Escort :: 99 Ford Sedan Runs Fine Then Die When Idling
Jan 23, 2012
I have a 1999 ford escort 4 door sedan, when the car is cold I can get it to start and it will run just fine, after it starts to warm up, it starts to make a misfire/ sputtering noise when it is starting to die when idling. when I am driving it, there are no signs it is going to die.
I took it to the ford dealership today and they said that I need to replace the fuel pump, and the relay control module.
I just replaced the fuel pump a week ago because I thought that was the problem. So I am thinking it is the Relay Control Module- only problem is I don't know where it is located, where it is?
View 1 Replies
Advertisement
I have a 1999 Ford Escort SE wagon with 112k miles on it. Last week when leaving work my car started very rough. This was unusual so I killed and restarted the car about three times before letting it run it's course (~30 seconds), after which the car ran fine. About a week later on my way to work the car seemed to 'sputter' (for lack of a better word) when I pushed down on the petal looking for some power on two separate occasions. On each side of the sputters the car seemed to respond fine, but when it did sputter there was a severe lack of power. I got to and from work just fine, but while letting the car idle in the parking spot of my apartment for a minute before shutting off the engine the check engine light finally came on. The following morning the car again started rough (as if it were misfiring/running on 3 of 4 cylinders) and this time it took a good minute before smoothing out. However, after the car smoothed out I experienced no issues on the way to work, no sputtering, no loss of power, nothing. Doing some initial online research I feel that the problem may be one (or more) of the following:
-Fuel pump
-Vacuum lines
-O2 Sensor
-Spark plugs (they are original)
-Fuel Filter (it is actually past due for replacement)
I plan on getting this checked out ASAP, but that still may be 2ish weeks away with my schedule. Some similar reports say that I may be having a 'lean mixture' issue (not getting enough fuel), but I haven't had the time to check the code. My question is, how "safe" is it to continue driving my car with the current situation? Is it at a super high risk of failure/random stalling during rush hour? Will it cause any damage to the engine if there is a cylinder misfire upon start up? I was also wondering if the car would be reasonably reliable to drive on a ~400 mile road trip on an upcoming weekend, but I am making plans as if it is not.
Additional Details:-Tried charging the fuel lines (car to 'ON' then 'OFF' position 3-4 times), had no effect on the morning start-up-Commute to/from work is about 20 miles
View 13 Replies
This problem has been getting worse over the last 2 years. When the car starts it idles fine at about 1000 RPM. As soon as it warms up, it starts to idle rough, between 500 and 750 RPM. It almost quits running. As soon as you give the car some gas it runs just fine. About 3 weeks ago I got a "Engine Lean" check engine light error. I reset the system and have not gotten the error again. Since then I have: changed the MAF cleaned the EGR (made sure it closes completely and ohm out the coils in the actuator) changed the O2 meter on the exhaust manifold cleaned out the throttle body Ohmed out the air idle controller. What I should check next. I was planning to check the fuel pressure in case it is a fuel system problem. It is a 1999 ....
View 5 Replies
Got a 97 Sedan with 207k+ on it. Just did all struts (monroe quick-strut), brake pads, shoes, drums, rotors, calipers, rear and front sway bar endlinks, and lower ball joints. All hardware is tight and secured.
I am getting a clunk when I go over some bumps, but not all of them. I also find that it will clunk when I try to accelerate while turning out onto, say, a main road or something where I need to pick up speed. At times it sounds like it's coming from the passenger and others it sound like the middle or driver side.
Control arm bushings don't look too bad and would probably cause more noise when accelerating and braking. Both wheels are snug and don't move when tugging on them in the air. There is no play in the steering as well.
View 14 Replies
Once again back to the ol' 92 GMC C1500 V6. Had my Ford Escort air assembly disassembled to clean something and received an emergency phone call, the truck seems to start just fine so I took it to get where I needed to go. Ran fine no issues even took it on the highway, ran just like she used to. On the way back I stopped at a gas station, when I went to start it she wouldn't start (towed it home again).
Checked ignition system and it was fine, removed the top of air filter housing and filter and looked down into the fuel injection system and had a person crank the engine and once again no fuel was squirting out. Took out the injectors and they both tested good and the same, 1.7 ohms each, going out to rent noid light again but doubting it will do any good to test again but who knows at this point.
View 19 Replies
I just purchased a 93 escort sedan 1.9 ltr engine. Car runs great when idling but bogs down when accelerating to the point it almost stalls out but doesn't stall. the car sat for a while 6 + months. We thought the gas might be bad so we drained the tank filed it with premium to run thru the line but that didn't work. thought maybe o2 sensor, changed that but didn't work. getting error codes 412 and 538 but can't find any info on these codes.
View 7 Replies
I start the car - a 2001 Ford Focus 4 cyl DOHC. It runs fine for 30 seconds then stops, as if it is no longer getting fuel. I can't start it again for a couple days then the same thing happens over again. FWIW, I parked the car for 8 months before this happened and only started it once in that time. But it ran fine then and before I parked it. What can this be?
View 1 Replies
The check engine light came on again after coming on about a week ago and then shutting of by itself. Everything seems to run normal with the car so I don't know if I should ignore the light and just keep driving or what. What would you do? My car is a 2011 Ford Taurus.
View 1 Replies
Almost everytime I drive the car for more than 2 consecutive it acts as if it drops a cylinder..running rough. The next day it will run fine until 2 hours go by...and so on. I have changed plugs wires and coil pack.... 4 cylinder .. automatic
View 2 Replies
2010 Escape with 74,000 miles. Backstory: This is my daughters car who is away at college about 300 miles away. About a year ago the engine started hesitating when driving and would stall to idle at highway speeds. She took the car in to dealer and they replaced the Throttle body under the CSP that had been issued just prior to the dealer visit. All was fine for about 3 months, then she reports that the car is doing the same thing. Check engine light briefly illuminates and goes right back off when this occurs. She is able to slip the car into neutral and it seems to correct the malfunction. Unfortunately she has gotten so good at this that she keeps her hand on the gearshift when driving. It seems to happen at various speeds with no warning and no lasting effects.
She came to visit for Christmas and I was able to replicate the problem after about 30 minutes of city driving, but not quick enough to take a picture of the wrench that illuminated briefly. I slowed to the edge of the road, put it in park and turned off the key (engine ran the whole time at idle). Cranked back up and good to go! She had the oil changed about a thousand miles ago, I replaced the air filter last night and she had to return to her house for work in the next couple of days. She said it happened 5 times on the way home last night.
Car has always been serviced regularly and was a certified pre-owned when we bought it in March or so of 2012. I also bought the extended warranty although that may be expired by now.
Her local dealer said they can't fix it if the CEL is not on or the problem is not occurring at the exact time they have it in the shop. Now, I am not sure but was under the impression that the computer would record any codes and store them even if the light went off and the car returned to normal.
View 6 Replies
97 aerostar rear ac stopped working. Blower runs fine. Checked solenoid has power and clicks when plug pulled and refitted.
Liquid line is hot to solenoid and somewhat warm after the solenoid. Return line from evap is at room temp.
Front is 40f at register. Am I looking at bad solenoid or blocked orifice tube. Solenoid is nla. Orifice not so. Still on original evaps comp etc.
View 7 Replies
I have a 2003 F250 with a 5.4L V8 automatic transmission with 64,000 miles. The truck runs and drives well, but occasionally while driving, it acts like it shifts into a higher gear, slips a bit, then downshifts and runs fine. The duration of this "acting up" is about 1-2sec. It seems to do it when going up a slight grade at cruising speed about 40-50mph. (Not towing when it does it) It doesn't do it all the time. I'm planning to change the filter and fluid but am doubtful that will work. The fluid color is nice bright pink and does not smell unusual.
View 1 Replies
I have Warn hubs that I have to lock in. All works good. A/C goes to defrost at first when cranking but then runs fine after a couple seconds. So, I was thinking that maybe my pump is running all the time. Who knows. I'm sure all my vacuum lines are dry rotted. What exactly is the need for it exactly and what's the best way to cap? Hoping to do it at the unit itself if possible.
View 6 Replies
2000 F350. Starts great. Idles fine. After it warms up a little, it will run rough and lose power like it is only hitting on a few cylinders. It will eventually stall unless I push the clutch in and bring it back to idle and then it smooths back out. I figured it was starving for fuel but I can rev it with the clutch in with no issue. I ran it up to 2500 rpm and held it there with the clutch in and ran perfect.
I let the clutch out and start rolling....missing again. The check engine light does come on but my scanner says that there are no codes stored. If I idle it, it will smooth out, and the light goes off. All I have done so far was change the fuel filter which was almost plugged shut and the housing was full of rust looking debris which I cleaned out. BINGO! Nope. Same issue.
I am really at a loss as to where to start. I bought this with 120k on it and it now has 170k and I have not had to do anything other than routine maintenance.
View 14 Replies
Let me start with I have a 2003 f250 5.4. The motor blew on my truck and I had a 100k motor dropped in it. I've put new spark plugs, ohmd out the coils. I tried both sets of injectors. cat delete and new fuel pump. It has rough idle and stalls but runs fine at higher rpms. Also has basically no brakes. I am thinking vacuum but I've check all the lines. No codes either!! also cleaned throttle body.
View 4 Replies
I just got done with a complete engine rebuild on my 02 1.8t jetta, had everything hooked back up and went to start it for the first time and it wouldn't. I went back looking for loose connections, nothing. Worked and banged my head for a day or two, I had fuel and spark but couldn't get it to fire. Finally I "choked" the intake to see if it was getting too much air and it fired right up. I unplugged my map sensor giggles and it starts up perfectly. I then hooked everything back up and what do you know it starts up and runs fine, but if I plug the sensor back in it kills the motor after about 10 seconds of running and won't start until I unplug the map again.
Car runs and drives but wont boost over wg pressure but that's probably because sensor itself is unplugged. I just wanna know what could cause it besides the sensor itself being bad. I ordered a new one waiting for it to get here (hoping it fixes the problem).. And I'm talking map (manifold absolute pressure) not maf (mass air flow), just in case people are confused.
View 4 Replies
My 1999 Jeep Cherokee, 4L inline 6, has a very weird problem. Usually, after starting, it runs well for around 10 seconds, during which time I back up and get ready to leave. Then when I switch to drive, it starts to run poorly, having no acceleration in speed or and very little in engine rpm, until I stop using the brakes. Exactly when the suspension relaxes, the idle returns to normal and it runs perfectly after that.
Sometimes the rough running starts while I'm backing up too. So I don't think it related to the transmission. But all I have to do is completely stop, and then it runs great from then on.
This doesn't happen every time, but probably 60-80% of the time. It's been happening for about 2 months now.
View 5 Replies
Often, when starting it will run rough and throw different misfire codes. Most of the time it smooths out in short order (a minute or less). When it doesn't smooth out quickly, it smooths out when I clear the code. Also, rarely it will start very hard. I have to wimd out the starter pretty good to get it to start. All that I have done is cleaned the MAF sensor.
View 3 Replies
I used a OBD scan tool and all it told me was my idle air control system rpm is lower than expected and my evaporative system has a high purge flow. What this means, can I fix it or do I have to send it to a shop. Also when idling the short term fuel trim 1 is at -3% whatever that means.
View 16 Replies
96 civic 120K miles, stock, automatic.
In March I was running low on fuel, maybe 1 gallon left in the tank. It took a few cranks and on the last try i gave it a little gas and it started, albeit very rocky for about 1 minute of driving, filled up immediately and 2 freeway miles later, no real issues. I live in LA so very low ambient temperature is not a problem.
April through May, starting was a little rocky, it was inconsistently rocky too, sometimes there was no problem. Usually it's weak, stuttering, sometimes just cranking but I seem to get it to start. I stopped giving the pedal gas because I read that's bad (I own a vintage bike, so it's news to me). I don't drive that far and figured I'd try some Seafoam and some freeway miles would clean out any debris. Worked for that tank a bit for the next tank before the problem came back.
Still getting the rough starts, but now when I give the car gas as I pull out sometimes it doesn't accelerate for 15-30 seconds, maybe 25 yards then it drive like normal. No dying at all but getting worse with starting up.
I've tried turning the key (not turning the engine over) 5 times and cranking on the 6th and it seems to work. I thought maybe it's the fuel pump or fuel filter but read it could be an ignition coil/ spark plug/ spark plug wire issue. Two different ball games.
My MPG is not really droppingI had a new fuel filter put in in February as routine maintenance (thing was on so tight had to bring it to a shop so no rookie mistakes there). Timing belt &water pump replaced 6,000 miles ago
View 3 Replies
1998 Dodge Durango, runs fine when cold, but when it warms up, the transmission will lock up going down the road(scary to say the least).
View 4 Replies
