time (about 3 months) and the battery went dead. I recharged the battery and started her up. I then drove my truck about 5 miles and noticed that the water temp gauge was pegged to overheat...unbelievable! So of course I stopped the truck at the the nearest spot that had a water hose. The water was about 2-3 liters low as I could tell. This should not have caused the engine to overheat though. So what happened here. The engine ran ok back home but now I do not know what to do. Is it an electrical issue where the cooling system has a valve that is signaled electronically to open for the water to flow thru the system??
View 14 Replies
Just bought a 03 F-350 dually today. 6L 4x4.
Headlights don't work , everything else does? Dash lights , taillights , cab marker lights all work. Headlights and front park lights don't?
I also see the overhead console is dead and shows nothing? Plus the ignition turns without a key being in it?
View 6 Replies
a little history here, about 2 years ago I got my first P401 so I changed the egr valve and it went away for a little while. Then I came back several months later and changed it again. along with the P401 I get heavy black smoke when taking off from a dead stop and after it gets a little speed it will run good. Here lately it seems I can only get 2 weeks to a month between cleaning the EGR valve.
Each time I clean it has a bb size piece of carbon stuck and is holding the valve open and there are several more under the EGR valve. each time I try to vacuum the carbon chunks out and clean everything as best I can. As of now I'm fed up with it and would like to do something to make it more reliable. would taking the intake off and cleaning completely and adding a EGR delete kit eliminate the carbon from building up?
View 11 Replies
On cruise control, engine went dead immediately after passing gear kicked in. After 2 days on the side of the road got a pull to the house. Then after having a charger on it over night the electric seems to be messed up. Switched on, the dash lights light full strength for a fraction of a second before appearing as thought the battery is real low. Also the doorlocks act crazy. I think maybe I blew out the BB on the high oil pressure pump.
View 6 Replies
