My truck has grinding noises when i am making turns from a stop or at slow speeds. Also my 4x4 dash light keeps flashing several times both when I am sitting still and when driving. Neither my 4x4 auto or 4x4 high work but the low will work. Trying to pinpoint where I should look to fix them. I did replace the 4x4 control mod as an attempt to fix this.
View 1 RepliesI recently had my manual transmission go out on my 2002 Elantra GLS. It has 208k miles and the tranny had been giving me shifting issues for years. It finally made some clunking and whining noises at certain speeds. I picked up a replacement tranny, but the car has sat in my garage for the last two months. I slowly worked on it over that time and have finally completed it. I went to start it up tonight and it idles normally for 1 second, then it revs up to about 5k. It does this over and over until I turn the car off, and a very hard to see white-ish smoke comes from the air intake tube as I have it only partially on for testing.
The car ran fine before hand. What could this be? I have never experienced this with a vehicle before and searching on the web only gives me links to people having idling and revving issues while at stop lights or on the freeway. The idle did used to stick around 2.5k RPM when I started it up from time to time. Although, a small blip of the throttle would set it back to its normal idle speeds. BTW, the engine runs well with no knocks and has great compression across all 4 cylinders.
My wife informed me about a noise coming from the chassis of her truck.
2007 Explorer XLT 4x4, 4.0 OHV, AT, 89,000 miles on the odometer.
We took the truck to dinner last night so I could investigate the problem. This occurs while only making left hand turns at slow speed.
There is a definite clunk sound AND feel. It actually sounds and feels like we are driving over a loose manhole cover, and IT DOES feel like metal to metal contact on the driverʻs sids of the truck.
Every once in a while, while driving my 06 350 SRW at slow speeds, I hear a grinding noise coming from the left side of the truck. It is almost like a winding grinding noise if that makes sense. It will grind slow to a stop, and then I hear a clunk.
This is a very intermittent problem. The tires are completely shot on the truck, and I thought that would be it, but considering it is intermittent and the clunk I hear as I come to a stop I figured it could be it.
I have a 2006 Subaru Forester with 115K miles. It's been well-maintained and well-loved.
For the past few months, the brakes have been inconsistently making a dragging/grinding noise when coming to a stop at low speeds (<5mph). It sounds to be coming from the front half of the car - I can feel it vibrating a little near the driver side. We've taken the car in to be looked at three times - each time, the mechanics think they've heard the noise and report there is absolutely nothing wrong with the brake pads or rotors. Twice they reported a shim was out of alignment. After the last shim adjustment, the noise got a little better - instead of grinding, it's more of a dragging sound now. Because the noise is inconsistent, I haven't been able to crack the formula of the conditions that produce it, other than that it only happens as I'm coming to a stop at very low speeds.
Is there something besides the brakes we should be having inspected? Does this sound safe to drive?
It is a 2002 Explorer xlt 4x4 4.6l v8 with 139k miles. It runs like a top and is in great condition. However I have a few questions:
Most importantly is it feels and sounds like the rear-end is slightly grinding at low speeds mainly when I turn right. If I give it a bit of gas when turning it doesn't seem to do it. I have tried running a vin decoder to figure out if I have limited slip or not so I can drain the rear diff and inspect it, but I haven't found what it has as far as gears go.
Number two. The keyless entry and remote worked when I bought the car and then about two days later it just stopped working. I bought a new battery for the remote and put it in and it still doesn't work.
Also the interior lights will stay on after you start the car until I hit about 15mph, and also stay on for about 5min after I shut the car off. I am not sure what may cause this. I have owned tons of older ford's but am relatively new to anything newer than 2000.
And I know pics or it didn't happen, so there is one of the door sticker, one of the rear axle, and one of the car ...
Grinding feeling, and noise from rear of 02 explorer xlt. only noticed when starting out from a full stop and turning. It feels like something is grabbing like the rear brakes. I purchased this suv of a local dealer lot, because it was so clean and on a short test run seamed fine.
The day after I picked it up I took it for a shakedown cruise to see if I noticed any problems. After going up a few forward grades I noticed a disturbing rattling noise coming from mid under carriage, and got very worried. I immediately took it to a local well revered mechanic. They eventually had it for 4 days in order to diagnose it. After the dealer had done the inspection on the car and passed it, that all rotors and pads needed to be replaced, left front wheel was locked up, inspection sticker month was never punched, both front tires were bad and either the flex plate or tork converter or both needed to be replaced. I took it back to the dealer with the report and he agreed to fix it with me paying for parts. He did and the rattle was gone !
Yet now I have noticed the problem mentioned at the beginning of this piece, plus the rear wiper does not work. I think I got taken for a ride, which may become a longer ride than I thought. All I want is a reliable car. what could that rear noise be ???
I've noticed my Gear box in the truck seems to be leaking and been getting some noises when making turns too that i can feel in the steering wheel more than hearing it. (not like air in the system or over steering things like that).. feels more like a grinding feeling.. anyways.. ive had a couple people recommend Redhead gear boxes.. but hadn't ever heard of them till they told me about it.
So was wondering what you all think about the company and for the ones that have gotten them any major issues?? Biggest thing I keep seeing on non-factory gear boxes are mentions of sloppy steering.. they can't be adjusted.. quick failures.. etc. etc... Worried I'd be wasting money getting something not-stock than if I'd had just bought it right from ford...
Mazda5; 2010; 105,000 miles.
Recently, our Mazda has started making a subdued grinding sound. It happens only when accelerating from idling to 10 miles per hour. It does not occur over 10 mph, in neutral, or park. It doesn't happen when starting the car or in reverse either. according to my wife, it does happens when turning right at slow speeds, but not left.
We have just driven it to our mechanic but it may take a couple days before they are able to look at it.
1990 Ranger 5 speed... The tranny has recently started making noises, first I thought it was the throw out bearing but I am afraid it is more than that. As I go thru the gears the trans makes rattling/grinding sounds: in 1st, 2nd, 3rd and 5th it is loud but 4th it is quiet. What might be going on inside the tranny....
View 14 RepliesHave a 2012 Camry 4cyl. LE, auto trans. This is especially noticeable when making right turns on city streets, and occasionally on left turns. When trying to accelerate back up to speed, it takes a second or two to begin to speed up, sometimes shifting down and then accelerating. What possible causes for this strange phenomenon? Just after buying it (used, very low mileage, 4000miles). I took it to the dealer, they said that that is normal.
View 3 RepliesI have a 2000 VW Passat V6. Last night when I got home I noticed that the fan wouldn't stop and it was making a different noise than usually (ocasionally when I get home the fan keeps running for several minutes which seems to be normal, but yesterday the noise that was coming from the fan was different). Today the battery was completely dead.
I've been reading different forums, and it looks like it can be either a problem with one of the fans, or fan relay. How can I diagnose the problem?
Went on a 400 mile trip today and noticed some strange noises. The rig is an 06 F250 lariat, V10, Zf6, SC, LB and only has 43k miles. It behaves normally except when coasting down a hill at 65+ mph, and it doesn't matter if I'm in neutral or overdrive, it makes a feint grinding sound that gets louder as speed increases. Maybe grinding isn't the best word to describe it, I'd say a cross between humming and light grinding. As soon as I give it any throttle or put any load on the tranny is goes away. It's really freaking me out as I just got the truck a month ago and I know the ZF6's are almost bulletproof.
View 14 Replies2004 Ford Explorer Sports Trac.
Just recently when driving down any road, when I let go of the gas to slow down from any speed, there is a funny grinding noise coming from under the truck, the Speedo drops fast, but the RPM`s stays the same. Then at around 30-40 km/hr, it just stops. When I place it into 4x4, I don`t have the problem. Also, again just recently, when I put the truck into reverse, I get the same grinding noise from under the truck. I have to putt he truck into 4x4, and then I put it in reverse for it to work.
I don`t have the problem going into drive. Both problems don't happen all the time, it will go away for 2-3 days then ill have problems for a few days after. I Took the truck to the shop and they said its the tranny so I replaced with a brand new one thinking that is the problem, but After the Tranny was replaced its still making all the same noises. The grinding noise sounds like "ice in a grinder" or to that effect. I'm not sure whats wrong, and I'm getting frustrated at my truck.
There is a grinding noise when i make a turn,when i straighten out it's fine,when i bought the truck in 09 i had a shudder problem but that was repaired by greasing the spline in the drive shaft. Truck has 59,000 and is coming up on the 60,000....
View 1 RepliesI have a 2002 Subaru legacy wagon, 185k miles, 5 speed manual, thumping noise when making sharp turns at slow speed, happens only after I drive over about 10 miles, does not happen after the car sits for any length of time.
View 5 RepliesI've noticed that when I take right or left turns at slow speeds I hear a series of clunks. Sounds like a pipe rolling in the bed. Guessing it has something to do with the rear springs??
View 2 RepliesThe steering on my wife's 2010 Tiguan makes a bit of a grinding/rubbing noise at low speeds? Something isn't right, it sounds the same way my X5 did when the Rack needed to be replaced. It would be strange to have 2 cars needing new racks within the same year....especially since they are both 2010 model.
View 9 RepliesI have a weird problem. Sometimes when i slow down to make a turn or stop at a stop sign my car just dies...that's it...it just turns off...but i turn the key and it starts right back up...the weird part is that i've had the car for a year and it only does it about once a month??? I took it to the dealer and...big surprise...they said they couldn't find anything wrong with it...it doesn't turn off while I'm driving on the highway or anything...only does it when i slow down to make a sharp turn or when i stop at a stop sign and go again... I might just trade it in for an Audi A4. I have a 2001 Jetta 1.8t...
View 24 RepliesI recently noticed my truck (2006 f250 v8) making some clicking noises on really sharp turns and also horrible grinding when stopping (like the brake pads were shot).
I replaced the pads a couple years ago, so I didn't then they were bad, but I took a look tonight. What I found was a couple of seals blown on both sides!
What these are and how this might have happened? They look the same on both sides. How do I replace them?
I have a 2003 Ford F150 with a 5.4V8 Triton 4X4. The truck is about to roll over 200K here soon. I am feeling/hearing a vibration/grinding sound coming from the truck when I am moving slowly and making turns, either left or right turns. Seems to happen more so on left hand turns. I have changed all power train fluids and filter, and still does it. I do not feel or notice the vibration/grinding when I am going straight or at highway speeds. It is only when I am moving from a stop and making turns. How to diagnose, find out, repair, fix this issue?
View 4 Replies