F Series :: 2003 - Vibration Develop When Shift Into Fourth Gear
Nov 6, 2013
At work we bought a 2003 F-250 at an online auction. I was driving it home, and when it shifts into fourth gear, (overdrive) a vibration develops. When I pushed the overdrive lockout on the gear selector and it downshifts to 3rd the vibration pretty much goes away. Turn OD back on and it upshifts and the vibration is back. The transmission seems to shift through all the gears really good / smoothly and is glass smooth when you go from Reverse to Drive. What could this be; fourth gear going out, sticking valve in the tranny, drive shaft off balance? Just not sure where to start on this one.
View 1 Replies
Advertisement
2003 3.0 FFV 5 speed automatic...... Just noticed recently that it seems slow to go into 2nd gear.....the rest of the shifts seem fine, firm and unchanged.....
View 4 Replies
My sister's Grand Am has been having a shift flutter issue (between third and fourth, around 40 mph it would shift rapidly back and forth until you either forced a downshift or reached 50-55 mph) for a while now. I read a lot about it online, and all signs and the experiences of others pointed to a bad shift solenoid or pressure control solenoid. I wanted to correct the issue before it caused any damage to the transmission. I removed the transmission from the car and replaced both shift solenoids, the torque converter clutch solenoid, the pressure control solenoid, and the manifold pressure switch with new ACDelco parts. I figured I may as well replace them all while the trans was apart. I also replaced the filter and fluid, of course. I got everything back together, and now the transmission slips in reverse and overdrive no longer works. Fluid level is full according to the method of pulling the level check fill plug while hot, idling in park. I used Valvoline Maxlife fluid, which meets Dexron VI specs according to the product label. I have double and triple checked everything and can't even fathom what I could have done to cause these new symptoms to crop up.
View 5 Replies
When I shift from first to second gear, especially when the car is still cold, I get a vibration(?) feeling through the shifter. I'm not shifting hard but not slow either. It's definitely not a grind but it only happens when shifting from first to second.
FYI- The car has ~550 miles on it.
View 1 Replies
I have a 98 Suburban with a 4l60e rebuilt 13 months ago, less than 15000 miles since. I have no second gear at all, but still no apparent slip at all in fourth. R,1,3 are fine. The fluid is a bit dark red, smells normal. There was a bit of the grey paste on the magnet but no obvious trauma. I did find a very small copper wire in there. It's about a 22 gauge, looks like it could have been a 3/8" ring or retainer.
I've replaced the servo, and of course fluid and filter. I pulled off the housing for the 1-2 piston but didn't have the right part to replace. I did not see anything cracked or cocked, it came out and went in fine. The main o ring did look fairly warn, but seemed all-right.
A transmission tester showed second gear being called for on a test drive. I did get a P1870 slippage code a couples weeks ago, I have since cleared it and it has not returned. Could the copper 'ring' be a retainer for something related? I'm guessing the solenoid, but I believe it also applies to 4th gear.
View 8 Replies
I have a Nissan Frontier, 2002, 4 cyl., manual 5 speed transmission. It seem to slip out of fourth gear, and only fourth gear, especially if I try to drive aggressively, or if I try to accelerate from fourth gear. It happens most when I am driving at lower speeds in fourth gear. Also, the colder the morning, the more likely it is to slip. IS this a transmission problem or a clutch problem (or something else), and what needs to be worked on or replaced- i.e. a whole system, or only a select couple of parts?
View 6 Replies
I was driving my elantra today, and hit a big pothole. Since then, sometimes when I'm driving in fourth gear (I think), I'll feel a thud, and the rpms will go up a little. Then, when I try to accelerate after a stop, the car won't accelerate normally, like it's still stuck in fourth gear. 2005 Elantra ...
View 3 Replies
I have a 2005 Hyundai Elantra. I recently have been having issues with the transmission. When I'm in fourth gear, I will sometimes feel a sudden jolt, and then the rpms will go up, and the engine will seem to be working harder and be noisier. When I then come to a stop and then try to accelerate again, the acceleration is very slow, as if the car is still in a high gear. When I turn the car off and then on, the car accelerates fine again. Since then, I have put the car into overdrive off, and haven't had any problems. If the problem is in the fourth gear, could I just use overdrive off consistently and not fix the problem? Could that somehow cause more damage or be bad for the engine? I put about 50 highway miles on the car each day. But I only plan on doing so for the next ten months or so, then I will generally only be using it for short trips around the neighborhood.
View 3 Replies
My 01 excursion with a v10 6.8 liter gas engine was running rough and cutting out at 40 miles an hour climbing hills and similar situations. Had some engine codes for cylinder misfires. Changed all the spark plugs. Now it does not cut out and runs generally smoother. But something is still very wrong. At idle, you can hear it kind of shuddering.
In first and second gear it does pretty well, but when it goes to 3rd the shudder and vibration in the vehicle becomes noticeable, it can become very bad as you slowly climb to 40 miles or 50 miles an hour. If you give it gas and rev the RPMs up and go on up to 60 or 70 miles an hour, it smooths out and you would not think there was anything wrong with it.
The mechanic said we would have to wait until an engine code comes up, but I would like to understand and fix this problem if we could.
View 12 Replies
ive been experiancing an issue with my trucks shifting. it shifts smoothly but doesnt like shift into 5th, as im driving it stays in 4th longer than necessary. my thought was that it was tied to a shift sensor, what do you think?
View 5 Replies
I own a 2004 Toyota Celica GTS 4-speed automatic, 24,600 original miles. The car is maybe 11 / 12 years old now. I've noticed that in extremely cold Wisconsin weather it takes a while for my car to shift into fourth gear. It kind of hangs onto third and then eventually shifts into fourth at about 40 - 45 miles per hour. Not sure if that's anything to be alarmed about or not. Drives fine and shifts smooth in warmer weather. I am the second owner. I am going to assume the original owner never changed the transmission fluid, or for that matter, never had a reason to. I purchased the car several years ago. So... is slow shifting enough to change the fluid? Or age of the fluid anything to worry about?
View 7 Replies
My husband's 1999 (manual transmission) Honda Accord has suddenly gone from a very reliable vehicle to a very big problem. Last week, he experienced problems while driving in fourth gear going up hill at around 45 MPH. The car essentially stopped pulling him up the hill, so he went into third, and got nothing, then second, and got nothing. It took a few tries to re-start the car, which then started idling at lower-than-usual RPM's.
He revved the engine a bit, gave it a test drive, and was able to get to his destination without any more problems. The next day, at about the same place in the road, he experienced something similar, but this time, he revved the engine to increase the RPM's while in fourth gear and was able to make it through without any stalls. This morning, however, his car did not start. The engine will turn over, but it is not engaging. It does not seem to be an electrical problem, since the engine is turning over. No warning or "check engine" lights have come on at this point.
View 3 Replies
Got our 2014 back in March and it still hangs in fourth gear after downshifting with the cruise on. Downshifting from 6th to 5th for small hills is fine but on steeper hills when it drops to 4th and hangs in there uncomfortably long.
What I've been doing is switching over to manual and bumping it up to 5th and then 6th. When I don't, it will hang in 4th and rev high and then eventually shift into 5th and 6th one right after the other long after the road has leveled out..
View 3 Replies
I posted earlier this month about my 1996 Ford F150 4x4 manual tranny truck. It had gotten stuck in fourth gear, and I, along with others, assumed it was the shift forks. I cracked open the top of the transmission yesterday, and what do I see? Melted plastic staring back at me. What's going on here? There was melted plastic jammed between fourth gear and the inner wall.
Is this a case of the surgeon leaving his instruments inside the patient? Could a mechanic have dropped his tuna sandwich wrapper in the transmission at some time?
View 8 Replies
i have a 1999 mazda troy lee b3000. The truck has a 3.0 flex fuel and 4r44e and when you go to drive it. turn the key engine fires up but the trans won't shift into gear. Here is the back story.Bought the truck brand new in 99 I'm the original owner it was a daily driver up until 2 years ago. the truck has over 300k miles and still ran great but the camshaft was starting to go. I was gona replace the cam but came across a killer deal on a new engine. picked up another 3.0 flex fuel with 50k miles. drove the truck into my garage removed the old engine installed the new engine. got in the truck turned the key and the new engine roared to life.
I went to put the truck into gear so i could get it out of the garage and go for a test drive and nothing. went to put it in drive and again nothing. no matter what gear its put in it doesn't move at this point i was confused and decided to quit for the night. That was in 2011 its now 2013 the truck has just sat there sense then. I've tried anything and everything even went as far as swapping transmissions and computers with no luck. I took the trans apart I don't know how many times can't find anything wrong with it.
View 4 Replies
It's a 4 cylinder 5 speed, and once or twice a day when the light turns green and I go to put it in low gear, it just doesn't want to go into gear easy. It's like the syncro isn't happy or something. The clutch is depressed all the way and not dragging.
View 14 Replies
I have a 1999 ford ranger 4x4 with automatic 5r55e and it had problems shifting smoothly into third gear. I changes the valve body gaskets and the (rooster comb) detent lever. Now it shifts very hard and has on first second and passing gear.
View 6 Replies
98 Ranger 4x4 4.0 L Supercab. Today I replaced my instrument cluster lights. When I put everything back together i noticed my gear shift indicator is off and I cant shift into 1st or 2nd. What did I screw up?
View 5 Replies
I have a 2001 Lincoln Town Car that has an intermittent vibration that can be felt when seating in the car and you move the gear shift lever to D for drive. The car has 141,000 miles. It is an automatic transmission. The vibration cannot be felt when touching the steering wheel. What could be causing the vibration?
View 3 Replies
2000 Ranger 4R44e transmission.Hard shift from 2-3 gear and when i run about 35-40 mph and brake then acelerate it downshifts hard . Whats wrong with it?
View 14 Replies
Recently my 93 Ranger 4.0 has started to take longer to shift into 2nd gear and the rpms are way up there. shortened 2nd gear then 3rd will be fine and so on. This only happens after the engine goes completely cold. I took it to a transmission shop and they said tranny is fine...Other than this issue the truck is fine.
View 6 Replies
