Elantra XD (2001-06) :: Won't Idle When Cold / Will Stall
Oct 24, 2013
My 05 Elantra 2.0, 5 speed won't idle when cold til I drive it a few hundred feet. It will stall. Only then will the idle rise to what it's supposed to be. Is there some sort of cold idle sensor/module that needs replacing?
View 2 Replies
Advertisement
I just picked up this 2005 Elantra last month. She runs GREAT - except after filling. Then she will occasionally sputter or sometimes stall during idle. Otherwise, if tank is below 3/4 (approximately), she runs fine.
View 7 Replies
04 Elantra GLS, AC works great and is icy cold at higher RPMs but gets hot when stopped at idle or driving low speed. Fan works, refrigerant level is correct. At low idle speeds the compressor just shuts off. A few minutes later or if the engine speed picks up it will engage and start cooling again. AC tech didn't think it was the compressor since the pressure difference between the high and low sides was in the correct range. Has this issue fixed by replacing the pressure sensor/switch on the high pressure side? It doesn't look like there is a low pressure side sensor that I can see.
View 2 Replies
I have a 2003 silverado with a 4.8 engine. i bought the truck in the summer of 2010. no problems in the winter of 2010. ran great all year in 2011, then my block heater shorted out in the winter of 2011, so i wasn't able to plug the truck in.
We get some cold nights up her in alberta, but anything below -10c the truck would idle surge and stall, would do this about 4 times in a row then it would just surge a few times but stay running.
I had a buddy that's a gm drive ability tech take the truck and do a tone of updates for the throttle body and to correct idle surge and some other drive ability related stuff. i cleaned the maf, map and tps as well as the throttle plates. replaced plugs, wires, air filter and fuel filter. all this and it was still doing it, but it had to be really cold to stall.
wasn't able to replace the block heater till this summer. but now that its getting colder and dropping below -10c at night the truck is starting to idle surge when i start it up in the morning.
View 3 Replies
Car: 2000 Mercedes-Benz E320 (W210) 4matic
This car runs beautifully if the air temperature is above 60 degrees or so (maybe 65) Fahrenheit.
If the air temperature, however, is much cooler, and the engine has had enough time to cool to air temperature, it stalls. Here's the sequence:- Start the car. Car runs fine, sounds good. Initial idle speed about 1200-1500 RPM.- Wait for car to warm up for a few seconds so it settles into normal idle. Idle speed settles to about 800 RPM after 5-20 seconds, depending upon air temperature.- Shift car into gear (D or R - doesn't matter). Idle speed drops to 500 or so, then the car stalls.- Restart the car. Allow it to warm up significantly (how much depends upon air temperature). - Shift into gear (D or R). Engine idle speed drops a bit, then recovers to ~800 RPM. No problems after that.
If it's a little cool (55-60 degrees Fahrenheit), I can drive off once the engine temp gauge needle rises a few degrees (45-50 degrees Centigrade).If it's around freezing (20-40 degrees Fahrenheit), I can't drive off until the engine temp gauge reaches nearly 80 degrees Centigrade.
If I'm on a hill (pointing down), I can start at a slightly lower temperature by allowing the car to start rolling as soon as I shift into gear. In this case, there's less resistance, so the idle speed doesn't go low enough to stall the car. If I am on a level surface (or pointing uphill), 80 degrees Centigrade seems to be almost a magic number when the air temperature is below 40 Fahrenheit (near freezing). When the needle is showing about 78 degrees Centigrade, the car will still stall. When it reaches 80 degrees Centigrade, the car is fine, and will not even come close to stalling when put in gear.
ONE CONFUSING VARIABLE: When I took this to my mechanic, it didn't exhibit the problem for him. When I picked it up (about 30 Fahrenheit), it stalled. He came out and started it, put it into gear, and it idled without stalling. I got in and let him watch while I got in, started it, put it into gear, and it stalled. We have no explanation as to why this would be any different (we tried several times, varying techniques, brake pressure, etc., with the same confusing results).
View 6 Replies
My truck is a 1995 Explorer 4.0 150,000 miles, 5 speed.
Problem - Rough idle : when cold it's worse and will stall and choke a little. When warmed up it just has a rough idle but will not stall and stays at a pretty constant RPM. It's very tolerable when warmed up but still not right. It drives fine once off idle. No black smoke that I can see. Power may be just a little off but I would not bet on it. MPG seems about normal but haven't been on a long enough trip since problem started to tell for sure. Also longer than normal cranking on occasion.
Diagnostics so far : Fuel pressure is at 32 PSI, vacuum off regulator it's at 40 PSI. Not sure about key on only as I don't trust the autozone loaner gauges. You have to fiddle with it each time before it will read. Leak down after 30 minutes was about 4 PSI
No Check engine light ever. KOEO test shows no hard or on demand codes, I get the 111 pass. From CM I get 336 and 45.
336 is EGR related and my looks pretty rusty. I put a vacuum pump on it while running and the EGR held vacuum but had no effect at all on idle, I was expecting it to get worse as I opened the EGR so it may be stuck.
Searched high and low for vacuum leaks by ear, visual and with starting fluid all turned up nothing.
Actions so far : Replaced plugs, wires, IAC, and fuel filter. Cleaned MAF sensor and throttle body plus ran lucas fuel injector cleaner through it.
Next steps : I've got the EGR but it's so rusty I am sure I'll break the tube it bolts to plus I don't know it that alone will cause the rough idle. Will the DPFE sensor and/or EVR create a rough idle yet not turn on the CEL?
Thought about changing the fuel pump and/or regulator but the numbers are not terrible. Agree?
Thought about changing the intake gaskets but don't see any leaks.
View 8 Replies
Car: Elantra 2002 GT
5 Speed Manual
318000km
Kept all recommended service checks
Just week ago strange occurrence of the following problem started. Car is Idling No Problem, Running in any speed, accelerating no problem. Driving on Highway one day engine started stall (check Engine popup stall) but I didn't push the clutch and its restarted and run and again after while come on and stall and restarted and run and after just running no problem.
Removed Fuel pump, check the tank, nothing visible, I put water remover in the tank refuel to the full tank, car is running. Driving for two days, no problem. Today I drove on the highway and its happened again, after 3-4 stall car is running smoothly again.
I have OBD reader with me, no codes, no stored codes...nothing. No battery failure as the clock and radio didn't reset. Drove around the bumpy street for 30 minutes, nothing as I thought some bad relay.
What I should try next? (HV for spark plugs, fuel pump is running smoothly and has pressure, dirty injection?)
View 27 Replies
I just started to have some idle problems with my 2013 Elantra GLS auto 1.8 that has 10k miles.
I went to the gas station to fill up the tank since the gas was very low (30 mile range). I filled up the tank, started the car and the engine began to stumble and idle poorly like it was about to stall. I put the car in drive and the engine stalled. I restarted the car and it ran normally.
The car will now briefly idle poorly when I'm at a stop light. The car will be at a stop light idling and running normally. Suddenly, the tach will go down to 200 rpm and then up to 1200 rpm, like it is about the stall. Then it will idle steadily and be back to normal. This has happened about three times over the past two weeks.
What may be causing this intermittent idle problem?
View 9 Replies
I have an '01 Impala, 3.8 engine with 200k miles. Whenever the engine idles, at a stop, or in a parking spot, the idle will drop, then the car will stall. It will start right back up, but unless you are actively pressing the accelerator, the same thing occurs. There's no sputtering or performance issues, and nothing to indicate that it's about to stall. I've replaced the IAC valve, AND the EGR valve. Still having the same issue.
View 5 Replies
I have a 2001 santafe with a 4 cyl The code 102 was up so I replaced the mass air flow censer . I go on a test drive and the light stays off , but when I go to re start it again the light come on and stays on, with the same code. The only strange thing is the idle will raise for a min then drop down to almost a stall.
View 2 Replies
My 2001 6.8 L V10 runs great all day & night without issue, but first thing in the morning when below freezing it has a hiccup. It'll fire right up and stutter and stall within less than 2 seconds. Usually twice. Third time it fires and keep running. Is there a fuel check valve somewhere on this thing? Not sure what that would have to do with the temps. Wondering if it's/there's an easy fix or not?
View 5 Replies
I have a 2001 Ford F150 Lariat. It has the 5.4L Triton motor. I was having starting problems as such the truck would crank and not start or crank, start and barely idle and stall within 5 seconds. It was NOT tripping any lights. I was told it was a possible fuel issue. I have since changed the fuel pump, fuel filter, as well as the hoses in the rear connected to the tank. Truck started, ran great, even seemed to have more power. Ran great for about a week. I was on my way out yesterday about 2 miles from home when the truck just stalled out on me. It is now having the same issues it was having before I changed the pump, filter, etc. What the issue may be? Clogged line? Fuel injector? If it is an injector how can I tell which one?
View 8 Replies
I have a 2010 Elantra and noticed after I start it when it's cold the rpm is about 1800rpm but doesn't drop. I never really payed attention on this car but my other cars would drop after a minute or so. Is this normal on the elantra or is something wrong?
View 7 Replies
My moms has a 2010 Elantra with 30,000kms on the clock, and we have noticed since new when the vehicle is started cold in the morning it seems to run rough for about 30-60 seconds then stabilizes.
It's almost like it has a slight misfire, or slight fuel flooded from sitting overnight. Now if course we have taken it to the dealership twice for this issue and dropped it off overnight for a cold start, and both times they cannot re-produce the problem.......surprise.
View 6 Replies
A few weeks ago I noticed a fluctuation in my car's heater. The heater blows really hot when driving, and blows cold when the car is idling or coasting. I read up on the forums to check the coolant levels, which were full since my last fluid change a few months ago. The next step seemed to be to change the thermostat. I changed the thermostat and the heater acts the same, and since then the car has begun intermittently overheating. The temperature warning will flash on for maybe about a minute, then go back off. I have been running the heater on full blast trying to keep the car from overheating.
This brings me to a couple of questions:
There's an arrow on the thermostat. Does this need to point toward the radiator, or straight up?
In moving the air cleaner housing to get to the thermostat, I lost two of the little clips that hold it shut. Is this critical?
If the thermostat is good, and the coolant levels are good, there's no air in the system and I don't have any leaks, what could this be?
View 16 Replies
So this problem came about after I changed the timing belt on my wife's 05' elantra.
The idle will bounce from 1.5k to 3k exactly and continue this for as long as the car is on. Some times it will stay at some point within that range for around 2 seconds then continue to bounce.
I checked the belt today, and it seems to be tight enough but not to loose either...maybe I screwed the timing up? But would that cause this problem?
Here is what I have done:
Replaced the IAC valve
Cleaned the MAP sensor (no MAF sensor on this engine, that I know of...)
Checked and cleaned the spark plugs
Cleaned all electrical terminals
Checked the resistance in the throttle control sensor
Checked for vaccum leaks with carb cleaner
Cleaned PCV valve (3 times)
Replaced Air filter
Probably a few things I am missing in there, but nothing has been a success.
View 3 Replies
02 elantra 138418 miles. Before I cleaned throttle body engine idled fine, but know I can't get engine to idle below 1500 rpm, check engine lite is on, went to advance auto parts, he pulled code, he said idle air control stuck, i am hoping there is something i can do before spending $ and replacing it.
View 6 Replies
New iac and now runs at 3000, replaced iac, input shft speed sensor,and #3 fuel inlector because of codes. Have factory shop manual. Old iac had higher than factory ohm resistance by 5 ohms on each test of terminals 1 and 2 and then on 2 and 3. new iac [wells] is 4 ohms higher on both tests . Old iac ran at 1200 rpm new at 3000 rpm. tps is smooth on resistance test so assume it is ok. Blocked off all hoses to intake manifold to check for open pcv or evap. valve but still the same. 2001 elantra gls is giving me a fit. soft reset of ecm did nothing. Pulling pigtail on iac will drop rpm's to about 1100 but runs rough.
View 8 Replies
2004 Elantra - 65,000 miles: Heat and AC works fine when vehicle is moving. At idle or parked it just blows air.
View 2 Replies
2001 elantra has been revving really high on cold starts, RPMs will stay at over 3000 till u switch it into drive or reverse, Never happens when engine is warm, had intake cleaned out, did not solve issue...
View 5 Replies
I've got a 2006 Elantra with 102,xxx miles. When starting the car, especially a cold start, it ignition is rough, sometimes a jolt. It runs fine after that. What might be the issue? FYI, i replaced the spark plugs in August or so.
View 4 Replies