Explorer :: 96 - Factory Radio Speaker Wire Color Code
Jun 4, 2015
So my son cut the factory speaker wires on his Explorer. I bought a new radio for him prior to the "CUT" and the new radio comes with a simple wire harness (2 green, 2 purple, 2 white, 2 grey). The picture shows the factory wires attached to factory module. The "New" speaker wire harness identifies which wire is for what speaker but I need to know what factory speaker wire would attached to the new wires. Based on the picture, how to identify the speaker wires and determine which wire goes to which speaker?
View 1 Replies
Want to upgrade my factory non entune radio 57076 to the factory entune radio. what model number radio am I looking for and will I encounter any issues with data for fuel and tire pressure sensors.
View 3 Replies
I have a 73 f100, I want to paint it the color of a 2004-2015 the factory grey, this color or was there a darker grey
View 2 Replies
In my 1999 Jeep Cherokee, with a 4.0L inline 6, I need to find the color of the wiring harness wire from the pre-catalytic convertor oxygen sensor. I think it's the black with dark green strip, but I have found conflicting information on the internet and in my Haynes book.
View 4 Replies
I bought a DVD version of the shop manual several years back. Apparently they expire? Mine will start, but it won't open anything. It says it is expired, and to discard the disk.
Anyway, what color the (+) reverse light wire is under the dash?
View 2 Replies
What is the color wire for the running lights? Preferably inside and not at the headlight.
View 1 Replies
I am installing a backup camera and want to hook the power of the backup camera up to the reverse lights power wires.
Which color(s) the reverse light wires are in the trunk?
View 7 Replies
What is the domelight wire color and location in an 07 LS460?
View 5 Replies
What is the color wire coming out of the fuse box for the Trailer Tow Battery Charge? It's number 115 in the fuse box and a 20amp FMX fuse I believe. It's a 2005 6.0l 2WD Eddie Bower Excursion...
View 14 Replies
I have a 99 f150 XL 4.6, 5 speed. I spent some time tracing the leads around the ignition system to find the EDIS module. The purpose of this is to install a aftermarket tach coming off the EDIS. This seems to be a simple approach and I have a pin diagram handy for it. I am initially shying away from tapping into the EEC. Maybe better yet, what wire color to splice behind the gauge cluster that would be useful too.
View 1 Replies
I'm not fully satisfied with the quality of sound - especially from rear speakers. The sound from rear is much inferior to the sound from front speakers. I'm NOT looking at replacing the factory stereo.
View 3 Replies
I've searched all over and can't seem to find the answer. When I pull the tail light out of my 12 F150 there is a blue/wht wire and a black wire going to the back up light. I assume the blue wire is the positive and black is the ground. Is that correct?
View 8 Replies
I need to know what the wire colors are for a engine temperature sensor connector (2-wire) are and the correct wiring diagram to get the temperature gauge to work again
View 1 Replies
When I pull the tail light out of my 12 F150 there is a blue/wht wire and a black wire going to the back up light. I assume the blue wire is the positive and black is the ground. Is that correct? I also posted this in the wiring section.
View 6 Replies
On a 2008 E250, Where is the dome light wire and what color is it? To use with an omega security system.
View 4 Replies
Installing a back up camera and need to locate reverse lights on driver's side at rear bumper. What color wire is for the reverse lights on a 2003 F-350 (truck in my sig)?
View 4 Replies
The right side seems plugged up with glove box components.
View 1 Replies
2013 Corolla L
Stock head unit non-touchscreen
Kenwood KAC 9105D Mono Amp 900w @ 2 ohms OR 500w @ 4ohms
Two 10" Kicker Solo Barics (old school round ; will be swapping soon)
They are Single Voice Coil 4 ohm (wired at a 2ohm load)
I wired the red hot wire (4 gauge) from the battery to the trunk. The ground wire is on the shock nut (4 gauge). The amp has power. The speakers are wired to a 2 ohm load. Now how do I get signal to the amp? This is my first car with a stock head unit. My amp has speaker level inputs and an auto detect feature so it turns on whenever signal comes through. So can I splice into a rear speaker and run the wire straight to the amp correct or would it be better to get a line converter and run RCA cables?
View 14 Replies
Question to those that have the car - is it possible to change the display colour of the radio? Can it be done via MFD?from the "white/silver" "buttons" to darker "buttons"?
View 6 Replies
At least once a week, only the FM band appear on my factory nav. My sat 1, sat 2, and fm2, and am1 band all dissapear. I have to turn the car off and back on to get everything to work again.
The cars currently in the dealer for an other issue and they are looking into this one also. Seems not much is going to happen as it's unduplicabale. I even showed them the videos I have take of it happening. Call VWOA and they said they will look into it.
I had the sirius module replace once, new firmware twice, and in the dealer another time and they couldn't replicate the issue.
View 9 Replies