Expedition :: 2005 - Rear Passenger Axle Noise Down To The Right Side Of Half Shaft
Apr 11, 2014
My wife has been complaining about a noise from her 2005 expo.
As she drove the truck today I have narrowed the noise down to the right side of the half shaft. From looking underneath and comparing what I was seeing and hearing, the track bar is not centered. Its more in on the driver side and out on the passenger side. I had her to stand on the running board and shake the truck.
I can definitely hear a kinda cluck? It sounds like the half shaft going to the tire but at the same time the bushing on the outer tire rod end. I can't determine what it is exactly.
when you rock the truck you can definitely hear it. Its not like violent loud but i'd like to get it taken care of. I looked for some grease points but I don't see none..
2nd question for the grease points that I do see how much do I grease it? how many strokes?
View 2 Replies
Advertisement
I thought that my front wheel bearing was bad but I removed it and it seems fine. The issue that I'm having is a continous vibration (noise) in the left front that gets worse with speed.The half shaft makes a noise at the point where the half shaft meets the steering knuckle and when I turn the shaft at the outer splines, the grinding noise is present. My question is, is the entire half shaft supposed to turn, even the outer diameter of it that would enter the steering knuckle, or is the shaft supposed to turn inside of that outer diameter? I hope I was able to explain my problem clearly/
View 6 Replies
2005 4wd excursion. I have a leaking rear seal on passenger side.
I have the hub assembly off. I'm down to the spindle. My old seal came out in pieces. There's either a piece of the old seal or another seal on the back of the spindle.
Are there two seals? This what looks like a seal still on the spindle against the plate on the back...
View 1 Replies
I was doing some work on my R today and noticed something. On the passenger side front half shaft, at the transmission side, there is a bolt that has worked itself lose that is rubbing against it. I cannot get a bit into the bolt to tighten it back up as is since it is pressed against the shaft.
View 7 Replies
I have recently replaced the clutch, clutch master cylinder, clutch slave cylinder, Strut tower mounts and brakes on my 2002 Hyundai Elantra 5 speed. Everything is working properly but now I have a transmission fluid leak. I can not locate the exact location. It appears that it is dripping down onto the passenger side half axle where it connects at the transmission.
View 2 Replies
I have a mkvi gti with all stock suspension except rear sway bar. And I'm right about to order driver gear springs. But have a question about suspension. My rear driver side of the car sits about half inch lower then then rear passenger side on a flat ground. Would this be caused by springs? Or struts? Or what. Planning on ordering the driver gear springs but what the real problem is. I want the driver gear so I'm a bit lowered but not crazy low since the roads in my home town are awful and my street I have to do figure 8's all the way down it to not hit a pot hole.
View 3 Replies
I currently have the rear axle shafts off the truck. I took off, cleaned then put on the rear diff cover.
I live in an area that does nothing but form rust anywhere and everywhere in very little time.
I don't want rust forming in the rear diff gears - can I fill the rear diff up ? Or will it leak out of the rear shaft holes ? Can I fill it up halfway then ?
View 2 Replies
I have a 2012 f150 supercrew with the eco boost. While driving down the highway my rear tire passed me. After crashing I looked at the rear end and the wheel and hub had broken off of axle. Scared the crap out of me. Would this be a warranty issue?
View 14 Replies
Here's my problem while replacing brake pads i found that my axle has leaked fluid on the pss,side rear rotor and all over .. I been looking for any info on repairing it myself . I found Everything for every other truck just not for this truck.
It's 2003 F-250 w/5.4L all Stock rear axle has 12 bolts and gears are 7.73 ... I believe its a Dana 60. No tags or markings on the Axle to go by..
I live in the Freak-en woods here so i like to order all the right parts once and do over the weekend .. its my only ride so once apart im stuck here.... I did check the Vent Tube its fine..
View 14 Replies
I have noticed a few drips coming from the rear axle input shaft where the drive shaft connects. It has only done it once and there is no residue on the trailer hitch so I know it didn't dump everything on the road. If change this seal, how difficult is it and do you have any information which might make it easier.
View 14 Replies
Today I took the bed off of my 99 ranger. I was sitting on the cab looking down at the rear axle noticed the drive shaft was not entering the rear diff perfectly straight. As I looked further into it, I noticed the distance between the rear spring on the passenger side tire, is noticeably different. To visualize it, the wheel, at the bumper side of the axle, has a shorter distance between it and the leafs than the cab side. Not massive, but a few inches, and it's noticeable now that I can stand over it. I'm beginning to be very annoyed by this truck and it's previous owners, whom I take it , scammed my brother quite well with a $5k tag for a truck with so much not right with it. It's about to become my yard art for awhile.
View 8 Replies
I have a 73 F100 with a 9" rear end. I need to replace the drivers side axle shaft as the bearing retainer is starting to slide off and I'm not willing to take a chance a new bearing and retainer will do it again. They are 31 spline axles and have the ball bearings not the tapered rollers.
What year trucks can I find a replacement axle shaft? Any other thing I should be aware of in finding a replacement?
View 1 Replies
There's a click in my wife's expedition coming from around passenger side 3rd row when the AC is on. When we turn the temp down a little bit the clicking goes away. What this is?
View 3 Replies
I have a E99 F350 7.3L 4x4 I know some or most of you have already probably replaced this part and or pulled a front axle shaft out. So here is my question...In the pictures provided you can see what I think everyone is calling a "Dust Seal" and as you can see it is bad and making a very terrible noise when i hit a bump...I was wondering what parts I would need to replace this seal? I tried looking it up and just get lost in all of the other things....I have found write-ups for the axle being removed while changing ball joints but none by it self to just replace this seal.
[URL] ....
View 14 Replies
I have a 2005 V8 Phateon. The molding on the driver side and rear passenger side door molding is coming off. Any clips you have to buy or can you just slide it off and put it back? Don't want to break anything trying to take the molding off.
View 2 Replies
Noticed fluid under the car two days after my dyno run but assumed it was from excess GumOut. I ran 3 tanks of fuel and the car is dripping fluid so the GumOut is not the problem. Closer investigation lead to fluid build up around the drive shaft on my passenger side. The driver side fits flush with the transmission housing but the passenger side has a gap.
Is the gap normal? It looks strange, kinda like the shaft is sliding out from the transmission. Again, the left sits flush. There is a small rubber gasket between the shaft and the housing. My passenger side has a 1/4 inch gap from the shaft to the housing and there is no rubber gasket. The undercarriage is soaked now. I will fill up THE transmission with fluid and take it to PTP.
What is the problem? Bad seals? Is there something missing? Did the dyno mess me up?
View 4 Replies
First day that is below freezing and my rear passenger driver side door is hard to open more than half way. I really have to push it to open all the way. How to fix this?
View 11 Replies
I have a 1996 chevy cavalier 4-door. It is a 2.2 auto. I changed the passenger side cv shaft and now it won't start. I have lights it won't turn over. I put a new battery in no luck.
View 4 Replies
After a quick search i came up with it possibly being the endlinks, but my question is how do i tell if they are bad and if its the upper or lower link? after getting under the car neither were loose or anything and the bushings had slight cracks in the rubber it didnt look too bad though. anything else i should be looking for?
View 4 Replies
I have a 2005 F350 XL Heavy Duty 6.0L truck that has 68,XXX miles. I recently changed the rear brake pads and about a week later the rear passenger side is leaking brake fluid. The fluid is slowly dripping from the bottom caliper bolt but i am not sure if there are seals in this area. the driver side is fine and the fluid is only leaking from the bottom caliper bolt not the top.
View 2 Replies
I've been having a *clunk* noise on the rear, passenger side. Its been there when I had stock springs and still there with Eibach springs. The rear has being inspected by 2 mechanics; my friend who has a shop and the guys at Lextech in SoCal; Nothing was loose and everything seemed fine.
I hear a *clunk* noise when I brake (not all the time)
I hear a *clunk, clunk, clunk...* when the car is moving at maybe 5mph and goes away when I start going faster.
There's no noise over bumps.
Noise is there regardless if I am driving on a shitty road or not.
I regressed the caliper pins, thinking that was my problem. What to check or what the Celica is known to be notorious at.
1995 Celica, 106k miles, MT, 5SFE
View 6 Replies
