Explorer :: 2000 Ford Trans Slip Around 3rd Going To 4th Gear
Feb 27, 2011
I got a 2000 ford explorer with 151k on it... Since iv had the truck (5yrs) its always had a slight slip around 3rd going to 4th. The tran is auto!!
I use to be able to jump in and take off but here lately i have to let the truck idl for a few sec or up to a min before i can take off (warm or cold). This just started a month ago...
The trans fluid smells burned and it has be 2yrs since iv changed fluid and filter in the tran...Everything other then that iv kept up to par. What do you think should i start looking for something new or just change filter and fluid????
I know the truck has had a good life so I am starting to think the tran maybe trying to go.... My friend has a 85 dodge ram charger suv not sure the miles but its auto as well....It has a 318. Other then a small dent the thing look good... It has some kinda vacuum leak major but doesn't effect running. He told me the leak is from something he had removed when we left CA that they said he had to have for smog?
View 3 Replies
Advertisement
He has a 2002 Explorer 4.6. The truck is having a hard time going into reverse intermittently, hard shift in normal driving and thinks it has slipped in first gear going up his driveway that is steep. He is worried that he put slightly over sized tires and this may hurt his tranny. The overdrive has blinked twice with in the year. Possible problems that could create this he is thinking solenoid pack, servos, torque converter. The truck has 110k and never done fluids, Would lucas slip fix or hurt we have heard that these tranny's are finicy.
View 1 Replies
I own a 2002 W8 passat b5.5 that had issues from the used car dealer i had bought it from. I had 2 new motors installed over the period of about 13 months . The first motor had a bad torque converter and seemed to also cause my trans to slip. I am not sure if that is the direct cause of the trans slip going from 2nd to 3rd gear. The second motor dropped 4 valves in the cylinder "3" and cracked the starter. I had all the work done by the VW dealer that i used to work at.
As of today i seem to hear a knocking from idle to 5,000rpms, which is the highest ill push it. Now I know that a lot of of the W8 had issues with the torque converters. my current engine has just about 4k miles on it and I know vw warranties this motor up to 12k miles. That is not my concern, my concern is why do these motors keep failing under normal every day use in my particular vehicle?
View 2 Replies
Have a 2009, 2500HD 4X4 23K miles that has an occaisional/intermittant trans slip when shifting from 2nd to 3rd (I think). It always seems to catch me by surprise so it may be 2-3 or 3rd to 4th. Shift point seems to be around 1800rpm, engine revs to about 2500 during the slip. It's always shortly after starting up and the trans is not necessarily up to full operating temp. I've noticed it happening in the dead of summer as well as the dead of winter.
View 14 Replies
My wifes 04 explorer 4.0 4x4 slips in between second and third gear and you cannot manually shift the gearshift below 3rd gear. I assumed tranny was going out but was told that it could be the transmission control solenoid or the transmission control switch (i think they are the same thing). I read that the most common symptom of this going bad is a slip between second and third gear. Haven't checked codes but will when i get home to see what it comes up with. This is the messed up model where you have to add fluid underneath through the drain plug. Was going to change fluid and add lucas to it to see if it remedies the problem.
View 1 Replies
2003 Ford Exploreer 4x4 5R55W Auto Tranny. From driving the car it does not shift into 2nd or 5th gear. The O/D light flashes, and the check engine light comes on. Gives Code P0775, which indicates a problem with Solenoid 2.
This weekend I changed the Shift Solenoid Pack with a brand new one from Ford, and the exact same problems still exist. It's as if I hadn't done anything to the car. I have read somewhere that 2nd and 5th gears share a band in the tranny, could the the problem.?
View 14 Replies
It's a 2002 explorer, 4.0, 5R55W trans, all was fine then O/D light starts flashing, so I limp it home. Trans isn't slipping, every gear works, it does kinda bang into 4th but is otherwise normal. Took it to auto zone to have the code read, but no codes found. Disconnected battery to see if it just needed a reset maybe, let it sit for a few hours, reconnect, OD light still flashes. Borrow a different OBD2 tester, still shows no codes, still drives the same just bangs into 4th. I've read up on the solenoid pack replacement, just kind hesitant as I feel like I'm guessing at the problem and might be throwing money away.
View 2 Replies
I recently bought a 2002 Accent with the 1.6 auto 133000 miles. I have been reading the postS around here about the crappy transmission. My car seems to have some life in the tranny still but it has slipped from 3rd to 4th gear around 45 mph when i get on the gas too hard. Its also a little sluggish to start off. My question is should i change the fluid out knowing i have a slipping issue? The reason i ask is that last time i changed the fluid and filter on a Jeep that was slipping i ended up having to rebuid it. Is that a real possibility if i change the fluid in this Hyundai?
View 3 Replies
My parents 2000 Explorer is having issues...It started with check engine light...came back to Oxygen sensors...Replaced all 4....light came back...still a couple of same codes...P1151 and P0153...smoked the intake with Evap Leak Detector...have several small vacuum leaks...little at EGR (No EGR codes)...little at TPS (No TPS Codes)...Little at throttle shafts...and some coming from what looks like underneath throttle body....none of these are as much of a concern as the next thing....NOW the trans will not shift out of 1st...unless you manually shift it from Drive to 2nd...then no other gears...Reverse works fine.....
View 13 Replies
I recently purchased a f150 with a reg cab short bed 4.6 4x4, and when you put it in drive the it shifts up to second fine, but when goes to third just revs up doesnt pull at all. Have to shut o.d. off and goes steady but run 2500 rpms to go 40 mph. I was told to check the solenoids but i dont know, if i do need a new trans how do i identify my trans. I know it has the code "U" on the door sticker, but its an 4r70 w code-w. But the junk yard has a YL3P-FA and a YL3P-JA?
View 1 Replies
Question about my dads 2000 explorer with the 4.0, he just noticed it was leaking oil heavily. Added 2quarts and drove it home. I looked under it and the oil is dripping very steadily from what appears to be the inspection plate area where engine meets trans. Have y'all ever seen a rear main seal fall out or cause a leak this heavy? I know we will have to clean it and re check but this is all I have seen at this point. Is there any other seal or issue that could cause this from inside the bell housing area or nearby?
View 2 Replies
I bought it for cheap. not shure what tranny is in it. So when you you put it in od it will take off and shift fine all the way to od. getting going and drive it a few miles and it will slip out of od into to neutral. I can put it in drive and it does fine. I did lose all forward gears earlier tonight though. First time it did this. OD is the only gear it slips out of. it willl re engage below 40 mph. But I usually just shift to drive and go on.
View 12 Replies
My car has started to do something odd. Whenever I am in 3rd gear, at about 2000-2200 rpm, the engine will revup 100 rpm or so and then back down (only for a split second). This only happens on 3rd gear and only at about 2000 rpm. Its a 2005 Hyundai Accent Hatchback with an automatic transmission with Royal Purple ATF. I also have a SRI and manga-flow muffler (if that makes any difference).
View 1 Replies
I just got a 2000 accent. The problems is that sometimes when I shift into 2nd and 3rd is notches sometimes. But it does not do it when i shift down. Also if I shift fast it will occur less often as when I shift low. When my friend drove the car it didnt do it for him. So maybe it is how i drive or something. I make sure the clutch is down all the way.
View 7 Replies
I've got a 2003 Accent and my automatic transmission went out, no reverse and the only forward gear is 1st. Was thinking of pulling it and swapping it for a used, but I have been reading on here the many, many automatic transmission problems of the accent and my next thought was to just rebuild it myself. But now I'm thinking more along the of a swap from auto to manual, as I don't want to have to rebuild a transmission that is only going to have to be rebuilt again anyway. As far as stuff like the clutch pedal, linkages, gear shifter, I can get those pretty easily. Does the Accent have a hydraulic clutch?
View 2 Replies
It does not like to stay in 5th gear, drops out to neutral. 2001 Accent Hatchback. 1.5l 5-speed
The other day it started slipping out of 5th gear on the expressway. Held good for the first 10 to 20 minutes. Afterwards I had to hold it in 5th for it to stay in gear. While holding I noticed it pushed on the shifter when applying throttle, and let up some when I let of the gas.
I inspected the pivots at the transmission. The forward / back bushing was not installed properly by the previous owner. I rigged it up better with a fender washer and cotterpin. It previously had just a pin and the bushing had expanded out. This removed the play from shifting I had previously noticed. It also halfway fixed the popping out of gear. It stays in gear a little longer, and when I put it back into 5th it stays there for a while most of the time.
I have not inspected the lubricant level yet. Where to check next?
View 10 Replies
I have a 2000 Explorer with the 4.0 OHV. 104,000 miles. Has always ran great. The last few days it has had a sputtering almost knocking sound that gets worse when put into gear or the ac turned on. I changed the oil and checked all fluids. Looks good. Only thing I had done was fill it up this past monday after a storm. My mother in law told me afterwards that the particular station always has complaints after rain and has leaks in their tanks. I'm assuming I may have gotten water into the system. Would this cause these problems? And is it ok to drive it out or should it be flushed. I've added a can of Iso Heat and am now down to 1/4 tank. I had planned on getting a little lower on fuel and filling up with Premium. I've never had a problem like this before so not really sure the best way to track the problem or fix it. Or it may be something else all together.
View 3 Replies
I have a 13' GT with an automatic trans and 15,000 miles.
While getting onto the highway yesterday I was in D (not + -) and I was probably in 4th gear and hit the gas pedal maybe 60-70% down and my rpms shot straight to 6-7k but I didn't get any acceleration. I let the rpms drop and it drove fine after. Pretty sure I was smelling burnt clutch too (kind of unfamiliar with that scent, I've never slipped a clutch before).
I should probably take it to the dealer for them to look at it, but am worried it will be a 1-2 week thing and I'm not sure if I'd get a loaner.
View 2 Replies
2011 SE leased in December 2010. I Now have 14,000 miles and my trans has started to slip.
First slip was yesterday on a a fully warmed motor while I was accelerating at a normal rate of speed. I am guessing the car was in 2nd gear (25mph) and the rpms shot all the way up to redline. I let off the gas, coasted for a few seconds and the trans engaged the gear and I kept driving. No cel
Today the same thing happened under the same conditions but this time when the trans re-engaged the gear, the car jerked forward pretty violently.
About 15 minutes later this happened again but at highway speeds (65mph) while cruising. Again, violent jerk and a thump when the trans caught the gear.
After all this I have no CEL. I know if I bring the truck to the dealer they are going to give me the old, "we cant reproduce the problem." Once the trans starts to slip like this the damage has already been done and its just a matter of time before I am stranded on the the side of the road.
View 9 Replies
My 3rd gear is starting to slip, Is there a chance that it might be a small fix ? if so how or what can I do? 2003 F150 4x4 Automatic ...
View 1 Replies
Ok so I was going to just swap the whole rear end from drum to disk but it looked to be too much difficult;t. So the rear I have has 278,000 miles in it and its starting to make noise we were thinking about swapping the gear from the disk to the drum because the disk rear has 140,000 miles on it. Both have a limited slip. And 3.55 gears but i was thinking about getting 3.73.... So my question is can I swap in 3.73 gears into a rear end with the limited slip from one with 3.55 gears? Or do I need to buy a different limited slip?
View 7 Replies
