Expedition :: 2007 - No Brake Lights Or Rear Turn Signals
May 29, 2010
I recently bought a 07 Expedition with light left front damage. After the repair I noticed that I'm not getting any power to the rear turn/brake, and backup lamps.The tail lamps and third break light work as does the trailer plug. I know that they were working prior to repairing the front. I did disconnect an aftermarket alarm during the repair. Basically all I replace was L/F sheet metal. Of cause I checked the obvious things like fuses and current to the tail light sockets.
View 6 Replies
Advertisement
I've got a 98 Silverado. Break lights and rear turn signals won't work but tail lights and reverse lights work. Also the brake light on the cab does work.
View 6 Replies
I have a 2006 F150 xlt 5.4 3v. I've owned it since Oct. 15'. In approximately Nov. I lost the rear right brake and blinker light, and then around Christmas I lost the rear left brake and blinker. I also have no rear hazards, but the inst cluster flashes at a normal rate when the flashers are engaged. All running lights work, and 3rd brake light works. Front blinkers work and all other electrical works. Have checked all fuses and bulbs with no solution.
View 6 Replies
A friend of mine has a 2004 F150. The tail lights and the 3rd brake light are working but the rear brake lights, flasher and turn signals have stopped working. What could be wrong? I googled the problem and did find one person with the same issue in a 2001 F150. There apparently was a recall (#05S28) of the SCDS (Speed Control Deactivation Switch) but that vehicle kept blowing fuse 13. My friend checked his fuses and they were all ok,
View 14 Replies
Dad borrowed truck and wired 7 pin trailer harness. Lights worked on truck/trailer for use but upon return the turn signals didnt work. Hazards and running and brake lights did work. Replaced TS flasher and Haz flasher. Still no signals. Pulled steering wheel and replaced turn signal cam only, not whole switch. Now no brake lights, no rear hazards or turn signals. Losing my marbles trying to follow schematic and using test light and mulit meter. All bulbs and fuses are good. Running lights and head lights working as well.
View 6 Replies
I just bought an 05 F250 XLT. I noticed tonight that the rear turn signals and brake lights don't work.
The front turn signals work fine, although they flash fast. I know that usually means a light on its way out. neither taillight flashes though, which puzzles me.
My second issue is that, of the 3 brake lights, only the high mounted light illuminates when I hit the brakes.
View 1 Replies
My sons 2006 F350 brake lights and rear turn signals quit working. When the headlights are on, all the lights operate but the rear turn signals and brake lights do not nor do the emergency flashers. The front signals work but flash very rapidly. Although I'm not an auto electrician, I'm fairly mechanically inclined but the fact that the front signals work, the rear don't and all lights work as lights, just not as turn signals or brake lights.
View 4 Replies
I have a 1995 Ford f250 Powerstroke and i do not have turn signals, rear running lights, brake lights or reverse lights. i checked the fuses and they seem to be good but i dont want to tear everything out to check the harness if it could be a bad ground. any insight?
View 1 Replies
I found out last night that all 3 of my brake lights are out. However, my tail lights work, and my turn-signals work. So obviously its not a big wiring deal. I was looking for the brake switch but i don't know where its at because i looked underneath. What fuse is the brake lights cause my manual doesn't have it listed. I drive a 04 Elantra GLS.
View 6 Replies
2010 F-250 14,000 miles, gas engine with Knapheide utility bed. Tilt wheel has been kept in the up position from day 1.
The problem:
No rear brake lights.
No high mount brake light.
No rear turn signals.
No rear hazard flashing lights.
All trailer lights work.
All other truck lights work.
Things checked: Fuses all OK. Visual inspection of multi-function switch. Looks clean. Brake switch at brake pedal has power on one wire. Jumpered the other wire-no brake lights.
I need to haul my trailer and am nervous when I see a Savannah, GA metro police car.
View 8 Replies
I have a 2007 F150 that it's brake lights and turn signals have gone out. What's wrong? I've checked fuses and connections.
View 1 Replies
So I lent my santa fe to a buddy to do some hauling, I got it back yesterday and the turn signals and the brake lights don't work...notta. Regular running lights are working without issue, but no turn signals, no hazards, no brakes. Even the "tick, tick, tick" of the turn signal is gone, it's just dead.
View 1 Replies
I was using a 2004 Heritage F150 and when I connected a trailer to it something got fried. I lost both my turn signals and brake lights. The trailer worked fine on my friends truck so I don't think the issue was there but with the 4-pin round connector that was on the truck.
I found two 10A fuses blown under the hood and replaced them but that didn't work. They were in slots 19 and 20 and are listed as the camper/trailer adapter fuses. The running lights still work. The interior turn signal arrows don't even light up or anything when the turn signal is activated.
View 2 Replies
This has been driving nuts for 2 days.... Brake lights dont work. Either pushing pedal or turning on lights. Turn signals work just fine.
Cab/cargo/3rd brake light on back of cab doesn't work either. I have checked/done the following:
- Checked Brake pedal switch for continuity. Tested fine.
- put multi meter on wiring all the way back to brake lights. No drop in voltage.
- changed bulbs. #3157 dual filament.
- positioned steering wheel all the way up and all the way down as suggested on here. No change.
- checked multi function switch (turn signal switch) for wiring issues. None found.
- kicked rear quarter panel for caveman adjustment out of frustration. No change.
What am I missing?
View 9 Replies
Well, on our way home during my leave, the wife made the comment about halfway home that the blinkers had quit working. I assumed it was probably a fuse or relay, so we came on home. I have been looking at it for a few days now (too hot to spend too much time out crawling around under the dash ) and I am still having some trouble. My brake lights, and hazards are not working, and neither is the cruise, which was working fine while I drove before the blinkers went out.
I have no power at all to the flasher relay. I replaced the brake light switch because it was definitely worn and looked a little burned inside when I pulled it out and inspected, but still nothing. Have not found any fuses blown. Brake pressure switch fused link harness seems good with my test light. Wipers, brights, everything else on the turn signal switch works fine. Can't even get the cruise to go into diagnostic mode, it only blinks once when I try.
View 5 Replies
All of this happened at the same time so has to be related. The a/c system has no power, the brake lights and turn signals don't work, windows wont work, air bag light on. However, the park lights, head lights and hazards work fine. Starts and runs fine. All fuses check out ok. New battery as well.
View 3 Replies
I was turning left in my 01 Excursion and I think I hit the turn signal while doing so and tripped something. Now I have no turn signals and no brake lights. Headlights and tail lights work fine. I checked a couple of fuses under the hood that I believe are for turn signals, according to my manual they are fuses #20 and 22. They aren't getting any power, but the fuses themselves are fine. Is there another fuse somewhere to check? Or something else entirely?
View 12 Replies
I have a f 550 that blew out starter cyl on inner fender.and starter, replaced both. Now I have no brake lights or 4 ways and no turn signals....
View 4 Replies
My '99 F150 is having wiring issues. It started with a left flasher being fast and the rear bulb not working. I put in new bulb and that didn't fix it. Then I realized that I also had no tail lights. The reverse lights are good and the brake lights work too.
So far I have searched for and repaired suspicious splices done by PO, added a ground wire that was cut off from the trailer wiring harness, checked every fuse that I could with an ohmmeter and I pulled the multi function switch and tested it with an ohmmeter also. It tested fine but I did find one of the female pin connectors had pulled out of the harness. I managed to get it back in and seemed to click into place alright. Somewhere over the course of all that I now have both sides of my flashers fast and still no tail lights. Good news is that I haven't broken my brake lights or reverse lights yet.
Could I have a bad flasher relay? Earlier in the process I did have my 4 way flashers working correctly and a couple times I even had the turn signals going. Now, none of the rear blinking lights work but the front ones go 90 to nothing and I still have no tail lights. My truck does have the auto lamp thing.
View 10 Replies
My brake lights, turn signals, and flasher are not working in my truck. Is it a fuse and what fuse? Could it be a relay?
View 2 Replies
I have checked all fuses, checked wires on top of steering column all checked out ok. Hazards work but when I press brake tail lights just blink with no brake light but the 3rd brake light works??? Signal switch maybe??
View 14 Replies
