This fuse controls the interior lights, power windows, and the brake pedal shifter release. I noticed the problem when the vehicle would not shift out of park.
I replaced #15 fuse (5amp) and everything worked fine however several hours later with the vehicle simply parked the fuse blew again.
Appears to be a "short" of some kind but it seems to take several hours for the fuse to blow.
I have a 2001 Ford Expedition with the 5.4L engine. I know that there are problems with the engines blowing out spark plugs. Besides putting in sleeves and replacing the cover when necessary, any good luck with a different alternative. If not what products with the above options seem to give you the most bang for your buck.
View 16 RepliesFuse #27 keeps blowing as soon as I shift into reverse.
Prior to shifting, everything works as it should - I've unplugged the rear sensors, back up lights, trailer plug, and each time, fuse #27 keeps blowing.....
Where I should look? Also - looking for a 2003 excursion wiring diagram that shows what all fuse#27 controls?
We went camping and my girlfriend wanted to take her brothers fishing boat for him, on the way back the electronic stability control light came on and when we reached our destination we discovered it wound not shift into or out of park without using the key override.
2011 front wheel drive santa fe ...
I have a 2006 f350 king ranch 4x4, I recently used 4 wheel drive and could not disengage it, it would go into 4 low but would not go back to 4 high or 2 wheel drive, I unplugged the actuator harness and applied 12 volts to the terminals and it disengaged, I reversed the power and it engages, the actuator seems to work properly, I then replaced the two relays located by themselves on the front fender driver side, when I try to install the 30 amp female fuse located in the outside fuse panel rear driver side, fuse #3 for 4x4 shift on the fly it blows immediately, it makes no difference if the harness is plugged into the actuator or not, if I remove the two relays then I can install the 30 amp fuse, but as soon as I try to install the relays it blows the fuse again..
View 6 RepliesMy wife's AC quit blowing air last week (a '05 Nissan Altima), so I decided to check all the fuses before just replacing the blower motor. I pulled all fuses out in all three fuse boxes and didn't find any blown. Got a call from an upset wife later that day saying she could not shift the car out of park. Currently, she is driving it by using a screwdriver to release the safety switch next to the shifter.
View 3 RepliesMy son's Honda Civic keeps periodically blowing the #4 fuse under the dash (alternator). He replaced the VSS and had the alternator tested but it still happens.
At one point the fuse would blow as soon as you turned the key to ignition but I traced that down to a shorted wiper motor which I replaced and that solved the immediate fuse blowing. BTW according to all documentation I have, the wiper motor is not supposed to be on fuse #4 so perhaps the under dash fuse box has issues.
Looking for a schematic for the under dash fuse box? I have the 01-02 service manual which has wiring diagrams that reference specific fuses but I can't found one for the box itself. Are there relays in that box or is it just wiring from fuse slots to the many connectors?
I have a 2004 Hyundai Sante Fe 2.4L that keeps blowing the ECU fuse under the hood when the ignition is turned on. We have replace the fuel pump and the inertia switch. I have tested the relay, ignition failure sensor, both coils and O2 sensor wiring.
View 10 RepliesWhy I"am blowing #19 fuse it is a 10 amp fuse. It is in the passenger compartment fuse panel. It controls the auxiliary powertrain control module (diesel only),Instrument Cluster, GEM Module, Overdrive Cancel Switch, Idel Validation (Diesel only), Overhead Console and Diesel PCM via Clutch. I would like to know where to start looking to solve this problom.
View 12 RepliesOn my 2005 Elantra - my radio, dash board clock, dome light, and keyless entry stopped working all at the same time.
Fuse #25 that controls these features is burnt out. As i replace this fuse, it immediately sparks and blows the new fuse.
I have an 01 f250 5.4l standard. #19 fuse keeps blowing. I hAve taken the gauge cluster out and do not see any wires melted or burned. It blows the fuse as soon as I turn the key over. I have read things saying the overdrive but that doesn't work with mine.
View 4 RepliesI'm having brake light issues with a 2001 Suzuki Grand Vitara. The brake light fuse keeps blowing. The last time driven with me following the driver side brake light was dimmer than the passenger side. At one stop the driver side brake light pulsed brighter for a split second then went back to dim. A few stops later it became as bright as the passenger side and stayed that way for the rest of the trip. The driver put in a breaker fuse and it was in during the observed trip. I'm not sure of the brake light visual symptoms without the breaker fuse in other than that the fuse keeps blowing which prevents the vehicle from being shifted out of park. What the problem could be? Bad ground?
View 4 RepliesI posted earlier about the tranny in my 01 Ex v10 having a transmission problem. The show looked at it and found the O2 sensor had shorted out and in some way sending the truck in to limp home causing the tranny fuse to blow????
Any way they fixed it or so they said and I drove it for a few hours and it did fine. The next morning I drove it and it blew the fuse. (under hood box I belive #19) I took it back to the shop and they beat and banged on it....got it wet etc. and can not get it to do it again. I know whe have an electrical issue but what all runs off of the fuse that controlls the tranny?
Is there any online wiring diagrams of excursions or superduty drive trains? Where all to look for the problem?
As the title states I have a 2001 f250 with the 5.4 4x4 and lately the auto headlight / overdrive fuse keeps blowing. Both seem to function just fine but a couple of days later the fuse will be blown. I am not functioning the OD button when it blows so I'm guessing its something with the headlights. What else does that fuse protect?
View 2 RepliesOn my 2002 sometimes when I come to a stop after rolling around with the ICE off, then right after I shift in Park the ICE starts up. Why would it do that? Is this a bug or is it normal?
View 16 Replies2001 F-350 diesel. Out of nowhere, I start the truck and there's no turn signals. Fuse is blown so I replace it. It immediately blows. Tail lights work. No turn signal, brake lights, or hazards. I haven't hooked up a trailer or done anything abnormal recently. Only the #1 fuse (20Amp) is blown. Pulled bulbs and they work fine. Inspected wiring under and near lights. NOTHING! Any way to localize a short?
View 2 RepliesThis is a car i am working on. 01 4motion passat. automatic. Tree fell on it. We put a new roof, quarter, door seats. Last night we moved it outside to clean the shop and went to move it back in. Won't shift out of park. Next tried turning ignition on the backing it off a little and cant get to neutral. Check fuses.
Brake light switch has been previously replaced by someone. and it works. Light next to gear selector working. brake lights fine. I have taken the center console out as much as I can. I can't get it completely out. But everything in there seems ok. When I press the brake in I don't hear any click or anything near the selector.
My 2001 subaru outback wagon when put in park doesn't shift out of that position unless I access the little hole for releasing the shift module and put it into gear. What is the problem? The fuse for the transmission is good. outside fuse box.
View 1 RepliesI have just bought a 2001 Prius with 127,550 miles. Hybrid battery has been replaced with a used one and all systems seem to work fine except the shift lever in the "Park" position does not lock the transmission. No big problem as long as the Parking Brake works. Preliminary investigation does not reveal any easy fix.
View 6 RepliesThe AC was blowing hot air. But then we noticed that we could hear a flap closing. So the game has been, to keep it cold, to stop somewhat abruptly, then turn on the AC, then DO NOT accelerate quickly or you will hear the "shut" which makes the air turn hot.
Now, I have gone to auto zone and bought two things: Air Door Actutator, and Blend Door Repair Kit, both supposed to be for 1999 Expedition. I don't yet know which I need. I am looking to do the fix through the glove compartment which I understand is possible, although no one mentioned it here back in 2004.
On my 2000 E.B. I have NO A/C at all. All vents on the dash, regardless of vent, floor, defrost, ETC all blow hot air, even with the A/C on Max A/C. Also, all the rear vents for the rear HVC blow WARM air as well. I have no A/C in the back either. I don't hear any flopping around under the dash going down the road and I have checked the A/C compressor with the unit on Max A/C and the clutch appears to be engaged and the compressor appears to be operating normally.
I have NOT YET checked the A/C lines or dryer to see if they get cold, I will check that tonight, but I expect them to be getting cold because the Compressor does not cycle on and off, it stays running pretty much all the time. It clicks off once and again, but not very often at all (such as the case would be if the system was low on freon).
So, if the A/C lines are getting cold (if they are not, I will know my problem is compressor related, likely anyway), what this problem could be? From what I've read, if the Front blows hot, yet the rear blows cold, it's a blend door actuator or broken blend door, but that is not my problem. I have no A/C at all, everything blows hot.