I was driving home from work and out of the blue my truck started slipping gears so wen I got home I looked under my truck at the transmission and drive shaft and from the picture I attached that is what I saw...
View 4 RepliesJust the other day I was driving my car till I've noticed the gears started slipping. At first it was having some issues shifting through the gears (automatic transmission btw). As soon as I got off the highway, I parked in a parking lot just to check underneath the hood. Everything looked fine, went to pull out of the parking lot, no reverse. The gears started to slip up really bad. I noticed that the RPM's kept on reving up and wouldn't go any faster than 20mph. I went to an advance auto parts to get automatic transmission fluid. Still having the same issue and no reverse either. I had to park the car at a location to get it towed back to my house. Some people are saying my transmission is bad, some say it could be a real simple fix. Where to start diagnosing this issue. The car was driving normally until last Monday. My question is where should I start to check and what can I do to see if the transmission is completely shot??
View 33 RepliesRecently with the rain and snow my truck has started missing but only around 2,000 rpm in lower gears. its a 1996 chevy k1500, it has new plug wires spark plugs and new distributor cap and rotor. When its dry outside it runs fine and everything is tight so I'm thinking it has to be the tower or coil.
View 1 RepliesAll week the truck was acting like the clutch was slight depressed when first taking off and then today i was driving and the underside of truck started smoking like crazy and slowly lost all the gears could put it in any gear and nothing just was acting like it was being revved. does this mean clutch is bad?
View 10 RepliesAt a loss right now. My 2004 F150 4X4 and just recently started sounding like the truck is trying to shift into 4X4 mode while driving it. It stops if it's switched into 4X4. I have taken it to a local mechanic shop I use and they said it was the Actuators and they replaced those. I got it back and the same day the noise came back. Took it back and they have had it for another week and still unable to figure it out. I even took it to another shop that was highly recommended and they say to take it to a Ford dealership. I have read that some say it could be the vacuum operated hubs? Need to figure out what it was and had it fixed?
View 1 Replies1999 ranger, 2.55 speed. truck idles with very high rpm's when driving and shifting gears. have changed the AIC, mass air sensor. Throttle position sensor and still does it. the AIC has been changed 5-6 times in 6-8 months as parts store kept telling me it was that. What can i look at, check, etc...
View 6 RepliesI have a 92 ranger 6cyl 4L. The truck stopped running while driving then kicked on again, it did this several times over about 20 minutes then finally died and now I can't get it started. I recently replaced the fuel pump and filter and spark plugs and wires. I get spark if I ground the plug and some gas will pour out of the fuel pressure test valve when I stick a screws driver in. When I check engine codes I get an all pass. Truck will turn over and sometimes run for 2 or 3 seconds but that is it.
View 2 RepliesSo I turned off my truck the other day, got out, and it started again on its own. Confused, I looked in my hand to see my key. I got back in, and tapped the brake thinking the command start had engaged, even though I did not have the remote with me. It continued to run. So I put the key back in the ignition, turned it to ON and back OFF. It still ran. I had to run inside for a half a minute so I left it running.
Came back and drove away with no issues. When I stopped again about 2 minutes later and shifted to PARK, the starter engaged making it's terrible 'hey stupid, I'm already running' sound. I tried shutting it OFF quickly but it still ran and made it's skinning crawling noise. So I quickly shifted back to DRIVE. All the gears worked fine but PARK and NEUTRAL had the starter engaging. I also could not shut the truck off from DRIVE as the key would not turn.
I drove over to a local garage and called them from the truck as I was effectively trapped in the truck with my foot on the brake, unable to shift to PARK or turn it OFF. No supporting staff. So I drove back to work where I had a co-worker remove the battery cable at which point I was able to shift to PARK and turn OFF the truck. I let it sit like that for about 10 minutes and haven't had a problem since.
What happened?? And for the record I can put gas in the tank and changed my own oil, but that is the extent of my vehicle knowledge.
I have an early model year 2004 Touareg which has lately developed what appears to be a slipping problem when changing gears from 5th to 4th when decelerating or the same when accelerating strongly and downshifting. When switching over to tiptronic mode, its not clear if that apparent slipping goes away or changes. It definitely isn't as severe but that could be due to perception or the RPMs where the shifting is occurring.
The only real interesting characteristic of this clunk and lurch that is experienced is that it only happens when the car is warm -- I've been watching the transmission oil temperature, and it appears to start happening as it passes through 200 degrees. When it starts, the lurch/clunk is small and not too bad. As the car reaches temperature, it reaches if full lurch/clunk potential.
I have taken it to the dealer once and they have "upgraded software" that was supposed to clear up the problem, but did not.
My wife was driving my Stage 1 R last night (by herself) and she ran into an issue where when she tried to leave from a red light, the clutch was slipping through the first three gears and she could barely get up any speed. She pulled over, let the car sit for a few minutes and then started going again with no issues.
She drove home about 5 miles and told me about what happened. The car smelled like burning clutch, but when I took it out for a quick test drive, everything seemed fine.
I am at around 5000 miles and have never had any issues before and I don't ever do high-rpm launches. So, could this have been a fluke or a sign of the clutch/pressure plate issues people have been having?
Transmission on 04 V8 phaeton is slipping between first & second gears. transmission repair $4-10K. thought of just taking out the first gear via reprogramming (had a jag where you could do that for snow/ice conditions). do yo think taking out the first gear will cause extra wear & tear on the drive train? The first gear seems to be very short.
View 16 Replies2003 rav4 . Recently, my rav4 has been slipping from gears 2-3. After exhaustive research, I found out that my car is known to have a bad ecm. So I decided to get a fixed ecm and replace it in my car. Car still slips so, thinking the ecm is good, I had my transmission rebuilt. After rebuilding my transmission, it still slips from gears 2-3. Do I need to replace my ecm again to coincide with the new transmission? I'm completely at a lost.
View 12 RepliesI've just about had it with this car:
- Car always had a "mushy" clutch feel. Not proper pushback against your foot feel.
- brought in several times under warranty, all was fine (documented by several dealers) from Jun- November 2015.
- Clutch then goes out at 52k, slipping in high gears. Dealer noted the pressure plate was blackened/burnt. June 2016
- I replace clutch at dealer, $1700 later. Pressure plate, slave cylinder, clutch disc, resurfaced flywheel. Pedal feel is awesome for about a month. Pedal "mush" comes back 1000 miles later. July 2016
- Take it in under the 12k warranty again, and they replace clutch master cylinder. It's about 60% better, but pedal will lose pressure occasionally and at higher altitudes (over 4000 feet) July 2016
What else haven't I replaced? And would a failed clutch master cylinder cause premature clutch wear if not replaced for months?
2003 Explorer with a slipping transmission...codes are P0731, P0732, P0733... Just had a new solenoid pack installed last week when O/D light came on and truck was clunking into reverse. Now, after new pack was installed the forward gears are slipping all over the place!
View 5 RepliesFrom the other users it seems that almost all are having slipping of gears and rough shifting associated with this code. On mine I'm not getting any slipping or rough shifting...it actually still seems to be driving just fine. The OD light came on and will go away after shutting the truck off and back on...it will then not flash anymore for say a couple of months or so...this has been happening for the past few years every now and again and i never thought much of it. I just made a 2k mile trip and this happened again but this time it threw the p0775 code which is a first.. Is it possibly a very early sign of the sensors going bad.
View 3 RepliesI own a 2005 f-250 superduty with the 6L diesel. Just recently when I leave to work in the morning I notice the trans shifts slow through the gears and when it does start to shift it will start slipping then kinda vibrate for a few seconds then finally shifts into the next gear. It will do this through all the gears until I get up to speed on the highway. After it warms up it shifts and drives great until I let it sit for around 8hrs or more. I really hope I don't need a new Transmission considering I bought this truck as is from the dealership just a little over a month ago. I have checked the trans fluid it is full, I even drained all the fluid and replace with new and it still does the same thing.
View 4 RepliesI have an automatic Jetta and just hit 130,000 miles. Recently, my car would randomly after I turn it on and put it in drive, the car would jerk forward and make like a popping noise. Then the car drives fine as usual. As if the gears are slipping? Is this a sign that my transmission is going out? What else can cause this? What should I do?
View 2 RepliesI can drive below 40 mph and nothing, once I hit the freeway engine light turns on and gears start slipping. I erase the code and it runs fine at first this would happen once in a while but lately its every time I get on the freeway. I cant keep driving and erasing the code, Every shop says I need to replace the transmission?
View 4 RepliesFor a little while I have been noticing an odd noise from the front driver side tire. About a year ago on two different occasions I heard a sound when I turned the wheel somewhat sharply that sounded like a clacking noise almost like gears slipping. It only happened for a few seconds and stopped but has never done it other than those 2 times that I am aware of. This is my wifes everyday driver, so I don't always hear the noises.
Recently it started making a sound that to me sounded very similar to a wheel bearing going bad. I looked into it a little and drove it and decided to change it even though it didn't have all the "symptoms" of a wheel bearing (louder when turning away from that side, quieter when turning towards that side, play in the wheel). After replacing the hub assembly it didnt make the same noise, but made a different noise that was from the shield on the back side of the rotor rubbing against it. Took it for a drive thinking that I fixed it only to have it start doing it again. After listening closer it sounded like a metal rubbing against metal sound, sorta like a brake pad dragging on a grooved or rusty rotor. I inspected the rotor and all i saw as an issue was on the inner side of it there was a ring of rust on the inner and outer edges, and it was wearing the pad to have beveled edges. I replace the pads and rotor, and it still makes the sound.
I am down to two options that I can think of trying but do not want to really try either one because of the amount of money I have already put into it.
1) I have thought about replacing the brake caliper.
2) I have thought about replacing the CV Axle, BUT the boots are in excellent shape.
It doesn't make the noise all the time, and sometimes it is worse when turning to the right, and other times there is no change regardless of the direction you turn. When it does do it, it feels almost as if the car is dragging and pulls to the drivers side.
I am really at a loss here and don't want to keep narrowing it down because I have misdiagnosed the problem twice now, and was really confident in it being the wheel bearing.
Well the clutch started slipping finally, not sure if it was the weather change on the drive from here to PA but I slip 5 and 6th wot 4-5k rpms. Have some coin set away because I knew it was going to happen sooner or later did some searching and I'm curious to here the verdict on the RSR clutch how many miles and how its holding up as well as whatever else you are running. Will probably keep the car 2+ for quite a while so not really worried about 3+ power.
View 24 RepliesI'm a new owner of a 04 gti 1.8t. The car has been modified with a ko5 turbo @ 20psi, apr tune, 3" turbo back exhaust, hks bov, and a FMIC. The car is amazing, but with my luck after only a few days of owning the car the clutch started slipping.
View 2 Replies